• Journal of Korean Association for Spatial Structures
• /
• v.8 no.4
• /
• pp.73-80
• /
• 2008

The objective of current study is to develop an optimization technique for the seismic actively controlled building structures using active tendon devices by an efficient solution of LQR control gain. In order to solve the active control system, the Ricatti closed-loop algorithm has been applied, and the state vector has been formulated by the transfer matrix and solved by a numerical technique of the trapezoidal rule. The time-delay problem has been also considered by phase compensation. To optimize the performance index, the ratio of the weighted matrix is the design variable, allowable story drift limits of IBC 2000 and tendon forces have been applied as restraint conditions, and the optimum control program has been developed with the algorithm of the SUMT technique. In examples of the optimization problem of eight stories shear buildings, it is evaluated that the optimum controlled building is more suitable in the control of earthquake response than the uncontrolled system and can reduce the performance index to compare with the controlled system with a constant ratio of the weighted matrix.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.18 no.1
• /
• pp.97-103
• /
• 2018

In satellite communication, modulated beacon signal is spreaded by gold sequence and the modulated beacon is transmitted via linear phase modulation. Due to the difference in characteristics of the satellite and the receiver on the ground, frequency offset (FO) occurs. An existing modulated beacon receiver is a method of synchronizing the frequency of a modulated beacon signal using FFT(Fast Fourier Transform), which not only increases the delay and complexity in terms of system implementation but also has a separate circuit for compensating the phase difference due to FO and phase offset from FFT points. In order to overcome this problem, this paper proposes and analyzes a scheme for compensating and demodulating the coarse FO and phase offset at one time using the 2-phase shaped characteristics of the modulated beacon signal. Also, through the simulation, the modulation index suitable for the proposed method is analyzed and the appropriate cumulative number is also analyzed.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.16 no.2 s.93
• /
• pp.120-127
• /
• 2005

The design method of the transversal filter using continuously cascaded directional couplers is presented. The coupler can be treated for a continuously varying nonuniform coupled transmission line. The design method is based on the optimum extraction of desired coupling factor by the control of null positions which are inherent to the coupling spectra pattern. In the optimization process, the improved Woodward-Lawson sampling method is applied to easily synthesize the distributed delay and weighting elements for transversal filter properties. For application, the microstrip transversal filter is fabricated and optimum dielectric overlay is introduced for the mode phase velocity compensation for non-TEM coupler nodes by using SDA(Spectral Domain Approach). Experiment results confirm the validity of the proposed method.

• The Transactions of the Korea Information Processing Society
• /
• v.6 no.8
• /
• pp.2179-2187
• /
• 1999

To privide multimedia mobile communication services for the users in scattered locations, the application ATM cells efficiently in wireless communications, it is effective to the use TDMA method. However, it is necessary to have methods to compensate the CDV(cell delay variation) caused by the difference between TDMA-ATM and cell stream multiplexing of the users. This paper optimizes the cell control time(Tc) when VBR traffic inputs have MMPP by applying CDV characteristics of time stamp method, which has the most advantages among compensation methods of CDV. This paper suggests a cell stream multiplex method employing time stamp techniques to reduce CDV for wireless suggest method shows that CDV distribution and cell stream multiples rangd can be controlled to 1.2${\times}$Tc which reduced over the VBR service in the TDMA-WATM transmission. This paper also presents evaluation of the suggested architecture obtained simulation.

• Journal of the Institute of Convergence Signal Processing
• /
• v.12 no.4
• /
• pp.322-332
• /
• 2011

In this paper, we introduce the 1st performance evaluation of VLBI Correlation Subsystem (VCS) main product, which is core system of Korea-Japan Joint VLBI Correlator (KJJVC). The main goal of the 1st performance evaluation of VCS main product is that the perfection of overall system will be enhanced after checking the unsolved part by performing the experiments towards various test items at the manufacturer before installation of field. The functional test was performed by including the overflow problem occurred in the FFT re-quantization module due to the insufficient of effective bit at the VCS trial product in this performance test of VCS main product. Through the performance test for VCS main product in the factory, the problem such as FFT re-quantization discovered at performance test of VCS trial product in 2008 was clearly solved and the important functions such as delay tracking, daly compensation, and frequency bining were added in this VCS main product. We also confirmed that the predicted correlation results (fringe) was obtained in the correlation test by using real astronomical observed data(wideband/narrow band).

• Journal of Arbitration Studies
• /
• v.23 no.2
• /
• pp.81-113
• /
• 2013

The World Trade Organization (WTO) offers remedies for non-compliance by the introduction of compensation or retaliation in the Dispute Settlement Understanding (DSU). There are no the provisions under the WTO DSU and it seems unclear what retaliation is attempting to achieve. Therefore, it is unclear whether the goal of WTO retaliation is to induce compliance or to restore the balance between the rights and the obligations of WTO members. It has been claimed the WTO has a strong dispute settlement system by providing retaliation when the recommendations and rulings of Dispute Settlement Body (DSB) are not complied with. But this seems to be inadequate to bring about effective and timely compliance. Especially there is a problem with free riding by a violating member because the level of retaliation is determined from the expiration of a reasonable period of time, providing an incentive to delay compliance. Also the level of the suspension of concessions or other obligations authorized by the DSB is equivalent to the level of nullification or impairment, according to DSU Article 22.4. However, if the member concerned objections to the level of the suspension proposed, the matter shall be referred to arbitration. The arbitrator shall not examine the nature of the suspension of concessions or other obligations to be suspended but shall determine whether the level of such suspension is equivalent to the nullification or impairment. The arbitrator makes an assessment standard of equivalence by comparing the suspension of concessions or other obligations and the nullification or impairment calculated in terms of the amount of trade. But it is necessary that other standards replace the quantitative standards when the level of the nullification or impairment cannot be quantified by concrete damages.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.12 no.1
• /
• pp.89-97
• /
• 2007

