• Geophysics and Geophysical Exploration
• /
• v.19 no.2
• /
• pp.76-83
• /
• 2016

Migration image can be distorted due to reflected waves in the source and receiver wavefields when discontinuities of input velocity model exist in seismic imaging. To remove reflected waves coming from layer interfaces, it is a common practice to smooth the velocity model for migration. If the velocity model is smoothed, however, the subsurface image can be distorted because the velocity changes around interfaces. In this paper, we attempt to minimize the distortion by reducing reflection energy in the source and receiver wavefields through acoustic impedance homogenization. To make acoustic impedance constant, we define fake density model and use it for migration. When the acoustic impedance is constant over all layers, the reflection coefficient at normal incidence becomes zero and the minimized reflection energy results in the improvement of migration result. To verify our algorithm, we implement the reverse-time migration using cell-based finite-difference method. Through numerical examples, we can note that the migration image is improved at the layer interfaces with high velocity contrast, and it shows the marked improvement particularly in the shallow part.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.21 no.2
• /
• pp.201-206
• /
• 1992

Pinus pollen is used as the chief ingredient for Song-wha-dashik (Korea's traditional pattern-pressed candy). It has been the food stuff indispensable especially on the occasion of performing ancestral rites and holding a banquet since Shilla and Koryo Dynasty. In this paper, therefore, a new examination is made of the nutritive ingredients of the very Pinus pollen. Analysis has been made of the proximate composition, minerals, heavy metals, vitamins and free sugars of the Pollen of both Pinus densinora Siebol et Zuccarini and Pinus rigida Miller. In the proximate composition, Pinus rigida Miller is high except in free sugar ; crude ash (4.0%), crude protein (15.0%), crude fat (2.5%), crude fiber (17.5%). A lot of minerals have been found in both the samples. They contain Mg, Cl, Ca, Fe, Mn, Na, Zn, etc. In heavy metals, both the samples contain the same quantity of Cd(0.3 ppm) and the contents of Pb, Cu, and As are lower than the maximal limit permitted for food stuff. The contents of vitamin B$_1$, B$_2$, vitamin C are a little higher in Pinus rigida Miller : in vitamin E, on the contrary, Pinus densiflora Siebol et Zucarini (1.6 mg) doubles Pinus rigida Miller (0.8 mg). In free sugars, the results is as follows : 6.6%/6.9% in sucrose : 0.2% in fructose : 2.1% /2.9% in glucose respectively.

• The Journal of Engineering Geology
• /
• v.16 no.2 s.48
• /
• pp.189-199
• /
• 2006

This paper presents a field study of the stability of slope collapsed during road construction and proposes a reasonable countermeasure if the current slope is unstable. As a result of slope investigation, it was found that the slope includes five tension cracks and the sliding surface is started from the tension crack and propagated the surface soil layer through weathered rock layer. The slope stability analyses are conducted in case of dry and rainfall seasons. The results indicate that the slope is unstable status. A reinforcement method of slope failure should be selected according to the scale of failure. That is, the scale of slope failure, which is classified small, middle and large size determines the reinforcement method of slope. Since the slope interested in this study is large size failure slope, the reinforcement method to control slope failure is selected stabilizing piles, and seed spray and drainage of surface waterare also selected to remain the factor of safety. The SLOPILE (Ver. 3.0) program is applied in order to do stability analysis of slope reinforced by piles. As the result of analysis, the slope reinforced by a row of piles shows the stable state. It is clearly confirmed that the stabilizing of piles can improve the stability of slope.

• Journal of Korean Society of Environmental Engineers
• /
• v.35 no.2
• /
• pp.109-114
• /
• 2013

Polyhydroxyalkanoates (PHAs) are synthesized by numerous bacteria as carbon and energy storage compounds and are raw materials for biocompatible plastics. In this paper, the effect of $CO_2$ concentrations on the growth of C. necator and the accumulation of Poly(3-hydroxybutyrate) (P(3HB)) are investigated by increasing the $CO_2$ concentration in the substrate gas mixture. During 6 d cultivation in a nitrogen-present mineral medium, the $CO_2$ concentration did not affect the growth of the cells, while the Poly(3- hydroxybutyrate) (P(3HB)) content decreased with increasing $CO_2$ concentrations from 1% to 20%. During 4 d cultivation in the nitrogen-limited medium, the P(3HB) accumulation was the greatest at 3% $CO_2$; however, the total amount of accumulated P(3HB) was the greatest at 1% $CO_2$, which decreased with increasing $CO_2$ concentrations. The results indicate that the gas mixture with 1% $CO_2$ is the most effective in both growing the cells and accumulating P(3HB) under our experimental conditions.

