• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2007년도 추계 학술논문 발표대회
• /
• pp.19-22
• /
• 2007

This study discussed the prevention of the spalling and improvement of the fire resistance performance how to fill up lightweight foamed concrete on high strength RC column attached with the stone panel. The destructive spalling extremely occur caused by sudden high temperature and increased vapor pressure corresponding to falling the ston panel at all RC column, and the steel bar is exposed. The stone panel fall off about 30 minutes and spalling occur about 70 minutes on Plan RC column, fire endurance paint, and fire endurance mortar, so it can be confirmed that fire endurance paint and mortar, which is used as fire endurance material, are not effective. In the other side, it can be protected from fire about $120{\sim}140$ minutes when the lightweight foamed concrete is used as fire endurance material. For the weight loss after the fire test, plain is 33, fire endurance paint is 37%, and fire endurance mortar s 40.7%. And W/B 60%-3 is 53.4%, 60%-1.5 is 40.1%,65%-3 is 39.4%, and 65%-1.5% is 47.1. Overall, the weight loss of the plain is lower than that of the lightweight foamed concrete.

• 한국건설관리학회:학술대회논문집
• /
• 한국건설관리학회 2008년도 정기학술발표대회 논문집
• /
• pp.804-807
• /
• 2008

최근 건축 구조물의 초고층화 대형화로 인해 고강도화 되는 콘크리트는 치밀한 조직으로 인해 화재시 폭렬에 취약하고, 내화성이 저하되는 문제점을 지니고 있다. 이로 인해 국내에서도 내화의 문제점을 인식하고 방안제도를 마련하고 있으며, 많은 연구진에 의해 고강도 콘크리트의 내화공법이 소개되고 있다. 이에 본 연구에서는 고강도 콘크리트의 내화공법 선정시 중요도를 관련 전문가의 설문조사를 기반으로 AHP 기법을 이용하여 분석하였다. 설문조사를 통한 분석 결과 상위 평가항목의 화재성능과 상시성능 중 내화공법 선정시에는 화재성능이 가장 중요시되는 것으로 나타났다. 화재성능에 대한 하위 항목에서는 인명보호가 중요한 요소로 산정되었고, 인명보호에 대한 하위 항목에서의 설문분석 결과 유해가스 발생억제가 중요한 요소로 산정되었다.

• 한국화재소방학회논문지
• /
• 제2권2호
• /
• pp.17-30
• /
• 1988

In Our Country, the fire safety design is done by the standard furnace fire test. This is haphazard procedure, as the standard furnace fire endurance of structural elements has little relation to the structural element endurance in an actual Compartment fire. The standard furnace fire test results, though obtained at great cost, do not contribute to the understanding of the behavior of structural elements in an elevated temperature environment and can not be applied rationally in fire safety design. The response of a steel and reinforced concrete structure in fire is a very complex problem. Therefore, in this paper is explained about tendency of study for fire safety design in advanced nations.

• 한국방재학회 논문집
• /
• 제6권1호
• /
• pp.17-27
• /
• 2006

화재동안 구조물의 복잡한 거동을 이해하기란 쉽지 않다 때문에 화재이후의 철근콘크리트 구조물의 잔류 강도를 평가하는 것은 매우 힘든 일이다. 그러나 교통시설의 화재로 인한 피해는 매우 크므로 화재에 대한 안전성 확보는 결코 간과해서는 안 될 중요한 요소이다. 따라서 이런 큰 피해를 줄이기 위한 철근콘크리트 구조물에 대한 정확한 내화성 평가 방법이 절실히 요구된다. 본 연구에서는 철근콘크리트 구조물의 내화성 평가를 위한 비선형 유한요소해석방법의 유효성을 증명하였고, 비선형 유한요소해석방법에 의한 지하차도 내화성 평가 결과를 ACI 216R-89의 결과와 비교하였다.

• 한국화재소방학회:학술대회논문집
• /
• 한국화재소방학회 1998년도 추계학술발표회 논문 초록집
• /
• pp.73-76
• /
• 1998

To use glazing systems protected by automatic sprinklers as fire barriers in building compartmentation, fire endurance tests of these systems have been performed by several research workers. Most of the tests concerned the types of glasses and sprinklers, sprinkler water flow rate, and sprinkler activation time. Horizontal side wall sprinklers and window glazing systems with a vertical center mullion were mainly applied in the tests. In the study, full-scale fire endurance tests were carried out to verify the ability of large glazing systems divided by a horizontal mullion and protected by pendent vertical sprinklers. The result shows that the protrusive length of the horizontal mullion, which is perpendicular to the glass surface, is the main parameter that determines the fire resistance rating of the systems. The mullion obstructs the water flow in the glass.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 2004년도 추계 학술발표회 제16권2호
• /
• pp.553-556
• /
• 2004

This paper is to investigate the spalling and fire endurance of high performance RC column member with PP fiber and lateral confinement of metal lath and non fire resistance removal type form. According to test results, combination of PP fiber and metal lath as well as use fire resistance non removal type form had favorable fire resistance by discharging internal vapour pressure and lateral confining. After fire endurance test, compressive strength decreased markedly caused by internal expansion pressure and crack. Residual strength of plain concrete was decreased to $22\%$. The use of PP fiber and lateral confinement of metal lath and non removal type form enhanced the residual strength above $40\%$. Especially, the combination of $0.1\%$ of PP fiber and lateral confinement with the level of 2.3T exhibited more than $51\%$ of residual strength. Therefore, to improve fire endurance and spalling resistance, the combination of $0.1\%$ of PP fiber and metal lath with 2.3T can be the proper measure.

