• 한국구조물진단유지관리공학회 논문집
• /
• 제18권1호
• /
• pp.166-173
• /
• 2014

본 연구에서는 레이저 가진을 이용한 초음파 전파 영상 기반 배관 비파괴 검사에 관해 다룬다. 손상의 영상화를 위해 갈바노미터 기반 레이저 미러 스캐너와 Q-Switch Nd: YAG 레이저 시스템을 사용하였다. 레이저 시스템을 가진원으로 사용하면 빠른 속도로 비접촉 초음파 가진이 가능하며, 온도의 변화가 급격한 환경이나 유해 물질이 포함된 환경에서도 대상 구조물의 원거리 가진이 가능하다. 또한 공간 해상도가 높으며, 입사각이 넓어 표면 형상이 복잡한 대상 구조물도 가진이 가능하다. 본 연구에서는 이러한 레이저 시스템으로부터 생성된 유도 초음파를 단일 PZT 센서를 사용하여 계측하고, 계측된 신호는 레이저 가진점에 해당하는 좌표점에 나열함으로써 2차원 공간좌표 및 시간축을 더한 초음파 전파 영상 생성을 위한 3차원 데이터를 구성한다. 이 데이터를 시간 축에 따라 연속적으로 반복 재생하면 초음파 전파 영상을 구할 수 있다. 이 때 웨이블릿 변환을 이용하여 계측 신호의 특정 주파수 성분을 추출해냄으로써 관찰하고자 하는 특정 유도 초음파 모드를 추출할 수 있다. 이러한 일련의 과정으로부터 획득한 초음파 전파 영상 데이터를 시간-공간 영역에서 주파수-wavenumber 영역으로 변환시켜줌으로써 손상 특성을 추출할 수 있다. 본 연구에서는 손상의 진단 및 위치 추정을 위해 wavenumber 필터링 기술을 적용하였으며, 시스템 검증을 위해 다양한 배관구조물 Testbed를 대상으로 실험을 수행하였다.

• 한국광학회지
• /
• 제10권5호
• /
• pp.391-395
• /
• 1999

4% 물의 MgO가 도핑된 광굴절 $LiNbO_3$ 결정에 기록된 광굴절 격자의 회절 효율과 응답시간을 측정하였다. 이 실험에는 고출력 펄스 Nd:YAG 레이저(Q-switch mode,$\lambda$=532nm)와 연속 발진 아르곤 이온 레이저($\lambda$=514.5nm)가 사용되었다. 두 종류의 레이저 광속에 대한 실험에서 광학계의 배열을 동일하게 하고 2광파 혼합 조건에서 레이저 광속의 세기를 1.6~100W/$\textrm{cm}^2$까지 변화시켜가며 최대 회절 효율과 기록 및 소거시의 응답시간을 측정하였다. 두 실험에서 얻은 결과를 비교하고 분석 하였다.

• 전기학회논문지
• /
• 제65권5호
• /
• pp.785-793
• /
• 2016

This paper analyzes an LCL-type isolated dc-dc converter operating for constant output voltage in the continuous conduction mode(CCM) with resistances of parasitic losses-static drain-source on resistance of power switch, ESR of resonant network(L-C-L)-using a high loaded quality factor Q assumptions and fourier series techniques. Simple analytical expressions for performance characteristics are derived under steady-state conditions for designing and understanding the behavior of the proposed converter. The voltage-driven rectifier is analyzed, taking into account the diode threshold voltage and the diode forward resistance. Experimental results measured for a proposed converter at low input voltage and various load resistances show agreement to the theoretical performance predicted by the analysis within maximum 4% error. Especially in the case of low output voltages and large loads, It is been observed that introduction of both rectifier and the parasitic components of converter had considerable effect on the performance.

• BMB Reports
• /
• 제38권3호
• /
• pp.266-274
• /
• 2005

High temperature requirement A (HtrA) and its homologues constitute the HtrA familiy proteins, a group of heat shock-induced serine proteases. Bacterial HtrA proteins perform crucial functions with regard to protein quality control in the periplasmic space, functioning as both molecular chaperones and proteases. In contrast to other bacterial quality control proteins, including ClpXP, ClpAP, and HslUV, HtrA proteins contain no regulatory components or ATP binding domains. Thus, they are commonly referred to as ATP-independent chaperone proteases. Whereas the function of ATP-dependent chaperone-proteases is regulated by ATP hydrolysis, HtrA exhibits a PDZ domain and a temperature-dependent switch mechanism, which effects the change in its function from molecular chaperone to protease. This mechanism is also related to substrate recognition and the fine control of its function. Structural and biochemical analyses of the three HtrA proteins, DegP, DegQ, and DegS, have provided us with clues as to the functional regulation of HtrA proteins, as well as their roles in protein quality control at atomic scales. The objective of this brief review is to discuss some of the recent studies which have been conducted regarding the structure and function of these HtrA proteins, and to compare their roles in the context of protein quality control.

