• Journal of Radiation Protection and Research
• /
• v.26 no.1
• /
• pp.19-26
• /
• 2001

In order to assess the atmospheric dispersion for the accidental releases of nuclear power plants, in calculating X/Q values in the XOQAR and PAVAN codes which are based on Reg. Guide 1.145, the X/Q and frequency values are plotted on log-normal paper. Starting with the highest X/Q value of this plot, the codes compare the slope of the line drawn from this point to every other point within an increment containing ten X/Q values. If there are fewer than ten values, only the number available are used. The coefficients that produce the line with the least negative slope are saved. The end point of this line is used as the next starting point, from which slopes to the points within the next increment, containing ten X/Q values, are compared. The X/Q values corresponding to the cumulative frequency values 0.5%, 5% or 50% are calculated to search for the $0{\sim}2$ hour X/Q value that tends to be a very conservative value. In this work, a fuzzy logic inference method is used for nonlinear interpolation of the X/Q values versus the cumulative frequency. The fuzzy logic inference method is known to be a food technique for nonlinear interpolation. The proposed method was applied to a potential accidential radioactive release of the Yonggwang nuclear power plant, which gives more realistic X/Q values.

• Biotechnology and Bioprocess Engineering:BBE
• /
• v.11 no.1
• /
• pp.61-66
• /
• 2006

The simple Langmuir isotherm is frequently employed to describe the equilibrium behavior of protein adsorption on a wide variety of adsorbents. The two adjustable parameters of the Langmuir isotherm - the saturation capacity, or $q_m$, and the dissociation constant, $K_d$ - are usually estimated by fitting the isotherm equation to the equilibrium data acquired from batch equilibration experiments. In this study, we have evaluated the possibility of estimating $q_m$ and $K_d$ for the adsorption of bovine serum albumin to a cation exchanger using batch kinetic data. A rate model predicated on the kinetic form of the Langmuir isotherm, with three adjustable parameters ($q_m,\;K_d$, and a rate constant), was fitted to a single kinetic profile. The value of $q_m$ determined as the result of this approach was quantitatively consistent with the $q_m$ value derived from the traditional batch equilibrium data. However, the $K_d$ value could not be retrieved from the kinetic profile, as the model fit proved insensitive to this parameter. Sensitivity analysis provided significant insight into the identifiability of the three model parameters.

• Bulletin of the Korean Mathematical Society
• /
• v.55 no.6
• /
• pp.1755-1771
• /
• 2018

In this paper, we investigate a certain type of q-difference Riccati equation in the complex plane. We prove that q-difference Riccati equation possesses a one parameter family of meromorphic solutions if it has three distinct meromorphic solutions. Furthermore, we find that all meromorphic solutions of q-difference Riccati equation and corresponding second order linear q-difference equation can be expressed by q-gamma function if this q-difference Riccati equation admits two distinct rational solutions and $q{\in}{\mathbb{C}}$ such that 0 < ${\mid}q{\mid}$ < 1. The growth and value distribution of differences of meromorphic solutions of q-difference Riccati equation are also treated.

• Cartoon and Animation Studies
• /
• s.26
• /
• pp.31-56
• /
• 2012

This is a scientific study of subjectivity on recognition types and preferences of animation audience. Therefore, Q-methodology was used as a methodology of this study. As a result, it was possible to find the various characteristics according to the preferences of audience on animation genres. The features of each type were classified into 3 types. First was an artistic and literary value-oriented type that explored storytelling and descriptive value. Second was a pictorial and aesthetic value-oriented type that explored visual beauty such as characters and Mise en scene. Third was a visual and entertainment value-oriented type that explored entertainment factors and attractions. Thus, according to the classification of preference types, it was inferred that digital image generation audience with an active preference that can create and consume images have developed a tendency that independently consumed their preferences based on thoroughly personal or subjective preferences rather than classified and accepted their preferred culture as their symbolic expressions of hierarchical position. In this aspect, Q-methodological consideration that is useful to analyze the subjectivity of audience could be a significant work. Nevertheless, this study alone could not reveal various generative contexts of specific preferences. It seems to have more significant results by applying various qualitative or quantitative methodologies together with this study and analyzing recognition types and preferences of audience.

• The Korean Journal of Applied Statistics
• /
• v.20 no.1
• /
• pp.1-9
• /
• 2007

This investigation on the change of the daily maxima temperature in Seoul, Daegu, Chunchen, Youngchen was triggered by news items such as the earth is getting warmer and a recent news item that said that Korea is getting warmer due to this climatic change. A statistical analysis on the daily maxima for June over this period in Seoul revealed a positive trend of 1.1190 centigrade over the 45 years, a change of 0.0249 degrees annually. Due to the large variation on these maximum temperatures, one can raise the question on the significance of this increase. To check the goodness of fit of the proposed extreme value model, we shown a Q-Q plot of the observed quantiles against the simulated quantiles and a probability plot. And we calculated statistics each month and a tolerance limit. This is tested through simulating a large number of similar datasets from an Extreme Value distribution which described the observed data very well. Only 0.02% of the simulated datasets showed an increase of this degrees or larger, meaning that the probability is very low for such an event to occur.

