• Proceedings of the Korean Vacuum Society Conference
• /
• 2014.02a
• /
• pp.341.1-341.1
• /
• 2014

In the advanced material for the next generation display device, transparent amorphous oxide semiconductors (TAOS) are promising materials as a channel layer in thin film transistor (TFT). The TAOS have many advantages for large-area application compared with hydrogenated amorphous silicon TFT (a-Si:H) and organic semiconductor TFT. For the reasonable characteristics of TAOS, The a-IGZO has the excellent performances such as low temperature fabrication (R.T~), high mobility, visible region transparent, and reasonable on-off ratio. In this study, we investigated how the electric characteristics and physical properties are changed as various oxygen ratio when magnetron sputtering. we analysis a-IGZO film by AFM, EDS and I-V measurement. decreasing the oxygen ratio, the threshold voltage is shifted negatively and mobility is increasing. Through this correlation, we confirm the effect of oxygen ratio. We fabricated the bottom-gate a-IGZO TFTs. The gate insulator, SiO2 film was grown on heavily doped silicon wafer by thermal oxidation method. a-IGZO channel layer was deposited by RF magnetron sputtering. and the annealing condition is $350^{\circ}C$. Electrode were patterned Al deposition through a shadow mask(160/1000 um).

• Proceedings of the KIEE Conference
• /
• 1999.11d
• /
• pp.918-920
• /
• 1999

Recently, the ceramics of high permittivity are applied to DRAM and FRAM. In this study, (Ba, Sr)$TiO_3$ (BST) ceramics thin films were prepared by Sol-Gel method. BST solution was made and spin-coated on Pt/$SiO_2$/Si substrate at 4000[rpm] for 10 seconds. Coating process was repeated 3 times and then sintered at $750[^{\circ}C]$ for 30 minutes. Each specimen was analyzed structure and electrical characteristics. Thickness of BST ceramics thin films are about $2000[\AA]$. Dielectric constant and loss of thin films was little decreased at $1[kHz]{\sim}1[MHz]$. Dielectric constant and loss to frequency were 250 and 0.02 in BST3. In accordance with applied voltage, property of leakage current was stability when the was $0{\sim}3$[V]. According to voltage, leakage current was increased exponentially at $4{\sim}7$[V].

• Journal of Korean Society for Atmospheric Environment
• /
• v.20 no.3
• /
• pp.397-409
• /
• 2004

There has been few studies of either domestic or international to apply CCT-ICP-MS for the precise analysis of As and Cr components associated with airborne particulate matter. To date, the use of CCT-ICP-MS is strongly recommended for the accurate analysis of the toxic trace metals; this is because CCT-ICP-MS technique prevents polyatomic spectral interferences involved in the determination of As and/or Cr components. Taking advantage of CCT-ICP-MS technique, the measurements of about 20 metals were undertaken in this study. The standard reference material (NIST SRM 2783) was used for analytical quality control. To improve analytical accuracy and of acid efficiency, we selected nitric acid based on a test of three kinds of acid for microwave digestion method 1 ) nitric acid. 2) nitric acid and hydrogen peroxide. and 3) nitric acid and perchloric acid. When this method was employed, relative errors to SRM values of Al, As, Cr Fe, Mg, Mn, Pb, Sb, V, and Zn fell below 20%, while those or Ca, Si, and Ti were higher than 20%. The overall results of our study show that the concentrations of As and V determined by CCT-ICP-MS were satisfied with the certificated values within a relative error of 20e1c, whereas those determined by ICP-MS were 10 times higher than the certificated values.

• Microbiology and Biotechnology Letters
• /
• v.22 no.6
• /
• pp.665-671
• /
• 1994

For the production of pyrogallot from gallic acid, about 100 strains of bacteria capable of assimilating gallic acid as a sole carbon and energy source were isolated from the soil. JH- 004 strain showing the highest activity of gallate decarboxy#lase was selected from them and identi- fied as Erwinia sp. The optimal conditions for the production of pyrogallol from gallic acid were examined. The resting cells of JH-004 cultured in a complex medium containing 0.2%(w/v) gallic acid were prepared after the treatment of the pellet with a freezing and thawing, and used as a enzyme source. The reaction mixtures for the maximal production of pyrogallol were shown to be 6 g/l of resting cells and 15 g/l of gallic acid in 25 mM potassium phosphate buffer. The optimal pH for the reaction was 5.0 and the optimal temperature was 35$\circ$C . Additionally, Triton X-100(0.01%, w/v) was found to be most effective for the production of pyrogallol. Under the above conditions, 10.27 g/l of pyrogallol was produced from 15 g/l of gallic acid after incubation of 35 hrs. This amount of pyrogallol corresponds to a 92.37% yields, based on gallic acid.

• Korean Journal of Pharmacognosy
• /
• v.49 no.1
• /
• pp.70-75
• /
• 2018

Acer tegmentosum Maxim (ATM) has been used to treat hepatic disorders in traditional oriental medicine. However, there is little information about phytochemical constituents for quality control of ATM. In this study, we developed and established a simultaneous analytical method of the 10 marker compounds (three coumarins, 3 flavonoids, 1 lignan, 3 phenolics) in ATM using ultra-performance liquid chromatography-mass spectrometry (UPLC-MS/MS). Chromatographic separation of ten target analytes was achieved with a Waters Acquity UPLC BEH $C_{18}$ analytical column ($2.1{\times}100mm$, $1.7{\mu}m$), using a mobile phase of 0.1% (v/v) formic acid in water and acetonitrile with gradient elution. Identifications and quantitation of all analytes were performed using a Q-Exactive UPLC-MS/MS system. Correlation coefficients of the calibration curve for all analytes were ${\geq}0.9986$. The values of limits of detection and quantification of all analytes were 0.5-10.0 and 5.0-50.0 ng/mL, respectively. The established UPLC-MS/MS method successfully identified all target analytes in ATM, and the phytochemicals were 0.01-67.98 mg/g in its lyophilized water extract.

