• Journal of the Korea Organic Resources Recycling Association
• /
• v.16 no.4
• /
• pp.91-97
• /
• 2008

The objective of this research is to investigate the effect of the addition of granular activated carbon (GAC) and granular sludge on the performance of upflow anaerobic sludge blanket (UASB) reactors for treating leachate. For the control reactor, sludge obtained from an anaerobic digester was used as a seed material. On the other hand, GAC and granular sludge were incorporated with the seed sludge in the GAC reactor and the Granule reactor, respectively. The shortest acclimation period was observed in the Granule reactor. The GAC reactor also gave comparable performance to the Granule reactor at the beginning of operation. However, as the adsorptive capacity of GAC was exhausted, the effluent COD concentration increased gradually. Once the systems were stabilized, the GAC reactor showed slightly better results than the other two reactors in terms of chemical oxygen demand (COD) removal. COD removal in all reactors was more than 90% at hydraulic retention time of 1.0 day. Furthermore, GAC reactor showed little variation in COD removal rate and remained at 95% with organic loading rate (OLR) of 4.0 to $8.2kg\;COD/m^3.d$. Initial operating period was reduced by the addition of granular sludge, while the treatment efficiency was enhanced by the addition of GAC.

• The Journal of the Korea Contents Association
• /
• v.13 no.4
• /
• pp.320-330
• /
• 2013

The purpose of this study is to increase efficiency of CPR through comparing the chest-compression quality between rescuer's simplified verbal order method and the continued verbal order method by utilizing voice meter during CPR. Subjects were 89 people(45 people for the experimental group, 44 people for the control group) who completed the 15-week CPR curriculum as undergraduates for the department of Emergency Medical Technology in C Province and were carried out by being randomly extracted. The group division was set for the experimental group as the group with the simplified verbal order and for the control group as the group with the continued verbal order. The period of measurement was progressed primarily(November 10, November 28, 2011) and secondarily(September 3-September 4, 2012). An analysis was used SPSS WIN 12.0 program. As a result of research, as for the implementation of appropriate chest compression(time, %), the quality was higher(p<.05) in the experimental group(102.86 times, 67.79%) than the control group(85.31 times, 55.84%). As a result of research, the chest compression(time, %) in the experimental group(102.86 times, 67.79%) had the higher effect of chest compression quality(p<.05) than the control group(85.31 times, 55.84%). On the other hand, the operation of weak chest compression(time) was higher in control group(61.13 times) than experimental group(35.54 times). The proper chest compression was shown(p<.05) in men of the experimental group as for gender and in over 60kg of the experimental group as for weight.

• Journal of KIISE:Computing Practices and Letters
• /
• v.11 no.3
• /
• pp.224-234
• /
• 2005

As the network-related technology develops the number of both Internet users and the usage are explosively increasing. The networking traffic is increasing in the campus as the networking system inside universities, following the trend, adds more nodes and various networking services. Nonetheless, the quality of services for users has been degraded. Accordingly, core problems, which can cause troubles for network management, design and expansion of the network, and the cost policy, has appeared. To effectively cope with the problems with analyses a great number of technicians, tools, and budget are needed. However, it is not possible for mid and small-sized colleges to spend such a high expenditure for professional consulting. To reduce the cost and investment creating the optimized environment, the analyses on the replacement of the tools, changing the network structure, and performance analysis about capacity planning of networking is necessary. For this reason, in this paper, framework-based performance management tools are used for all steps that are related to the subject of the analysis for the network management. As the major research method, the current data in detailed categories are collected, processed, and analyzed to provide the solution for the problems. As a result we could manage the network, server, and application more systematically and react efficiently to errors and degrading of performance that affect the networking tasks. Also, with the scientific and organized analyses the overall efficiency is upgraded by optimizing the cost for managing the operation of entire system.

• Journal of Navigation and Port Research
• /
• v.27 no.1
• /
• pp.97-102
• /
• 2003

Wire ropes are used in a myriad of various industrial applications such as elevator, mine hoist, construction machinery, lift, and suspension bridge. Especially, the wire rope of crane is important component to container transfer. If it happens wire rope failures during the operation, it may lead to safety accident, economic loss by productivity decline and so on. To solve this problem, we developed remote wire rope fault detecting system, and this system is consisted of 3 parts that portable fault detecting part, signal processing part and remote monitoring part. All detected signal has external noise or disturbance according to circumstances. So, we applied to discrete wavelet transform to extract a signal from noisy data. It is verified that the detecting system by de-noising has good efficiency for inspecting faults of wire ropes in service. As a result, by developing this system, container terminal could reduce expense because of extension fo wire ropes exchange period and could competitive power. Also, this system is possible to apply in several field such as elevator, lift and so on.

• Korean Chemical Engineering Research
• /
• v.49 no.4
• /
• pp.423-431
• /
• 2011

Recentincreasing awareness of the environmental damage caused by the $CO_2$ emission of fossil fuelsstimulated the interest in alternative and renewable sources of energy. Fuel cell is a representative example of hydrogen energy utilization. In this study, Molten Carbonate Fuel Cell system is simulated by using $Aspen^{TM}$. Stack model is consisted of equilibrium reaction equations using $ACM^{TM}$(Aspen Custom Modeler). Balance of process of fuel cell system is developed in Aspen $Plus^{TM}$ and simulated at steady-state. Analysis of performance of the system is carried out by using sensitivity analysis tool with main operating parameters such as current density, S/C ratio, and fuel utilization and recycle ratio.In Aspen $Dynamics^{TM}$, dynamics of MCFC system is simulated with PID control loops. From the simulation, we proposed operation range which generated maximum power and efficiency in MCFC power plant.

