• Journal of Korea Society of Digital Industry and Information Management
• /
• v.8 no.4
• /
• pp.115-120
• /
• 2012

In multi-user multi-input multi-output (MU-MIMO) system, zero forcing beamforming (ZFB) is regarded as a realistic solution for transmitting scheme due to its low complexity and simple structure. However, ZFB shows a significant performance degradation when channel matrix has large condition number. In this case, the largest singular value of the channel inversion matrix has a dominant effect on transmit power. In this paper, we propose a perturbation method for reducing an effect of the dominant singular value. In the proposed algorithm, channel inverse matrix is first decomposed by SVD for the transmit signal to be expressed as a combination of singular vectors. Then, the transmit signal is perturbed to reduce the coefficient of the singular vector corresponding to the largest singular value. When a number of transmit antennas is 4, the simulation results of this paper shows that the proposed method shows 8dB performance enhancement at 10-3 uncoded bit error rate (BER) compared with conventional ZFB. Also, the simulation results show that the proposed method provides a comparable performance to Tomlinson-Harashima Precoding (THP) with much lower complexity.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.15 no.4
• /
• pp.1568-1589
• /
• 2021

Deployment of access point (AP) is a problem that must be considered in network planning. However, this problem is usually a NP-hard problem which is difficult to directly reach optimal solution. Thus, improved AP deployment optimization scheme based on swarm intelligence algorithm is proposed to research on this problem. First, the scheme estimates the number of APs. Second, the multi-objective particle swarm optimization (MOPSO) algorithm is used to optimize the location and transmit power of APs. Finally, the greedy algorithm is used to remove the redundant APs. Comparing with multi-objective whale swarm optimization algorithm (MOWOA), particle swarm optimization (PSO) and grey wolf optimization (GWO), the proposed deployment scheme can reduce AP's transmit power and improves energy efficiency under different numbers of users. From the experimental results, the proposed deployment scheme can reduce transmit power about 2%-7% and increase energy efficiency about 2%-25%, comparing with MOWOA. In addition, the proposed deployment scheme can reduce transmit power at most 50% and increase energy efficiency at most 200%, comparing with PSO and GWO.

• Journal of Korea Society of Industrial Information Systems
• /
• v.25 no.2
• /
• pp.49-56
• /
• 2020

We investigate the transmit power control algorithm for multi-access points environment. Each terminal may transmit a signal to one of these access points. Each access point may receive a signal from desired terminals as well as interference from neighbor terminals. In this paper, a transmit power control algorithm is developed such that the total transmit power is minimized, while each terminal meets the target signal to interference ratio (SIR) requirement. In particular, the effect of increasing the number of access-points on the total transmit power consumption is analyzed. Based on this analysis, we propose a convergence guaranteed power control algorithm. We prove that the proposed iterative algorithm always converges to the target SIR. In addition, we show that the proposed algorithm optimizes the transmit power level. Simulation results show that the proposed algorithm guarantees convergence regardless of the number of access points. We also observed that increasing the number of access points reduces the total transmit power consumption.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.37A no.9
• /
• pp.721-727
• /
• 2012

Since a conventional multi-cell transmit diversity scheme depends on the feedback from the user for the channel gain information, its performance gets to severely degrade when the channel varies fast due to the high mobility of the user. Also, transmit power of the base station cannot be fully used in the conventional scheme because only one transmit antenna is used for data transmission. In this paper, we propose a multi-cell transmit diversity scheme appropriate for fast fading channel. In the proposed scheme, channel-independent precoding vector is applied over all transmit antennas and different precoding vectors are applied for neighboring subcarriers so that the received signal is avoided to experience deep fading over multiple neighboring subcarriers. Simulation results show that the proposed scheme has better detector output signal-to-noise ratio (SNR) and bit error rate (BER) performances than the conventional scheme.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2015.05a
• /
• pp.57-60
• /
• 2015

Recently, a multi-user massive MIMO (MU-Massive MIMO) network has been attracting tremendous interest as one of technologies to accommodate explosively increasing mobile data traffic. The MU-Massive MIMO network can significantly enhance the network capacity because a base station (BS) equipped with large-scale transmit antennas can transmit high-rate data to multiple users simultaneously. In the MU-Massive MIMO network, transmit antenna selection schemes are generally used to decrease the computational complexity and cost of the BS. In this paper, we investigate the energy efficiency of the transmit antenna selection scheme in the MU-Massive MIMO network and the optimal number of selected transmit antennas for maximizing the energy efficiency.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.24 no.8
• /
• pp.1022-1029
• /
• 2020