• 대한전기학회논문지:전기기기및에너지변환시스템부문B
• /
• 제54권12호
• /
• pp.609-615
• /
• 2005

A 30kW electrical power conversion system is developed for a variable speed wind turbine. In the wind energy conversion system(WECS) a synchronous generator with field current excitation converts the mechanical energy into electrical energy. As the voltage and the frequency of the generator output vary according to the wind speed, a 6-bridge diode rectifier and a PWM boost chopper is utilized as an ac-dc converter maintaining the constant dc-link voltage with only single switch control. An input current control algorithm for maximum power generation during the variable speed operation is proposed without any usage of speed sensor. Grid connection type PWM inverter converts dc input power to ac output currents into the grid. The active power to the grid is controlled by q-axis current and the reactive power is controlled by d-axis current with appropriate decoupling. The phase angle of utility voltage is detected using software PLL(Phased Locked Loop) in d-q synchronous reference frame. Experimental results from the test of 30kW prototype wind turbine system show that the generator power can be controlled effectively during the variable speed operation without any speed sensor.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1995년도 하계학술대회 논문집 C
• /
• pp.1347-1349
• /
• 1995

Insulators contaminated by salt particles may cause flashovers in humid climate or light rain. Therefore, the quantity of salt on insulators should be monitored not to exceed a critical value. We propose a new remote sensing technique to measure the quantity of salt on insulators of power systems. The amount of the salt is measured from the intensity of the spontaneous emission from the sodium atoms. In this paper, a compact remote on-line salt-meter composed of Q Switch pulsed Nd:YAG laser and emission signal detection system will be introduced. And as the first result of this study, the operating characteristics of our developing laser system is also introduced.

• 한국멀티미디어학회:학술대회논문집
• /
• 한국멀티미디어학회 2000년도 춘계학술발표논문집
• /
• pp.40-48
• /
• 2000

ABR 서비스에서 전송률 제어 방식은 크게 크래딧 방식과 전송률 기반 방식으로 구분되는데, 전송률 기반 방식의 대표적인 스위치 알고리즘인 EPRCA(Enhanced Properties RATE Control Algorithm)를 비롯하여 지금까지 제안된 전송률 기반 폭주제어방법은 대부분 스위치의 평균 큐 길이 Q 에 의한 폭주제어 방식을 사용한다. [2, 6, 8]. 폭주판단방법은 큐 임계치 방식, 부하 임계치 방식, 큐 증가 임계치 방식으로 나눌 수있다. 큐 임게치 만을 사용하는 방법이 가장 일반적이지만, 큐 길이와 큐 임계치의 비교에 따른 지연이 발생하게 된다. 본 논문에서는 큐 길이의 증감 상태를 큐 임계치와 동시에 사용하여 폭주제어를 신속히 할 수 있는 스위치 알고리즘을 제안한다.

• 전기학회논문지
• /
• 제56권3호
• /
• pp.623-628
• /
• 2007

This paper presents the new power line coupler which is applicable to spread spectrum power line communications. The proposed coupler maintains the adequate value of a capacitor between the transmitter mode and the receiver mode using a switch. In the transmit mode, the relatively high value of the capacitor is chosen to minimize the attenuation of transmitted signals. In the receiver mode, the value of the capacitor is chosen to be small enough so that the coupler attenuates power line noises. This coupler reduced the magnitude distortion due to having a high Q value and the power consumption caused by the AC current flowing into the capacitor. The simulation and measurement results show the improved performance in the transmitter and receiver mode, respectively.

• Journal of information and communication convergence engineering
• /
• 제7권3호
• /
• pp.377-382
• /
• 2009

In this paper, theoretical analysis for metropolitan optical networks is performed. First, analytical optical SNR is derived assuming each node consists of an EDFA, an optical filter, an optical switch, and a VOA, and then the relationship between OSNR and BER is studied. In a metropolitan optical network, an optical signal can be dropped to deliver data, and we also studied the effect of drop loss on system performance. When the drop loss is relatively small, the receiver structure of the node can be treated as a preamplifier receiver which is widely used in long-haul systems. In that case, ASE noise from EDFAs is the dominant noise source in the receiver. However, system performance is relatively insensitive to OSNR when the drop loss is significant because of the noise sources in the receiver (thermal and shot noise).

• Journal of Electrical Engineering and Technology
• /
• 제9권1호
• /
• pp.197-204
• /
• 2014

In this paper an Improved Zero Voltage Zero Current Pulse Width Modulation Forward converter which employs a simple resonance snubber circuit is introduced. A simple snubber circuit consists of a capacitor, an inductor and two diodes. In proposed converter, switch Q1 operates at ZCS turn-on, and ZVS turn-off conditions and all-passive semiconductor devices operate at ZVZCS turn-on and turn-off state. The proposed converter is analyzed and various operating modes of the ZVZCS-PWM forward converter are discussed. Analysis and design considerations are presented and the prototype experimental results of a 100w (40 V/2.5A) proposed converter operating at 30 KHz switching frequency confirm the validity of theoretical analysis.