• Proceedings of the Korean Vacuum Society Conference
• /
• 2013.02a
• /
• pp.161-161
• /
• 2013

Two-dimensional electron gas (2DEG) has been investigated at the heterointerface between two insulating dielectric perovskite oxides, $LaAlO_3$ (LAO)/$SrTiO_3$ (STO). Properties of the 2DEG have attracted an enormous interest in condensed matter physics due to multifunctional properties such as the coexistence of ferromagnetism and superconductivity, as well as the high electron mobility. Here, we have grown $Ta_2O_5$ thin films using pulsed laser deposition on $SrTiO_3$ substrate to investigate the electric properties of the $Ta_2O_5$/STO heterointerface. Our research reveal that the non-polar $Ta_2O_5$/$TiO_2$ heterointerface favors the formation of 2DEG similar to that at the LAO/STO heterointerface. The metallic behavior was found in this heterointerface with the current about $10{\sim}100{\mu}A$ at 5 V by using conventional I-V measurements, when the $Ta_20_5$ film thickness reaches over critical thickness, $d_c{\simeq}2uc$. The finding that electrons was localized at $Ta_2O_5$/STO heterointerface have attracted to be strong and new candidate for nanoscale oxide device applications.

• Proceedings of the Korean Ceranic Society Conference
• /
• 2004.04b
• /
• pp.38.1-38.1
• /
• 2004

• Journal of the Korean Chemical Society
• /
• v.35 no.6
• /
• pp.653-658
• /
• 1991

The structural variation process and relation of water of amorphous Ta-IPA bulk and thin film upon heat-treatment conditions of $25^{\circ}C$ and $340^{\circ}C$ have been studied by using the radial distribution functions$ (RDF_{obs})$ estimated from the X-ray diffraction intensities, TG-DTA and Infrared spectrophotometer. The expected Ta-IPA structure was determined by comparing the $ RDF_{obs}$ with that for $RDF_{calc}$. The structure of specimens prepared by sol-gel method is basically based on the L-$Ta_2O_5$ crystal. Thin film of samples are mainly composed of octahedral Ta$O_6$and have smaller cluster than bulk samples.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2013.02a
• /
• pp.619-619
• /
• 2013

The interfacial state between $Ta_2O_5$ and a Si substrate during the growth of $Ta_2O_5$ films by atomic layer deposition (ALD) was investigated using in-situ synchrotron radiation photoemission spectroscopy (SRPES). A newly synthesized liquid precursor Ta($N^tBu$) $(dmamp)_2Me$ was used as the metal precursor, with Ar as a purging gas and $H_2O$ as the oxidant source. After each half reaction cycle, samples were analyzed using in-situ SRPES under ultrahigh vacuum at room temperature. SRPES analysis revealed that Ta suboxide and Si dioxide were formed at the initial stages of $Ta_2O_5$ growth. However, the Ta suboxide states almostdisappeared as the ALD cycles progressed. Consequently, the $Ta^{5+}$ state, which corresponds with the stoichiometric $Ta_2O_5$, only appeared after 4.0 cycles. Additionally, tantalum silicate was not detected at the interfacial states between $Ta_2O_5$ and Si. The measured valence band offset between $Ta_2O_5$ and the Si substrate was 3.22 eV after 3.0 cycles.

• Proceedings of the Materials Research Society of Korea Conference
• /
• 2003.11a
• /
• pp.171-171
• /
• 2003

공정기술의 향상으로 DRAM(dynamic random acess memory)의 고집적화가 이루어지고 있으며, 각 개별소자 및 셀 영역의 점유면적의 감소가 요구되어지고 있다. 따라서 기존에 사용하던 NO (Si$_3$N$_4$/SiO$_2$)박막보다 유전율이 높은 고유전물질에 대한 연구가 진행되고 있다. Ta$_2$O$_{5}$, $Y_2$O$_3$, HfO$_2$, ZrO$_2$,Nb$_2$O$_{5}$, BaTiO$_3$, SrTiO$_3$ 및 (BaSr)TiO등이 고유전물질로 연구되고 있는데 그 중 공정의 안정성, 누설전류의 우수성으로 인해 Ta$_2$O$_{5}$이 많이 연구되고 있다. 본 실험에서는 TiO$_2$가 8 mol%가 첨가된 Ta$_2$O$_{5}$의 열처리 온도에 따른 전기적, 유전특성을 살펴보려고 한다살펴보려고 한다

• Journal of the Korean Ceramic Society
• /
• v.47 no.5
• /
• pp.461-466
• /
• 2010

