• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2018.05a
• /
• pp.63-64
• /
• 2018

In this study, a design method for a circular polarization patch antenna operating at a frequency 1.5 GHz~1.7 GHz was studied. To obtain the wide bandwidth and high gain, air substrate between patch and ground plane was applied. The impedance bandwidth is improved by adjusting the sizes of patch, the distance between main patch and ground plate, the length of internal slots, the position of feeding point, the length of external stub, etc. The antenna is designed and simulated for an operation in the frequency range of 1.5GHz~1.7GHz band. The results show that antenna characteristics such as return loss, gain, axial ratio, radiation patterns are appropriate for the satellite navigation system.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.37 no.2
• /
• pp.83-90
• /
• 2000

In this paper, a stacked circular-disk microstrip 1${\times}$4 array antenna was designed and manufactured and tested to apply in next generation mobile communication, on IMT-2000 system(up-link: 1.885 GHz∼2.025 GHz, down-link: 2.11 GHz∼2.2 GHz) base station which has dual frequency, broadband and high-gain characteristics. The experimental results are as follows : resonant frequency of 1.885 GHz and 2.178 GHz VSWR (1.064 , 1.432), return loss (-30.19 dB , -24.99 dB), band width (VSWR<2) are 402 MHz, -3dB beam width at radiation pattern are ${\alpha}$E-16.8$^{\circ}$, ${\alpha}$H-69$^{\circ}$(1.885 GHz) and ${\alpha}$E-l5.2$^{\circ}$, ${\alpha}$H-51.5$^{\circ}$(2.178 GHz), gain(13.7 dBi∼15.21 dBi).

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.20 no.9
• /
• pp.1014-1020
• /
• 2009

In this paper, a novel UWB(Ultra Wide-band) antenna with suppressed band of IEEE 802.11a($5.15{\sim}5.825\;GHz$) WLAN was designed and fabricated by using SRR(Split Ring Resonator) with band rejection property. MWS(Micro-wave Studio) of CST company was utilized in the design stage. The antenna was fabricated on a substrate, Rogers 4003, with the thickness of 0.8 mm and relative permittivity of 3.38. The measured result shows that the proposed antenna has a good return loss below -10 dB and group delay below 1nsec over UWB communication band($3.1{\sim}10.6\;GHz$) except WLAN band. It also shows the omni-directional radiation pattern.

• Journal of Gastric Cancer
• /
• v.6 no.3
• /
• pp.193-197
• /
• 2006

Melanoma is a malignant neoplasm of melanocytes most frequently arising from the skin, but primary melanoma can also arise from the mucosa of the gastrointestinal tract. Gastrointestinal melanomas are most commonly metastases from a cutaneous melanoma. Primary melanoma of the stomach is rare and carries a poor prognosis. Reported here is the case of a 75-year-old man with a primary gastric melanoma who presented with a melena, abdominal pain, and weight loss. Most cases of melanoma are treated by excision of the primary tumor. Patients with melanoma have been treated with adjuvant chemotherapy, radiation therapy, and immunotherapy. None of these modalities has been demonstrated to prolong the survival rate. To improve long-term disease-free survival, early diagnosis and surgical intervention are very important.

• KIEAE Journal
• /
• v.16 no.6
• /
• pp.167-172
• /
• 2016

Purpose: The solar water heater with natural circulation has been used for several decades in the world as it is automatically operated without a pump and controller and is easy to maintain and repair. After the subsidy was offered from 2012, the solar water heater with natural circulation is becoming increasingly popular in Korea. Recently, the development of a wall-integrated solar water heater, which improves the applicability of buildings and prevents the overheating in the summer, is being developed. On the other hand, the design and performance evaluation data of solar water heaters are very inadequate, and analysis of heat and flow is required to develop a new type of solar water heater. Method: Therefore, in this study, we proposed a new simplified system analysis model that reflects heat and pressure loss from the test results of KS B ISO 9806-1 (Solar collector test method), assuming that the collector is a simple pipe system, the validity of which was verified through experiments. Result: As a result, first, the RMSE of the system circulation flow rate and the average temperature of the inlet and outlet of the collector according to the experimental results and the simulation are 0.05563 and 0.88530, respectively, which are very consistent. Secondly, the mass flow rate is increased linearly with the increase of the solar radiation, and the mass flow rate is 0.0104 ~ 0.0180kg/s in the range of $200{\sim}380W/m^2$ of solar irradiance. Compared with the test flow rate 0.0764kg / s of the test collector, it showed a level of less than 20%.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.16 no.1 s.92
• /
• pp.66-77
• /
• 2005

