• Journal of the Korea Fashion and Costume Design Association
• /
• v.10 no.2
• /
• pp.105-115
• /
• 2008

Men's outer wear, such as jackets and coats appeared since the 16th century. They have been changed from doublets, coats, justaucorps, tail-coats, frock coats and morning coats to contemporary men's suits. Since the early 17th century, sleeve patterns of men's outer jackets had been mostly two-pieces close fitted patterns. The purpose of this article is to compare sleeve patterns of various jackets, which appear in various historic costume books. Armhole measurements, sleeve head measurements, amounts of ease, armhole depths, armhole widths, crown heights, sleeve width and sleeve angle had been compared to find out the differences among patterns of different times and styles. Coming to the present, the difference between top sleeve and under sleeve became more obvious, and the sleeve angle became less curvy. Another interesting point is that there had been considerable amounts of ease, which is the difference between sleeve head measurements and corresponding armhole measurements. It is because the sleeve has been attached to the armhole not by seam but by string. It is believed that the present sleeves have more natural curve and shape compared to the past.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2013.05a
• /
• pp.59-61
• /
• 2013

The purpose of this study was to present the necessary data concerning the selection and development of floor-coverings in view of slipperiness by comparing the relationship between CSR measured with O-Y·PSM and RCOF calculated from the result of gait analysis. CSR was calculated from maximum tensile load(Pmax) divided by perpendicular load(785N) when pulled 18 degrees upward the moment the bottom of the slip piece contacted the surface of the test piece. RCOF was calculated based on Fy/Fz from when horizontal load reached the maximum point within the sections from the moment the front of outsole touched the test piece to when pulled off the test piece. The results from the research were as follows: (1) Range of CSR was 0.15-1.02, which meant the differences of slipperiness of the test pieces definitely showed up. (2) RCOF are inadequate to express the characteristic about the slipperiness of the floors, since there were no differences between the test pieces.

• Industrial Engineering and Management Systems
• /
• v.15 no.3
• /
• pp.278-288
• /
• 2016

Automation ensures accurate and well-organized container transportation in container terminals. This paper addresses operational issues such as equipment scheduling and the coordination between various pieces of equipment in a rail-based automated container terminal. Containers are relayed using multiple types of equipment from road trucks to a vessel and vice versa. Therefore, handshaking is required during a container transfer between different pieces of equipment. Synchronization between the schedules of all the equipment is important to reduce equipment waiting times and the time required for transporting containers, which results in a short turnaround time for a vessel. This paper proposes an integrated control system with the objective of synchronizing the operations of different types of equipment, provides a list of decisions to be made by the control module of each type of equipment, and shows all the required information transfers between control modules. A scheme for the integrated scheduling of multiple types of equipment is proposed. The decisions made by each control module in a real-time fashion are listed with detailed explanations, and the information transfer between managers in a real-time situation at the proposed terminal is described.

• Journal of the Korea Furniture Society
• /
• v.28 no.2
• /
• pp.126-134
• /
• 2017

This study explores PyeongSang, a piece of traditional Korean furniture, in order to make people know the details about what the piece is in the first paper. And based on the paper, PyeongSang will be developed as moulded multi-useful beds and sofas adapting the joint and ornament from the structure and pattern of the piece in the next paper. As the result, it appeared as two styles such as bed types mentioned as SalPyeongSang and ttulmaru in Korean. The pieces have been used from the three Kingdoms period in Korean history. The styles appeared as the structure of four parts with the lower fences called as nangan, the seats jointed by thin wood pieces, the wind hole, and the legs of foot types. The parts were beautifully carved with the ornament such as lattice patterns like geokjamun and manjamun, flower patterns like dangchomun, elephant eyes patterns like ansangmun from the Korean tradition. And the legs showed various shapes such as supports transformed from horse foots, tiger legs and bamboo, and board types carved with elephant eyes and geometric patterns. Hence, in the next paper based on this paper, PyeongSang will be developed as moulded multi-useful beds and sofas adapting the joints and ornaments from the structure and patterns of the piece.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.26 no.3_4
• /
• pp.539-547
• /
• 2002

Heungdukwang's(興德王) costume ordinance(834A.D.) is a very important written historical record because it reveals Tongil Shilla's(統-新羅) costume. And among the clothing pieces that appeared in Heungdukwang's(興德王) costume ordinance, from Pyosang(表裳), Naesang(內裳), we know they wore one skirt over another. But skirts appearing in visual records are wort in waist line or breast line, and when they wore skirts in breast line, there were shoulder belts or not. Also among the clothing pieces that appeared in Heungdukwang'a (興德王) costume ordinance, Yo( ) and Ban( ) seems to be connected with skirt. but it is not clear. So this study focuses on the history of wearing skirt in breast line and one skirt over another, shoulder belts of skirt, and relation among yo( ), Ban( ) and skirt. The results are as follows. First, wearing skirt in breast line is already appeared in Ancient Shilla's(新羅) clay figure, and wearing one skirt over another is also appeared in Sunhung tomb's mural painting. so it is not completely under the influence of Tang(唐). Second, the shoulder belts of skirt is for convenience of action, But, at that time, there is no shoulder belts of skirt in Tang(唐). Third, between Yo( ) and Ban( ), If Yo( ) is connected with skirt, it is a shoulder belts of skirt or waist of skirt. And Ban( ) is a ire of skirt.