• Journal of the Korean Society for Heat Treatment
• /
• v.20 no.2
• /
• pp.78-83
• /
• 2007

CrN coatings were deposited by cathodic arc ion plating method on the SKD11 steel substrates. Atmosphere temperature of $350^{\circ}C$, arc current of 90 A, nitrogen partial pressure of 1.0-5.3 Pa, and negative bias voltage of 30-135 V were selected. The characteristics of microstructure were investigated with XRD. Hardness, adhesion and friction coefficient measured by microhardness tester, scratch tester, and ball on disk tribometer. Microstructures depended on nitrogen partial pressure and bias voltage. The preferred orientation of the films was changed from (200) to (111) with decreasing pressure and increasing bias voltage. Adhesion properties related with microstructure, but microstructure changes slightly influenced on hardness and friction properties. The critical load.($Lc_1$) and hardness of CrN films deposited at 5.3 Pa, -30 V condition were 55 N(HF1), $2157{\pm}47\;Hk_{0.025}$. The friction coefficient were about 0.5 under dry condition.

• Food Science and Biotechnology
• /
• v.14 no.6
• /
• pp.847-853
• /
• 2005

A total of 60 growth curves were generated with combinations of temperature, pH, and potassium lactate (PL) (60% (v/v) commercial solution) to determine the lag time (LT) and specific growth rate (SGR) of L. monocytogenes in broth. LT and SGR were significantly (P<0.05) affected by temperature, pH, concentration of PL, or the combined interaction of these factors. LT was extended and SGR was reduced significantly (P<0.05) by increased concentration of PL at lower temperature and pH. Listericidal effect was observed in the broth containing 2, 3, and 4% PL at pH 5.0 and $4^{\circ}C$. The antimicrobial activity of PL against L. monocytogenes increased when the pH of the medium was decreased at all temperatures tested. The results suggest that PL has antimicrobial properties to suppress the growth of L. monocytogenes. Potassium lactate has many potential applications as an antimicrobial additive in variety of refrigerated ready-to-eat foods.

• The Korean Journal of Food And Nutrition
• /
• v.12 no.5
• /
• pp.455-461
• /
• 1999

The possibility of wine making from soft and dried persimmon and the effects of treatment for persimmon on the quality of wine have been investigated. Soft persimmon was pretreated by two method of heat and hydrochloric acid treatment. Fermentation mash was composed of 12% persimmon and 15% of sucrose and was fermented at 17$^{\circ}C$ for 36 days. The fermentation using persimmons which were untreated and treated by acid was not successful because of contamination caused by lactic acid and acetic acid bacteria. Acidity of the fermented broth produced from boiled dried acid treated and untreated persimmon was 4,4, 5.0, 5,8 and 13.5ml(0.1N NaOH/10ml broth) respectively. Ethanol concentration of the fermented broth produced from boiled dried acid treated and untreated persimmon was 11.2, 10.0, 9.4 and 6.1% v/v respectively. The wine fermented for 28day's fermentation using boiled persimmon as substate had the best quality and stability. After 36day's fermentation using boild persimon following composition was obtained: 4.65% of total sugar 3.65% of reducing sugar 0.03mg/ml of protin 0.17$\mu$/ml of amino acid and 13.02 $\mu$g/ml of pectin. The pH and yeast cell of the boiled persimmon broth were 3.4 and 5.75 logCFU/ml. Fermented wine using dried persimmon had aslo good quality but the fermentation rate was slow.

• Korean Journal of Pharmacognosy
• /
• v.46 no.4
• /
• pp.342-351
• /
• 2015

In this study, we performed quantitative determination of the three marker compounds such as gallic acid, ellagic acid, and quercetin in the 70% ethanol extracts of non-processed Sanguisorbae Radix and processed Sanguisorbae Radix using a high-performance liquid chromatography coupled with photodiode array detector. The analytical column for separation of the three compounds was used a Gemini $C_{18}$ column ($5{\mu}m$, $4.6{\times}250mm$) by the gradient elution with distilled water and acetonitrile containing 1.0% (v/v) acetic acid as mobile phase. The flow rate and injection volume were $1.0{\mu}L/min$ and $10{\mu}L$. The concentrations of gallic acid, ellagic acid, and quercetin in non-processed Sanguisorbae Radix were 0.25, 0.26, and 0.007%, respectively, while the concentrations of gallic acid, ellagic acid, and quercetin in non-processed Sanguisorbae Radix 0.14-0.55, 0.27-2.03, and 0.001-0.007%, respectively. Among the three components, the amount of the ellagic acid was increased after processing in Sanguisorbae Radix.

• Proceedings of the KIEE Conference
• /
• 2000.11c
• /
• pp.446-448
• /
• 2000

Organic semiconductors based on vacuum-deposited films of fused-ring polycyclic aromatic hydrocarbon have great potential to be utilized as an active layer for electronic and optoelectronic devices. In this study, pentacene thin films and electrode materials were deposited by Organic Molecular Beam Deposition (OMBD) and vacuum evaporation respectively. For the gate dielectric layer, OPTMER PC403 photo acryl (JSR Coporation.) was spin-coated and cured at $220^{\circ}C$. Electrical characteristics of the devices were investigated, where the channel length and width was $50{\mu}m$ and 5 mm. It was found that field effect mobility was $0.039\;cm^2V^{-1}s^{-1}$, threshold voltage was -7 V, and on/off current ratio was $10^6$.