• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.16 no.1
• /
• pp.191-197
• /
• 2012

In this paper we propose the FQSM(Fairness and QoS Supporting MAC) protocol that supports fairness and Quality of Service(QoS). The received or measured data traffics will be assigned a priority level according to its transmission urgency in the FQSM. And the load prediction algorithm is used to support the fairness between different priority traffics. For this, the buffer length values of the nodes are continuously monitored for a some period. Based on the buffer length variations for this period, the order of transmission is determined. FQSM also adapts cross-layer concept to rearrange the data transmission order in each sensor node's buffer, saves energy consumption by allowing few nodes in data transmission, and prolongs the network lifetime.

• 전자공학회논문지 IE
• /
• v.47 no.3
• /
• pp.41-46
• /
• 2010

WSN, or Wireless Sensor Network, consists of a multitude of inexpensive micro-sensors. Because the batteries in sensor nodes can not be replaced once they are deployed, the life of a WSN is absolutely determined by the batteries. So, energy efficiency of a network is a critical factor for long-life operation. LEACH protocol which divides WSN into two groups is a typical routing protocol based on the clustering scheme for the efficient use of limited energy. It is composed of round units which are separated into set-up and steady state. In this paper we propose a power saving scheme to minimize set-up phase itself and to involve a data comparison algorithm. We evaluate the performance of the proposed scheme in comparison with original LEACH protocol. Simulation results validate our scheme has better performance in terms of the number of alive nodes as time evolves and average energy dissipated.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.37 no.8B
• /
• pp.637-646
• /
• 2012

Recently, Wireless Sensor Networks (WSNs) are used in many applications. When sensor nodes are deployed on special areas, where humans have any difficulties to get in, the nodes form network topology themselves. By using the sensor nodes, users are able to obtain environmental information. Due to the lack of the battery capability, sensor nodes should be efficiently managed with energy consumption in WSNs. In specific applications (e.g. in intrusion detections), intruders tend to occur unexpectedly. For the energy efficiency in the applications, an appropriate algorithm is strongly required. In this paper, we propose tree-based routing algorithm for the specific applications, which based on the intrusion detection. In addition, In order to decrease traffic density, the proposed algorithm provides enhanced method considering link cost and load balance, and it establishes efficient links amongst the sensor nodes. Simultaneously, by using the proposed scheme, parent and child nodes are (re-)defined. Furthermore, efficient routing table management facilitates to improve energy efficiency especially in the limited power source. In order to apply a realistic military environment, in this paper, we design three scenarios according to an intruder's moving direction; (1) the intruder is passing along a path where sensor nodes have been already deployed. (2) the intruders are crossing the path. (3) the intruders, who are moving as (1)'s scenario, are certainly deviating from the middle of the path. In conclusion, through the simulation results, we obtain the performance results in terms of latency and energy consumption, and analyze them. Finally, we validate our algorithm is highly able to adapt on such the application environments.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.4
• /
• pp.252-258
• /
• 2013

As WSN is energy constraint so energy efficiency of nodes is important. Because avoiding long distance communication, clustering operating in rounds is an efficient algorithm for prolonging the lifetime of WSN and its performance depends on duration of a round. A short round time leads to frequent re-clustering while a long round time increases energy consume of cluster heads more. So existing clustering schemes determine proper round time, based on the parameters of initial WSN. But it is not appropriate to apply the round time according to initial value throughout the whole network time because WSN is very dynamic networks nodes can be added or vanished. In this paper we propose a new algorithm which calculates the round time relying on the alive node number to adapt the dynamic WSN. Simulation results validate the proposed algorithm has better performance in terms of energy consumption of nodes and loss rate of data.

• Journal of KIISE:Databases
• /
• v.37 no.6
• /
• pp.315-323
• /
• 2010

In Wireless Sensor Networks (WSNs), various Data-Centric Storages (DCS) schemes have been proposed to store the collected data and to efficiently process a query. A DCS scheme assigns distributed data regions to sensor nodes and stores the collected data to the sensor which is responsible for the data region to process the query efficiently. However, since the whole data stored in a node will be lost when a fault of the node occurs, the accuracy of the query processing becomes low, In this paper, we propose an in-network aggregation query processing method that assures the high accuracy of query result in the case of data loss due to the faults of the nodes in the DCS scheme. When a data loss occurs, the proposed method creates a compensation model for an area of data loss using the linear regression technique and returns the result of the query including the virtual data. It guarantees the query result with high accuracy in spite of the faults of the nodes, To show the superiority of our proposed method, we compare E-KDDCS (KDDCS with the proposed method) with existing DCS schemes without the data-loss correction method. In the result, our proposed method increases accuracy and reduces query processing costs over the existing schemes.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.39B no.10
• /
• pp.691-699
• /
• 2014

