• Journal of the Semiconductor & Display Technology
• /
• v.15 no.4
• /
• pp.41-45
• /
• 2016

ITO/GZO double layered thin films were prepared on transparent glass substrates. Ga-doped ZnO(GZO) films were deposited by RF magnetron sputtering using an ZnO:Ga (98: 2 wt%) target. The post deposition annealing process was conducted for 30 minutes at different temperature of 100, 200, 300 and $400^{\circ}C$, respectively. As increase annealing temperature, ITO/GZO double layered thin films show the increment of the prefer orientation of ZnO diffraction peak (002) in the XRD patterns. We obtained Ga-doped ZnO thin films with a lowest resistivity of $1.84{\times}10^{-4}{\Omega}-cm$ at $400^{\circ}C$ and transparency above 80% in visible ranges. The figure of merit obtained in this study means that ITO/GZO double layered thin films which annealed at $400^{\circ}C$ have the highest optoelectrical performance in this study.

• Korean Journal of Materials Research
• /
• v.31 no.6
• /
• pp.320-324
• /
• 2021

Effects of growth variables and post-growth annealing on the optical, structural and electrical properties of magnetron-sputtered Ga_0.04Mg_0.10Zn_0.86O films are characterized in detail. It is observed that films grown from pure oxygen plasma showed high resistivity, ~10² Ω·cm, whereas films grown in Ar plasma showed much lower resistivity, 2.0 × 10^-2 ~ 1.0 × 10^-1 Ω·cm. Post-growth annealing significantly improved the electrical resistivity, to 4.3 ~ 9.0 × 10^-3 Ω·cm for the vacuum annealed samples and to 1.3 ~ 3.0 × 10^-3 Ω·cm for the films annealed in Zn vapor. It is proposed that these phenomena may be attributed to the improved crystalline quality and to changes in the defect chemistry. It is suggested that growth within oxygen environments leads to suppression of oxygen vacancy (Vo) donors and formation of Zn vacancy (V_Zn) acceptors, resulting in highly resistive films. After annealing treatment, the activation of Ga donors is enhanced, Vo donors are annihilated, and crystalline quality is improved, increasing the electron mobility and the concentration. After annealing in Zn vapor, Zn interstitial donors are introduced, further increasing the electron concentration.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.23 no.9
• /
• pp.685-690
• /
• 2010

ZnO with the wide band gap near 3.37 eV is typically an n-type semiconductor in which deviation from stoichiometry is electrically active. It was known that the films with a resistivity of the order of $10^{-4}{\Omega}cm$ is not easy to obtain. In order to improve electrical characteristic of ZnO, we added 1, 3, 5 wt% Ga element in ZnO. The Ga-doped ZnO (GZO) was grown on a glass substrate by radio frequency (RF) magnetron sputtering at the temperature range from 100 to $500^{\circ}C$. X-ray diffraction (XRD) patterns of GZO films showed preferable crystal orientation of (002) plane. The lowest resistivity of the GZO films was $8.9{\times}10^{-4}{\Omega}cm$. GZO films significantly influenced by the working temperature. The average transmittance of the films was over 80% in the visible ranges.

• Current Photovoltaic Research
• /
• v.5 no.4
• /
• pp.135-139
• /
• 2017

We fabricated two different transparent conducting oxide thin films of ZnO doped with Ga ($Ga_2O_3$ 0.9 wt%) as well as Al ($Al_2O_3$ 2.1 wt%) (GAZO) and ZnO doped only with Al ($Al_2O_3$ 3 wt%) (AZO). It was investigated how it affects the moisture resistance of the transparent electrode. In addition, $Cu(In,Ga)Se_2$ thin film solar cells with two transparent oxides as front electrodes were fabricated, and the correlation between humidity resistance of transparent electrodes and device performance of solar cells was examined. When both transparent electrodes were exposed to high temperature distilled water, they showed a rapid increase in sheet resistance and a decrease in the fill factor of the solar cell. However, AZO showed a drastic decrease in efficiency at the beginning of exposure, while GAZO showed that the deterioration of efficiency occurred over a long period of time and that the long term moisture resistance of GAZO was better.