This paper describes a load simulator with power recovery capability, which is based on the voltage source converter-inverter set. The load simulator can save the electric energy that should be consumed to test the operation and performance of the power quality compensator and the power equipment. The load simulator consists of a converter-inverter set with a DSP controller for system control and PWM pulse generation. The converter operates as a universal load to model the linear load and the non-linear load, while the inverter feed the energy back to the power source with harmonic compensation. the performance of proposed load simulator was analyzed with scaled-model experiment, interconnected with the active power filter. The experimental results confirms that the proposed load simulator can be utilized to test the performance of active power filter.

• Journal of the Korea Institute of Information Security & Cryptology
• /
• v.33 no.6
• /
• pp.1055-1065
• /
• 2023

Recently, various studies using deep reinforcement learning (deep RL) technology have been conducted to solve complex problems using big data collected at industrial internet of things. Deep RL uses reinforcement learning"s trial-and-error algorithms and cumulative compensation functions to generate and learn its own data and quickly explore neural network structures and parameter decisions. However, studies so far have shown that the larger the size of the learning data is, the higher are the memory usage and search time, and the lower is the accuracy. In this study, model-agnostic learning for efficient federated deep RL was utilized to solve privacy invasion by increasing robustness as 55.9% and achieve 97.8% accuracy, an improvement of 5.5% compared with the comparative optimization-based meta learning models, and to reduce the delay time by 28.9% on average.

• Current Optics and Photonics
• /
• v.7 no.6
• /
• pp.738-744
• /
• 2023

Graphene-based saturable absorbers (SAs) are widely used as laser mode-lockers at various laser oscillators. In particular, transmission-type graphene-SAs with ultrabroad spectral coverage are typically manufactured on transparent substrates with low nonlinearity to minimize the effects on the oscillators. Here, we developed two types of transmitting graphene SAs based on CaF₂ and ZnSe. Using the graphene-SA based on CaF₂, a passively mode-locked mid-infrared Cr:ZnS laser delivers relatively long 540 fs pulses with a maximum output power of up to 760 mW. In the negative net cavity dispersion regime, the pulse width was not reduced further by inhomogeneous group delay dispersion (GDD) compensation. In the same laser cavity, we replaced only the graphene-SA based on CaF₂ with the SA based on ZnSe. Due to the additional self-phase modulation effect induced by the ZnSe substrate with high nonlinearity, the stably mode-locked Cr:ZnS laser produced Fourier transform-limited ~130 fs near 2,340 nm. In the stable single-pulse operation regime, average output powers up to 635 mW at 234 MHz repetition rates were achieved. To our knowledge, this is the first attempt to achieve shorter pulse widths from a polycrystalline Cr:ZnS laser by utilizing the graphene deposited on the substrate with high nonlinearity.

• The Korean Journal of Air & Space Law and Policy
• /
• v.26 no.1
• /
• pp.147-176
• /
• 2011

China is experiencing rapid economic development and the volume of air passengers and cargo transportation has increased significantly in recent years. To the contray, the regulations on liability of air carrier in china fall behind and are not sufficiently applicable in disputes. Their lack of sufficient protection for air passenger's interests became obstructive factor for further developments of Chinese air transportation industry. The legal system of air carrier's liability mainly consists of the contents as followed. The liability period, the scope of liability, amount of compensation for damage, limitation of liability, liability exemption of air carrier, jurisdiction, limitation of action, applicable law etc. Laws and rules concerning these issues are regulated in Civil Aviation Law and regulations published by Civil Aviation Administration of China. This article described the main contents of air carrier's liability and examined the legislative problems in their applications in real cases. In order to solve the legal problems on the air carrier's liability and disputes between wrongdoers and survivors etc, it is necessary and desirable for china to amend revelvant provisions. One of my proposals is to raise the amount of compensation limitation for damage. And I also would like to suggest that Civil Aviation Law should treat international and domestic transportation equally on the limitation of compensation for air carrier's liability. China has also acceded to the Montreal Convention of 1999 on July 31, 2005. This is an effort to make the law of air carriage unified worldwide through various international conventions to achieve conformity between rules of international air carriage and that of Chinese domestic aircarriage. Furthermore, there should be additional detailed implementation rules for air carrier to assume liability for the losses to passengers, baggage or cargoes caused by delays in the air transport. Significant clarifications are also needed for provisions concerning whether and how air carrier assume liability for moral damage caused by accident.