This paper proposed a novel broadband PIFA(Planar Inverted-F Antenna) for IMT-2000/WLAN/DMB terminal. Two branch lines for meander line were utilized in order to improve the characteristics of PIFA which usually has a narrow band. The shorting strip between the ground plane and meander-type radiation elements were used in order to minimize the size of the antenna. The -10 dB return loss bandwidth of a realized antenna was $38.2{\%}$(1.84~2.71 GHz), which contains the broadband bandwidth with triple band. And the simulated and measured values of 1 g and 10 g averaged peak SAR on human head caused by the triple band PIFA mounted on folder-type handsets were analyzed and discussed. As a result, the measured 1 g and 10 g averaged peak SARs of PIFA were similar with the simulated values and were lower than the 1.6 W/kg and 2 W/kg of 1 g and 10 g averaged peak SAR limits.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.21 no.12
• /
• pp.3205-3214
• /
• 1996

In this paper, the microstrip phased array antennas with coupling-slots for the base station of mobile communication is proposed and anlyzed with accurate analysis method which is based on both reciprocity principle and full-wave analysis. The basis functions used for the numerical analysis are determined depending upon the accuracy, convergence properties of the solution, and the computation time. The patch uses 3 EB mode and the slot uses IPWS mode. The designed phased array antenna has 8 slot-coupled microstrip patch array elements and the beam scanning capability is obtained by using the 4-bit PIN-diode phase shifters as switching devices which are consisted of the loaded line phase shifters for 30.deg. and 60.deg. and the reflection type phase shifters for 90.deg. and 180.deg. repectively. The 4-bits phase shifters which aremade by connecting each phase shifter have about 2.deg.-3.deg. phase errors and their insertion loss are about 3dB for each phase state. The fabricated 8-element phased array antenna with 4-bits phase shifters provides 12.deg.-14.deg. beamwidths depending on the scanning angle and is capable of scanning its beam to .+-.45.deg. with 9.deg. intervals, and the gain 12dBi. The overall results show that the slot-coupled phased array antenna has great advantages of wideband, high gain and reduced spurious radiation. Also, the antenna can be made small and thin. Furthermore, the scanning property of this antenna allows for its application in several areas, such as mobile communication system and PCS.

• Journal of Hydrogen and New Energy
• /
• v.29 no.4
• /
• pp.386-392
• /
• 2018

Fuel cells are known as eco - friendly energy facilities that can use heat energy and electric energy at the same time. Fuel cells are classified according to the temperature and material used, and solid oxide fuel cell (SOFC) is relatively high temperature ($700-800^{\circ}C$). SOFC requires a hot box consisting of a high temperature stack, a reformer, a burner, and the heat exchangers in order to use energy efficiently. The hot box needs to maintain heat insulation performance at high temperature to reduce heat loss. However, Fibrous insulation, which is widely used, needs to be improved because it has a disadvantage that the thermal conductivity is rapidly increased due to the increase of temperature. Therefore, this study was carried out to develop a thermal insulation, which is applied to multiple layers insulation (MLI) technic, that can be used under SOFC operating conditions and prevent a drastic drop in thermal conductivity at high temperature. The developed insulation is consist of a thermally conductive material, a spacer, and a reflective plate. The thermal conductivity of the insulation was measured by in the thermal conductivity measuring device at high temperature range. As a result, it was confirmed that the developed layers insulation have an good thermal conductivity (0.116 W/mK) than fibrous insulation (0.24 W/mK) as a radiation shielding effect at a high temperature of 1,173 K.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.45 no.1
• /
• pp.85-90
• /
• 2008

In this paper, we studied on dual reflector adjusted to monopulse antenna system. As a result, when the efficiency of main reflector is more than 70%, The size of reflector is 30 wavelength of maximum frequency and minimum frequency gain is 37.9dBi, and Maximum frequency gain is 38.6dBi. Also, when a radius is D and Focus-distance is $F_e$, a scheme for efficiency improvement of Sub Reflector is to increase the Focus-distance to Diameter Ratio. In this case, Cross polarization in Far field improved and spherical spreading loss in circumference of reflector reduced. The influence of Radiation pattern followed by the side displacement of feed antenna(at $x_sy_s$) is decreased, it is confirmed that performance of scanning is improved.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.16 no.11 s.102
• /
• pp.1086-1098
• /
• 2005

Two types of small wideband antennas are proposed for UWB application. One type is small biconical structure fed by coaxial probe, which is easy to be installed on the circuit board. The other type is of planar bow-tie type fed by coplanar transmission line. Generally, the bandwidth of the latter type is significantly narrower than that of the former type. It is shown, however that the bandwidth of the latter type can be made to be comparable to that of the former, if some series inductive component is introduced in the center conductor line in the CPW transmission line by replacing some part of center line with narrower line of higher characteristic impedance. The series inductance component play an important role of neutralizing the capacitive component of the small bow-tie antenna, thereby making broadband impedance matching possible. The small planar bow-tie antenna was fabricated and experimented. The experimental results for return loss are observed to be in good agreement with simulated results. The radiation pattern is also investigated experimentally.