• Journal of Advanced Marine Engineering and Technology
• /
• v.33 no.8
• /
• pp.1254-1260
• /
• 2009

CDMA tele-Controller system is designed with a low power consumption 8 bit microcontroller, ATmega 2560. ATmega 2560 microcontroller consists of 4 UART (Universal asynchronous receiver/transmitter) ports, 4 kbytes EEPROM, 256 kbytes flash memory, 4 kbytes SRAM. 4 URAT is used for CDMA modem, communication for GPS module, EEPROM is used for saving a configuration for program running, a flash memory of 256 kbytes is used for storing a F/W(Firm Ware), and SRAM is used for stack, storing memory of global variables while program running. We have tested the communication distance between the coast station and sea by the fabricated control board using 800 MHz CDMA modem and GPS module, which is building for the navigational aid management system by remote control. As a results, the receiving signal strength is above -80 dBm, and then the characteristics of the control board implemented more than 10 km in the distance of the communication.

• Journal of the Computational Structural Engineering Institute of Korea
• /
• v.28 no.6
• /
• pp.707-714
• /
• 2015

In this paper, an experimental program has been conducted to investigate transfer length in high strength concrete members pretensioned through a seven-wire strand with FBG sensors. To measure transfer length, five members were fabricated, which had a length of 3 m and a cross-section of $150{\times}150mm$. It was measured that the concrete compressive strength was 58MPa at pretensioning. Test results indicated that more precise and reliable measurement on the transfer length was attained with FBG sensors than conventional gauges attached on concrete surface. Through comparing the measured transfer length and predictions, applicability of several transfer length models in literature was investigated. This paper can be useful for relevant research field such as investigation on the bond mechanism of a seven-wire strand in concrete members.

• Journal of Advanced Marine Engineering and Technology
• /
• v.35 no.6
• /
• pp.796-801
• /
• 2011

The objective of this work presented here was focused on analysis of development trend for the integrated power system of naval vessels to perform the high-power and energy mission load platform. These mission loads are affected by the high level of military technologies, digitalization of the ocean battlefield, high power sensor system for maximization of the ship survivability. All electric power including propulsion power for ship should be controlled by integrated single system in order to carry various high power density weapon system such as Electromagnetic Aircraft Launch System, Electromagnetic Rail Gun[feasible precision striking at long distance 200NM(370km) or over]. As the analyzing the present state of things, mechanical propulsion system is shifted into hybrid or fully electric propulsion systems to realize integrated power system at the developed countries. Such challenges include reduced dependency on foreign-supplied fossil fuel, increasing demand for installed ship power, controlling life-cycle costs.

• Journal of Advanced Navigation Technology
• /
• v.18 no.2
• /
• pp.128-133
• /
• 2014

This paper is the study of BNWAS based on TLC. The functionality of BNWAS and its operations are investigated through its international standard. But the BNWAS to be used currently in the ship have difficulty in monitoring. Several kinds of data are generated from many equipments in BNWAS, such as NMEA-0183 data or NMEA-2000. Although these data are mainly used for the safe navigation of ship, their usability may be enhanced if they are managed to control the BNWAS equipment with sensors. The purpose of this system is prevent the marine accidents on sailing voyages due to drowsiness of watchers. On Night sailing, watcher is collected the navigation information from multiple devices and he determines the safe operation of the ship through continuous monitoring.

• Journal of Advanced Marine Engineering and Technology
• /
• v.37 no.4
• /
• pp.425-430
• /
• 2013

Robust and high speed underwater communication is severely limited when compared to communications in terrestial. In free space, RF communication operates over long distances at high data rates. However, the obstacle in seawater is the severe attenuation due to the conducting nature. Acoustic modems are capable of long range communication up to several tens of kilometers, but it has low data-rate, high power consumption and low propagation speed. An alternative means of underwater communication is based on optics, wherein high data rates are possible. In this paper, the characteristics of underwater channel in the range of visible wavelength is investigated. And the possibility of optical wireless communication in underwater is also described. The LED-based transceiver and CMOS sensor module are integrated in the system, and the performance of image transmission was demonstrated.

