• 전력전자학회논문지
• /
• 제16권1호
• /
• pp.88-95
• /
• 2011

본 논문은 다중출력 스위칭-모드 전원 공급 장치에서 변압기 2차 측의 출력전압 안정을 위하여, 일반적으로 사용하는 선형 전압조절기의 피드백 보상기의 제어신호를 이용하여 부하 전류정보를 측정하고, 모든 부하가 경부하 상태일 경우에만 대기전력 모드로 동작하도록 하였다. 기존 방식은 주제어기 출력의 부하상태에만 의존하여, 나머지 2차측 출력의 부하상태와 상관없이 대기전력을 저감하기 위한 간헐 스위칭 모드 (burst mode) 제어로 들어가는 문제가 있다. 기존의 전류센서 혹은 저항을 이용하여 부하전류 정보를 얻는 방식이 아닌 선형전압 조절기를 이용하여 시스템을 저가격화 하였으며 모든 출력이 경부하일 경우에만 대기모드로 전환 하도록 하여 출력전압의 신뢰성을 향상시켰다. 본 논문에서는 제안된 제어기 회로의 동작원리를 설명하고 시뮬레이션으로 검증 하였으며 25W급 하드웨어를 구현하여 제안된 회로를 검증한다.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2000년도 전력전자학술대회 논문집
• /
• pp.651-656
• /
• 2000

This paper describes the optimal sizing of each component using computer simulation and presents the efficient operating scheme of series HEV using hardware simulator the equivalent system. As the sizing method of components have been experimental and empirical it is needed to spend much time and development cost. however the results of computer simulation will set the optimal sizing of components in short time. There are two type of driving control power-tracking mode and load-levelling mode in series HEV. This paper presents that series HEV be operated in the load-levelling mode which is more efficient that power-tracking mode.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2013년도 전력전자학술대회 논문집
• /
• pp.137-138
• /
• 2013

This paper proposes the single-phase double-conversion UPS(Uninterruptible Power Supply) with ESS(Energy Storage System). The Proposed system is operating in three modes, which are normal mode, battery mode, and bypass mode. Not only in black-out but also in peak load times, the system is operating in battery mode which is using the stored energy of the battery to manage the power effectively. The validity of proposed system could be verified by simulations and experiments.

• Journal of Astronomy and Space Sciences
• /
• 제26권3호
• /
• pp.287-294
• /
• 2009

In helioseismology it is normally assumed that p-mode oscillations are excited in a statistically independent fashion. Unfortunately, however, this issue is not clearly settled down in that two experiments exist, which apparently look in discrepancy. That is, Appourchaux et al. (2000) looked at bin-to-bin correlation and found no evidence that the assumption is invalid. On the other hand, Roth (2001) reported that p-mode pairs with nearby frequencies tend to be anti-correlated, possibly by a mode-coupling effect. This work is motivated by an idea that one may test if there exists an excess of anticorrelated power variations of pairs of solar p-modes. We have analyzed a 72-day MDI spherical-harmonic time series to examine temporal variations of p-mode power and their correlation. The power variation is computed by a running-window method after the previous study by Roth (2001), and then distribution function of power correlation between mode pairs is produced. We have confirmed Roth's result that there is an excess of anti-correlated p-mode pairs with nearby frequencies. On the other hand, the amount of excess was somewhat smaller than the previous study. Moreover, the distribution function does not exhibit significant change when we paired modes with non-nearby frequencies, implying that the excess is not due to mode coupling. We conclude that the origin of this excess of anticorrelations may not be a solar physical process, by pointing out the possibility of statistical bias playing the central role in producing the excess.

• JSTS:Journal of Semiconductor Technology and Science
• /
• 제13권6호
• /
• pp.562-568
• /
• 2013

This paper presents a design of a wireless power transfer system based on magnetic resonant coupling technology with in-band wireless communication. To increase the transmission distance and compensate for the change in the effective capacitance due to the varying distance, the proposed system used a loop antenna with a selectable capacitor array. Because the increased transmission distance enables multiple charging, we added a communication protocol operated at the same frequency band to manage a network and control power circuits. In order to achieve the efficient bandwidth in both power transfer mode and communication mode, the S-parameters of the loop antennas are adjusted by switching a series resistor. Our test results showed that the loop antenna achieved a high Q factor in power transfer mode and enough passband in communication mode.