• Korean Chemical Engineering Research
• /
• v.56 no.5
• /
• pp.631-640
• /
• 2018

The application of an oxy-combustion circulating fluidized bed combustor (Oxy-CFBC) for low grade coals has recently developed in the world to meet the continuous increase of energy demand and to achieve the reduction of greenhouse gases. Since demo plants for Oxy-CFBC have been developed, the combustion properties of Oxy-CFBC in various operation conditions, such as gas flow rates, combustion temperature, fuel, and so on, should be investigated to develop design criteria for a commercial Oxy-CFBC. In this study, a computational simulation tool for Oxy-CFBC was developed on the basis of the IEA-CFBC (International Energy Agency Circulating Fluidized Bed Combustor) model. Simulation was performed under various conditions such as reaction temperature ($800^{\circ}C{\sim}900^{\circ}C$), oxygen contents (21%~41%), coal feeding rate, Ca/S mole ratio (1.5~4.0), and so on. Simulation results show that the combustion furnace temperature is higher in oxy 1 than air fired. However, the temperature gradient tended to decrease with increasing oxy mixing percent. In case of $SO_x$, the higher the Ca/S mole ratio and oxy mixing percent, the higher the desulfurization efficiency.

• Clean Technology
• /
• v.20 no.4
• /
• pp.449-456
• /
• 2014

There has been increasing concerns for the problems of water security in countries, caused by the frequent occurrence of localized drought due to the climate change and uncertainty of water balance. The importance of fresh water is emphasized as considerable amount of usable fresh water is utilized for power generation sector producing electricity. PV power system, the source of renewable energy, consumes water for the every steps of life cycle: manufacturing, installation, and operation. However, it uses relatively less water than the traditional energy sources such as thermal power and nuclear power sources. In this study, to find out the use of water for the entire process of PV power system from extracting raw materials to operating the system, the footprint of water in the whole process is measured to be analyzed. Measuring the result, the PV water footprint of value chain was $0.989m^3/MWh$ and the water footprint appeared higher specially in poly-Si and solar cell process. The following two reasons explain it: poly-Si process is energy-intensive process and it consumes lots of cooling water. In solar cell process, deionized water is used considerably for washing a high-efficiency crystalline silicon. It is identified that PV system is the source using less water than traditional ones, which has a critical value in saving water. In discussing the future energy policy, it is vital to introduce the concept of water footprint as a supplementary value of renewable energy.

• Korean Journal of Agricultural Science
• /
• v.28 no.2
• /
• pp.99-107
• /
• 2001

It is difficult to install a ventilation window on the roof of single span greenhouses of arch shape. Investigation on the roof ventilation structures for those greenhouses was conducted. In small greenhouses with spans of 5 to 8 m, circular or chimney type ridge vents made of plastic were employed. In large greenhouses with spans of 12 to 18 m, even span roll-up ridge vents made of steel pipe were employed. The effect of roof ventilation was evaluated by comparative experiments between greenhouse installing ridge vents and having controlled side vents only. Roof ventilation contributed greatly to restraint of temperature rise and maintenance of uniform temperature distribution in greenhouses. And ventilation efficiency was analyzed by experiments on the opening and closing operation of the ridge and side vent. There were no temperature differences according to opening and closing sequence of ventilation window. But for greenhouse temperature control by ventilation, it is desirable to open side vents after ridge vents and to close ridge vents after side vents.

• Journal of Digital Convergence
• /
• v.12 no.10
• /
• pp.317-327
• /
• 2014

To improve the efficiency of wireless channel, IEEE 802.11ac uses the DL MU-MIMO MAC scheme through which an AP transmits multiple frames to different mobile nodes simultaneously. IEEE 802.11ac DL MU-MIMO MAC needs a new step, called as TXOP sharing, between legacy IEEE 802.11n DL SU-MIMO's two operations, the obtaining an EDCA TXOP and the transmitting multiple frames for EDCA TXOP. In the TXOP sharing operation, both wireless channel destinations and frames transmitted for its TXOP period should are determined. So this paper deals with the TXOP sharing for improving IEEE 802.11ac MAC performance. However, the EDCA priority based method mentioned by IEEE 802.11ac standard document not fair among the buffers and the frames of buffers, and occurs in high_loss rate and high_delay about specific buffers. In this paper, we propose a new scheme of the TXOP sharing with sequencing p-AC, s-AC in similar properties, and all S-AC. This method provides a differentiated service without damage of EDCA characteristics.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.31 no.2D
• /
• pp.193-201
• /
• 2011

The provision of traffic information plays an important role in increasing social benefit not only by saving travel time for individuals but also by improving the efficiency of road operation. VMS(Variable Message Sign) helps on-wheel drivers easily understand the road situation, and also provides real-time traffic information to people on the streets. However, it has not been sufficiently studied on how traffic information based on VMS influences on the drivers' selection of route. This study investigated how drivers use VMS traffic information and how they are satisfied with it. Then, the model of drivers' route selection was specified with the types of traffic information and the expected travel time to examine the influence on the selection of drivers' route. The model was estimated and analyzed in three types according to the condition of detour roads, and the rate of route change and the degree of sensitivity was calculated from the estimation. The results of analysis are as follows. the $1^{st}$ type model showed the 10% of route change for the travel time saving of 5minutes, and the 81.6% of route change for the travel time saving of 20minutes. The $2^{nd}$ type led to the range of route change from 14.2% to 92.7% over the 5 through 20 minutes of travel time saving. The $3^{rd}$ model resulted in the 99.1% of route change. The sensitivity of route change showed the highest for the travel time saving of 11 minutes with the $1^{st}$ type model, 9 minutes with the $2^{nd}$ type model, and 5 minutes with the $3^{rd}$ type model respectively.