• Proceedings of the IEEK Conference
• /
• 2002.07c
• /
• pp.1428-1431
• /
• 2002

It is general opinion that the future mobile multimedia networks will use different standards and a prospective solution to this problem will be software defined radio (SDR) techniques. SDR provides the flexibility to support multiple air interfaces and signal processing functions at the same time. Especially, digital signal processors and FPGAs are widely used for implementation of these adaptive and flexible functions of a baseband modem for SDR applications. Also, it is known that the modulation schemes of OCQPSK (Orthogonal Complex QPSK) and HPSK (Hybrid PSK) are used for IMT-2000 services of cdma2000 and WCDMA, respectively. Thus, in this paper, we design and implement an OCQPSK / HPSK modem using a DSP chip of Texas Instrument's TMS320C6701. One modulation scheme is operated by adaptive selection between the two schemes and 5 physical traffic channels differentiated by orthogonal codes are implemented in one DSP chip and each channel has 1Mbps data rates and 8Mcps chip rates.

• IE interfaces
• /
• v.9 no.3
• /
• pp.92-100
• /
• 1996

The current copper-based communication network is going to be replaced with an optic fiber network. The new technology allows a larger amount of information to be transmitted than before. Due to its bandwidth and relatively high installation cost, however, the optic fiber network does not exhibit the inherent structural redundancy provided by the conventional copper-based network. We propose to supply it by adding multiple paths between important nodes. This so-called network survivability problem is computationally expensive to solve exactly. We report the application of a heuristic algorithm to this problem. Also discussed is the issue of how to make use of existing conduits.

• IE interfaces
• /
• v.9 no.3
• /
• pp.64-71
• /
• 1996

In the survivability and simplicity aspect, SONET Self-healing Ring(SHR) is one of the most important schemes for the high-speed telecommunication networks. Since the ring capacity requirement is defined by the largest STS-1 cross-section in the ring, load balancing is the key issue in the design of SONET SHR. Recently, most of the research on load balancing problem have been concentrated on the SONET single-ring case. However, in certain applications, multiple-ring configuration is necessary because of the geographical limitations or the need for extra bandwidth. In this paper, the load balancing problem for SONET dual-ring is considered by assuming symmetric inter-ring demands. We present a linear programming based formulation of the problem. Initial solution and improvement procedures are presented, which solves the routing and interconnection between the two rings for each demand. Computational experiments are performed on various size of networks with randomly generated demand sets. Results show that the proposed algorithm is excellent in both the solution quality and the computational time requirement. The average error bound of the solutions obtained is 0.26% of the optimum.

• IE interfaces
• /
• v.25 no.2
• /
• pp.153-162
• /
• 2012

The reliability is defined as a probability that a system will operate properly for a specified period of time under the design operating conditions without failure and it has been considered as one of the major design parameters in the field of industries. Reliability-Redundancy Optimization Problem(RROP) involves selec tion of components with multiple choices and redundancy levels for maximizing system reliability with constraints such as cost, weight, etc. However, in practice both active and cold standby redundancies may be used within a particular system design. Therefore, a redundancy strategy(active, cold standby) for each subsystem in order to maximize system reliability is considered in this study. Due to the nature of RROP, i.e. NP-hard problem, A Parallel Particle Swarm Optimization(PPSO) algorithm is proposed to solve the mathematical programming model and it gives consistently better quality solutions than existing studies for benchmark problems.

• IE interfaces
• /
• v.20 no.4
• /
• pp.504-514
• /
• 2007

The multicast routing problem lies in the composition of a multicast routing tree including a source node and multiple destinations. There is a trade-off relationship between cost and delay, and the multicast routing problem of optimizing these two conditions at the same time is a difficult problem to solve and it belongs to a multi-objective optimization problem (MOOP). A multi-objective genetic algorithm (MOGA) is efficient to solve MOOP. A micro-genetic algorithm(${\mu}GA$) is a genetic algorithm with a very small population and a reinitialization process, and it is faster than a simple genetic algorithm (SGA). We propose a multi-objective micro-genetic algorithm (MO${\mu}GA$) that combines a MOGA and a ${\mu}GA$ to find optimal solutions (Pareto optimal solutions) of multicast routing problems. Computational results of a MO${\mu}GA$ show fast convergence and give better solutions for the same amount of computation than a MOGA.

• ETRI Journal
• /
• v.37 no.5
• /
• pp.906-916
• /
• 2015

High-speed I/O channels require adaptive techniques to optimize the settings for filter tap weights at decision feedback equalization (DFE) read channels to compensate for channel inter-symbol interference (ISI) and crosstalk from multiple adjacent channels. Both ISI and crosstalk tend to vary with channel length, process, and temperature variations. Individually optimizing parameters such as those just mentioned leads to suboptimal solutions. We propose a joint optimization technique for crosstalk cancellation (XTC) at DFE to compensate for both ISI and XTC in high-speed I/O channels. The technique is used to compensate for between 15.7 dB and 19.7 dB of channel loss combined with a variety of crosstalk strengths from $60mV_{p-p}$ to $180mV_{p-p}$ adaptively, where the transmit non-return-to-zero signal amplitude is a constant $500mV_{p-p}$.

• IE interfaces
• /
• v.14 no.2
• /
• pp.172-181
• /
• 2001

Application Service Provider(ASP), the service provider who manages and delivers standard application functionality or associated service across a network to multiple customers using a usage-based pricing model, has appeared as a new business style in information technology market. For successful implementation of the ASP model, some critical issues should be noted. Because these issues are related to service qualities, certification and audit of ASP are important. This paper investigates characteristics of the ASP model and designs the proper frameworks for certification and audit of ASP. It is examined how the framework can remove potential threats and risks of the ASP model, and how the framework can be compared with traditional approaches.

• IE interfaces
• /
• v.13 no.4
• /
• pp.572-583
• /
• 2000

In this research we have developed a prototype which manages a product structure and configuration of a product under distributed heterogeneous computing environments. First, the data schema for product structure and configuration which can represent options and effectivity is proposed. Second, a technique to use JAVA and CORBA is suggested for the exchange of product structure among multiple servers in CITIS environments. Functions of the prototype related to option-based product structure are described to help readers' understanding.

• IE interfaces
• /
• v.16 no.1
• /
• pp.27-33
• /
• 2003

The maintenance cost in K Steelworks has been continuously increased in proportion to the production cost. However, there seems to be a possibility of reducing cost through the optimization of maintenance actions. The failure types of the equipment in steelworks ate various with different failure cost. Thus the failure rate and cost of each type of failures should be considered simultaneously when the optimum maintenance period is to be determined. It is considered that the equipment undergoes periodic replacement and a specified number of incomplete preventive maintenance actions are performed during a replacement period. Assuming that the time to failure follows a Weibull distribution, the parameters of the failure rate are estimated using the maximum likelihood estimation. The optimal replacement period is determined to minimize the average cost per unit time. As the result of analysis it is suggested that the existing maintenance period for a hot-rolling equipment can be extended significantly.

• Proceedings of the KIEE Conference
• /
• 1996.07b
• /
• pp.1272-1274
• /
• 1996

This paper presents the development of tactile sensor systems for robot hand which are truly usable, robust, reliable and cheap system. The sensor incorporates multiple sensing subsystems for detecting distributed contact forces and surface characteristics. The fabrication and experimental evaluation of the tactile system and its electric interfaces are described. The results indicate that the system provides reasonable performances for practical applications requiring manipulation with tactile feedback.