• Journal of the Korean Institute of Intelligent Systems
• /
• v.15 no.4
• /
• pp.406-411
• /
• 2005

In this paper, we present the area-based Q-learning to search a target object using multiple robot. To search the target in Markovian space, the robots should recognize their surrounding at where they are located and generate some rules to act upon by themselves. Under area-based Q-learning, a robot, first of all, obtains 6-distances from itself to environment by infrared sensor which are hexagonally allocated around itself. Second, it calculates 6-areas with those distances then take an action, i.e., turn and move toward where the widest space will be guaranteed. After the action is taken, the value of Q will be updated by relative formula at the state. We set up an experimental environment with five small mobile robots, obstacles, and a target object, and tried to search for a target object while navigating in a unknown hallway where some obstacles were placed. In the end of this paper, we presents the results of three algorithms - a random search, area-based action making (ABAM), and hexagonal area-based Q-teaming.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.14 no.5
• /
• pp.1133-1138
• /
• 2010

In the anti-collision scheme proposed by EPCglobal Class-1 Gen-2 standard, the frame size for a query round is determined by Q-algorithm. In the Q-algorithm, the reader calculates a frame size without estimating the number of tags in it's identification range. It uses only the slot status. Therefore, Q-algorithm has advantage that the reader's algorithm is simpler than other algorithms. However, it cannot allocate an optimized frame size because it does not consider the number of tags. Also, the conventional Q-algorithm does not define an optimized parameter value C for adjusting the frame size. In this paper, we propose a modified Q-algorithm and evaluate the performance with computer simulations. The proposed Q-algorithm estimates the number of tags at every query round, and determines the parameter value C based on the estimated number of tags.

• The Journal of Engineering Geology
• /
• v.11 no.2
• /
• pp.175-190
• /
• 2001

This study investigates the existing theoretical backgrounds in order to examine the behavior of lateral flow according to the plasticity of soils when unsymmetrical surcharge is worked on polluted soft soils by comparing and analyzing the results measured through model tests. Model tests are canied out as follows soil tank, bearing frame and bearing plate are made. By increasing unsymmetrical surcharge to the ground soils with the consistent water content and with gradually increased polluted materials at intervals, the amounts of settlement, lateral displacement and upheaval were respectively observed. In conclusion, the value of critical surcharge was expressed as q$_{cr}$=2.78$_{cu}$ which was similar to those Tschebotarioff(q$_{cr}$=3.0$_{cu}$) and Meyerhof(q$_{cr}$=(B/2H+$\pi$/2)$_{cu}$) had been proposed. The value of ultimate capacity was expressed as q$_{ult}$=4.84$_{cu}$ which was similar to that of Prandtl. The lateral flow pressure is adeQuately calculated by the eQuation(P$_{max}$=K$_o$ r H) and the maximum value of lateral flow pressure is found near O.3H of layer thickness(H) and is higher to ground surface than the ones in composition pattern, Poulos distribution pattern and softclay soils (CL, CH) which is not polluted. The stability control method used in this research followed the management diagram of Tominaga.Hashimoto, Shibata.Sekiguchi, Matsuo.Kawamura who use the amounts of plasticity displacement by lateral flow. As a result, the ultimate capacity values in the diagram {S$_v$-(Y$_m$/S$_v$)} of Matsuo.Kawamura and in the diagram {(q/Y$_m$)-q} of Shibata. Sekiguchi were smaller than in the ones of load-settlement curve (q-S$_v$).

• Journal of the Korean Mathematical Society
• /
• v.34 no.1
• /
• pp.247-255
• /
• 1997

In this paper, we are concerned with the existence of positive solutions for the boundary value problems of the form; $$(1) u"(t) + q(t)g(u(t)) = 0, 0 < t < 1 $$ $$ u(0) = 0 = u(1), $$ where q is singular at 0 and /or 1.or 1.

• The KIPS Transactions:PartB
• /
• v.10B no.6
• /
• pp.587-592
• /
• 2003

Many real world control problems have continuous states and actions. When the state space is continuous, the reinforcement learning problems involve very large state space and suffer from memory and time for learning all individual state-action values. These problems need function approximators that reason action about new state from previously experienced states. We introduce Fuzzy Q-Map that is a function approximators for 1 - step Q-learning and is based on fuzzy clustering. Fuzzy Q-Map groups similar states and chooses an action and refers Q value according to membership degree. The centroid and Q value of winner cluster is updated using membership degree and TD(Temporal Difference) error. We applied Fuzzy Q-Map to the mountain car problem and acquired accelerated learning speed.