• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 1997.04a
• /
• pp.347-351
• /
• 1997

A micromachined piezoelectic cantilever transducer,which works both as a microphone and as a microspeaker,has been fabricated and tested. The 2000*2000*3.mu.m .sap2. cantilever has oxide(ZnO)piezoelectric thin film on a supporting layer of low-pressure chemical-vapor-deposited(LPCVD)low-stress siliconnitride. A highlight of the fabrication process which may also be relevant for other micromachined stuctures is the technique for producing a flat,multilayer cantilever. The measured microphone sensitivity is fairly constant at 2 mV/.mu.bar in the low frequency range and rise to 20 mV/.mu.bar at the lowest resonant frequency of 890 Hz. The 2 mV/.mu.bar sensitivity is the highest report to data for a microphone with a micromachined diaphragm. When measured into a 2 cm/sap3 coupler with 4V (zero-park)drive,the microspeaker output sound pressure level(SPL) is 75 dB at 890 Hz. It increases to approximately 100dB SPL at 4.8kHz with 6V(zero-park)drive. The measured microphone frequency response agrees well with the results of an ABAQUS simulation.

• BMB Reports
• /
• v.40 no.3
• /
• pp.432-438
• /
• 2007

V(D)J recombination, a site-specific gene rearrangement process occurring during the lymphocyte development, begins with DNA double strand breaks by two recombination activating gene products (RAG1/2) and finishes with the repair process by several proteins including DNA-dependent protein kinase (DNA-PK). In this report, we found that RAG2 was specifically phosphorylated by DNA-PK at the $365^{th}$ serine residue, and this phosphorylated RAG2 affected the V(D)J recombination activity in cells in the GFP expression-based assay. While the V(D)J recombination activity between wild-type RAG2 and mutant S365A RAG2 in the assay using a signal joint substrate was undistinguishable in DNA-PK deficient cells (M059J), the activity with wild-type RAG2 was largely increased in DNA-PK proficient cells (M059K) in comparison with mutant RAG2, suggesting that RAG2 phosphorylation by DNA-PK plays a crucial role in the signal joint formation during V(D)J recombination.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.47 no.3
• /
• pp.18-27
• /
• 2010

In this paper, a 1.2V 7-bit 1GSPS A/D converter with offset self-calibration is proposed. The proposed A/D converter structure is based on the folding-interpolation whose folding rate is 2, interpolation rate is 8. Further, for the purpose of improving the chip performance, an offset self-calibration circuit is used. The offset self-calibration circuit reduce the variation of the offset-voltage，due to process mismatch, parasitic resistor, and parasitic capacitance. The chip has been fabricated with a 1.2V 65nm 1-poly 6-metal CMOS technology. The effective chip area is $0.87mm^2$ and the power dissipates about 110mW at 1.2V power supply. The measured SNDR is about 39.1dB when the input frequency is 250MHz at 800MHz sampling frequency. The measured SNDR is 3dB higher than the same circuit without any calibration.

• The Korean Journal of Physiology
• /
• v.26 no.1
• /
• pp.15-25
• /
• 1992

In order to elucidate the properties of the background current whole cell patch clamp studies were performed in rabbit ventricular cells. Ramp pulses of ${\pm}80\;mV$ from holding potential of 40 mV(or 20 mV) at the speed of 0.8 V/sec were given every 30 sec(or 10 sec) and current-voltage diagrams(I-V curve) were obtained. For the activation of the background current isoprenaline, adenosine 3',5'-cyclic monophosphate(dBcAMP), guanosine 3',5'-cyclic monophosphate(cGMP), and $N^6$-2'-o-dibutyryladenosine 3',5'-cyclic monophosphate(dBcAMP) were applied after all known current systems were blocked with 2mM Ba, 1 mM Cd ,5 mM Ni, 10 ${\mu}M$ diltiazem, 10 ${\mu}m$ ouabain, and 20 mM tetraethylammonium(TEA). The conductance of background current in control was $0.65{\pm}0.69$ nS at 0 mV, its I-V curves was almost linear and reversed near 50 mV. When there was no taurine in pipette solution, isoprenaline hardly activated the background current but when taurine existed in pipette solution, isoprenaline activated the larger background current. Cyclic AMP or cyclic GMP alone had little effect on the activation of the background current, while cGMP potentiated cGMP effect. When the background current was activated with cGMP and cAMP, isoprenaline could not further increased the background current. The background current activated by isoprenaline depended on extracellular $Cl^-$ concentration and its reversal potential was shifted according to chloride equilibrium potential. The change of extracellular $Na+$ concentration had little effect on reversal potential of the background current activated by isoprenaline.

• Journal of the Korean Institute of Telematics and Electronics C
• /
• v.36C no.8
• /
• pp.10-21
• /
• 1999

This paper describes a 12bit CMOS current cell matrix D/A converter which shows a conversion rate of 65MHz and a power supply of 3.3V. Designed D/A converter utilizes current cell matrix structure with good monotonicity characteristic and fast settling time, and it is implemented by using the tree structure bias circuit, the symmetrical routing method with ground line and the cascode current switch to reduce the errors of the conventional D/A converter caused by a threshold voltage mismatch of current cells and a voltage drop of the ground line. The designed D/A converter was implemented with a $0.6{\mu}m$ CMOS n-well technology. The measured data shows a settling time of 20ns, a conversion rate of 50 MHz and a power dissipation of 35.6mW with a single power supply of 3.3V. The experimental SNR, DNL, and INL of the D/A converter is measured to be 55dB, ${\pm}0.5LSB$, and ${\pm}2LSB$, respectively.

