• Journal of the Korean Chemical Society
• /
• v.34 no.6
• /
• pp.622-628
• /
• 1990

The bio-sensor for glutamine has been constructed by immobilizing petal of the rose structural elements on an ammonia gas sensor. This sensor was investigated for the effects of pH, temperature, buffer solution, tissular amounts, interferences and lifetime. As a result, the tissue sensor showed linear range of $8.0 {\times} 10^{-4}$ ∼$5.0 {\times} 10^{-2}$ M glutamine with a slope of 52 mV/decade in pH 7.8, 0.2M phosphate beffer solution at 37$^{\circ}C$. The tissular amounts used for this sensor was 50 mg. This sensorr showed excellent selectivity. This sensor was compared with other structural elements of rose. Actually, this tissue sensor appeared to be very useful for the determination of glutamine.

• Transactions on Electrical and Electronic Materials
• /
• v.12 no.4
• /
• pp.169-173
• /
• 2011

In this study, Al-N codoped p-type zinc oxide (ZnO) thin films were deposited on Si and homo-buffer layer templates in a mixture of $N_2$ and $O_2$ gas with ceramic ZnO:(2 wt% $Al_2O_3$) as a sputtering target using DC- magnetron sputtering. X-ray diffraction spectra of two-theta diffraction showed that all films have a predominant (002) peak of ZnO Wurtzite structure. As the $N_2$ fraction in the mixed $N_2$ and $O_2$ gases increased, field emission secondary electron microscopy revealed that the surface appearance of codoped films on Si varied from smooth to textured structure. The p-type ZnO thin films showed carrier concentration in the range of $1.5{\times}10^{15}-2.93{\times}10^{17}\;cm^{-3}$, resistivity in the range of 131.2-2.864 ${\Omega}cm$, and mobility in the range of $3.99-31.6\;cm^2V^{-1}s^{-1}$ respectively.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.18 no.6
• /
• pp.213-219
• /
• 2004

This paper describes the developmnet of a web-based boiler controller which can be in parallel operated with an existing boiler controller. The web-based boiler controller mainly consists of RTL8019AS NIC and TS80C32 microcontroller. In order to communicate over the Internet, we need to develop network driver, IP, TCP, UDP, ICMP, and HTTP. For a specific application like web-boiler controller, we have proposed a common global data buffer algorithm to minimize the RAM memory usage. Finally, the correctness and performance of the protocols are tested and verified using CommView and Dummynet. The development is satisfactorily operated only for few hundreds of bytes of RAM usage without sacrificing interoperability between hosts.

• Journal of Information Processing Systems
• /
• v.1 no.1 s.1
• /
• pp.36-40
• /
• 2005

TRISO (Tri-Isotropic)-coated fuel particle is widely applied due to its higher stability at high temperature and its efficient retention capability for fission products in the HTGR (high temperature gas-cooled reactor), one of the highly efficient Generation IV reactors. The typical ball-type TRISO-coated fuel particle with a diameter of about 1 mm is composed of a nuclear fuel particle as a kernel and of outer coating layers. The coating layers consist of a buffer PyC, inner PyC, SiC, and outer PyC layer. In this study, a digital image processing algorithm is proposed to automatically measure the thickness of the coating layers. An FBP (filtered backprojection) algorithm was applied to reconstruct the CT image using virtual X-ray radiographic images for a simulated TRISO-coated fuel particle. The automatic measurement algorithm was developed to measure the coating thickness for the reconstructed image with noises. The boundary lines were automatically detected, then the coating thickness was circularly by the algorithm. The simulation result showed that the measurement error rate was less than 1.4%.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2007.06a
• /
• pp.503-504
• /
• 2007

$Bi_2Sr_2Ca_{n-1}Cu_nO_x$(n=0, 1, 2)superconducting thin films have been fabricated by atomic layer-by-layer deposition at an ultra low growth rate using IBS(Ion Beam Sputtering) method. During the deposition, 90 mol% ozone gas of typical pressure of $1{\sim}9{\times}10^{-5}$ Torr are supplied with ultraviolet light irradiation for oxidation. XRD and RHEED investigations reveal out that a buffer layer with some different compositions is formed at the early deposition stage of less than 10 units cell and then Bi-2201 oriented along the c-axis is grown.

• Korean Journal of Optics and Photonics
• /
• v.3 no.3
• /
• pp.178-182
• /
• 1992

An air-cooled discharge-heated copper-vapor laser system with its inter-electrode distance of 45 cm has been developed by utilizing an alumina ceramic plasma tube of 1.6 cm in diameter and 50 cm in lengih. For operating the laser, a dc high voltage power supply with output rating of 6 kV and 500 mA, a resonant charging circuitry consisting partly of an 1.8 H inductor assembly and a 5 nF storage capacitor, and a thyratron driver operating up to 7 kHz have also been developed. The present laser system starts lasing at the tube temperature of about $1350^{\circ}C$ and an maximum average output power of 0.7 W has been obtained at 12 kV, 4.5 kHz. 50 mbar of Ne buffer gas pressure, and at the tube temperature of $1460^{\circ}C$.

