• Journal of the Korean GEO-environmental Society
• /
• v.11 no.6
• /
• pp.57-67
• /
• 2010

Specific yield is an essential parameter of the water table fluctuation method for recharge calculation. Specific yield is not easily estimated because of limited availability of aquifer test data and soil samples at National Groundwater Monitoring Stations in South Korea. The linear relationship between rainfall and water level rise was used to estimate the specific yields of aquifer for 34 shallow monitoring wells which were grouped into three clusters. In the case of Cluster-1 and Cluster-2, this method was not applicable because of low cross correlation between rainfall and water level rise and also a long lag time of water level rise to rainfall. However, the specific yields for 19 monitoring wells belonging to Cluster-3, which have relatively high cross correlation and short lag time, within 2 days after rainfall, range from 0.06 to 0.27 with mean value of 0.17. These values are within the general range for sand and gravel sediments and similar to those from aquifer test data. A detailed field survey is required to identify monitoring sites that are not greatly affected by pumping, stream flow, evapotranspiration, or delayed response of water levels to rainfall, because these factors may cause overestimation of specific yield estimates.

• Journal of Environmental Impact Assessment
• /
• v.28 no.6
• /
• pp.525-535
• /
• 2019

In this study, 49 major WCS(Wildlife Crossing Structure), including Baekdu-daegan, were evaluated for the effectiveness of WCS on using the daily average frequency index and diversity Index comparing the number of species that appear with the surrounding habitats. According to the analysis, the average use frequency of the entire WCS was 1.4 times, and the average number of WCS exceeded the average was 17 and 34.7 percent of the total. There were 18 WCS with the same number of habitats and species that appeared in the same area, or 36.7 percent of the total. The daily average use frequency and variety were all analyzed at 10 efficient WCS, accounting for 20.4 percent of the total. According to the results of an site survey on the compliance rate of 4 efficient WCS, the compliance rate of the Deoksanjae overpass was the best in location selection, specifications, vegetation cover and soil, fence. The results of this research will be used as basic data for the study of WCS effectiveness, including the improvement of functions of new and installed WCS.

• Weed & Turfgrass Science
• /
• v.5 no.3
• /
• pp.155-164
• /
• 2016

Earworm is very useful animal in soil ecosystem, however it is harmful for golf courses because they introduce many cast on turfgrass that reduces turf uniformity and play quality. However, no information has found on earthworm diversity and seasonal fluctuation in different Korean golf courses. In this study, we focused to carry out earthworm species composition and seasonal population structure in turfgrass of golf courses. During spring and fall season survey with direct digging and tea saponin drenching sampling in 5 different golf courses, 6 species under 3 families of earthworms were collected. Earthworm species composition and density was different among the golf courses. Aporrectodea caliginosa in Lumbricidae was dominant species in Anseong and Dongrae Benest Golf Club; however Amynthas carnosus in Megascolecidae was dominant species in Anyang and Glenrose Golf Club. Ap. caliginosa was collected only aclitellum in July and Am. carnosus was collected aclitellum and clitellum in August in golf courses. Seasonal population of earthworm was different depending on earthworm species (Am. hupeiensis was the highest in August and Ap. caliginosa was in April) however small number of collected earthworm species were not dominant trend in golf courses.

• Korean Journal of Organic Agriculture
• /
• v.22 no.4
• /
• pp.773-787
• /
• 2014