• Journal of the Korean Society for Marine Environment & Energy
• /
• v.16 no.4
• /
• pp.263-267
• /
• 2013

In this research, a novel optical measuring methodology for the measurement of oil thickness in seawater is suggested by evaluating the light absorption which is occurred in the process of penetrating through oil layer on seawater. Laser having monochromatic wave is used as a light source and photodiode which can convert the intensity of the light into an electrical signal is applied to measure the intensity of the penetrating light through the oil-water mixtures. In the experiment, bunker C and lubricating oil are used, and three different lasers having different wavelengths are applied and compared for the selection of an optimal light source. As a result, it is observed that in the case of blue laser, the intensity of the light on the optical sensor decreases with an increase in the oil thickness. Through this relation, both the presence of oil and the thickness of oil can be determined.

• Ocean and Polar Research
• /
• v.35 no.1
• /
• pp.15-26
• /
• 2013

The toxic, Harmful Algal Blooms (HABs) caused by the Cochlodinium polykrikoides have a serious impact on the coastal waters of Korea. In this study, the acoustic detection system was developed for rapid HABs detection, based on the acoustic backscattering properties of the C. polykrikoides. The developed system was mainly composed of a pulser-receiver board, a signal processor board, a control board, a network board, a power board, ultrasonic sensors (3.5 and 5.0 MHz), an environmental sensor, GPS, and a land-based control unit. To evaluate the performance of the system, a trail was done at a laboratory, and two in situ trials were conducted: (1) when there was no red tide, and (2) when there was red tide. In the laboratory evaluation, the system performed well in accordance with the number of C. polykrikoides in the received level. Second, under the condition when there was no red tide in the field, there was a good correlation between the acoustic data and sampling data. Finally, under the condition when there was red tide in the field, the system successfully worked at various densities in accordance with the number of C. polykrikoides, and the results corresponded with the sampling data and monitoring result of NFRDI (National Fisheries Research & Development Institute). From the laboratory and field evaluations, the developed acoustic detection system for early detecting HABs has demonstrated that it could be a significant system to monitor the occurrence of HABs in coastal regions.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.19 no.6
• /
• pp.643-648
• /
• 2013

In this paper, we developed a system which can detect and can alarm about the sailing provocative climate by using a photo. The research on domestic shipbuilding industry and in IT fusion technology is under construction, but a reliable safety device which can alarm a sailor about the circumstances of the fog and rain during ship operation as soon as possible due to the constant state in domestic. In this paper, a compact, for system low-power transceiver and data processing equipment for sensing were developed, also a performance evaluation got accomplished with simulation analysis. In results, it is operating normally at least 32.36[dB] and maximum values f 89.20[dB] in the domestic, and 32.55 to 60.66[dB] in the outdoors.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2011.05a
• /
• pp.187-190
• /
• 2011

Until now, water pollution environmental monitoring system has been used at to acquire and measure data for streams and rivers. Recently coastal and marine environment monitoring system is becoming most important and urgent thing. The realtime automatic coastal and marine environment monitoring system using CDMA data transmission technique is developed in this study. The Embedded field server is designed and developed to acquire and measure underwater environment information such as pH, DO, water temperature using the water quality sensor. The obtained data is sent to the server via CDMA modem connected to the embedded field server and stored in database. Our purpose is to provide and monitor underwater environment information with CDMA communication in coastal areas.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2011.05a
• /
• pp.180-183
• /
• 2011

Recently, environmental problems have been deteriorating rapidly. Therefore, there is an urgent need to establish policies and research in the conservation of the global environment. Many researchers are studied in environment systems to prevent and reduce pollution of water, air and soil actively. In this paper, several parameters such as temperature, humidity, illumination, barometric pressure, dew point, water quality data, and air conditions are collected and transmitted thorough wireless sensor network. The field server is located in the coastal and marine area so that any abrupt changes can be detected quickly. In addition, WSN based flooding routing protocol for efficient data transmission is designed to support and monitor information of climate and marin factors.