• Journal of KIISE:Computer Systems and Theory
• /
• v.31 no.11
• /
• pp.617-625
• /
• 2004

We propose an efficient stream authentication scheme that is an improvement of PCC scheme by using information dispersal algorithm. The drawback of PCC scheme is that received packets for each group are verifiable only if the signature packet of the group is successfully received. The proposed scheme processes the signature packet by introducing some amount of redundancy and splitting the result into pieces, which are then transmitted. The receiver is able to reconstruct the signature packet if the number of the received pieces is larger than the threshold. It is shown that under the same communication overhead verification probability of the proposed scheme is higher than that of SAIDA. Moreover, its computational cost is lower than that of SAIDA.

• Research in Plant Disease
• /
• v.24 no.3
• /
• pp.237-241
• /
• 2018

A circular bark with a 30 cm width was artificially removed from the trunk of a 250-year-old zelkova tree (Zelkova serrata) heavily damaged by artificial girdling in Sunchang, Jeonbuk Province in March of 2005. The debarked area was cleaned approximately 10 days after artificial girdling and bark margins with 2 cm width above and below the girdled portion were cut off to promote wound callus formation. Nine pieces of fresh bark (width 8 cm, length 35 cm, thickness 0.5 cm) were then prepared from branches of neighbor zelkova trees broken by heavy snowfalls and pasted onto the girdled portion of the tree, after which a Vaseline dressing was applied to water-proof the area and rubber bars were used to hold the implants to the trunk. Two pieces of the implanted fresh barks were successfully grafted onto the girdled area and the damaged tree has been vigorously growing over 13 years. To our knowledge, this is the first case of successful bark implantation to cure a 250-year-old zelkova tree heavily damaged by artificial girdling. This bark implantation technique will be utilized for the conversation and management of heavily damaged big and old trees in the future.

• Journal of the Korean Wood Science and Technology
• /
• v.28 no.2
• /
• pp.19-24
• /
• 2000

Effects of the cross-sectional dimension and moisture profile of wood specimens on the ultrasonic sound velocities of radiata pine heartwood and sapwood. Each moisture profile model specimen was made by composing five wood pieces with various moisture contents. As the cross-sectional dimensions decreased the ultrasonic velocities of both heartwood and sapwood decreased by 4~8%. In the ultrasonic signals transmitted through the specimens low frequency components more dominated than high frequency components as the dimension of cross section increased. The specimens with the same average MCs and different moisture profiles showed different ultrasonic velocities. By plotting the ultrasonic velocities against the average moisture contents of the inner three pieces of the moisture profile model specimens it was revealed that three distinct plot patterns existed.

• Journal of Veterinary Clinics
• /
• v.24 no.2
• /
• pp.264-268
• /
• 2007

Three German Shepherd dogs (5 years old, 30 kg, male; 4 years old, 23 kg, female; 4 years old, 24 kg, female) with history of acute vomiting, hemorrhagic diarrhea, anorexia and dullness were admitted to veterinary clinic in the military working dogs training corp (MWDTC). All of them showed same symptoms after ingestion the $'PREVNTIC^{(R)}'$ collar to control ecto-parasites infection in field. One dog was operated by gastrotomy and the $5{\sim}6$ pieces of the $'PREVNTIC^{(R)}'$ collar were removed. The dog was completely cured by intensive care within 2 hours after $'PREVNTIC^{(R)}'$ collar ingestion. However, two dogs were operated by gastrotomy and intensive care over 24 hours after $'PREVNTIC^{(R)}'$ collar ingestion but died. In autopsy, the $5{\sim}6$ pieces of hard materials were found in the stomach, and severe thickness, congestion hemorrhage and swelling of the stomach walls and mucous membrane were observed. In these cases, it was suggested that the first aid of treatment such as gastrotomy within two hours after $'PREVNTIC^{(R)}'$ collar ingestion as soon as possible was helpful for attenuating of toxicosis.

• Journal of Technologic Dentistry
• /
• v.7 no.1
• /
• pp.5-12
• /
• 1985

This experimental study is perform to study the effect of the direction for the centrifugal force in operating centrifugal casting machine. In order to investigate the effect of direction for centrifugal force action on the casting ability 20 pieces of specimen are produced including one vertical direction and four horizontal directions. Casting shows us that the 15 pieces of specimen among them are included within $\pm$16. The results obtained through the comparison with 5 groups of the casting ability are as follows: 1. In the experiment of the casting, statistically significant difference are found between the vertical direction and the group of horizontal direction, namely, the direction of 3, 6, 9 and 12 o'clock, and also statistically there are significant differences between the direction of 9 o'clock and of 6 o'clock, and between the direction of 9 o'clock and of 12 o'clock which lie between the groups of horizontal directions. 2. The degree of casting ability is showing us on an average, 23.80 in the vertical direction. And also in the group of horizontal direction it prove in turn 15.60 in the direction of 9 o'clock, 14.47 of 3 o'clock, 13.30 of 12 o'clock, and 12.80 of 6 o'clock.