• Journal of information and communication convergence engineering
• /
• v.7 no.3
• /
• pp.361-365
• /
• 2009

This paper has been presented the transport characteristics of FinFET using the analytical potential model based on the Poisson's equation in subthreshold and threshold region. The threshold voltage is the most important factor of device design since threshold voltage decides ON/OFF of transistor. We have investigated the variations of threshold voltage and drain induced barrier lowing according to the variation of geometry such as the length, width and thickness of channel. The analytical potential model derived from the three dimensional Poisson's equation has been used since the channel electrostatics under threshold and subthreshold region is governed by the Poisson's equation. The appropriate boundary conditions for source/drain and gates has been also used to solve analytically the three dimensional Poisson's equation. Since the model is validated by comparing with the three dimensional numerical simulation, the subthreshold current is derived from this potential model. The threshold voltage is obtained from calculating the front gate bias when the drain current is $10^{-6}A$.

• The Transactions of the Korean Institute of Electrical Engineers B
• /
• v.49 no.12
• /
• pp.789-796
• /
• 2000

This paper deals with magnetic field and characteristic analysis for ring type slotless synchronous motors by using analytical method. Since magnetic air-gap in the slotless motors is much larger than mechanical air-gap, it is necessary to analyze the magnetic flux distribution at the whole magnetic airgap region. therefore, this paper analyzes the duplicated magnetic field derived by both Permanent Magnet(PM) and armature current and estimates the back electromotive force and torque characteristic by subdividing the conductor region. The analysis results are verified by comparing with Finite Element Analysis(FEA) results.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.29 no.6
• /
• pp.862-875
• /
• 1996

The CTD data observed in the sea northwest of Cheju Island have been analyzed to figure out the seasonal circulation around Cheju Island. Warm and saline waters flow into the Yellow Sea through the middle region of the Yellow Sea in winter and along the west coast of Korean Peninsula in summer. On the other hand, cold and less saline waters flow out of the Yellow Sea through the middle region in summer and along the west coast of Korean Peninsula in winter. These flows make the seasonal circulation around Cheju Island. As dynamics, the monsoon wind and the variation of Kuroshio transport have been suggested. Comparing the observational result, the circulation driven by the variation of Kuroshio transport is strengthened by monsoon winds in the numerical model.

• The Journal of the Korea Contents Association
• /
• v.15 no.6
• /
• pp.539-546
• /
• 2015

In this study, we develop numerical model using the elliptic mild-slope equation for waves propagating around axis-symmetric topographies where the water depth varies arbitrarily having zero at the coastline. The entire region is divided into three regions. In the both of inner and outer regions, an existing analytical solutions are used. In the middle region, the finite element technique is applied to the governing equation. To get the solution, the methods of separation of variables, Frobenius series are used. Developed solution is validated by comparing with previously developed analytical solution. We also investigate various cases with different bottom topographies.

• Journal of Power System Engineering
• /
• v.20 no.2
• /
• pp.5-16
• /
• 2016

Generally, methods using transfer techniques, like the transfer matrix method and the transfer stiffness coefficient method, find natural frequencies using the sign change of frequency determinants in searching frequency region. However, these methods may omit some natural frequencies when the initial frequency interval is large. The Sylvester-transfer stiffness coefficient method ("S-TSCM") can always obtain all natural frequencies in the searching frequency region even though the initial frequency interval is large. Because the S-TSCM obtain natural frequencies using the number of natural frequencies existing under a searching frequency. In this paper, the algorithm for the free vibration analysis of axisymmetric conical shells was formulated with S-TSCM. The effectiveness of S-TSCM was verified by comparing numerical results of S-TSCM with those of other methods when analyzing free vibration in two computational models: a truncated conical shell and a complete (not truncated) conical shell.

