• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.44 no.11
• /
• pp.109-118
• /
• 2007

As the integration density and the operating speed of System on Chips (SoCs) become increasingly high, it is crucial to test delay defects on the SoCs. This paper introduces an enhanced IEEE 1500 wrapper cell architecture and IEEE 1149.1 TAP controller for the wrapper interface logic, and proposes a transition delay fault test method. The method proposed can detect slow-to-rise and slow-to-fall faults sequentially with low area overhead and short test time. and simultaneously test IEEE 1500 wrapped cores operating at different core clocks.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.37 no.6
• /
• pp.72-84
• /
• 2000

The test patterns for path delay faults consist of two patterns. So in order to test the delay faults, a new weight generation algorithm that is different from the weight generation algorithm for stuck-at faults must be applied. When deterministic test patterns for weight calculation are used, the deterministic test patterns must be divided into several subsets, so that Hamming distances between patterns are not too long. But this method makes the number of weight sets too large in delay testing, and may generate inaccurate weights. In this pater, we perform fault simulation without pattern partition. Experimental results for ISCAS 89 benchmark circuits prove the effectiveness of the new weight generation algorithm proposed in this paper.

• Proceedings of the Korean Society Of Semiconductor Equipment Technology
• /
• 2002.11a
• /
• pp.130-136
• /
• 2002

Device makers want to make higher density chips as devices shrink, especially WSix poly stack down is one of the key issues. However, EPD (End Point Detection) time delay was happened in DPS+ poly chamber which is a barrier to achieve device shrink because EPD time delay killed test pattern and next generation device. To investigate the EPD time delay, a test was done with patterned wafers. This experimental was carried out combined with OES(Optical Emission Spectroscopy) and SEM (Scanning Electron Microscopy). OES was used to find corrected wavelength in WSix stack down gate etching. SEM was used to confirm WSix gate profile and gate oxide damage. Through the experiment, a new wavelength (252nm) line of plasma is selected for DPS+ chamber to call correct EPD in WSix stack down gate etching for current device and next generation device.

• ETRI Journal
• /
• v.36 no.2
• /
• pp.188-196
• /
• 2014

This paper describes a simple delay diversity technique for terrestrial digital multimedia broadcasting (T-DMB) and digital audio broadcasting in a single-frequency network (SFN). For the diversity technique, a delay diversity scheme is adopted. In the delay diversity scheme, a non-delayed signal is transmitted in the first antenna, and delayed versions of the signal are transmitted in each additional antenna. For an SFN environment with multiple transmitters, delay diversity can be executed by controlling the emission times of the transmitters. This SFN delay diversity scheme does not require any hardware changes in either the transmitter or receiver, and perfect backward compatibility can be acquired. To evaluate the performance improvement, laboratory tests are executed with various types of commercial T-DMB receivers as well as a measurement receiver. The improvement in the bit error rate performance is evaluated using a measurement receiver, and an improvement of the threshold of visibility value is evaluated for commercial receivers. Test results show that the T-DMB system can obtain diversity gain using the described technique.

• Korean Journal of Human Ecology
• /
• v.14 no.5
• /
• pp.737-747
• /
• 2005

The purpose of this study was to identify the impact of preschoolers' cognitive ability, parenting behavior, and attachment to their mothers and teachers on delay of gratification of preschoolers. The participants of this study were 116 mothers and their 15 teachers of 3-6 year olds from 2 day-care centers in Seoul. T-test, F-test, Correlation analysis, multiple regression analysis were used for data analysis. First, the result of this study showed that preschoolers' delay of gratification by cognitive ability was significant to only motor intelligence. Second, preschoolers' delay of gratification showed positive correlation with warm-acceptance of parenting. Third, preschoolers' delay of gratification by attachment to their mothers was statistically significant, but it was not significant to their teachers. Fourth, the effect of preschoolers' intelligence, parenting behavior, and attachment to their mothers and teachers on delay of gratification was statistically significant to mothers' warm-acceptance($\beta$=.24, p<.05) and was negatively significant to mothers' permissiveness(.$\beta$=-.35, p<.001).

