• Nuclear Engineering and Technology
• /
• v.53 no.7
• /
• pp.2357-2363
• /
• 2021

Silicon carbide is widely used in radiation environments due to its excellent properties. However, when exposed to the strong radiation environment constantly, plenty of defects are generated, thus causing the material performance downgrades or failures. In this paper, the two-temperature model (2T-MD) is used to explore the defect recovery process by applying the electronic energy loss (Se) on the pre-damaged system. The effects of defect concentration and the applied electronic energy loss on the defect recovery process are investigated, respectively. The results demonstrate that almost no defect recovery takes place until the defect density in the damage region or the local defect density is large enough, and the probability of defect recovery increases with the defect concentration. Additionally, the results indicate that the defect recovery induced by swift heavy ions is mainly connected with the homogeneous recombination of the carbon defects, while the probability of heterogeneous recombination is mainly dependent on the silicon defects.

• Journal of Electrical Engineering and Technology
• /
• v.10 no.3
• /
• pp.1066-1074
• /
• 2015

This paper presents the reverse recovery characteristic according to the change of switching states when Si diode and SiC diode are used as clamp diode and proposes a method to minimize the switching loss containing the reverse recovery loss in the neutral-point-clamped inverter at low modulation index. The previous papers introduce many multiple circuits replacing Si diode with SiC diode to reduce the switching loss. In the neutral-point-clamped inverter, the switching loss can be also reduced by replacing device in the clamp diode. However, the switching loss in IGBT is large and the reduced switching loss cannot be still neglected. It is expected that the reverse recovery effect can be infrequent and the switching loss can be considerably reduced by the proposed method. Therefore, it is also possible to operate the inverter at the higher frequency with the better system efficiency and reduce the volume, weight and cost of filters and heatsink. The effectiveness of the proposed method is verified by numerical analysis and experiment results.

• Proceedings of the KIPE Conference
• /
• 2008.06a
• /
• pp.391-393
• /
• 2008

A modified boost converter with magnetic coupling is presented to reduce the reverse recovery loss while maintaining low conduction loss of the rectifiers. By utilizing a coupled inductor and a set of diodes, the current passing the boost rectifier is transferred to an auxiliary loop before turn-off, allowing low di/dt for reduced recovery loss. Moreover, the boost inductor is brought inside the bridge rectifier to reduce conduction loss by decreasing the number of conducting diodes during switch turn-off. Experimental results of a 500W prototype are provided to verify the increase in efficiency and validity of the proposed converter.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.2 no.2
• /
• pp.82-102
• /
• 2008

Packet losses tend to occur during short error bursts separated by long periods of relatively error-free transmission. There is also a significant spatial correlation in loss among the receiver nodes in a multicast session. To recover packet transmission errors at the transport layer, tree-based protocols construct a logical tree for error recovery before data transmission is started. The current tree construction scheme does not scale well because it overloads the sender node. We propose a scalable recovery tree construction scheme considering these properties. Unlike the existing tree construction schemes, our scheme distributes some tasks normally handled by the sender node to specific nodes acting as repair node distributors. It also allows receiver nodes to adaptively re-select their repair node when they experience unacceptable error recovery delay. Simulation results show that our scheme constructs the logical tree with reduced message and time overhead. Our analysis also indicates that it provides fast error recovery, since it can reduce the number of additional retransmissions from its upstream repair nodes or sender node.

• Proceedings of the Korean Society Of Semiconductor Equipment Technology
• /
• 2005.05a
• /
• pp.192-200
• /
• 2005

A high speed address recovery technique for AC plasma display panel(PDP) is proposed. By removing the GND switching operation, the recovery speed can be increased and switching loss due to GND switch also becomes to be reduced. The proposed method is able to perform load-adaptive operation by controlling the voltage level of energy recovery capacitor, which prevents increasing inefficient power consumption caused by circuit loss during recovery operation. Thus, th e technique shows the minimum address power consumption according to various displayed images, different from prior methods operating in fixed mode regardless of images. Test results with 50' HD single- scan PDP(resolution : $1366{\times}768$) show that less than 350ns of recovery time is successfully accomplished and about $54\%$ of the maximum power consumption can be reduced, tracing minimum power consumption curves.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.24 no.6
• /
• pp.396-405
• /
• 2019

