• Journal of Power Electronics
• /
• 제2권1호
• /
• pp.32-45
• /
• 2002

This paper proposes an unified definition of powers for various circuit conditions such as balanced/unbalanced, sinusoidal/non-sinusoidal, and linear/nonlinear, fur single-phase systems and three-phase systems. Conventional reactive power is more classified into an interactive power and an alternating power. These powers are defined both in the time domain and the frequency domain consistently, and agree well with the conservation law. Several important power quality factors are defined to measure and evaluate the power quality fur the various circuits in the single-phase and three-phase systems. Simulation results show the power quality factors can evaluate and classify the various circuit conditions clearly.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2001년도 Proceedings ICPE 01 2001 International Conference on Power Electronics
• /
• pp.489-496
• /
• 2001

This paper proposes an unified definition of powers for various circuit conditions such as balanced/unbalanced, sinusoidal/non-sinusoidal, and linear/nonlinear, for single-phase systems and three-phase systems. Conventional reactive power is more classified into an interactive power and a scattering power. These powers are defined both in the time domain and the frequency domain consistently, and agree well with the conservation law. Several important power quality factors are defined to measure and evaluate the power quality for the various circuits in the single-phase and three-phase systems. Simulation results show the power quality factors can evaluate and classify the various circuit conditions clearly.

• 한국대기환경학회지
• /
• 제27권5호
• /
• pp.485-493
• /
• 2011

In Korea, PM (Particulate Matter) emissions caused by coal-fired power plants are measured by a system, so called Clean Air Policy Support System (CAPSS), which uses foreign emission factors. However, the system fails to reflect the characteristics of domestic power plants. In this regard, this study aims to develop local, accurate domestic emission factors. The study measured the amount of TSP (Total Suspended Particulates), PM10 and PM2.5 by collecting samples from the latter parts of pollution control devices which were installed at 3 bituminous-fired power plants and 3 anthracite-fired power plants. The results showed that the average concentrations of TSP, PM10 and PM2.5 measured at bituminous-fired power plants were 4.63 mg/$Sm^3$, 2.96 mg/$Sm^3$ and 3.07 mg/$Sm^3$ respectively, much higher than those from anthracite-fired power plants (2.96 mg/$Sm^3$, 2.47 mg/$Sm^3$ and 1.37 mg/$Sm^3$, respectively). In addition, bituminous-fired power plants showed higher ratios of PM10/TSP and PM2.5/TSP with 0.66 and 0.92, respectively, compared to 0.82 and 0.46, the ratios of PM10/TSP and PM2.5/TSP measured in anthracite-fired power plants. Emission factors based-on concentration measurements were also higher for bituminous-fired power plants, and PM with smaller particles tended to have bigger difference in emission factors between the two fuels. This study calculated the amount of PM emissions by using the estimated emission factors. When it comes to the PM emissions, it was less than that of CAPSS while similar to that of CleanSYS in its amount. It is expected that the emission factors developed by this study will be used in Korea replacing foreign emission factors currently used in Korea by ensuring the objectivity and reliability as domestic emission factors.

• 산업경영시스템학회지
• /
• 제23권54호
• /
• pp.167-177
• /
• 2000

The problem of system reliability is very important issue in the nuclear power plant, because the failure of its system brings about extravagant economic loss, environment destruction, and quality loss. This paper therefore proposes a normalized scoring model by the qualitative factors order to evaluate the robust reliability of nuclear power plants under uncertainty. Especially, the qualitative factors including risk, functional, human error, and quality function factors for the robust justification has been also introduced. Finally, the analytical reliability and safety assessment model developed in this paper can be used in the real nuclear power plant.

• 성인간호학회지
• /
• 제29권3호
• /
• pp.290-301
• /
• 2017

Purpose: This study was aimed to identify the level of emotional labor, job stress and professional quality of life and to identify the factors affecting on professional quality of life among nurses in long-term care hospitals. Methods: 136 nurses working at eight different long-term care hospitals were recruited from May 1 to June 30, 2016. Data were analyzed by descriptive statistics, t-test, ANOVA, Pearson correlation, and stepwise multiple regression using SPSS/WIN 22.0. Results: Professional quality of life is consisted of three subcategories as compassion satisfaction, secondary traumatic stress and burn-out. As for the factors affecting on compassion satisfaction, age, satisfaction on working ward and shift pattern of duties were significant factors. The three variables' explanation power on compassion satisfaction was 25.0%. As for factors affecting on secondary traumatic stress, emotional labor was a significant factor. The emotional labor's explanation power on secondary traumatic stress was 13.0%. Factors affecting on burn-out, emotional labor, age, and health condition were significant factors. The three variables' explanation power on burnout is 31.0%. Conclusion: On the basis of results, program development are required to relieve emotional labor and job stress for nurses at long-term care hospitals and to improve their professional quality of life.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2005년도 제36회 하계학술대회 논문집 A
• /
• pp.277-279
• /
• 2005