Bacterial pustule of soybean caused by Xanthomonas axonopodis pv. glycines is one of the most prevalent bacterial diseases in many areas where soybeans are grown. This study was carried out to evaluate the effect of cultivars, sowing date and cropping system on the suppression of soybean bacterial pustule in the field. One hundred soybean cultivars were screened for disease resistance against bacterial pustule in naturally infested field. Among them, fourteen cultivars including 'Pureun' were found to be high resistant. And thirty cultivars showed to be moderate resistant(less than 3% of diseased leaf area). When Soybean cultivar 'Taekwang' were sown in four different dates, May 25, June 5, June 15, and June 25, at 10 day-interval in Milyang, the diseased leaf area of bacterial pustule was 23.3%-25.7%, 14.7%-18.0%, 10.7%-12.8%, and 1.0%-2.7%, respectively. The lowest percentage of diseased leaf area was recorded in the plots sown on June 25, whereas the highest percentage of diseased leaf area was recorded in the plot sown on May 25. As sowing time was delayed, incidence of soybean bacterial pustule found to be comparatively reduced. From December in 2006 to June in 2007, we surveyed the pathogen population of soybean bacterial pustule in five cropping upland soils where soybean was cultivated. The survey result showed the bacterial pustule pathogens were detected from the all cropping soils. The pathogen populations of soybean bacterial pustule in soybean-barley and soybean-garlic cropping soil were significantly lower than that of the other cropping soils. In addition, the incidence of soybean bacterial pustule was decreased under the two cropping systems.

• Korean Journal of Remote Sensing
• /
• v.35 no.5_1
• /
• pp.751-761
• /
• 2019

Mt. Baekdu, Mt. Aso, Mt. Sakurajima, Mt. Kikai and etc are distributed around the Korean Peninsula. Recently signs of eruption of Mt. Baekdu are increasing, raising concerns over possible damage to volcanic ash from seasonal winds during the winter eruption. Therefore, detailed procedures for investigation and countermeasures for volcanic ash spread and damage are required. But the standards for the warning and alarm signal of volcanic ash presented by Korea Ministry of Government Legislation are vague, with "when damage is expected" and "when serious damage is expected". In this study, to analyze the damage threshold and to apply the cases of overseas damage to the country, a survey was conducted on the establishment of domestic spatial information by public institutions with public confidence. As a result of the investigation of damage from volcanic ash overseas, the details of the damage cases were different depending on the type of life or income sources of each country. Therefore, instead of applying the volcanic ash damage cases abroad in Korea, spatial information analysis was performed to reflect domestic social and natural characteristics. In addition, we selected the areas to be considered in the event of volcanic ash damage in Korea. Finally, domestic volcanic ash damages should be classified as health, residential, road, railroad, aviation, power, water, agriculture, livestock, forest, and soil. When establishing the volcanic ash alarm optimized for Korea in the future, overseas volcanic ash damage cases and domestic spatial information construction in this study will be helpful in policy establishment.

• Geophysics and Geophysical Exploration
• /
• v.19 no.4
• /
• pp.187-199
• /
• 2016

In order to delineate the soft ground distribution, an integrated geostatistical analysis was performed using the MASW (Multichannel Analysis of Surface Wave) which has the information of overall region and CPTu (Piezo Cone Penetration Test) which provides the direct information of the measuring point of the ground. MASW results were known to have close relationship with the ground stiffness. This correlation was confirmed through the comparison of MASW data obtained from two survey lines to the laboratory test with extracted soil samples. 3D physical property distribution in the study area was acquired by geostatistical integrated analysis with the data of tip resistance ($q_c$) and pore pressure (u) from the CPTu obtained at 6 points within the study area. The integrated analysis was conducted by applying the COSGSIM (Sequential Gaussian Co-Simulation) technology which can carry out the simulation in accordance with the spatial correlation between the MASW results and both tip resistance and pore pressure. Besides the locations of CPTu, borehole investigations were also conducted at two different positions. As a result, the N value of SPT and borehole log could be secured, so these data were used for the analysis of the geotechnical engineering accuracy of the integrated analysis result. For the verification of reliability of the 3D distribution of tip resistance and pore pressure secured through integrated analysis, the geotechnical information gained from the two drilling areas was compared, and the result showed extremely high correlation.