• Economic and Environmental Geology
• /
• v.42 no.5
• /
• pp.495-500
• /
• 2009

Actinide sorption to the geological materials can reduce the mobility and bioavailability of radionuclides released to the environment through the development of nuclear weapons and nuclear energy. Under circumneutral pH conditions, actinide sorption can be enhanced by phosphate anions sorbed on oxide mineral surfaces as indicated by the sorption of trivalent lanthanide ions ($Ln^{3+}$), the chemical analog for trivalent actinide ions ($Ac^{3+}$). In this paper, we examined a ternary sorption system of trivalent europium ions ($Eu^{3+}$) sorbed onto boehmite (${\gamma}$-AlOOH) surfaces pre-sorbed with phosphate anions (${PO_4}^{3-}$), using extended X-ray absorption fine structure (EXAFS) spectroscopy. In the Eu-$PO_4$-boehmite ternary sorption system, $EuPO_4$ surface precipitates were formed as implicated by Eu $L_{III}$-edge EXAFS spectroscopy. Phosphorus K-edge EXAFS fingerprinting indicated a bidentate mononuclear surface complex formation of phosphate sorbed on boehmite surfaces as well as $EuPO_4$ surface precipitate formation.

• Korean Journal of Agricultural and Forest Meteorology
• /
• v.2 no.4
• /
• pp.190-197
• /
• 2000

Anions such as C $l^{[-10]}$ , N $O_3$$^{[-10]}$ , S $O_4$$^{2-}$, P $O_4$$^{3-}$, and organic anions, that do not become a part of the clay mineral crystal lattice, are of considerable interest in soils which are a potential sink caused by acid rain. In this paper, elution of native sulfate and breakthrough curves (BTC) were obtained from miscible displacement of non-specifically or specifically adsorbed anions through non-saturated or saturated Bt soil of Chungwon series. The shape and position of the BTC's could be affected by adsoprtion and ion exchange onto the soil particle surfaces. Measured BTC's for oxalic acid under unsaturated and saturated conditions showed that less pore volumes were required to displace the native S $O_4$$^{2-}$S from the soil column, and that maximum detection limit of oxalic acid reached earlier than under unsaturated. The retarded BTC's to the righthand side could be attributed by different adsorption behavior of each anion, although BTC's may be influenced by the smaller order of velocity change. The alternate breakthrough and elution curves show the rapid approach to the maximum detection limit of C/Co = 1, compared to progressive tailing of elution curve to reach to C/Co = 0. The probable explanation for asymmetric elution patterns for both anion is that the anion was selectively adsorbed on the positively charged soil surface from the solution passing in the soil column. On the other hand, the variations of pH in effluent showed that pH was increased to 7 in the first 6 pore volume and then gradually decreased to pH 4.

• Restorative Dentistry and Endodontics
• /
• v.34 no.3
• /
• pp.208-214
• /
• 2009

The purpose of this study was to compare the dye leakage of MTA (mineral trioxide aggregate) apical plug produced by two orthograde placement techniques (hand condensation technique and ultrasonically assisted hand condensation technique). To simulate straight canal, 60 transparent acrylic blocks with straight canal were fabricated. These transparent acrylic blocks were divided into 2 groups (Group C; hand condensation technique (HC) and Group U; ultrasonically assisted hand condensation technique (UAHC)) of 30 blocks with each MTA application method. Each group was divided into 2 subgroups (n=15) with different canal size of #70 (subgroup C70 and subgroup U70) and #120 (subgroup C120 and subgroup U120). After apical plug was created, a wet paper point was placed over the MTA plug and specimen was kept in a humid condition at room temperature to allow MTA to set. After 24 hours, remaining canal space was backfilled using Obtura II. All specimens were transferred to floral form socked by 0.2% rhodamine B solution and stored in 100% humidity at room temperature. After 48 hours, resin block specimens were washed and scanned using a scanner. The maximum length of micro leakage was measured from the scanned images of four surfaces of each resin block using Photoshop 6.0. Statistical analysis was performed with Mann-Whitney U test. Group U of UAHC had significantly lower leakage than Group C of HC in #70-size canal (subgroup U70) (p<0.05).

