• Journal of IKEEE
• /
• v.13 no.2
• /
• pp.208-215
• /
• 2009

The high efficiency power management IC(PMIC) with DT-CMOS(Dynamic Threshold voltage MOSFET) switching device for portable application is proposed in this paper. Because portable applications need high output voltages and low output voltage, Boost converter and Buck converter are embedded in One-chip. PMIC is controlled with PWM control method in order to have high power efficiency at high current level. DTMOS with low on-resistance is designed to decrease conduction loss. Boost converter and Buck converter, are based on Voltage-mode PWM control circuits and low on-resistance switching device, achieved the high efficiency near 92.1% and 95%, respectively, at 100mA output current. And Step-down DC-DC converter in stand-by mode below 1mA is designed with LDO in order to achive high efficiency.

• Journal of IKEEE
• /
• v.17 no.3
• /
• pp.324-331
• /
• 2013

In this paper, we implemented memristor emulator circuit on Printed Circuit Board (PCB) and observed the inherent pinched hysteresis characteristic of memristors by measuring the emulator circuit on PCB. The memristor emulator circuit implemented on PCB is composed of simple discrete devices not using any complicated circuit blocks thus we can integrate the memristor emulator circuits in very small layout area on Silicon substrate. The programmable gain amplifier is designed using the proposed memristor emulator circuit and verified that the amplifier's voltage gain can be controlled by programming memristance of the emulator circuit by circuit simulation. Threshold switching is also realized in the proposed emulator circuit thus memristance can remain unchanged when the input voltage applied to the emulator circuit is lower than VREF. The memristor emulator circuit and the programmable gain amplifier using the proposed circuit can be useful in teaching the device operation, functions, characteristics, and applications of memristors to students when thet cannot access to device and fabrication technologies of real memristors.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.15 no.3
• /
• pp.107-112
• /
• 2015

A smart phone and the number of wireless terminals are mobile-to the nature of the AP mobility are many call transfer between wireless terminals and AP (Access Point). Each wireless terminal that is the call processing process for each is relatively large to cause the wireless traffic, and a factor that inhibits the efficient use of the radio band on the AP. In this paper, we use the power intensity threshold and threshold timer of the AP received by the mobile station to reduce the amount of switching traffic between the AP's cause and traffic generation factors between the wireless device and the AP that can effectively utilize the radio traffic from the AP the measures proposed. The proposed method and the conventional method is improved by simulation to handle the amount of radio traffic from the AP it was confirmed that it is possible to effectively utilize the whole of the radio band.

• Journal of Distribution Science
• /
• v.15 no.12
• /
• pp.53-60
• /
• 2017

Purpose - This paper analyzes the effect of the handset subsidy and the Mobile Number Portability subscriber subsidy regulation, which are the main regulation adopted in "Law on the Improvement of the Mobile Terminal Distribution System" (Mobile Terminal Distribution Act), on the social surplus, the consumer surplus and profits of telecommunications carriers. We focus our analysis on whether the service charge competition is stimulated enough so that it can compensate for the loss of subsidies. Research design, data, and methodology - We use simple economic model to assess the impact of the handset subsidy and the Mobile Number Portability subscriber subsidy regulation. Unlike the former researches on this topic, we depart from using Hotelling model, and instead use the switching cost model, which uses switching cost as a parameter of market powers of telecommunications carriers. We also study the effect of the two different regulations when they are adopted both independently and concurrently. Results - If the market powers of telecommunications carriers are over certain threshold, contrary to the regulatory agency's assertion, the service charge competition would not be stimulated enough to compensate for the deduction in the subsidies, and thus the consumer surplus is compromised. Number Portability subsidy, especially, undermines the rival's market power and thus reduces the service charge. On the other hand, the regulations will also increase the profits of telecommunications carriers. However, social surplus is maximized when both of the regulations are present because the regulations reduces the frequency of switching handsets inefficiently. Conclusions - In enacting the Mobile Terminal Distribution Act, the telecommunications regulatory agency asserted that the regulation on subsidies will stimulate service charge competition, and in the long run, enhance the consumer surplus. However, contrary to the regulatory agency's assertion, subsidy regulation, especially the regulation on Number Portability subsidy, reduces consumer surplus. On the other hand, the Mobile Terminal Distribution Act can also increase the profits of telecommunications carriers because it decreases competition among the telecommunications carriers. However, the Mobile Terminal Distribution Act can increase the social surplus because it reduces inefficient switching of handsets.