We investigate the joint selection problem of the transmit power level and the best access point for multi-access points. We further reduce the transmit power by jointly optimizing the transmit power and the access point selection. Our aim is to minimize the total transmit power, while each terminal maintains minimum signal to interference ratio requirement. We observe that the optimum solution can be achieved through proposed iterative algorithm for both TA link and AT link. Simulation results show that proposed algorithm (joint optimization of transmit power level and access point) outperforms the algorithm which optimizes the transmit power only. We also observe that the duality between the TA link and AT link does not hold in multi-access points environment. Accordingly, the resulting power vectors and the access point vectors for TA link and AT link are different in general.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.25 no.8B
• /
• pp.1348-1356
• /
• 2000

In this paper, we proposed a trellis coded Multi-Carrier CDMA 16 QAM system with multiple transmit/receive antenna diversity technique, which is simple and suitable for indoor wireless communications. The proposed multiple transmit/receive antenna diversity technique is that the transmitter sends a trellis coded Multi-Carrier CDMA 16 QAM signal from multiple transmitting antennas with intentional time delays, which makes a receiver possible to distinguish and combine the signals from different antennas. In wireless indoor communication system, if we allow the increase of the complexity of the system, it is also possible to achieve additional diversity gain in the performance with the combination of the proposed technique and the conventional receiving antenna diversity. Furthermore, we have found that the proposed trellis coded Multi-Carrier CDMA 16 QAM system, which employs multiple transmit/receive antenna, is less sensitive to the multiple user interference and fading than conventional receiving antenna diversity systems.

• Journal of Satellite, Information and Communications
• /
• v.6 no.2
• /
• pp.20-25
• /
• 2011

The authors have proposed novel TDD-CDMA systems with Pre-Rake transmit diversity schemes (system 1 and system 2) using multiple transmit antennas in [2] and have also evaluated the system performance through the theoretical analysis and computer simulation. However, the performance of system 2 which transmit a signal using all antennas has not been evaluated for multi-user environment. Therefore in this paper, we analyze the performance of system 2 for multi-user environment and compare the performance with that of the already proposed system 1 which chooses only one antenna. From the numerical results, it is found that system 2 outperforms system 1 as the number of users increases while system 1 outperforms system 2 at a small number of users. Therefore in order to achieve the best system performance, the Pre-Rake transmit diversity type should be selected at the base station according to the number of users.

• Journal of Positioning, Navigation, and Timing
• /
• v.7 no.2
• /
• pp.53-59
• /
• 2018

This paper proposes a pseudo-random beamforming technique for time-synchronized mobile base stations (BSs) for multi-cell downlink networks which have mobility. The base stations equipped with multi-antennas and mobile stations (MSs) are time-synchronized based on global positioning system (GPS) signals and generate a number of transmit beamforming matrix candidates according to the predetermined pseudo-random pattern. In addition, MSs generate receive beamforming vectors that correspond to the beam index number based on the minimum mean square error (MMSE) using transmit beamforming vectors that make up a number of transmit beamforming matrices and wireless channel matrices from BSs estimated via the reference signals (RS). Afterward, values of received signal-to-interference-plus-noise ratio (SINR) with regard to all transmit beamforming vectors are calculated, and the resulting values are then feedbacked to the BS of the same cells along with the beam index number. Each of the BSs calculates each of the sum-rates of the transmit beamforming matrix candidates based on the feedback information and then transmits the calculated results to the BS coordinator. After this, optimum transmit beamforming matrices, which can maximize a sum-rate of the entire cells, are selected at the BS coordinator and informed to the BSs. Finally, data signals are transmitted using them. The simulation results verified that a sum-rate of the entire cells was improved as the number of transmit beamforming matrix candidates increased. It was also found that if the received SINR values and beam index numbers are feedbacked opportunistically from each of the MSs to the BSs, not only nearly the same performance in sum-rate with that of applying existing feedback techniques could be achieved but also an amount of feedback was significantly reduced.

• Proceedings of the IEEK Conference
• /
• 2006.06a
• /
• pp.19-20
• /
• 2006

In this paper, to reduce uplink feedback information for the beam weight and simultaneously maintaining the performance, we propose a MIMO-OFDM (Multi Input Multi Output-Orthogonal Frequency Division Multiplexing) system based on beamforming with antenna selection. In the proposed system, to perform the beamforming with more useful transmit antennas, the optimal combination of transmit antennas with maximum MRT (Maximum Ratio Transmission) beamforming gain is selected. Simulation results reveal that the proposed MIMO-OFDM system adopting the beamforming with antenna selection can reduce the feedback information for the beam weights as compared to the system using all the transmit antennas without serious degradation of system performance.