• Transactions on Electrical and Electronic Materials
• /
• v.10 no.1
• /
• pp.24-27
• /
• 2009

N-doped ZnO thin films were deposited on n-type Si(100) and homo-buffer layer, and undoped ZnO thin film was also deposited on homo-buffer layer by RF magnetron sputtering method. After deposition, all films were in-situ annealed at $800^{\circ}C$ for 5 minutes in ambient of $O_2$ with pressure of 10Torr. X -ray diffraction shows that the homo-buffer layer is beneficial to the crystalline of N-doped ZnO thin films and all films have preferable c-axis orientation. Atomic force microscopy shows that undoped ZnO thin film grown on homo-buffer layer has an evident improvement of smoothness compared with N-dope ZnO thin films. Hall-effect measurements show that all ZnO films annealed at $800^{\circ}C$ possess p-type conductivities. The undoped ZnO film has the highest carrier concentration of $1.145{\times}10^{17}cm{-3}$. The photoluminescence spectra show the emissions related to FE, DAP and many defects such as $V_{Zn}$, $Zn_O$, $O_i$ and $O_{Zn}$. The p-type defects ($O_i$, $V_{Zn}$, and $O_{Zn}$) are dominant. The undoped ZnO thin film has a better p-type conductivity compared with N-doped ZnO thin film.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2012.02a
• /
• pp.310-310
• /
• 2012

ZnO thin films were grown on porous silicon (PS) by plasma-assisted molecular beam epitaxy (PA-MBE). The optical properties of the ZnO thin films grown on PS were studied using room-temperature, low-temperature, and temperature-dependent photoluminescence (PL). The full width at half maximum (FWHM) of the near-band-edge emission (NBE) from the ZnO thin films was 98 meV, which was much smaller than that of ZnO thin films grown on a Si substrate. This value was even smaller than that of ZnO thin films grown on a sapphire substrate. The Huang-Rhys factor S associated with the free exciton (FX) emission from the ZnO thin films was found to be 0.124. The Eg(0) value obtained from the fitting was 3.37 eV, with ${\alpha}=3.3{\times}10^{-2}eV/K$ and ${\beta}=8.6{\times}10^3K$. The low- and high-temperature activation energies were 9 and 28 meV, respectively. The exciton radiative lifetime of the ZnO thin films showed a non-linear behavior, which was established using a quadratic equation.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2008.11a
• /
• pp.235-236
• /
• 2008

Wet etched ZnO:Al films for thin film solar cells were prepared by Facing Target sputtering(FTS) method. Wet etching has been used to produce a rough TCO surface that enables light trapping in the absorber. The ZnO:Al films for thin film solar cells were etched by HCl 0.5%. The etching performance of ZnO:Al films can be tuned by changing etching time. The etched ZnO:Al films compared to a smooth ZnO:Al thin film structure. From the results, the lowest resistivity of deposited films was $5.67\times10^{-4}$ [$\Omega$-cm] and the transmittance of all ZnO:Al thin films were over 80% in visible range.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.54 no.3
• /
• pp.103-108
• /
• 2005

ZnO thin films on (001) sapphire substrates have been deposited by pulsed laser deposition(PLD) technique using an Nd:YAG laser with a wavelength of 266nm. Before post-annealing treatment in the oxygen ambient, the experiment of the deposition of ZnO thin films has been performed for substrate temperatures in the range of $300\~450^{\circ}C$ and oxygen gas flow rate of $100\~700\;sccm$. In order to investigate the effect of post-annealing treatment of ZnO thin films, films have been annealed at various temperatures after deposition. After post-annealing treatment in the oxygen ambient, the structural properties of ZnO thin films were characterized by X-ray diffraction(XRD), scanning electron microscopy(SEM) and the optical properties of the ZnO were characterized by photoluminescence(PL).

• Proceedings of the Korean Vacuum Society Conference
• /
• 2013.02a
• /
• pp.336-336
• /
• 2013

Zinc oxide (ZnO) based transparent oxide semiconductors have been studied due to their high transmittance and electrical conductivity. Pure ZnO have unstable optical and electrical properties at high temperatures but doped ZnO thin films can have stable optical and electrical properties. In this paper, transparent oxide semiconductors of Y-doped ZnO thin films prepared by sol-gel method. The ionic radius of $Y^{3+}$ (0.90 A) is close to that of $Zn^{2+}$ (0.74 A), which makes Y suitable dopant for ZnO thin films. The Sn-doped ZnO thin films were deposited onto quartz substrates with different atomic percentages of dopant which were Y/Zn = 0, 1, 2, 3, 4, and 5 at.%. These thin films were pre-heated at $150^{\circ}C$ for 10 min and then annealed at $500^{\circ}C$ or 1 h. The structural and optical properties of the Y-doped ZnO thin films were investigated using field-emission scanning electronmicroscopy (FE-SEM), X-ray diffraction (XRD), UV-visible spectroscopy, and photoluminescence (PL).