• Korean Journal of Poultry Science
• /
• v.27 no.2
• /
• pp.115-132
• /
• 2000

Eggshell strength and eggshell pigmentation are described in this paper since these are needed for quality egg production. A strong eggshell is determined by the components of the shell (cuticle, true shell and membranes) as well as the proper function of the gastrointestinal tract, the shell gland, the Kidneys and the endocrine system. When the puller reaches sexual maturity, the medullary bone must be ready for the laying hen at the peak egg shell formation. The amount of calcium in the layer diet, sources of calcium feed, the ratio of calcium and phosphorus in the layer diet, adequate levels of vitamin D and the dietary mineral (electrolyte) balance in the body fluid are important factors along with the levels of other nutrients. Biological, environmental and managerial factors such as the age of laying flock, temperature and humidity of the hen house, bird strain, disease, egg collection through transportation and others and influence the shell breakage at various stages of movement of the eggs from the producer to the consumer. The pigments present in eggshells are protoporphyrin-Ⅸ, biliverdin-Ⅸ and its zinc chelate and occasional traces of coproporphyrin-Ⅲ. However, there are several causes of changes in eggshell pigmentation such as the age of hen, disease, drugs and surface defects due to abnormal post-cuticular deposits.

• Korean Journal of Soil Science and Fertilizer
• /
• v.44 no.5
• /
• pp.727-733
• /
• 2011

A new Korean standard for the determination of Cr(VI) in soils has been officially published as ES 07408.1 in 2009. This analytical method is based on the hot alkaline digestion and colorimetric detection prescribed by U.S. EPA method 3060A and 7196A. The hot alkaline digestion accomplished using 0.28 M $Na_2CO_3$ and 0.5 M NaOH solution (pH 13.4) at $90{\sim}95^{\circ}C$ determines total Cr(VI) in soils extracting all forms of Cr(VI), including water-soluble, adsorbed, precipitated, and mineral-bound chromates. This aggressive alkaline digestion, however, proved to be problematic for certain soils which contain large amounts of soluble humic substances or active manganese oxides. Cr(III) could be oxidized to Cr(VI) by manganese oxides during the strong alkaline extraction, resulting in overestimation (positive error) of Cr(VI). In contrast, Cr(VI) reduction by dissolved humic matter or Fe(II) could occur during the neutralization and acidic colorimetric detection procedure, resulting in underestimation (negative error) of Cr(VI). Futhermore, dissolved humic matter hampered the colorimetric detection of Cr(VI) using UV/Vis spectrophotometer due to the strong coloration of the filtrate, resulting in overestimation (positive error) of Cr(VI). Without understanding the mechanisms of Cr(VI) and Cr(III) transformation during the analysis it could be difficult to operate the experiment in laboratory and to evaluate the Cr(VI) results. For this reason, in this paper we described the theoretical principles and limitations of Cr(VI) analysis and provided useful guidelines for laboratory work and Cr(VI) data analysis.

• Journal of Korean Tunnelling and Underground Space Association
• /
• v.21 no.1
• /
• pp.137-153
• /
• 2019

Estimating tunnel construction time and costs are the most fundamental part of a tunnel project planning, which has been generally assessed on a deterministic basis until now. In this paper, excavation cycle time was investigated for two road tunnels and one subway tunnel, and the results were compared with the Standard of Construction Estimate (SE), which is made for the estimation of construction time and cost in a design stage. The results show that the difference in cycle time between SE and actual cycle time is 50%, 7% and 31% respectively for the three tunnels, which means that SE does not reflect practical operation time. The major reasons of the difference are skilled level of tunneling workers, the change of operation sequences for more effective operations, much more complicated working atmosphere in a tunnel than the assumption of SE etc. Finally, even though the results can not be generalized since investigated tunnels are only 3, but it is thought that SE needs to be upgraded into the model able to consider quite common situations through additional tunnel investigation and studies in the future.