• Journal of Korean Society on Water Environment
• /
• v.25 no.2
• /
• pp.288-294
• /
• 2009

Flow field-flow fractionation (Fl-FFF) device has been widely used to verify the size and molecular weight of various colloids and organics. The Fl-FFF, however, generally uses carrier solutions with only low to moderate ionic strengths to exclude the high affinity of materials to the membrane under high ionic strength conditions. Thus, materials existing in seawaters have not been accurately analysed based on the hydrodynamic size and molecular weight using current Fl-FFF techniques. The highest ionic strength tested was up to 0.1 M, while seawater ionic strength is about 0.6 M. The aim of this study is to accurately measure the hydrodynamic size of particles under carrier solutions close to seawater conditions with the Fl-FFF. By employing various operating conditions during the Fl-FFF analyses, it was demonstrated that the flow conditions, the concentration of surfactants, and stabilization times were key factors in acquiring compatible data. Results have shown that the cross flow was more influential factor than the channel flow. The concentration of the surfactant was to be at least 0.05% and the minimum 15 hr of stabilization was needed for accurate and reproducible data acquisition under seawater condition.

• Transactions of the KSME C: Technology and Education
• /
• v.3 no.4
• /
• pp.291-297
• /
• 2015

As promising future energy source, hydrogen has been drawing much attention; however, it is easily leaked from the small gap in any storage container due to its find molecule size. In this study, Laser induced breakdown spectroscopy(LIBS) was used for hydrogen leak detection, and feasibility of the scheme was evaluated based on different way for plasma generation. Laser power of 295 mW was required for generating plasma on metal surface to measure hydrogen atomic emission while approximately 2.5 times higher laser power was needed for plasma formation directly in the hydrogen gas stream. It was shown that peak to base ratio increased linearly with increasing the concentration of hydrogen. It can be concluded that LIBS is a viable technique for hydrogen sensing when the concentration of hydrogen is less than 5%.

• Journal of Energy Engineering
• /
• v.25 no.1
• /
• pp.145-152
• /
• 2016

Recently, we can find news about toxic and combustible gas accident. So, we have to develop gas detector that can measure gas at dangerous area for preventing gas accidents. In this paper, we calculate a approximation function from sensor's output using the linear regressiong. And we develop software algorithm using Neville's algorithm for measuring gas concentration. Finally, we compare our algorithm with combustible gas detectors that are already developed, by using standard gas samples manufactured Korea Gas Safety. As a result of this experiment, we confirm that performance of our algorithm is more improved than performance of already developed combustible gas detectors. In the future, we'll research how to improve reliability from using count, temperature and humidity. And we'll design hardware applied explosion proof for safety.

• Journal of dental hygiene science
• /
• v.11 no.4
• /
• pp.375-380
• /
• 2011

This study evaluated whether fluoride treatment can affect recovery of the irregularity of enamel surface after tooth whitening with a high concentration of hydrogen peroxide (HP) activated by plasma arc light. A total of 36 bovine teeth stained with coke were used in this experiment. The specimens were classified into following three groups (two different commercial plasma arc groups and a control group without light curing source): (1) 35% HP gel only, (2): 35% HP gel and Plasma arc A, and (3) 35% HP gel and Plasma arc B. To measure color changes and surface morphologies before and after the bleaching, colorimeter and scanning electron microscopy were used, respectively. When the specimens were bleached with hydrogen peroxide and plasma arc lights, the bleaching effect was greater than when only hydrogen peroxide gels were used (Kruskal-Wallis test, p<0.05). In addition, plasma arc B showed the more color changes than plasma arc A (Bonferroni post-hoc test, p<0.05). The surfaces of the teeth treated with fluoride gel after the whitening treatment came to be smooth. Therefore, the results of this study suggested that the fluoride application for patients who got tooth whitening therapy with a high concentration of hydrogen peroxide gels activated by plasma arc light will be effective to recover rough enamel surfaces.

• The Journal of the Acoustical Society of Korea
• /
• v.33 no.1
• /
• pp.21-30
• /
• 2014

The temperature change due to focused ultrasound in dissipative acoustic medium is very important because it provides us much information. To measure the temperature change inside of the dissipative acoustic medium non-invasively, we adopt a temperature sensitive film which has thermochromic particles with critical temperature of $30^{\circ}C$. As a dissipative acoustic medium, agar layer is chosen in the study. The temperature change due to the ultrasound was measured depending on the concentration of the sugar in the agar layer. The color change on the film due to the ultrasound was investigated when the concentration of sugar was from 25% to 40%. As the result, there were rapid increases of discolored area on the film within 2~5 second after the ultrasound driving and the increasing rates decreased after the period. To compare the simulation results were also shown. However in the simulated result, the discolored areas linearly increased from start to 10 seconds. The reason of the differences between the experimental results and simulated ones is that the change of thermal conductivity and heat capacity of the medium were not considered in the simulation program.

