• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.38 no.2
• /
• pp.141-151
• /
• 2020

Since it was first studied in 1980, solar energy analysis model for geographic information systems has been used to determine the approximate spatial distribution of terrain. However, the spatial pattern was not able to be grasped in 3D (three-dimensional) space with low accuracy due to the limitation of input data. Because of computational efficiency, using a constant value for the brightness of the sky caused the simulation results to be less reliable especially when the slope is high or buildings are crowded around. For the above reasons, this study proposed a model that predicts solar energy of vertical surfaces of buildings with four stages below. Firstly, CIE (Commission Internationale de l'Eclairage) luminance distribution model was used to calculate the brightness distribution of the sky using NREL (National Renewable Energy Laboratory) solar tracking algorithm. Secondly, we suggested a method of calculating the shadow effect using ray tracing. Thirdly, LOD (Level of Detail) 3 of 3D spatial data was used as input data for analysis. Lastly, the accuracy was evaluated based on the atmospheric radiation data collected through the ground observation equipment in Daejeon, South Korea. As a result of evaluating the accuracy, NMBE was 5.14%, RMSE 11.12, and CVRMSE 7.09%.

• Journal of Power System Engineering
• /
• v.4 no.2
• /
• pp.40-45
• /
• 2000

Some engineering materials are often known to have considerable spatial variation in their resisting strength and other properties. The objective of this study is to investigate the averaging effect and the applicability of extremal statistic for the statistical size effect. In the present study, it is assumed that the material property is a stationary random process in space. The theoretical autocorrelation function of the material strength are discussed for several correlation lengths. And, in order to investigate the statistical size effect, the material properties was simulated by using the non-Gaussian random process method. The material properties were plotted on the Weibull probability papers. The main results are summarized as follows: The autocorrelation function of the material properties are almost independent of the averaging length. The variance decreases with increasing the averaging length. As correlation length is smaller, the slope is larger. And also, it was found that Weibull statistics based on the weakest-link model could not explain the spatial variation of material properties with respect to the size effect satisfactory.

• The Korean Journal of Applied Statistics
• /
• v.11 no.1
• /
• pp.163-175
• /
• 1998

The change of hazard rates at some unknown time point has been the interest of many statisticians. But it was restricted to the constant hazard rates which correspond to the exponential distribution. In this paper we generalize the change-point model in which any specific functional forms of hazard rates are net assumed. The assumed model includes various types of changes before and after the unknown time point. The Nelson estimator of cumulative hazard function is introduced. We estimate the change-point maximizing slope changes of Nelson estimator. Consistency and asymptotic distribution of bootstrap estimator are obtained using the martingale theory. Through a Monte Carlo study we check the performance of the proposed method. We also explain the proposed method using the Stanford Heart Transplant Data set.

• Journal of Wetlands Research
• /
• v.10 no.1
• /
• pp.21-30
• /
• 2008

Evapotranspiration is an important factor in the energy interaction process between the surface and the air. Over a vegetable canopy, evapotranspiration was investigated by measuring the sensible heat flux, the soil heat flux and the net radiation flux. Evapotranspiration based on routine AWS data is in good agreement with that estimated from the energy balance equation except for weak wind shear less than $1s^{-1}$ and a cloudy period. Soil heat flux can be approximately to 10% of net radiation flux at the lower layer. When the slope of the saturation vapor pressure versus temperature curve ($de_s/dT$) is approximated to 1.5, the evapotranspiration can be described in function of the net radiation energy flux over Goheung bay wetland covered with the vegetable canopy, reeds.

• Proceedings of the KSRS Conference
• /
• 2005.10a
• /
• pp.325-328
• /
• 2005

To estimate presumptive local ground subsidence area near Abandoned Under ground Coal Mine(AUCM) at Samcheok city in Korea, the geological properties of existing ground subsidence area and the geophysical prospecting data were analyzed using GIS. The electrical resistivity survey and seismic reflection survey database were constructed from investigation reports and factors which are related with ground subsidence such as geological map, topological map, land use map, lineament map, groundwater level, RMR (Rock Mass Rating), mining tunnel map and slope database were constructed also to make a comparative study of each parameters. As a result of the spatial analysis of existing ground subsidence area, 9 major factors causing ground subsidence were extracted and a connection between the structure of underground and the ground subsidence was determined from the analysis of geophysical prospecting data. The estimation of presumptive ground subsidence area was performed using the correlation between the result from neural network analysis of 9 factors and the scrutiny of geophysical prospecting data.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.6 no.1
• /
• pp.80-89
• /
• 1998