• 한국전기전자재료학회논문지
• /
• 제21권4호
• /
• pp.289-295
• /
• 2008

In this paper, we designed the off-line PWM(Pulse width modulation) control IC for flyback type power converter to reduce the standby power consumption. In normal state, this off-line PWM IC generates the output pulse with $40\sim60kHz$ frequency and duty ratio of $20\sim88%$. When SMPS operates in standby mode, this IC generates the output pulse with 33kHz frequency and duty ratio of 1 %. SPICE simulation was performed to verify the standby power consumption of the power converter with designed of-line PWM IC. Power converter with designed off-line PWM IC consumes less than 0.3W when it operates in standby mode condition.

• Journal of Power Electronics
• /
• 제10권6호
• /
• pp.784-791
• /
• 2010

In this paper, a resonant pulse power converter (RPPC) is proposed. The proposed RPPC transfers the pulse-shape power from a DC source to a load periodically. The RPPC consists of a resonant circuit and a resonant pulse converter driven by a self-switching circuit. Depending on the magnitude difference between the input and output voltages, the operations of the RPPC are divided into 4 modes; boost mode, hybrid mode, direct mode and cut-off mode, respectively. The main switch of the RPPC turns on in the ZCS condition and off in the ZVS condition spontaneously. The operational principles of a RPPC using the self-switching technique are analyzed and verified in experiments. An example of a RPPC application is demonstrated in the area of thermoelectric energy harvesting.

• 대한기계학회논문집A
• /
• 제24권10호
• /
• pp.2477-2486
• /
• 2000

A planetary gear assembly is a key component to combine and/or split a power from the source. With a planetary gear assembly, a continuously variable unit extends its capacity by means of power bra nching mechanism. Power branching with one planetary gear assembly and one continuously variable unit is categorized into 12 basic types. Each type represents peculiar power transmitting characteristics. Additionally, a multi-mode (range) continuously variable transmission can be designed with accompanying clutches. A multi-mode continuously variable transmission changes the path through which the source power is transmitted. Each path has its own features, such as high efficiency. In this paper, some design principles are examined such as, criteria to guarantee the minimum power efficiency, and constraints to guarantee the smooth mode shift after discussing well-known features of multi-mode M mathematically.

• 한국통신학회논문지
• /
• 제34권10A호
• /
• pp.776-783
• /
• 2009

본 논문에서는 OFDM과 같은 대용량 무선 전송방식의 베이스밴드단(Baseband) 신호처리 방식 중 직병렬/병직렬 변환기(Serial-to-Parallel/Parallel-to-Serial Converter)를 전류모드(Current-mode) 회로로 구현했을 경우 유효한 설계 기법을 제안한다. 전류모드를 이용한 OFDM(Orthogonal Frequency Division Multiplexing: 직교주파수분할다중)용 아날로그 프리에 변환(FFT) LSI의 병렬 입출력을 담당하는 전류모드 직병렬병직렬 변환기의 홀드모드(Hold mode)의 불필요한 전류를 제거할 수 있다. 이를 통해 전류모드로 구성한 아날로그 신호처리 시스템의 저소비전력을 실현하기 위해 필수적인 새로운 전류모드 직병렬/병직렬 변환기를 제시하고 설계된 칩의 측정결과가 시뮬레이션 결과와 일치하는 것을 확인하였다. 이를 통해 저전력형 대용량 무선통신 시스템의 베이스밴드단 구축이 가능한 전류모드 아날로그 시스템의 구현 가능성을 제시하였다.

• 한국광학회지
• /
• 제14권3호
• /
• pp.292-297
• /
• 2003

최대 1.9 W의 레이저 다이오드 출력을 Nd:YV $O_4$결정 단면에 집속시키고 공진기 내부에 KTP 결정을 두어서 제2고조파 변환시켜 녹색광(532 nm) 레이저를 발생시켰다. 다이오드 레이저 스퍽트럼과 레이저 결정의 흡수 스펙트럼을 비교하여 최적의 다이오드 작동 온도를 찾았다. 공진기 길이와 출력경의 곡률을 변화시키면서 출력의 변화를 관측한 결과, 최대 80 ㎽의 녹색광 레이저 출력을 얻었으며 최대 출력을 내는 공진기 조건에서는 집속된 여기광의 직경과 TE $M_{00}$ 모드의 직경이 일치함을 알았다. 발생된 녹색광 레이저는 다중모드로 발진하였으며 출력 요동이 심하였다. 단일모드 발진을 시키기 위하여 브루스터 판과 에탈론 등을 사용하는 여러 가지 형태의 공진기를 시도하여 보았다. 실험 결과, 에탈론을 사용한 공진기에서 가장 큰 출력인 60 ㎽ 의 단일 종모드 출력을 얻었다. 단일모드로 발진하는 레이저의 출력 요동은 다중 모드에 비하여 1/10이하로 감소하였다.