In this study, $Al_2O_3/TaAlO_4/SiO_2$ (A/TAlO/S) structures with tantalum aluminate charge trap layer were fabricated for Nand flash memory device. We evaluated the memory window and retention characteristic as the thickness of the tunnel oxide was varied among 3 nm, 4 nm, and 5 nm. All tunnel oxide thicknesses were measured by ellipsometer and TEM (Transmission Electron Microscope). The A/TAlO/S multi-layer film consisted of 5 nm tunnel oxide showed the best result of memory window of 1.57 V and retention characteristics. After annealing the 5 nm tunnel oxide A/TAlO/S multi-layer film at $900^{\circ}C$. The memory window decreased to 1.32 V. Moreover, the TEM images confirmed that the thickness of multi-layer structure decreased 14.3% after annealing and the program conditions of A/TAlO/S multi-layer film decreased from 13 V to 11 V for 100 ms. Retention properties of both as-deposited and annealed films stably maintained until to $10^4$ cycles.

• Journal of the Korean Ceramic Society
• /
• v.34 no.2
• /
• pp.202-208
• /
• 1997

Bi-layered SrBi2Ta2O9(SBT) films were deposited on Pt/Ti/SiO2/Si sibstrates by rf magnetron sputt-ering at room temperature and then were annealed at 75$0^{\circ}C$, 80$0^{\circ}C$ and 85$0^{\circ}C$ for 1 hour in oxygen at-mosphere. The film composition of SrBi2Ta2O9 was obtained after depositing at room temperature and annealing at 80$0^{\circ}C$. Excess 20mole% Bi2O3 and 30 mole% SrCO3 were added to the target to compensate for the lack of Bi and Sr in SBT film. 200 nm thick SBT film exhibited and dense microstructure, adielectric constant of 210, and a dissipation factor of 0.05 at 1 MHz frequency. The films exhibited Curie temperature of 32$0^{\circ}C$ and a dielectric constant of 314 at that temperature under 100 kHz frequency. The remanent polarization(2Pr) and the coercive field(2Ec) of the SBT films were 9.1 $\mu$C/$\textrm{cm}^2$ and 85 kV/cm at an applied voltage of 3V, resspectively and the SBT film showed a fatigue-free characteristics up to 1010 cy-cles under 5V bipolar pulse. The leakage current density of the SBT film was about 7$\times$10-7A/$\textrm{cm}^2$ at 150 kV/cm. Fatigue-free SBT films prepared by rf magnetron sputtering can be suitable for application to non-volatile memory device.

• Journal of the Korean Vacuum Society
• /
• v.8 no.3A
• /
• pp.224-230
• /
• 1999

$SrBi_{2x}Ta_2O_9$ (SBT) thin films were prepared on platinized silicon substrates by MOD process, and their ferroelectric and leakage current characteristics were investigated. The grain size of the MOD derived SBT films increased with increasing the BI/Ta mole ration. Although the SBT films with x of 0.8~1.2 were composed of the equiaxed grains, the elongated grains were also observed for the SBT films with x of 1.4 and 1.6. The SBT film with x of 1.2 exhibited the optimum ferroelectric properties of 2PR : 9.79 $\muC/\textrm{cm}^2$ and Ec : 24.2kV/cm at applied voltage of 5V. The leakage current density of the SBT films increased with increasing the BI/Ta mole ratio. With post annealing process, 2Pr and $E_c$of the SBT film with x of 1.2 increases 11.3 $\muC/\textrm{cm}^2$ and 39.6kV/cm, respectively. decrement of the leakage current density by post annealing process increased remarkably with increasing the Bi/ta mole ratio, and the SBT film with x=1.6 exhibited the lowest leakage current density after post annealing process.

• Journal of the Korean Ceramic Society
• /
• v.40 no.12
• /
• pp.1165-1169
• /
• 2003

The Ta$_2$O$_{5}$ thin film was deposited on Si-(III) and glass substrate with the change of Ar:O$_2$ gas flow rate in the assist ion gun by the Dual ion-Beam Sputtering (DIBS). As the $O_2$ gas flow of the assist ion gun was decreased, the deposition rate of the thin films decreased. The refractive index was fixed (2.11, at 1550 nm) without regarding to $O_2$ gas flow of the range 3∼12 sccm in assist ion gun. The condition of Ar:O$_2$=3:12 was formatted stoichiometry composition of Ta$_2$O$_{5}$ and the ms roughness was small (0.183 nm).

• Proceedings of the Materials Research Society of Korea Conference
• /
• 2003.11a
• /
• pp.57-57
• /
• 2003

High dielectric constant materials (high K) have attracted a great deal of interest because of the dramatic scaling down of DRAM capacitor reaching its physical limit in terms of reduction of thickness. Among high-K materials that can replace silicon dioxide, tantalum pentoxide (Ta2O5) thin film, with their high dielectric constant (∼25) and good step coverage, is the candidate of choice.