• Journal of Welding and Joining
• /
• v.16 no.2
• /
• pp.48-56
• /
• 1998

This study was performed to find the best bonding conditions by comparing mechanical properties in thermoplastic resin of polyethylene (PE) and polyamide (PA) adhesion. Following results were obtained from the tests with varying welding time and welding pressure. Satisfactory adhesion was executed in ultrasonic welding for the same materials of PE and PA. The best welding conditions were found to be welding time of 1 second, welding pressure of 250kPa for PE-PE weding, 2 second and 350kPa for PA-PA welding. Welding time and welding pressure end to increase with the increase of materials strength. Dissimilar materials were adhered when adhesion and ultrasonc welding were performed simultaneously. The observation of the structure of ultrasonic welding area with microscope showed differenticated structures between well adhered region and badly adhered region.

• The Transactions of the Korean Institute of Electrical Engineers
• /
• v.38 no.6
• /
• pp.401-415
• /
• 1989

A simple but accurate analytical model for the lateral channel electric field in gate-offset structured Lightly Doped Drain MOSFET has been developed. Our model assumes Gaussian doping profile, rather than simple uniform doping, for the lightly doped region and our model can be applied to LDD structures where the junction depth of LDD is not identical to the heavily doped drain. The validity of our model has been proved by comparing our analytical results with two dimensional device simulations. Due to its simplicity, our model gives a better understanding of the mechanisms involved in reducing the electric field in the LDD MOSFET. The model shows clearly the dependencies of the lateral channel electric field on the drain and gate bias conditions and process, design parameters. Advantages of our analytical model over costly 2-D device simulations is to identify the effects of various parameters, such as oxide thickness, junction depth, gate/drain bias, the length and doping concentration of the lightly doped region, on the peak electric field that causes hot-electron pohenomena, individually. Our model can also find the optimum doping concentration of LDD which minimizes the peak electric field and hot-electron effects.

• Proceedings of the KSRS Conference
• /
• 2003.11a
• /
• pp.1039-1041
• /
• 2003

Ocean color products derived from remote sensing satellite data are useful for monitoring the sea water quality such as the concentrations of chlorophyll, sediments and dissolved organic matter. Currently, ocean color products derived from MODIS data can be requested from NASA over the internet. However, due to the bandwidth limitation of most users in this region, and the time delay in data delivery, the products cannot be use for near-real time monitoring of sea water chlorophyll. CRISP operates a MODIS data receiving station for environmental monitoring purposes. MODIS data have been routinely received and processed to level 1B. We have adapted the higher level processing algorithms from the Institutional Algorithms provided by NASA to run in a standalone environment. The implemented algorithms include the MODIS ocean color algorithms. Seasonal chlorophyll concentration composite can be compiled for the region. By comparing the near-real time chlorophyll product with the seasonal composite, anomaly in chlorophyll concentration can be detected.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.11 no.5
• /
• pp.347-352
• /
• 1998

In this paper, the extraction and optimization of SPICE parameters on SONOSFET for NVSM circuit design were discussed. SONOSFET devices with different channel widths and lengths were fabricated using conventional 1.2 um n-well CMOS process. And, electric properties for dc parameters and capacitance parameters were measured on wafer. SPICE parameters for the SONOSFET were extracted from the UC Berkeley level 3 model for the MOSFET. And, local optimization of Ids-Vgs curves has carried out in the bias region of subthreshold, linear, saturation respectively. Finally, the extracted SPICE parameters were optimized globally by comparing drain current (Ids), output conductance(gds), transconductance(gm) curves with theoretical curves in whole region of bias conditions. It is shown that the conventional model for the MOSFET can be applied to the SONOSFET modeling except sidewalk effect.

• Proceedings of the KIEE Conference
• /
• 2005.07b
• /
• pp.987-989
• /
• 2005

Axi-periodic analysis using magnetic vector potential is formulated in time harmonic field and applied to the field analysis for the end region of large turbo generator in this paper. By using axi-periodic analysis, the effect of flux shield, one of the structure placed in the end region of large turbo generator to prevent stator end from thermal damage, is studied, and eddy current loss in the flux shield is estimated for operation conditions. 3D FEA is used for the verification of presented analysis method. Because 3D flux distribution can be calculated with 2D modeling, magnetic field showing 3D distribution can be effectively calculated by axi-periodic analysis comparing with 3D FEA.