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.26 no.2
• /
• pp.109-113
• /
• 2013

ZnO thin films were synthesized on Si substrates by MOCVD using diethyl zinc as a precursor. Effects of $O_2$/DEZ gas mixing ratio on the growth rate, surface morphology, preferred orientation, and electrical properties of the ZnO thin films were investigated with SEM, XRD, and Hall measurement. The surface reflectance variations of ZnO thin films were analyzed using laser-photometer apparatus. As the $O_2$/DEZ mixing ratio increased, growth rate and $I_{(002)}/I_{(101)}$ in XRD of ZnO thin films decreased, and the crystal structure was changed from columnar to planar structure. All ZnO films deposited at various CVD conditions exhibited c-axis (002) plane preferred orientation. The electrical properties of ZnO thin films mainly depended on the carrier mobility.

• Journal of the Korean Vacuum Society
• /
• v.22 no.1
• /
• pp.20-25
• /
• 2013

ZnO:Al thin films deposited by RF magnetron sputtering were post-annealed and the electrical and optical properties of ZnO:Al thin films were investigated before and after anneling. We confirmed that the ZnO:Al thin film was affected by post-annealing temperature. As post-annealing temperature increases, crystallinity and transmittance in visible area (400~800 nm) of ZnO:Al thin films decreased. While sheet resistance of thin films increased sharply with increasing to $400^{\circ}C$. This result is due to reduce of carrier concentration caused by absorption of $O_2$ or $N_2$ at surface of thin film.

• Journal of Advanced Marine Engineering and Technology
• /
• v.37 no.1
• /
• pp.72-77
• /
• 2013

The effect of sputtering condition on the structural properties of ZnO thin films grown by RF magnetron sputtering system was investigated for TFT driver circuit. ZnO thin films were grown with ZnO target varying RF power and working pressure. Structural properties were investigated by X-ray diffraction (XRD) and atomic force microscope (AFM). The ZnO thin films have sufficient crystallinity on the 100W RF power. But, the surface roughness of ZnO films was increased as increased RF power. As increased working pressure from 5 mTorr to 15 mTorr, a full width at half maximum (FWHM) of ZnO (002) peak was increased.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2000.11a
• /
• pp.324-327
• /
• 2000

ZnO(Zinc Oxide) thin films were deposited on glass substrate by Facing Targets Sputtering. Facing Targets Sputtering system can deposit thin films in plasma-free situation and change the sputtering conditions in wide range. The characteristics of ZnO thin films deposited at variation of sputtering conditions films thickness, power and substrate temperature were evaluated by XRD(x-ray diffractometer), ${\alpha}$-step (Tencor). The excellently c-axis oriented ZnO thin films were obtained at sputter pressure ImTorr, power 150W, substrate temperature 200$^{\circ}C$. In these conditions, the rocking curve of ZnO thin films deposited on glass was 3.3$^{\circ}$.

• Journal of the Korean Ceramic Society
• /
• v.33 no.2
• /
• pp.149-154
• /
• 1996

ZnO and Al-doped ZnO thin films were prepared by sol-gel dip-coating method and electrical and optical properties of films were investigated. Using the zinc acetate dihydrate and acetylaceton(AcAc) as a chelating agent stable ZnO sol was synthesized with HCl catalyst. Adding aluminium chloride to the ZnO sol Al-doped ZnO sol could be also synthesized. As Al contents increase the crystallinity of ZnO thin film was retarded by increased compressive stress in the film resulted from the difference of ionic radius between Zn2+ and Al3+ The thickness of ZnO and Al-doped ZnO thin film was in the range of 2100~2350$\AA$. The resistivity of ZnO thin films was measured by Van der Pauw method. ZnO and Al-doped ZnO thin films with annealing temperature and Al content had the resistivity of 0.78~1.65$\Omega$cm and ZnO and Al-doped ZnO thin film post-annealed at 40$0^{\circ}C$ in vacuum(5$\times$10-5 torr) showed the resistivity of 2.28$\times$10-2$\Omega$cm. And the trans-mittance of ZnO and Al-doped ZnO thin film is in the range of 91-97% in visible range.