• Steel and Composite Structures
• /
• 제30권4호
• /
• pp.351-364
• /
• 2019

Earthquake and fire are both severe disasters for building structures. Since earthquake-induced damage will weaken the structure and reduce its fire endurance, it is important to investigate the behavior of structure subjected to post-earthquake fire. In this paper, steel-concrete composite beam-to-column joints were tested under fire with pre-damage caused by cyclic loads. Beforehand, three control specimens with no pre-damage were tested to capture the static, cyclic and fire-resistant performance of intact joints. Experimental data including strain, deflection and temperature recorded at several points are presented and analyzed to quantify the influence of cyclic damage on fire resistance. It is indicated that the fire endurance of damaged joints decreased with the increase of damage level, mainly due to faster heating-up rate after cyclic damage. However, cracks induced by cyclic loading in concrete are found to mitigate the concrete spalling at elevated temperatures. Moreover, the relationship between fire resistance and damage degree is revealed from experimental results, which can be applied in fire safety design and is worthwhile for further research.

• Steel and Composite Structures
• /
• 제11권4호
• /
• pp.307-324
• /
• 2011

With the increasing use of concrete-filled steel tubes (CFST) as structural members, there is a growing need to provide suitable measures for possible strengthening or repair of these kinds of structural elements. Fibre reinforced polymer (FRP) jacketing is a recent method and is particularly attractive in which it does not significantly increase the section size, and is relatively easy to install. Thus, it can be used to enhance strength and/or ductility of CFST members. Very little information is available on the performance of FRP-strengthened CFST members under fire conditions. This paper is an attempt to study the fire performance of CFST columns strengthened by FRP. The results of fire endurance tests on FRP-strengthened circular CFST columns are presented. Failure modes of the specimens after exposure to fire, temperatures in the cross section, axial deformation and fire resistance of the composite columns are analysed. It is demonstrated that the required fire endurance can be achieved if the strengthened composite columns are appropriately designed.

• 한국화재소방학회논문지
• /
• 제18권4호
• /
• pp.93-102
• /
• 2004

원자력발전소에서 방화벽 관통부 내화충전구조는 화재가 발생장소 이외의 구역으로 전파되는 것을 차단하여 타구역에 설치된 안전에 중요한 기기를 보호하는 중요한 구성요소이다. 그러나 국내 장기 가동중 원전의 경우 관통부 충전구조의 내화성능을 입증하는 인증시험서가 구비되어 있지 않아 별도의 내화성능평가가 이루어져야 하고, 성능평가 결과가 적정 내화등급을 만족하지 못하는 관통부에 대해서는 관통물질의 재배치 둥의 구조변경이 이루어져야 한다 본 연구는 분석적인 방법에 의한 관통부 충전구조의 내화성능 평가기법을 정립하고. 분석적인 방법을 적용하여 실제 발전소에 설치된 관통부 충전구조의 내화등급을 결정하는 방법을 제시하였다. 이를 통하여 분석에 의한 관통부 충전구조의 내화성능평가방법은 내화인증시험서가 없는 국내 장기가동 원자력발전소에 효율적으로 적용될 수 있을 것으로 판단된다.

• Structural Engineering and Mechanics
• /
• 제77권5호
• /
• pp.673-689
• /
• 2021

This paper addresses the efficiency of thermal insulation layers applied to protect structural elements strengthened by fiber-reinforced polymers (FRP) in the case of fire event. The paper presents numerical modeling and nonlinear analysis of reinforced concrete (RC) columns externally strengthened by FRP and protected by thermal insulation layers when subjected to elevated temperature specified by standard fire tests, in order to predict their residual capacity and fire endurance. The adopted numerical approach uses commercial software includes heat transfer, variation of thermal and mechanical properties of concrete, steel reinforcement, FRP and insulation material with elevated temperature. The numerical results show good agreement with published results of full-scale fire tests. A parametric study was conducted to investigate the influence of several variables on the structural response and residual capacity of insulated FRP-confined columns loaded by service loads when exposed to fire. The residual capacity of FRP-confined RC column was affected by concrete grade and insulation material and was shown to improve substantially by increasing the concrete cover and insulation layer thickness. By increasing the VG insulation layer thickness 15, 32, 44, 57 mm, the loss in column capacity after 5 hours of fire was 30%, 13%, 7% and 5%, respectively. The obtained results demonstrate the validity of the presented approach for estimation of fire endurance and residual strength, as an alternative for fire testing, and for design of fire protection layers for FRP-confined RC columns.