• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.13 no.2
• /
• pp.79-82
• /
• 2003

GaN nanoparticles were synthesized by the pulsed laser deposition (PLD) process on $SiO_2$substrate after irradiating the surface of the GaN sintered pellet by the ArF (193 nm) excimer laser. At this moment Ar gas pressure of 100 Pa, 50 Pa, 10 Pa and 1 Pa were applied during the ablation process and laser power of 100 mJ and 200 mJ were also applied. The synthesized fan nanoparticles were characterized by XRD, SEM, TEM, XPS and optical absorption spectra. The synthesized GaN nanoparticles had the crystallite sizes of 20~30 nm, and besides, GaN nanoparticles synthesized under low Ar gas pressure compared to the others corresponded with stoichiometry, and the optical band edge of the GaN nanoparticles was blueshifted.

• Journal of the Korean institute of surface engineering
• /
• v.48 no.3
• /
• pp.82-86
• /
• 2015

$Dy^{3+}$- and $Eu^{3+}$-codoped $CaMoO_4$ Phosphors were synthesized by using the solid-state reaction method. The crystal structure, morphology, and optical properties of the resulting phosphor particles were investigated by using the X-ray diffraction, field-emission scanning electron microscopy, and photoluminescence spectroscopy. XRD patterns exhibited that all the synthesized phosphors showed a tetragonal system with a main (112) diffraction peak, irrespective of the content of $Eu^{3+}$ ions. As the content of $Eu^{3+}$ ions increased, the grains showed a tendency to agglomerate. The excitation spectra of the synthesized powders were composed of one strong broad band centered at 305 nm in the range of 220 - 350 nm and several weak peaks in the range of 350 - 500 nm resulting from the 4f transitions of activator ions. Upon ultraviolet excitation at 305 nm, the yellow emission line due to the $^4F_{9/2}{\rightarrow}^6H_{13/2}$ transition of $Dy^{3+}$ ions and the main red emission spectrum resulting from the $^5D_0{\rightarrow}^7F_2$ transition of $Eu^{3+}$ ions were observed. With the increase of the content of $Eu^{3+}$, the intensity of the yellow emission band gradually decreased while that of the red emission increased. These results indicated that the emission intensities of yellow and red emissions could be modulated by changing the content of the $Dy^{3+}$ and $Eu^{3+}$ ions incorporated into the host crystal.

• Proceedings of the KIEE Conference
• /
• 1995.11a
• /
• pp.329-331
• /
• 1995

Laser ablation was used to fabricate superconducting $YBa_2Cu_3O_{7-x}$ (YBCO) thin films on metallic substrates with an YSZ buffer layer. An ArF excimer laser with an wavelength of 193 nm was used to deposit both YSZ buffer layer and superconducting thin film. The characterizations of thin films were performed and compared. With a 200 nm YSZ buffer layer, c-axis orientation and $T_c$=85 K were obtained for a 200 nm-thick YBCO film.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2003.07a
• /
• pp.319-322
• /
• 2003

To match the charge induced by the insulators $CeO_2$ with the remanent polarization of ferro electric SBT thin films, areas of Pt/SBT/Pt (MFM) and those of $Pt/CeO_2/Si$ (MIS) capacitors were ind ependently designed. The area $S_M$ of MIS capacitors to the area $S_F$ of MFM capacitors were varied from 1 to 10, 15, and 20. Top electrode Pt and SBT layers were etched with for various area ratios of $S_M\;/\;S_F$. Bottom electrode Pt and $CeO_2$ layers were respectively deposited by do and rf sputtering in-situ process. SBT thin film were prepared by the metal orgnic decomposition (MOD) technique. $Pt(100nm)/SBT(350nm)/Pt(300nm)/CeO_2(40nm)/p-Si$ (MFMIS) gate structures have been fabricated with the various $S_M\;/\;S_F$ ratios using inductively coupled plasma reactive ion etching (ICP-RIE). The leakage current density of MFMIS gate structures were improved to $6.32{\times}10^{-7}\;A/cm^2$ at the applied gate voltage of 10 V. It is shown that in the memory window increase with the area ratio $S_M\;/\;S_F$ of the MFMIS structures and a larger memory window of 3 V can be obtained for a voltage sweep of ${\pm}9\;V$ for MFMIS structures with an area ratio $S_M\;/\;S_F\;=\;6$ than that of 0.9 V of MFS at the same applied voltage. The maximum memory windows of MFMIS structures were 2.28 V, 3.35 V, and 3.7 V with the are a ratios 1, 2, and 6 at the applied gate voltage of 11 V, respectively. It is concluded that ferroelectric gate capacitors of MFMIS are good candidates for nondestructive readout-nonvolatile memories.

• Journal of the Korean institute of surface engineering
• /
• v.40 no.5
• /
• pp.241-244
• /
• 2007

$MgF_2$/Cr/$MgF_2$, $MgF_2$/Cu/$MgF_2$ and $MgF_2$/Al/$MgF_2$ multi-layered thin films were fabricated by evaporation system. $MgF_2$ and Cr(Cu, And Al) was selected as a low refractive index material and mid reflector layer, respectively. Optical properties including color effect were systematically studied in terms of different film layer by using spectrophotometer. Experimental results were compared to the simulation result. The films consistings of $MgF_2$/Cr/$MgF_2$, $MgF_2$/Cu/$MgF_2$, $MgF_2$/Al/$MgF_2$ multi-layered thin films showed wavelength range of $430{\sim}780nm$, typically color range between greenish yellow and orange at view angle of $45^{\circ}$. It was confirmed that this experimental result was well matched with simulation result.

