• Journal of Navigation and Port Research
• /
• v.33 no.5
• /
• pp.369-374
• /
• 2009

Recently, the number of design for open-spaces at waterfront, such as open-air restaurant and cafeteria, has been increasing to provide openness and natural environment of waterfront. However, when planning open-air restaurant and cafeteria, it is essential to investigate the climate characteristic of waterfront, especially wind environment, since the waterfront has a special quality of climate like low-temperature and strong wind which differs from downtown or inland In this study, wind environments of Haeundae, Suyoungrnan, and Gwanganli, the famous waterfronts in Busan, were investigated for design of open-air restaurants and open cafeterias. The main results were as follows. 1) the waterfront area of Haeundae, Suyoungman, and Gwanganli is suitable for open-air restaurant and open cafeterias; and 2) the appropriate period for open space in this area is from the end of March to November.

• Journal of Navigation and Port Research
• /
• v.33 no.5
• /
• pp.361-368
• /
• 2009

If we think about the form of housing architecture, we can find a general or typical type has been through the architectural history. because the formal transformation in housing architecture is very difficult. Recently, there are many housing works in powerful ocean state, netherlands that was different from the typical type in the form of housing architecture. This study focusing on the formal characteristics in such works. Such distinctive works in netherlands is the result from an attempt to fulfill the diverse needs of our contemporary society and in an effort to refuse the typical type of the modern architecture. The main purpose of this study is to reveal the meaning of typological transformation in the contemporary' housing architecture.

• Journal of Navigation and Port Research
• /
• v.34 no.3
• /
• pp.257-265
• /
• 2010

This research aims to grasp ripple effect of land space by assuming the linkage of transcontinental railway, asian highway, rail ferry and undersea tunnel. The result of research was drawn positively. But all region don't have same result. Pacific Yellow Sea of Chnia has better route on the present sea transport. The other region has better route on changing network. This research has some academic significants as a research start in an unexplored field and basic research for following research. Also, Academic contribution is in attempt to analyze effect size, change of effect and contribution of balance development by linkage of ultra infra structure and gives political proposals for related research development.

• Journal of Navigation and Port Research
• /
• v.33 no.3
• /
• pp.175-180
• /
• 2009

In this study, the basic data were collected for improving the amenity of indoor environment of a super yacht and the performance of indoor environment was analyzed by utilizing measured data during summer period. Through the results of examination, the following conclusions are drawn. 1) It is estimated that, in case of closing the door of Saloon connected with outside, there is little inflow of exhaust gas, but when the door is open, the indoor-air might be polluted so fast. Therefore, it is necessary to make a counter plan about the method of ventilation and amount of ventilation to keep the indoor aerial environment agreeable. 2) It is urgent to conceive countermeasure against engine noise because the noise level of all rooms exceeds 60dB, which is regulation of noise for protecting crew established in ship's classification, during the sailing. 3) State cabin and Guest cabin are super cooled by operating air conditioner exceeding agreeableness extent and it is needed to prevent them.

• Journal of Navigation and Port Research
• /
• v.43 no.3
• /
• pp.197-208
• /
• 2019

This paper assessed the impacts of the specification of the yard, handling equipment, and operation approaches on the expected number of re-handles during the loading operation for empty containers. When the various types of empty containers from multiple shipping liners are placed in separate spaces from each other, then the storage space cannot be fully utilized. So as to increase the utilization of the storage space, empty containers from multiple vessel liners are stored together incurring additional re-handles during the loading operation. Several formulas are derived for the estimation of the expected number of handles, including re-handles, for empty container retrieval from a bay. Transfer cranes and top handlers are utilized as handling equipment and various retrieval strategies are examined. Numerical analysis was conducted to assess the effects of various designs and operational parameters of the container stacking yard on the expected number of handles.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.47 no.1
• /
• pp.17-25
• /
• 2019