• Asian-Australasian Journal of Animal Sciences
• /
• v.22 no.1
• /
• pp.42-48
• /
• 2009

An in vitro incubation study was conducted to investigate effects of 2-bromoethanesulfonic acid (BES) on ruminal fermentation characteristics and methanogen population. BES at the final concentration of 0, 1 and 5 mM with two different substrates having a different ratio of timothy and concentrate (100% timothy vs. 40% timothy-60% concentrate) was incubated for 0, 24, 48 and 72 h in a $39^{\circ}C$ incubator. Total DNA extracted from culture fluid was used as a template for real-time PCR to measure the population of methanogens. Four different primer sets were used for amplification of total bacteria, total methanogens, the order Methanobacteriales and the order Methanomicrobiales. BES reduced (p<0.01) total gas and methane production in a dose-dependent manner. BES at 5 mM inhibited methane production by more than 95% compared to the control. An interaction between substrate and level of BES in total gas and methane was detected (p<0.01). The decrease of methane production with increasing BES level was more pronounced on mixed substrate than on timothy alone. However, hydrogen production was increased by BES treatment (p<0.01). Total VFA concentration was not affected, but molar percentage of propionate and butyrate was increased and acetate to propionate ratio was reduced by BES treatment (p<0.01). BES did not affect the population density of total bacteria but reduced (p<0.01) the population of total methanogens, the order Methanobacteriales and the order Methanomicrobiales in a dose-dependent manner. The type of substrate did not influence the trend, although the magnitude of response was different between all-roughage and 40% roughage substrate.

• Journal of Digital Convergence
• /
• v.18 no.6
• /
• pp.33-44
• /
• 2020

The main objective of this study is to measure the concentration and deconcentration of the domestic freight forwarding system which illustrate the development trends in this industry. In this study, Herfindal-Hirschman index (HHI), shift-share analysis (SSA), and GINI coefficient combined with Lorenz curves were employed to investigate the domestic freight forwarders. The results are as follows: first, the HHI was used to assess the concentration of domestic freight forwarders in Vietnam. The downward trend from 0.117 in 2008 to 0.083 in 2018 indicate the deconcentration of domestic freight forwarders in Vietnam. Second, the SSA results indicated that the company Transimex showed the best performance with a shift effect of million VND 1,906,515 and a ABSGR value of million VND 2,158,232. Third, the GINI index go down from 0.468 to 0.393 in 2008-2018 as follow and the Lorenz curves covered a large part which make more demonstrate the deconcentration trend of freight forwarding in Vietnam. The results show that deconcentration is a trend in 2008-2018. The results of this study provides relevant data on freight forwarders which are not easily accessible to related stakeholders.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.67 no.3
• /
• pp.413-418
• /
• 2018

In this paper, we describe the development of a non-enzymatic glucose sensor based on copper nanocubes(Cu NCs) electroplated laser induced graphene(LIG) electrodes which can detect a certain range of glucose concentrations. $CO_2$ laser equipment was used to form LIG electrodes on the PI film. This fabrication method allows easy control of the LIG electrode size and shape. The Cu NCs were electrochemically deposited on the LIG electrodes to improve electron transfer rates and thus enhancing electrocatalytic reaction with glucose. The average sheet resistances before and after electroplating were $15.6{\Omega}/{\Box}$ and $19.6{\Omega}/{\Box}$, respectively, which confirmed that copper nanocubes were formed on the laser induced graphene electrodes. The prepared electrode was used to measure the current according to glucose concentration using an electrochemical method. The LIG electrodes with Cu NCs demonstrated a high degree of sensitivity ($1643.31{\mu}A/mM{\cdot}cm^2$), good stability with a linear response to glucose ranging from 0.05 mM to 1 mM concentration, and a limit of detection of 0.05 mM. In order to verify that these electrodes can be used as flexible devices, the electrodes were bent to $30^{\circ}$, $90^{\circ}$, and $180^{\circ}$ and cyclic voltammetry measurements were taken while the electrodes were bent. The measured data showed that the peak voltage was almost constant at 0.42 V and the signal was stable even in the flexed condition. Therefore, it is concluded that these electrodes can be used in flexible sensors for detecting glucose in the physiological sample like saliva, tear or sweat.

• Journal of Environmental Health Sciences
• /
• v.42 no.2
• /
• pp.118-125
• /
• 2016

Objectives: The traditional type of residence in used in Mongolia, called a ger, is an important residential form and applies coal combustion for cooking and heating. The combustion of coal in ger is the major source of indoor air pollution. The purposes of this study were to measure indoor air pollution in ger and determine the effect of cooking and heating activities. Methods: Indoor temperature, relative humidity, particulate matter less than $2.5{\mu}m$ ($PM_{2.5}$) and black carbon (BC) were continuously measured for 24 hours in eight ger. The measurements were conducted in January or February 2015. Heavy metals in $PM_{2.5}$ filter samples were analyzed by ICP-MS. Results: Average indoor temperature and relative humidity were $19.6{\pm}4.6^{\circ}C$ and $21.4{\pm}5.2%$, respectively. The average indoor $PM_{2.5}$ concentration in the eight ger was $119.8{\mu}g/m^3$ and ranged from 69.4 to $202.7{\mu}g/m^3$. The peak concentrations of $PM_{2.5}$ and BC during cooking and heating periods were several times higher than the 24- hour average concentration. Conclusion: The major contributor to indoor $PM_{2.5}$ and BC concentrations in the ger was coal combustion for cooking and heating.

• Journal of Digital Convergence
• /
• v.13 no.12
• /
• pp.433-440
• /
• 2015

This study was conducted to examine mediative effects of two factors, emotion control and thinking control, in the relationship between avoid fusion and attention. Participants (308 high school students) were asked to complete a questionnaire which contains items to measure some psychological properties such as emotion control (EC), thinking control (TC), avoidance avoid fusion (CF), conceration(Co) and learning attitude(LA). Structural equation model analysis showed that 8 of modified 9 paths were statistically significant; CF to Co and TC, TC to EC, Co, and LA, EC to Co and LA, and Co to LA. Limitations and suggestions were mentioned in the discussion.