• Journal of Korean Society of Forest Science
• /
• v.110 no.3
• /
• pp.419-430
• /
• 2021

This study investigated spatiotemporal trends of sediment-related disasters in North Korea from 1960 to 2019 and post-disaster recovery cases based on a literature review and satellite images. Results showed that occurrence status of sediment-related disasters was initially externally reported in 1995 (during the Kim Jongil era); their main triggering factor was heavy summer rainfall. Furthermore, forest degradation rate was positively correlated with population density (R² = 0.4347, p = 0.02) and occurrence number of sediment-related disasters was relatively high on the west coast region, where both variables showed high values. This indicates that human activity was a major cause of forest degradation and thus, significantly affected sediment-related disasters in mountain regions. Finally, sediment- related disasters due to shallow landslides, debris flow, and slow-moving landslides were observed in undisturbed forest regions and human-impacted forest regions, including terraced fields, opencast mines, forest roads, and post-wildfire areas, via satellite image analysis. These disaster-hit areas remained mostly abandoned without any recovery works, whereas hillside erosion control work (e.g., treeplanting with terracing) or torrent erosion control work (e.g., check dam, debris flow guide bank) were implemented in certain areas. These findings can provide reference information to expand inter-Korean exchange and cooperation in forest rehabilitation and erosion control works of North Korea.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.19 no.11
• /
• pp.481-487
• /
• 2018

This paper proposes a method to detect and monitor the land creeping area using a UAV to analyze the damaged area efficiently. Using a UAV, it was possible to secure the safety of the investigators before the field survey and effectively utilize it to establish an investigation plan because an orthophoto can be used to detect and scale the cracks in a land creeping area. In addition, it was possible to analyze the scale of the crack quantitatively by extracting the topographic information from the orthophoto. The study sites were found to have a total crack area of 1.01 ha, a length of 1.07 km, an average width of 10 m, and a step distance of 1 to 10 m. Periodic UAV measurements can be used to detect displacements on the land creeping area and monitor the direction and scale of crack spread. Therefore, it is expected to be used effectively during recovery planning. Applying the UAV to the land creeping area resulted in the qualitative and quantitative results quickly and easily in dangerous mountainous watersheds. Therefore, it is expected that it will contribute to the development of related industries because of the high availability of a UAV in forest soil sediment disasters, such as landslides, debris flow, and land creeping area.

• Resources Recycling
• /
• v.28 no.4
• /
• pp.59-64
• /
• 2019

This study suggests a conceptual strategy and methodology for the risk assessment of the domestic abandoned mine fillers with fly ash. The fillers are composed of coal fly ash and solidification materials, and contain little toxic substances such as carbonates but also some heavy metals; therefore, those requires a risk assessment. The risk assessment should primarily focus on estimation of the effects to human health both on carcinogen and non-carcinogen aspects. The significant data such as toxicity and partition coefficients can be obtained from the national soil or mine environmental risk assessment guidelines. Accurate risk assessment of heavy metal contamination in the fillers may consume lots of time and efforts through site survey and instrumental analyses, etc. Moreover, it is inefficient to explore all of the factors as concentrations and categories in every heavy metal in the fillers, due to a high variety and complexity. Therefore, implementation of a preliminary risk assessment is suggested by using the literature data and the basic characteristics of the filler samples prior to the detailed risk assessment. Certainly, this presumes a thorough understanding of reliable sample analysis methods, exposure pathways, and relevant physicochemical and biological mechanisms.

• Journal of the Korean Society of Mineral and Energy Resources Engineers
• /
• v.55 no.6
• /
• pp.576-587
• /
• 2018

This study has focused on analysis factors affecting safety monitoring system at tailings sites, and the evaluation equipment to monitor the factors. Twenty sites at eighteen mines with unsafe conditions were selected to examine the equipment. There were three main factors influenced safety in the sites including surface erosion, piping, and slope instability. In detail, the surface erosion was divided into three sub-factors (planting, soil-topping layer, and tailings), piping into three sub-factors (liner, rain protection facility and leachate), and slop instability was also divided into three sub-factors (slop, concrete wall, and reinforcing wall). As results of in-field measurement, a CCTV was the most effective facility, and electrical resistivity survey, acoustic sensing, thermal liner sensor, structure inclinometer, rainfall meter, and flowmeter were also highly effective. According to applications of the facilities in the unstable tailings, structural defects were mainly found in the piping, which was the most important monitoring factor for safety management of tailings sites.