Single-phase full-bridge inverters have shoot-through problems. Dead time is an essential way of solving these issues, but it distorts the output voltage and current. Dual-buck inverters are designed to eliminate the abovementioned problems. However, these inverters result in switching power loss and electromagnetic interference due to the diode reverse-recovery problem. Previous studies have suggested reducing the switching power loss from diode reverse-recovery, but their proposed methods have complex circuit configurations and high system costs. To alleviate the switching power loss from diode reverse-recovery, the current work proposes a dual-buck inverter with a coupled inductor. In the structure of the proposed inverter, the current flowing into the original diode is divided into a new diode. Therefore, the switching power loss is reduced, and the efficiency of the proposed inverter is improved. Simulation waveforms and experimental results for a 1.0 kW prototype inverter are discussed to verify the performance of the proposed inverter.

• The Journal of Internal Korean Medicine
• /
• v.1 no.1
• /
• pp.44-49
• /
• 1976

To investigate the effect of Kwi Ryong Tang a precious tonic of herbal drugs, the blood of rabbit was depleted from the heart for the purpose of experiment and the author administered the Kwi Ryong Tang to that rabbit. This effect of the tonic on the experimental groups was Compared with that of the control group and the author observed the following results; 1. In the experimental group treated with Kwi Ryong Tang before the depletion of the blood, the recovery of blood, the recovery of blood loss is some what accelerated that in the control group. 2. In the experimental group treated with Kwi Ryong Tang after the depletion of the blood, the recovery of blood loss is slightly accelerated that in experimental group which was treated with Kwi Ryong Tang before the depletion of the blood. 3. In the experimental group treated with Kwi Ryong Tang before and after the depletion of the blood, the recovery of the blood loss is markedly accelerated Comparing, that in the experimental group which was treated with Kwi Ryong Tang before or after the depletion of the blood loss.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.28 no.12B
• /
• pp.1106-1114
• /
• 2003

Several analytic models describe transmission control protocol (TCP) performance such as steady-state throughput as an averaged ratio of number of transmissions to latency. For more detailed analysis of TCP latency, the latency during packet losses are recovered should be considered. In this paper, we derive the expected duration of loss recovery latency considering the number of packet losses recovered by retransmissions. Based on the numerical results verified by simulations, TCP using selective acknowledgement (SACK) option is more effective than TCP NewReno from the aspect of loss recovery latency.

• Journal of the Korean Society of Hazard Mitigation
• /
• v.10 no.2
• /
• pp.135-141
• /
• 2010

Recently, to ensure the stability of flood control, instead of removal of concrete revetment, the vegetation mat method has been widely used on the recovery soil. However, the recovery soil method often failed to be stable against the flood, which caused the economic loss. In this study, the rate of soil loss and the velocity distribution on high water revetment are evaluated by the hydraulic experiments. The maximum difference of the soil loss rate was 52% depending on the vegetation. The reduction of the soli loss rate according to the vegetation is large when the revetment slope is steep. The maximum soil loss rate is 19.5% when there is no vegetation.

• Journal of Institute of Control, Robotics and Systems
• /
• v.17 no.7
• /
• pp.704-713
• /
• 2011

For many years, many pilots lost their lives and aircrafts due to GLOC(Gravity-induced Loss Of Consciousness). Due to the emergence of high-gravity maneuvering aircraft such as the F-16, F-15 and T-50, the automatic GLOC detection and recovery systems are necessary to increase the aircraft safeties even when the pilot loses his consciousness due to high-G maneuvering. This paper addresses the design of GLOC detection, warning and recovery algorithm based on a model of supersonic jet trainer. The system is solely controlled by the pilot's control input (i.e., control stick force) and aircraft status such as attitude, airspeed, altitude and so forth. And, moreover, it does not depend upon any pilot physiological condition. The test evaluation results show that the developed system supports the recovery of an aircraft from the unusual aircraft attitude and improves the aircraft safeties even when the pilot loses his consciousness due to high-G maneuvering.