• Korean Journal of Optics and Photonics
• /
• v.29 no.6
• /
• pp.247-252
• /
• 2018

We report amplification of a small signal in a diode-pumped Cs vapor cell with 500 torr of ethane buffer gas, in the low-pump-power regime of 200 mW or less. For efficient amplifier operation, the pump and signal beams were coupled to a single-mode optical fiber, and completely overlapped in the Cs vapor cell. We investigated the amplification of the small signal according to cell temperature, signal power, and pump power. An amplification factor of 56 was achieved under the conditions of cell temperature of $115^{\circ}C$, signal power of 0.1 mW, and pump power of 200 mW.

• KOREAN JOURNAL OF PACKAGING SCIENCE & TECHNOLOGY
• /
• v.27 no.1
• /
• pp.35-40
• /
• 2021

Calcium hydroxide (CH) reacts with CO2 to produce moisture, and sodium carbonate (SC) reacts with CO2 in the presence of moisture. Using these different characteristics of these two reactants, a CH/SC mixture of CO2 absorber tuned for kimchi ripening to produce CO2 in a flexible package was selected. A ratio of CH:SC (1:2) in highly gas permeable microporous spunbonded film (Tyvek) sachet was found to be appropriate for delayed and consistent CO2 absorption useful for kimchi package. Addition of superabsorbent polymer (SAP) as moisture buffer was helpful for boosting the consistency of CO2 absorption. In a package of 0.5 kg kimchi at 10℃, the sachet consisting of 0.794 g of CH + 2.276 g of SC + 0.4 g of SAP suppressed its volume expansion and maintained a suitable range of CO2 partial pressure (PCO2) steadily inside. These optimal conditions may vary depending on the type and salinity of kimchi, storage and distribution temperature, and the material and area of the absorber sachet. This study showed a potential of mixture CO2 absorber to be tuned for CO2 producing packaged kimchi for the purpose of keeping consistent PCO2 at tolerable volume expansion.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.19 no.4
• /
• pp.469-477
• /
• 2021

Safe storage of spent nuclear fuel in deep underground repositories necessitates an understanding of the long-term alteration of metal canisters and buffer materials. A small-scale laboratory alteration test was performed on metal (Cu or Fe) chips embedded in compacted bentonite blocks placed in anaerobic water for 1 year. Lactate, sulfate, and bacteria were separately added to the water to promote biochemical reactions in the system. The bentonite blocks immersed in the water were dismantled after 1 year, showing that their alteration was insignificant. However, the Cu chip exhibited some microscopic etch pits on its surface, wherein a slight sulfur component was detected. Overall, the Fe chip was more corroded than the Cu chip under the same conditions. The secondary phase of the Fe chip was locally found as carbonate materials, such as siderite (FeCO₃) and calcite ((Ca, Fe)CO₃). These secondary products can imply that the local carbonate occurrence on the Fe chip may be initiated and developed by an evolution (alteration) of bentonite and a diffusive provision of biogenic CO₂ gas. These laboratory scale results suggest that the actual long-term alteration of metal canisters/bentonite blocks in the engineered barrier could be possible by microbial activities.

• The Korea Journal of Herbology
• /
• v.38 no.5
• /
• pp.39-47
• /
• 2023

Objectives : The objective of present study was to investigate the vasorelaxant effects of 20 Korean native plants on isolated rat thoracic aorta precontracted with phenylephrine (PE). Methods : Dried 20 plant materials were extracted 3 times with water, ethanol, or methanol for 3h in the reflux apparatus at 70 ± 5℃. Male SD rats were anesthetized by ether inhalation, and their aorta rings were isolated and placed in 10 ㎖ Krebs Henseleit (KH) buffer. While using an isolated organ-chamber technique, the aorta rings were maintained by bubbling with a gas mixture of 95% O₂-5% CO₂ at 37℃. Changes in isometric tension of aorta rings were recorded via isometric transducers connected to a Powerlab Data Acquisition System. Results : Among the 20 native plants, Chrysanthemum indicum L. flower, Nelumbo nucifera Gaertn. rhizome, Schisandra chinensis (Turcz.) Baill. fruit, Anthriscus sylvestris (L.) Hoffm. root, Corydalis turtschaninovii Besser tuber, Corydalis decumbens (Thunb.) Pers. tuber, and Dolichos lablab L. seed showed significant vasorelaxant effect on the contraction of aorta rings induced by PE. In contrast, Mertensia maritima subsp. asiatica Takeda whole plant, Ajuga decumbens Thunb. whole plant, Trigonotis peduncularis (Trevis.) Benth. ex Baker & S.Moore whole plant, Dioscorea quinquelobate Thunb. rhizome, Allium microdictyon Prokh aerial part, Momordica charantia L. fruit, Carthamus tinctorius L. flower, and Clematis terniflora DC. root constricted more the aorta rings precontracted by PE Conclusion : These results suggest that the possibility as useful herbal resources for the development of functional foods or medicines for hypertension treatment.