• Proceedings of the Optical Society of Korea Conference
• /
• 2001.02a
• /
• pp.232-233
• /
• 2001

2차 비선형광학 물질이 높은 응용성을 갖기 위해서는 큰 2차 비선형광학 계수뿐만 아니라 넓은 파장 영역에 걸친 투명성을 가지고 있어야 한다. vinylidene fluoride(VDF)와 trifluoroethylene(TrFE)가 공중합된 f(VDf-TrFE) 공중합체는 이러한 조건을 갖추고 있는 강유전성 물질이다. 우리는 몰비율이 72：28인 P(VDF-TrFE)을 ITO기판위에 casting하고 corona 극화한 뒤, 두 개의 입력 파장(1064nm, 532nm)에 대한 2차 조화파 발생 실험을 실시하고 Herman과 Hayden의 마커무의 식을 이용하여 2차 비선형 광학 계수를 측정하였다. (중략)

• Nuclear Engineering and Technology
• /
• v.55 no.11
• /
• pp.3935-3939
• /
• 2023

The paper presents the results of a study of radioactive noble gases and from decay products in the atmosphere of the reactor hall of the research nuclear reactor IVV-2M. The distribution of short-lived ⁸⁸Rb and ¹³⁸Cs activity by sizes of aerosol particles was measured in the range of 0.5-1000 nm. It is shown that radioactive aerosols are characterized by three main modes with AMTD 2-3 nm, 7-15 nm and 400 nm. About 70% of aerosol activity is due to ⁸⁸Rb. The equilibrium factor between ⁸⁸Kr and ⁸⁸Rb is 0.2 ± 0.1. The total concentration of aerosols particles was measured using an aerosol diffusion spectrometer. The value of unattached fraction of radioactive aerosols in the atmosphere of reactor hall IVV2M was f = 0.15-0.25 at the average total aerosol particles concentration from 20,000 cm³ to 53,000 cm³.

• Journal of the Korean Vacuum Society
• /
• v.16 no.3
• /
• pp.215-220
• /
• 2007

Thin films of $SBT(SrBi_2Ta_2O_9)$ having $Pt/SBT/Seed/Pt/Ti/SiO_2/Si$ structure were fabricated using self-seed layer method by R.F. Magnetron sputter. Self-seed layers were deposited at room temperature and $600^{\circ}C$, which had 30 nm thickness. To investigate crystallization of self-seed layer we characterized by XRD after various heat treatment. And we characterized the crystallinity and electrical properties of SBT on self-seed layer after various heat treatment.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.33 no.5
• /
• pp.393-399
• /
• 2020

A series of phosphors, SrWO₄:5 mol% Dy³⁺, SrWO₄:5 mol% Sm³⁺, and SrWO₄:5 mol% Dy³⁺:x Sm³⁺ (x＝1~15 mol%), were prepared using a facile co-precipitation. The crystal structure, morphology, photoluminescence properties, and application in anti-counterfeiting fields were investigated. The crystalline structures of the prepared phosphors were found to be tetragonal systems with the dominant peak occurring at the (112) plane. The excitation spectra of the Dy³⁺ singly-doped SrWO₄ phosphors were composed of an intense charge-transfer band centered at 246 nm in the range of 210~270 nm and two weak peaks at 351 nm and 387 nm due to the ⁶H_15/2→⁶P_7/2 and ⁶H_15/2→⁴I_13/2 transitions of Dy³⁺ ions, respectively. The wavelength of 246 nm was optimum for exciting the luminescence of Dy³⁺ and Sm³⁺ co-doped SrWO₄ phosphors. The emission spectra consisted of two intense blue and yellow emission bands at 480 nm and 573 nm corresponding to the ⁴F_9/2→⁶H_15/2 and ⁴F_9/2→⁶H_13/2 transitions of Dy³⁺, and two strong emission peaks at 599 nm and 643 nm originating from the ⁴G_5/2→⁶H_7/2 and ⁴G_5/2→⁶H_9/2 transitions of Sm³⁺, respectively. As the concentration of Sm³⁺ ions increased, the emission intensities of Dy³⁺ rapidly decreased, while the emission intensities of Sm³⁺ gradually increased. These results suggest that the color of the emission light can be tuned from yellow to white by changing the concentration of Sm³⁺ ions at a fixed 5 mol% Dy³⁺. Furthermore, the fluorescent security inks were synthesized for use in anti-counterfeiting applications.

• The Korean Journal of Food And Nutrition
• /
• v.11 no.4
• /
• pp.375-380
• /
• 1998

A study of characteristics of greenish pigments from silkwarm excrement by ethanol extraction. Through visible absorption scanning, it showed two absorption peaks at 415 and 657nm, and it was shown to be greenish color. In the presence of light, the stability of pigments rapidly degraded, but in the presence of Al-foil, green and blue cover were very stable. It was shown to be stabilized at the temperature of 7$0^{\circ}C$ until 20days and presence of metal ions, such as Na+, K+, Ca2+, Mg2+ and Zn2+. The pigments was shown to be stabilized in 5% acetic acid solution, but in the presence of lactic acid, citric acid and tartaric acid solution were unstable. On the result of TLC analysis, pigments were shown to be composed of eight color fractions, and main color fractions were F-1, F-2 and F-3. In F-1, F-2 fractions were revealed green color and F-3 fraction were revealed yellow color.