• Proceedings of the Korean Institute of Surface Engineering Conference
• /
• 2013.05a
• /
• pp.162-163
• /
• 2013

Single-crystal InGaZnO (IGZO) thin films were spontaneously formed as periodic layered structure along the c-axis by thermal treatment at high temperature. when the IGZO superlattice were synthesized by sol-gel method, the effects of preferred growth orientations and the flatness of ZnO buffer layer were investigated. $InGaO_3(ZnO)_2$ superlattice were favorably formed on ZnO buffer layer with single preferred orientation. Futhermore, it showed relatively high Seebeck coefficient and power factor.

• Journal of Information Display
• /
• v.9 no.3
• /
• pp.8-11
• /
• 2008

A novel non-alkoxide sol-gel process for synthesizing Ga-doped ZnO thin film on glass was derived for possible use as a transparent electrode in flat-panel displays, using zinc acetate dehydrate as the starting material. The structural and electrical properties of thin films have been characterized as functions of Ga addition and post-heat-treatments. Their carrier density, Hall mobility, and optical transmittance were measured and discussed herein to explain the characteristics of the sol-gel-derived Ga-doped ZnO thin film on glass.

• Korean Journal of Materials Research
• /
• v.26 no.6
• /
• pp.347-352
• /
• 2016

ZnO with wurtzite structure has a wide band gap of 3.37 eV. Because ZnO has a direct band gap and a large exciton binding energy, it has higher optical efficiency and thermal stability than the GaN material of blue light emitting devices. To fabricate ZnO devices with optical and thermal advantages, n-type and p-type doping are needed. Many research groups have devoted themselves to fabricating stable p-type ZnO. In this study, $As^+$ ion was implanted using an ion implanter to fabricate p-type ZnO. After the ion implant, rapid thermal annealing (RTA) was conducted to activate the arsenic dopants. First, the structural and optical properties of the ZnO thin films were investigated for as-grown, as-implanted, and annealed ZnO using FE-SEM, XRD, and PL, respectively. Then, the structural, optical, and electrical properties of the ZnO thin films, depending on the As ion dose variation and the RTA temperatures, were analyzed using the same methods. In our experiment, p-type ZnO thin films with a hole concentration of $1.263{\times}10^{18}cm^{-3}$ were obtained when the dose of $5{\times}10^{14}$ As $ions/cm^2$ was implanted and the RTA was conducted at $850^{\circ}C$ for 1 min.

• Proceedings of the Materials Research Society of Korea Conference
• /
• 1999.05a
• /
• pp.111-111
• /
• 1999

• Proceedings of the Korea Committee for Ocean Resources and Engineering Conference
• /
• 2004.05a
• /
• pp.342-346
• /
• 2004

Recently there has been a great world-wide interest in developing and characterizing new nano-structured materials. These newly developed materials are often prepared in limited quantities and shapes unsuitable for the extensive mechanical testing. The development of depth sensing indentation methods have introduced the advantage of load and depth measurement during the indentation cycle. In the present work, ZnO thin films are prepared on the Glass, GaAs(100), Si(111), and Si(100) substrates at different temperatures by pulsed laser deposition(PLD) method. Because the potential energy in c-axis is law, the films always shaw c-axis orientation at the optimized conditions in spite of the different substrates. Thin films are investigated by X-ray diffractometer and Nano indentation equipment. From these measurements it is possible to get elastic modulus and hardness of ZnO thin films on all substrates.

• Journal of the Korean Vacuum Society
• /
• v.21 no.1
• /
• pp.17-21
• /
• 2012

Ga-doped ZnO (GZO) thin films for application as transparent conducting oxide film were deposited on the glass substrate by using rf-magnetron sputtering system. The effects of working pressure on electrical and optical characteristics of GZO films were investigated. Regardless of the working pressure, all films were oriented along with the c-axis, perpendicular to the substrate. The electrical resistivity was about $8.68{\times}10^{-3}{\Omega}{\cdot}cm\sim2.18{\times}10^{-3}{\Omega}{\cdot}cm$ and the average transmittance of all films including substrates was over 90% in the visible range. The good transparents and conducting properties were obtained due to controle the working pressure. The obtained results have acceptable for application as transparent conductive electrodes in LCDs and solar cells.