• Journal of Advanced Navigation Technology
• /
• v.23 no.5
• /
• pp.386-391
• /
• 2019

This paper presents analysis results for the effect of the directional group delay of the antenna to implement a precision radio navigation system. The analysis was conducted through antenna simulation and test, and the test was performed in an anechoic chamber. The directional group delay of the antenna was calculated in phase-based analysis method. The results showed that a variation of up to 7.7ns in group delay occurred per antenna direction. The group delay variation from the analysis is 2.31 meters when converted into distance. It was tested using a real radio navigation system based on the time of arrival (TOA). The test verified the distance variation of 2.1 meters, and this value is similar to those obtained from the simulation and chamber test analysis.

• Proceedings of the KIEE Conference
• /
• 2003.11c
• /
• pp.727-730
• /
• 2003

Electric pulp test is a method to examine the vitality of dental pulp using the electrical stimulation. During the pulp test, the current stimulates intradental nerve, and makes patients painful. Some studies were accomplished to measure the responses of subjects by stimulating over the sensory threshold. In this study, we examined the time delay between pain feeling and stimulation stop in clinical situation. And we measured the activated responses(EMG in anterior belly of digastric muscle, voice, and finger span). As a result, it was verified that the minimum and maximum delay was EMG and voice, respectively. By reducing the excessive stimulus time, the unnecessary pain can be minimized using EMG that has the minimum delay.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.22 no.6
• /
• pp.577-583
• /
• 2011

Radar performance test is one of the major steps for radar system design. However, it is restricted by time and cost when radar performance tests are performed with opportunity targets. So various simulated target generators are developed and used to evaluate radar performance. To simulate the target's range, most of simulated target generators are developed with optical line or DRFM(Digital RF Memory) technique but there are many restrictions such as limit of range imitation and test scenario because of their original usage. In this paper, DDL(Digital Delay Line) module for development of simulated target generator is designed with precise range simulation and easily embodiment feature. And pulse recognition and delay gap detection technique are used to simulate the time delay without distortions. Developed DDL module performances are verified through their performance tests and test results are described in this paper.

• The Journal of Korean Physical Therapy
• /
• v.27 no.4
• /
• pp.183-189
• /
• 2015

Purpose: The aim of this study was to examine the test-retest and inter-rater reliability of the pediatric functional muscle testing (PFMT) when applied to children with developmental delay. Methods: Sixteen children with developmental delay (seven females, nine males) participated in this study. For the inter-rater reliability, each was scored on the PMFT by two pediatric physical therapists with more than 8 years of clinical experience on the same day. For assessment of the test-retest reliability, one therapist tested the children again within 10 days. The second measurement was performed by taking a first measurement in video. Intraclass correlation coefficient (ICC) was calculated to determine the test-retest and inter-rater reliability of the PFMT, and Chronbach's alpha was used to measure internal consistency. Results: The results of this study were as follows: 1) The test-retest ICC of the score of the infant action month and the right side of the PFMT was from 0.53 to 1.00 and from 0.63 to 0.99, respectively. 2) The inter-rater ICC of the score of the infant action month and the right side of the PFMT was from 0.66 to 1.00 and from 0.64 to 1.00, respectively. 3) Chronbach's alpha was 0.93. The internal consistency indicated excellent. Conclusion: In conclusion, this study showed that the test-retest and inter-rater reliability of the PFMT was relatively high, except for a few items. Therefore, it can be suggested that the PFMT will be a useful tool for measurement of muscle strength for children with developmental delay if it be some modifications.

• International conference on construction engineering and project management
• /
• 2011.02a
• /
• pp.614-620
• /
• 2011

Delays in completing construction projects have significant financial and social impact to all parties involved in the construction process and in particular in developing countries. This is very evident in most construction projects in Libya and in both public and private sectors. The research study was initiated by Libyan Government and the main aim of the project is to develop a new strategy in reducing the impact of delay factors. In order to achieve this, a number of objectives have been set-to conduct a comprehensive literature survey, to conduct a comparative study of the delay factors in project completion in both Libya and UK using semi structured questionnaire and finally, to identify and analyse the causes of delay and ranked them using frequency of occurrence and severity. The critical causes of delay for construction projects were quite different between Libya and UK. For the former, the most critical causes of delay in Libyan construction industry were low skills of manpower, changes in the scope of the project, slowness in giving instruction and poor qualification of consultant, while for the latter they were financial problems, bad weather conditions on the job site and change in the scope of project. Statistical experiments including Paired Samples T-Test, was run to test the significance of the survey data in both countries Libya and UK. The statistical results confirmed the collected data from the survey were significant.