Recently, due to the increase of power conversion devices and nonlinear loads with the development of information, communication and control technologies, the instantaneous minute interruption factors such as voltage & current harmonics, surge occurring frequency, instantaneous voltage variation, voltage unbalance, flicker etc. have greatly threatened the power quality, and the deterioration of electric power facilities and the functional error of controllers are increasing. As such an instantaneous minute interruption appears to be small and local, accurate evaluation with measurement is difficult and total analysis system is required through a wide range of power quality effect analysis such as the simultaneous measurement on various power supply phenomena and the analysis on the interrelation with system loads. Most of conventional power quality diagnosis equipments have beer developed and applied, which were able to measure the stability rate of frequency, the stability rate of voltage, the electricity-failure duration etc, However, they were insufficient to analyze the system present situation, understand the cause of the failure occurred by the problem of power quality and analyze out the phenomena. Accordingly, this study will address the development of the system for a wide range of power quality diagnosis over the present level, the system for supporting the determination such as the analysis on risk factors, failure mode and impact, the system for harmonic evaluation based on international standards(IEC 61000 Series) and the total power quality diagnosis network & system with the extension and openness as a local and national-scale broadband power quality diagnosis system.

• 지역사회간호학회지
• /
• 제27권3호
• /
• pp.193-201
• /
• 2016

Purpose: The aim of the study is to determine factors influencing quality of caregiving by caregivers for the elderly with dementia. Methods: Data were collected from 87 caregivers for elders with dementia who had visited in Busan Metropolitan Center for Dementia and D-University hospital outpatient center from July 10 to September 30, 2015. A self-reported questionnaire was used to assess the severity of the elders' dementia and knowledge of dementia, burdens and quality of caregiving by the caregivers. The SPSS 21.0 version program was used for data analysis. Data were analyzed using descriptive statistics, Pearson's correlation, t-test, ANOVA and multiple regression. Results: Significant predictors of quality of caregiving by caregivers included caregivers' burdens (explanation power 25%), knowledge of dementia (explanation power 4%) and levels of education (explanation power 3%). These factors explained 32.3% of the variances in quality of caregiving. Conclusion: Burdens on caregivers were a major factor that decreased quality of caregiving, and knowledge of dementia was a factor that increased it. These findings show that educational programs and intervention for reducing burdens and improving knowledge of dementia are necessary to improve quality of caregiving by caregivers.

• 전기학회논문지
• /
• 제57권10호
• /
• pp.1744-1751
• /
• 2008

This paper presents a monitor positioning algorithm to identify the power quality event source in the distribution system with distributed generations. This algorithm determines the appropriate number of monitors and their locations considering power system topology together with distributed generation. This paper summarizes the guidelines of monitor positioning into five principles and defines the weighting factors according to the principles. To evaluate the adequacy of monitor positioning results, ambiguity indices considering monitor location and system topology are proposed. The optimal number and locations of monitors are determined from optimization routine using the weighting factors and the monitor positioning results are evaluated in terms of ambiguity indices. The algorithm is applied to IEEE 13 bus test feeder and suggests the optimal number and locations of power quality monitors. The proposed approach can realize the expert's knowledge on monitor positioning into a sophisticated automatic computing algorithm.

• 유통과학연구
• /
• 제11권2호
• /
• pp.23-33
• /
• 2013

Purpose - Numerous studies have tried to assess the role of a warranty as an explanatory instrument for product quality. While one study argued that manufacturers signal their superior quality to consumers by extending the duration of a warranty, quality is not necessarily related to warranty and a warranty for a short duration is a sign of high product quality. However, there are limitations to measuring product quality in terms of a single variable such as a warranty. Some other studies have evaluated the influence of brand power or value and price on the supposed quality of a product while the influence of warranty was found to be insignificant. Research design, data, methodology - The study analyzes the influence of brand power and the country of origin effect on consumers' perception of product quality in line with warranty and establishes a priority strategy. Especially, consumer experience has a significant influence on state of the art technology products like applied home electronics as these goods are generally quite expensive and consumers expend significant energy in purchasing them, so the associated warranty and brand can have a critical role in the decision making process. The price of the product was excluded in this discussion as it continually varies with the market share of the product. Results - The results of the analysis are as follows: First, each of the factors such as the standard of the warranty, brand power, and country of origin effect influences the degree of satisfaction of an individual. Second, the factors brand power and quality of the warranty interact both complementarily and synergistically at a time, depending on the brand power. As brand power is more significant, the degree of satisfaction is greater in case of products with low quality warranty compared to those with high quality warranty. Third, the brand power and country of origin effect present a complementary interaction. Fourth, the country of origin effect and quality of a warranty interact synergistically. Conclusions - Thus, the higher the quality of warranty, greater is the increment in the degree of satisfaction. The comprehensive study on the effect of the country of origin on the purchase decision process and the degree of satisfaction compared to the other elements shows that in case of Japanese and Korean markets the brand power of a company is desirable in sustaining the quality of warranty to the industrial average. Also, there is no significant improvement in the perceived quality of the product when the quality of the warranty is lowered. Therefore, the warranty effect diminishes when the value of the brand is known, while it perishes when both the brand power and the country of origin effect are strong enough.

• 전기학회논문지P
• /
• 제58권4호
• /
• pp.579-584
• /
• 2009

This paper describes a power quality analysis of a photovoltaic generating systems. Prior to the power measurement, domestic and foreign codes related to the photovoltaic generating systems were briefly summarized. After constructing about 5 kW photovoltaic systems, input/output voltages and currents were measured to compare and analyze the power quality by the module type. Based on the measured values, a couple of factors such as active power, power factor, total harmonic distortion(THD) was calculated and analyzed.