• Journal of Korea Foresty Energy
• /
• v.20 no.2
• /
• pp.69-80
• /
• 2001

Larix kaemferi Carr. is one of main timber species in Korea that could be found in plantations and growing stands on all over the country The proper practice of thinning is one of very important techiques in silviculture, which greatly affects the quality and size of timber produced. Proper thinning period is considered to be important for maintaining stand growth before competition initiated. To investigate suitable thinning period, this study investigates the volume and radial growths of Larix kaemferi plantation in Mt. Worak located in the central part of Korea. The main findings and conclusions obtained from this study were as follow ; (1) The tree height curve equation for Larix kaemferi in Mt. Worak was calculated H=4.25783+0.80024D(H=Tree height, D=DBH). (2) To estimate tree volume for Larix kaemferi by DBH and tree height or only by DBH, regression equations were calculated as V=0.00147-0.002095D-0.000211H+0.00015D.H++$0.000744D^2$+$0.000008H^2$(V=Volume(($m^3$), H=Tree height(m), D=DBH(cm)), V=0.0000794-0.000512D+$0.000826D^2$. (3) The criteria of estimating thinning time of Larix kaemferi are the age when maximum tree height-MAI(mean annual increment) obtained and the age when annual DBH increments of dead trees decrease to below average. (4) The age of maximum tree height MAI was not significantly correlated with stocking. Therefore, it can not be used as a criterion for estimating thinning time of Larix kaemferi (5) The estimated thinning time equation of Larix kaemferi was obtained by regression analysis of the disk section collected from dead trees. The obtained equation is Y=0.2825+0.01752X(Y=Desirable thinning age, X=the sum total of nearest 4-trees interval(cm)). (6) General estimated thinning age of Larix kaemferi, which planted 3,086 stocks/ha, is concluded as 12 to 14 year.

• Journal of applied mathematics & informatics
• /
• v.38 no.1_2
• /
• pp.189-200
• /
• 2020

Let G be a simple connected graph with n vertices and m edges. Denote by d₁ ≥ d₂ ≥ ⋯ ≥ d_n > 0 and d(e₁) ≥ d(e₂) ≥ ⋯ ≥ d(e_m) sequences of vertex and edge degrees, respectively. If vertices v_i and v_j are adjacent, we write i ~ j. The general sum-connectivity index is defined as 𝒳_α(G) = ∑_i~j(d_i + d_j)^α, where α is an arbitrary real number. Firstly, we determine a relation between 𝒳_α(G) and 𝒳_α-1(G). Then we use it to obtain some new bounds for 𝒳_α(G).

• 한국정보디스플레이학회:학술대회논문집
• /
• 2004.08a
• /
• pp.1251-1253
• /
• 2004

Light diffraction on optically anisotropic substrates with the surface microrelief has been calculated by using the OAGSM method. Varying of the microrelief depth and material birefringence allows to realize different polarization state of the light beam transmitted or reflected by the substrate. The approach can be used to optimize the LCD backlight.

• Journal of the Korean Applied Science and Technology
• /
• v.34 no.2
• /
• pp.376-381
• /
• 2017

We were investigated by cyclic voltammetry to the stability through the electrochemical characteristics of Langmuir-Blodgett films mixed with myristic acid and stearic acid. Fatty acid mixture monolayer LB films was deposited by the LB method on the indium tin oxide(ITO) glass. The electrochemical properties was measured by cyclic voltammetry with a three-electrode system in 0.01 N $NaClO_4$ solution. The measuring range is continuously oxidized to 1650 mV, with an initial potential of -1350 mV was reduced. Scanning rates of 50, 100, 150, 200, and 250 mV/s was set. As a result, LB monolayer films of fatty acid mixture was appeared on irreversible processes by the oxidation current from the cyclic voltammogram. Diffusion coefficient (D) of fatty acid mixture was calculated $7.9{\times}10^{-2}cm^2s^{-1}$ at 0.01 N $NaClO_4$ solution.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.22 no.9
• /
• pp.1941-1948
• /
• 1997

In this paper, the power efficient linear upconversion mixer which is a functional circuit in transmit path of intermediate frequency(IF) part of Code Division Multiple (CDMA) cellular phone was explained. In generally, the low CMOS devices limits the implementation of upconversion mixer especially for lower loads. Using replica transconductor, the linear range is extended up to the limit. Thiscircuit was imprlemented using $0.8{\mu}\textrm{m}$ N-well CMOS technology with 2-poly/2-metal. The active area of chip is $0.53mm{\times}0.92mm$. The power consumption is 30mW with 3.3V suply voltage. The 1dB conpression characteristics is -27.3dB with $25{\Omega}$. load and being applied by 2-tone input signal. The mixer operates properly above 200MHz.