In order to increase network lifetime, duty-cycle MAC protocols which can reduce energy consumption caused by idle listening is proposed for WSNs. In common duty-cycle MAC protocols, each sensor node calculates its duty-cycle interval based on the current amount of residual energy. However, in WSNs with the capability of energy harvesting, existing duty-cycle intervals based on the residual energy may cause the sensor nodes which have high energy harvesting rate to suffer unnecessary sleep latency. Therefore, a duty-cycle scheduling scheme which adjust the duty-cycle interval based on both of the residual energy and the energy harvesting rate was proposed in our previous work. However, since this duty-cycle MAC protocol overlooked the performance variation according to the change of duty-cycle interval and adjusted the duty-cycle interval only linearly, the optimal duty-cycle interval could not be obtained to meet application requirements. In this paper, we propose three methods which calculate the duty-cycle interval and analyse their results. Through simulation study, we verify that network lifetime, end-to-end delay and packet delivery ratio can be improved up to 23%, 44% and 31% as compared to the existing linear duty-cycle scheduling method, respectively.

• Journal of the Korea Society for Simulation
• /
• v.19 no.1
• /
• pp.53-61
• /
• 2010

In wireless sensor networks(WSNs) individual sensor nodes are subject to security compromises. An adversary can physically capture sensor nodes and obtain the security information. And the adversary injects false reports into the network using compromised nodes. If undetected, these false reports are forwarded to the base station. False reports injection attacks can not only result in false alarms but also depletion of the limited amount of energy in battery powered sensor nodes. To combat these false reports injection attacks, several filtering schemes have been proposed. The statistical en-routing filtering(SEF) scheme can detect and drop false reports during the forwarding process. In SEF, The number of the message authentication codes(threshold) is important for detecting false reports and saving energy. In this paper, we propose a dynamic threshold determination method for energy efficient SEF using fuzzy-logic in wireless sensor networks. The proposed method consider false reports rate and the number of compromised partitions. If low rate of false reports in the networks, the threshold should low. If high rate of false reports in networks, the threshold should high. We evaluated the proposed method’s performance via simulation.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.15 no.6
• /
• pp.2148-2167
• /
• 2021

The proliferation of the Internet of Things (IoT) technologies and applications, especially the rapid rise in the use of mobile devices, from individuals to organizations, has led to the fundamental role of secure wireless networks in all aspects of services that presented with many opportunities and challenges. To ensure the CIA (confidentiality, integrity and accessibility) security model of the networks security and high efficiency of performance results in various resource-constrained applications and environments of the IoT platform, DDO-(data-driven operation) based constructions have been introduced as a primitive design that meet the demand of high speed encryption systems. Among of them, the TMN-family ciphers which were proposed by Tuan P.M., Do Thi B., etc., in 2016, are entirely suitable approaches for various communication applications of wireless mobile networks (WMNs) and advanced wireless sensor networks (WSNs) with high flexibility, applicability and mobility shown in two different algorithm selections, TMN64 and TMN128. The two ciphers provide strong security against known cryptanalysis, such as linear attacks and differential attacks. In this study, we demonstrate new probability results on the security of the two TMN construction versions - TMN64 and TMN128, by proposing efficient related-key recovery attacks. The high probability characteristics (DCs) are constructed under the related-key differential properties on a full number of function rounds of TMN64 and TMN128, as 10-rounds and 12-rounds, respectively. Hence, the amplified boomerang attacks can be applied to break these two ciphers with appropriate complexity of data and time consumptions. The work is expected to be extended and improved with the latest BCT technique for better cryptanalytic results in further research.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.16 no.1
• /
• pp.193-198
• /
• 2016

For environmental monitoring and risk identification of industrial plants, several monitoring systems using Wireless Sensor Networks (WSNs) have been developed. In this paper, we propose a dynamic duty cycle adjustment mechanism for reduced latency in industrial plants. The proposed method adjusts the duty cycle among predefined risk groups depending on the urgency of sensed data values. To demonstrate its efficacy, we analyze the expected transmission latency model and then discuss the characteristics in detail. We show that the proposed dynamic duty cycle mechanism is a more effective than a periodic mechanism by analyzing the expected latency of them in industrial plants where there are various types of sensory data with different levels of reliability.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.10B
• /
• pp.1043-1049
• /
• 2009

Broadcast of sink node is used for network management, data collection by query and synchronization in wireless sensor networks. Simple flooding scheme induces the broadcast storm problem. The MPR based broadcast schemes reduce redundant retransmission of broadcast packets. MPR is a set of one hop neighbor nodes which have to relay broadcast message to cover all two hop neighbors. Though MPR can reduce redundant retransmission remarkably, it still suffers from energy waste problem caused by collision and duplicate packets reception. This paper proposes a new MPR based sink broadcast scheme using 3-channel. The proposed scheme reduces energy consumption by avoiding duplicate packet reception, while increases reliability by reducing collision probability remarkably. The results of analysis and simulation show that the proposed scheme is more efficient in energy consumption compared to the MPR based scheme. The result also shows that the proposed scheme reduces delivery latency by evading a contention with other relay nodes and improves reliability of broadcast message delivery by reducing collision probability.