An intake of Aircraft becomes S-shaped geometry due to spatial limitation or procuring survivability. But curvature of the S-shaped geometry makes secondary flow or flow separation which is the cause of non-uniform pressure distribution. In this study, boundary layer suction is applied to RAE M 2129 S-Duct by attaching sub duct. Design variable is suction location and angle. A mass flow rate drawn out by suction at the sub duct outlet is constant over every model. A grid dependency test was conducted to verify validity of computation. The comparison among the CFD (Computation Fluid Dynamics), ARA experimental result, and ARA computation result of non-dimensional pressure distribution on the Port side and Starboard Side confirmed the validity of CFD. In this study, Distortion Coefficient was used for evaluating aerodynamic performance of S-Duct. The analysis, which was about flow separation, vortex, mass flow rate distribution, and pressure distribution were also investigated. Maximum 26.14% reduction in Distortion Coefficient was verified.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.48 no.12
• /
• pp.1005-1012
• /
• 2020

Avionics systems that use the PCI-Express bus unfortunately cannot use at least one I/O device if the bus fails, because the I/O device is connected to CPU through only one PCI-Express channel. This paper presents a fault-tolerant architecture of the PCI-Express bus for avionics systems, which tolerates one channel failure with help of the other redundant channel that has not been failed. In this architecture, each redundant PCI-Express channel connects a corresponding port of CPU to each switch logic of channels to provide each I/O device through a switched fault-tolerant channel. This paper includes the results of experimentation to show that the architecture detects the faulty condition in real time and switches the channel to the other redundant channel which has not been failed, when the architecture meets a failure.

• Journal of Korean Tunnelling and Underground Space Association
• /
• v.24 no.1
• /
• pp.15-38
• /
• 2022

Recently, tunnel technology in Korea has shown various achievements such as long tunnel and large section by tunnel construction using TBM in Korea and abroad. Especially subsea tunnels are frequently designed and constructed. The Ga-deok subsea tunnel was completed in December 2010, and the Incheon North Port Tunnel was opened and operated in 2017, and the Bo-ryeong subsea tunnel between Dae-cheon Port and Won-san Island will be completed in 2021. In foreign countries, many subsea tunnels have been constructed and operated in such as Norway and Japan. The main technical problem in the construction of subsea tunnel is to secure stability due to high water pressure conditions and large-scale seawater inflow in fault zones and weak zones. In this paper, various risk factors and solutions are described in the subsea tunnel planning of national road 77 construction work between Abhae and Hwawon.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.32A no.5
• /
• pp.60-70
• /
• 1995

As a Basic study to implement a wide-band photonic switching sysetm, we proposed a scheme of free-space-division-multiplexed photonic switching based on a holographic interconnectio method and carried out simple experiments on it. First, we recorded holgraphic interconnection element array for nonblocking optical interconnections. Just a single stage of the array realizes full optical interconnections between NN${\times}$NN input prots and NN${\times}$NN output ports in 3-D space. Next, in reading of the array for optical internnections, we showed that the zeroth-order diffacted beam could be eliminated in the output port by introducing a right angle prism. The elimination of the zeroth-order diffracted beam reduces optical noise in the output ports and provides conveniences of interconnection control in our scheme. Finally, from the experiments on ON-OFF switching of the optical interconnection paths one by one using a spatial (display of the liquid crystal telecision), we showed the feasibility of photonic wsitching based on the holographic interconnection method. We also estimated approximately the maximum interconnectio scale that can be realized without difficulty with current optical devices.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2004.03a
• /
• pp.687-692
• /
• 2004

For the prediction of sloshing in the propellant tank of rocket vehicle utilized in RVT (reusable rocket vehicle testing) conducted by ISAS/JAXA, the flow field in the propellant tank during the ballistic flight was experimentally reproduced with the sub-scale model of it. The lateral acceleration as large as about 0.8 G was provided with a mechanical exciter and the deformation of liquid surface in the vessel was visualized with a high-speed camera. The several con-figurations of damping devices were installed and tested in the vessel, which should keep the ullage gas away from the outlet port. It was consequently suggested that the combination of a baffle plate and a perforated cylinder could be effective against the gas suction before the re-ignition of the engine. The sloshing phenomena were also simulated with the CFD code, called CIP-LSM. The numerical results showed good agreement with the corresponding data obtained in the experiment.