• Journal of Biosystems Engineering
• /
• v.14 no.2
• /
• pp.128-136
• /
• 1989

The purpose of this study was to develop a computer operated automatic drip irrigation system for application in vinyl-house cultivation. The results can be summarized as follows: 1) The T-type ice compensation wire was used to measure the temperature. The voltage level measured up to 0.02 volt was used as input to an 8-bit A/D converter. 2) A specially devised tensiometer was used to content the watering system. When the needle of the pressure gauge reaches the lower threshold position it turns on the pumping system and turns off when it reaches higher threshold position. 3) In order to use the multiple gypsum blocks for one transducer, reed relays and a D/O board were used to make the sequential switching possible. 4) It was possible to automate the trickle irrigation system for the whole growth period of vinyl-house crops with the help of microcomputer. 5) In terms of furrow irrigation, the irrigation water consumption was the smallest, 2.8 times less than conventional method of surface trickle irrigation, 3.4 times less than subsurface trickle irrigation method. 6) In terms of productivity of cucumber, there was a drop in productivity when compared to furrow irrigation method, 7.2% for surface trickle irrigation, 27.4% for subsurface irrigation method.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2008.10a
• /
• pp.1208-1211
• /
• 2008

We study the amorphous In-Ga-Zn-O thin-film transistors (TFTs) properties under monochromatic illumination ($\lambda=420nm$) with different intensity. TFT off-state drain current ($I_{DS_off}$) was found to increase with the light intensity while field effect mobility ($\mu_{eff}$) is almost unchanged; only small change was observed for sub-threshold swing (S). Due to photo-generated charge trapping, a negative threshold voltage ($V_{th}$) shift is also observed. The photofield-effect analysis suggests a highly efficient UV photocurrent conversion in a-IGZO TFT. Finally, a-IGZO mid-gap density-of-states (DOS) was extracted and is more than an order lower than reported value for a-Si:H, which can explain a good switching properties of the a-IGZO TFTs.

• Journal of IKEEE
• /
• v.14 no.3
• /
• pp.250-255
• /
• 2010

The interleaved power management IC(PMIC) with DTMOS(Dynamic Threshold voltage MOSFET) switching device is proposed in this paper. The buck-boost converter used to provide the high output voltage and low output voltage for portable applications. Also we used the PWM(Pulse Width Modulation) control method for high power efficiency at high current level. DTMOS with low on-resistance is designed to decrease conduction loss. The interleaved PMIC to reduce output ripple. And step-down DC-DC converter in stand-by mode below 1mA is designed with LDO in order to achive high efficiency.

• Journal of the Korea Society of Computer and Information
• /
• v.4 no.4
• /
• pp.101-112
• /
• 1999

In this paper variable bit rate VBR Moving Picture Experts Group (MPEG) coded full-motion video traffic is modeled by a nonlinear time-series process. The threshold autoregressive (TAR) process is of particular interest. The TAR model is comprised of a set of autoregressive (AR) processes that are switched between amplitude sub-regions. To model the dynamics of the switching between the sub-regions a selection of amplitude dependent thresholds and a delay value is required. To this end, an efficient and accurate TAR model construction algorithm is developed to model VBR MPEG-coded video traffic. The TAR model is shown to accurately represent statistical characteristics of the actual full-motion video trace. Furthermore. in simulations for the bit-loss rate actual and TAR traces show good agreement.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.9 no.5
• /
• pp.31-37
• /
• 2009

In the two-way relay channel, the relay employ Amplify-and-Forward (AF) or Decode-and-Forward (DF) protocol, and broadcast the network-coded signal to both user. In the system, DF protocol provides maximum throughput at low signal to noise ratio(SNR). On the other hand, at high SNR, AF protocol provides maximum throughput. The paper propose active transmission scheme which employ Amplify-and-Forward or Decode-and-Forward protocol based on received SNR at the relay over Two-way relay channel. The optimal threshold is investigated numerically for switching the protocol. Through numerical results, we confirm that the proposed scheme outperforms conventional schemes over two-way relay channel.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.19 no.4
• /
• pp.376-382
• /
• 2014

This paper proposes the pulse width modulation (PWM) control strategy for low-speed operation in the three-level neutral-point-clamped (NPC) inverters based on the bootstrap gate drive circuit. As a purpose of the cost reduction, several papers have paid attention to the bootstrap circuit applied to the three-level NPC inverter. However, the bootstrap gate driver IC cannot generate the gate signal to the IGBT for low-speed operation, because the bootstrap capacitor voltage decreases under the threshold level. For low-speed operation, the dipolar and partial-dipolar modulations can be the effective solution. However, these modulations have drawbacks in terms of the switching loss and THD. Therefore, this paper proposes the PWM control strategy to operate the inverter at low-speed and to minimize the switching loss and harmonics. The experimental results are presented to verify the validity on the proposed method.