• 한국건설순환자원학회지
• /
• 제15권3호
• /
• pp.60-65
• /
• 2020

• 한국철도학회논문집
• /
• 제9권2호
• /
• pp.174-179
• /
• 2006

Recently, the crossing tunnel has been constructed frequently to connect the separated area by highway and railroad. The construction of crossing tunnel must be progressed while maintaining the existing traffic of the highway as well as railroad. There are many cross funnelling methods such as NTR, TRCM, Messer Shield, Front Jacking, and Pipe Roof Method. The advantages of adopting RPS(Roof Panel Shield) method in crossing tunnel construction with comparing other existing cross funnelling methods are needed a little volume of concrete and easy to change the direction of cutting shoe during the construction of pipe roof, The 3-dimensional numerical analysis of RPS to consider the arching effect was performed for the application in the crossing tunnel under railroad. The earth pressure distribution and settlement were predicted when the RPS method was applied during the excavation for crossing railroad tunnel construction.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• 제2권2호
• /
• pp.82-102
• /
• 2008

Packet losses tend to occur during short error bursts separated by long periods of relatively error-free transmission. There is also a significant spatial correlation in loss among the receiver nodes in a multicast session. To recover packet transmission errors at the transport layer, tree-based protocols construct a logical tree for error recovery before data transmission is started. The current tree construction scheme does not scale well because it overloads the sender node. We propose a scalable recovery tree construction scheme considering these properties. Unlike the existing tree construction schemes, our scheme distributes some tasks normally handled by the sender node to specific nodes acting as repair node distributors. It also allows receiver nodes to adaptively re-select their repair node when they experience unacceptable error recovery delay. Simulation results show that our scheme constructs the logical tree with reduced message and time overhead. Our analysis also indicates that it provides fast error recovery, since it can reduce the number of additional retransmissions from its upstream repair nodes or sender node.

• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2011년도 춘계 학술논문 발표대회 1부
• /
• pp.173-175
• /
• 2011

A study is for improvement in practical use of RFID+4D. In the yard of construction industry, using information has become more important part to control total process. One of the way to improve the information using that comes from each step, RFID is getting attention. But it's not really adapted on construction industry. Especially, a study on the curtain wall part has a problem of engineering process. Each steps of curtain wall process are separated. If it' could be connect totally, controling information of curtain wall from producing to fitting become more efficient with adapted RFID+4D.

• 품질경영학회지
• /
• 제38권3호
• /
• pp.463-474
• /
• 2010

In this study, we evaluate the efficiency of Construction Industry using Data Envelopment Analysis(DEA). Since the Construction Industry has been traditionally operated through competition, it is important to measure the efficiency. In this paper, we empirically analyze the Efficiency of the 50 Korean Construction Industry. In detail, we used the scale of efficiency in order that efficiency cannot be affected by the total technical efficiency of each company and the scale of DMU by applying CCR or BBC model. Also, we analyzed the changes of measurement DEA model score. we adopted the basic DEA, RTS Region and MPSS(Most Productive Scale Size) method which are combined with efficiency measurement model in order to analyze the operational status. Furthermore, by complementing the shortfalls of the scale efficiency value of the DEA Model, RTS Region Model can be recommended to be appropriate in the evaluation of ideal input/output Quantity. In particular, input variables are total assets, construction capacity, the technical staff and output variables are sales volume, operating income. The result of RTS Region and MPSS shows that 9 DMUs of the efficiency frontier in the Construction Industry are analyzed to be relatively efficient DMUs, and 41 DMUs are analyzed to be inefficient DMUs, and finally inefficient DMUs are separated with Region 1 and Region 6.

• Journal of Biosystems Engineering
• /
• 제26권2호
• /
• pp.131-140
• /
• 2001

This study was conducted to develop a garlic separator which could to reduce the labor in preparation of seeding. After consideration of the design criteria of a garlic separator such as no additional conveying device, simple construction and operation, enhancement of separating efficiency, reduction of damage, degree a rotating corn type garlic separator was designed. The effects of design parameters such as height and angle of the inner and outer corns, rotating speed of inner corn on the separating performance of the prototype were estimated. In performance was compared with manual work. The results are summarized as follows. 1. Garlic bulbs were separated by a spiral movement in the gap between inner rotating corn and outer fixed corn. At constant feed rate of garlic bulbs, the capacity of garlic separation increased with increase of rotating speed of inner corn. Especially, the capacity was very high at the rotating speeds of 300 and 400rpm. 2. The damage degree of separated garlics increased with rotating speed of corn within 10%. Above 300rpm, separability of Uisung garlic was about 100% and incomplete separation of Namdo garlic was within 2%. 3. The capacity of prototype garlic separator developed in this study was 30 times as large as that of human being.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2003년도 봄 학술발표회 논문집
• /
• pp.447-454
• /
• 2003

In this test, two separated oil jacks were placed at bottom of drilled shaft(D = 1,500mm, L = 33m), and maximum upward and downward load of 1,250 tonf was applied. Also, the deformable rod sensors were placed on each level, and axial strains at each level were measured. Because the side skin friction and the end bearing could be measured separately in the Osterberg type pile load test, this test might be more economical and more applicable than a conventional static pile load test. Thus, if this Osterberg type pile load test could be established during design stage, construction cost might be reduced and its application for large diameter pile could be enhance greatly.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 1994년도 가을 학술발표회 논문집
• /
• pp.225-230
• /
• 1994

This paper concerns a case study on the design concept, analysis, construction methodology of a subway tunnel excavated in the soft ground beneath an existing building where the distance between the bottom of the building and the crown of the tunnel is separated by about 3 meters only. The silot tunnels are excavated in advance, and side reinforced-concrete walls are installed. Then, main tunnels are excavated with ring cut method. The steel ribs are installed and supported by the side walls made in advance. Between the steel ribs and the side walls, the screw jack is installed to apply prestressing so that settlement can be controlled at minimum. Various in-situ seasurements are made and compared with computed values obtained by numerical methods. By choosing this underpinning method with very caraful construction control, tunnelling projects could be finished successfully without having any damage to the building located very closely to the tunnel crown.

• 한국정보시스템학회지:정보시스템연구
• /
• 제7권1호
• /
• pp.129-158
• /
• 1998

By investigating various information promotion plans by Taegu Metropolitan City Government, Kyungbuk Provincial Government or by the ministry of Agricultural, Forestry, and Fishery Affairs, this paper intends to analyze current trends of information approached from wider perspective, and to propose multi-layered alternatives which improve informatization promulgation in rural areas of Taegu, Kyungbuk areas. This research proposes following 6 alternatives, as informatization strategies to develop rural economics ; (1) construction of Agricultural Techno Park to advance and develop informatization in rural areas, (2) construction of communication super highway to strengthen information infrastructure, (3) construction of region-specific information system to provide agricultural information unique to its region or areas, (4) provision of agriculture-related information by establishing regional information centers separated by regions like North, South, Eastern regions etc., (5) establishment information, (6) establishment of information gallery of village to provide information needed. And this research also investigates specific contents progresses of various plans by various actors.

• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2011년도 춘계 학술논문 발표대회 1부
• /
• pp.99-101
• /
• 2011

In order to have pumping technology for high speed construction of tall building, study for quantitative evaluation of flow characteristics and pumpability should be conducted. So, this study evaluate the characteristics among the inner pipe pressure, fresh concrete properties and separated mortar through the continuous pumping test. Then it consider of relations between rheological properties and pumpability. In the result of test, it found that there are high interrelationship between the rheological characteristics which represented plastic viscosity and pressure lose by pipe length.