The residual gas in an spark-ignition engine is one of important factors on emissions and performance such as combustion stability. With high residual gas fractions, flame speed and maximum combustion temperature are decreased and these are deeply related with combustion stability especially at idle and NOx emission at relatively high engine load. Therefore, there is a need to characterize the residual gas fraction as a function of the engine operating load. Therefore, there is a need to characterize the residual gas fraction as a function of the engine operating parameters. In the present study, the quantitative measurement technique of residual gas fraction was studied by using Fast Response Flame Ionization Detector(FRFID). The measuring technique and model for estimation of residual gas fraction were reported in this paper. By the assuming that the raw signal from FRFID saturates with the same slope for firing and misfiring cycle, in-cylinder hydrocarbon(HC) concentration can be estimated. Residual gas fraction can be obtained from the in-cylinder HC concentration measured at firing and motoring condition. The developed measurement and calibration procedure were applied to the limited engine operating and design condition such as intake manifold pressure and valve overlap. The results show relevant trends by comparing those from previous studies.

• Journal of Environmental Impact Assessment
• /
• v.21 no.5
• /
• pp.801-811
• /
• 2012

For biodiversity conservation, Biological Impact Assessment is very important. The focus of the study is to enhance efficient Environment Impact Assessment(EIA) based on collecting existing information of endangered species covering the status survey, estimation of effects and reducing methods. Habitat Suitability Index(HSI) can be applicable to Ecological Impact Assessment and finding various reducing methods based on estimating effects. For this study, the EIA report of Samjang - Sanchung highway construction was chosen as an example and Prionailurus bengalensis euptilura as an endangered species was chosen to assess the ecosystem impact on road construction. Water, road, ground coverage, slope, altitude as variables of habitat were weighted and final HSI map was calculated using Arc map and Arc view. Through comparing of before and after HSI, quantitative estimating on effects was possible to minimize impact of road construction to wildlife habitat.

• The Journal of the Acoustical Society of Korea
• /
• v.20 no.7
• /
• pp.3-12
• /
• 2001

It is known that the roughness is one of the most important metrics in assessing the sound quality. In this study, a new roughness model is suggested by combing the previous auditory filter model and several signal processing methods for the enhancement of calculation efficiency and accuracy. For testing the usefulness of the present model, the predicted responses are compared with the experimental data and it is observed that they are in good agreements. Also, it is found that the previous models have limitations to search frequency components mainly contributed to overall roughness. By modifying the correlation criteria of the present model, the revised model for the proper estimation of roughness-contributed components is embedded.

• Journal of Korean Society for Atmospheric Environment
• /
• v.18 no.4
• /
• pp.265-274
• /
• 2002

The concentrations of polychlorinated biphenyls (PCBs) in air and plant were measured every other week at Hankyong University located in Ansung, Kyoung-ki province from July to November of 1999. The predicted PCB concentrations in air derived from measured Morus allba were compared with ambient measurement data. This was necessary to test the possibility of using the two equations incorporating Riederer's and Bacci's bioconcentration factors (BCFs) based on the octanol-air partition coefficient (Ksub/oa/) to predict the air-plant equilibrium of PCBs. Ratios of calculated to measured PCB concentrations in air were 2.4 (1.24~4.36), 2.7 (0.17~7.96) using Riederer's and Bacci's equations, respectively Regression analysis between PCBs calculated by Riederer's equation and PCBs directly measured in air, showed correlation ($R^2$= 0.90). However, slope of regression between calculated and directly measured PCB concentrations was above 1. The results thus suggest that calculated PCBs were overestimated comparing with direct measurements. Bio-monitoring using Morus allba may have possibilities in predicting PCBs concentration in air with a further extension of air-plant equilibrium research.

• Proceedings of the KSRS Conference
• /
• v.2
• /
• pp.717-720
• /
• 2006

In this study, we predicted locations vulnerable to ground subsidence hazard using fuzzy logic and geographic information system (GIS). Test was carried out at an abandoned underground coal mine in Samcheok City, Korea. Estimation of relative ratings of eight major factors influencing subsidence and determination of effective fuzzy operators are presented. Eight major factors causing ground subsidence were extracted and constructed as a spatial database using the spatial analysis and the probability analysis functions. The eight factors include geology, slope, landuse, depth of mined tunnel, distance from mined tunnel, RMR, permeability, and depth of ground water. A frequency ratio model was applied to calculate relative rating of each factor, and the ratings were integrated using fuzzy membership function and five different fuzzy operators to produce a ground subsidence susceptibility map. The ground subsidence susceptibility map was verified by comparing it with the existing ground subsidences. The obtained susceptibility map well agreed with the actual ground subsidence areas. Especially, ${\gamma}-operator$ and algebraic product operator were the most effective among the tested fuzzy operators.