• Journal of electromagnetic engineering and science
• /
• v.9 no.2
• /
• pp.78-84
• /
• 2009

This paper represents the effects of drain bias on the linearity and efficiency of an analog pre-distortion power amplifier(PA) for wideband code division multiple access(WCDMA) repeater applications. For verification, an analog predistorter(APD) with three-branch nonlinear paths for memory-effect compensation is implemented and a class-AB PA is fabricated using a 30-W Si LOMaS. From the measured results, at an average output power of 33 dBm(lO-dB back-off power), the PA with APD shows the adjacent channel leakage ratio(ACLR, ${\pm}$5 MHz offset) of below -45.1 dBc, with a drain efficiency of 24 % at the drain bias voltage($V_{DD}$) of 18 V. This compared an ACLR of -36.7 dEc and drain efficiency of 14.1 % at the $V_{DD}$ of 28 V for a PA without APD.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2003.11a
• /
• pp.107-111
• /
• 2003

The need for this study must be considerable, as being activate of green roofs research that the organization and construction obtain access to more development technologies. Nevertheless, the green roofs system has begun to apply since 1980's, the green roofs technology was restricted to develop without verification of technologies such as a load or water leakage. There is a limit as urethane waterproofing to almost domestic waterproofing materials and methods of construction for general green roofs. The introduction of materials and methods of construction which are appropriated to property of green roofs could be a decisive factor in a long-range durability and economical maintenance cost, moreover, it support to variety construction system and organization. This present paper describes a necessity of waterproofing and root barrier system is one of the sub-organization based on green roofs construction, which have enormously large impact on the durability.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.67 no.8
• /
• pp.1106-1112
• /
• 2018

In this paper, measurement techniques are presented to test the performance of insulation without interruption if it is difficult to measure insulation resistance. Especially, non-contact voltage phase detection techniques have been developed that can be applied in environments where it is difficult to find voltage measurement locations such as component receptors. The performance verification of the non-interrupting insulation resistance measuring devices has been tested against existing products using standard calibration equipment and test jigs. The validation confirmed performance within 2 % for direct contact type and within 10 % for non-contact type. In addition, the procedure to make continuous insulation test using the equipment was proposed.

• Journal of IKEEE
• /
• v.19 no.4
• /
• pp.610-616
• /
• 2015

In this paper, an electronic ID system satisfying security requirements of authentication certificate was designed using fingerprint recognition. The proposed electronic ID system generates a digital signature with forgery prevention, confidentiality, content integrity, and personal identification (=non-repudiation) using fingerprint information, and also encrypts, sends, and verify it. The proposed electronic ID system exploits fingerprint instead of user password, so it avoids leakage and hijacking. And it provides same legal force as conventional authentication certificate. The proposed electronic ID consists of 4 modules, i.e. HSM device, verification server, CA server, and RA client. Prototypes of all modules are designed and verified to have correct operation.

• Journal of Magnetics
• /
• v.14 no.1
• /
• pp.47-51
• /
• 2009

The coreless linear synchronous motor (coreless LSM) has been widely used as a driving source of semiconductor production processes for machine speeding up, positioning accuracy and simple maintenance. However, this coreless LSM suffers the disadvantage of decreased thrust force created by the leakage of magnetic flux. With the goal of increasing the generated thrust force and decreasing the cogging force, the slot of the core part was removed and a moving-coil-type slotless LSM (moving-coil-type slotless LSM) is proposed in this paper. Although this moving-coil-type slotless LSM with a back-yoke at the primary side demonstrated an increase in the generated thrust force, it remained capable of generating the cogging force when the primary side was moved due to the position between the permanent magnet and the back-yoke. Therefore, we attempted to decrease the cogging force of the moving-coil-type slotless LSM. We found that the back-yoke length at the primary side needs to be made $0.5{\tau}$ longer than the integral multiple of the magnetic pole pitch in order to decrease the cogging force created by the moving-coil-type slotless LSM.

• Journal of electromagnetic engineering and science
• /
• v.15 no.1
• /
• pp.53-58
• /
• 2015

For the testing of nonlinear power amplifiers, this paper suggests an approach to design optimized multisine signals that could be substituted for the original modulated signal. In the design of multisines, complex coefficients should be determined to mimic the target signal as much as possible, but very few methods have been adopted as general solutions to the coefficients. Furthermore, no solid method for the phase of coefficients has been proven to show the best resemblance to the original. Therefore, in order to determine the phase of multisine coefficients, a time-domain nonlinear optimization method is suggested. A frequency-domain-method based on the spectral response of the target signal is also suggested for the magnitude of the coefficients. For the verification, multisine signals are designed to emulate the LTE downlink signal of 10 MHz bandwidth and are used to test a nonlinear amplifier at 1.9 GHz. The suggested phase-optimized multisine had a lower normalized error by 0.163 dB when N = 100, and the measurement results showed that the suggested multisine achieved more accurate adjacent-channel leakage ratio (ACLR) estimation by as much as 12 dB compared to that of the conventional iterative method.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.18 no.3
• /
• pp.576-585
• /
• 2014

Collecting and utilizing have a huge amount of personal data have caused severe security issues such as leakage of personal information. Several encryption algorithms for collected personal information have been widely adopted to prevent such problems. In this paper, a novel algorithm based on MapReduce is proposed for encrypting such private information. Furthermore, test environment has been built for the performance verification of the distributed encryption processing method. As the result of the test, average time efficiency has improved to 15.3% compare to encryption processing of token server and 3.13% compare to parallel processing.

• Journal of the Korea Institute of Building Construction
• /
• v.4 no.1
• /
• pp.111-118
• /
• 2004

The need for this study must be considerable. as being activate of green roofs research that the organization and construction obtain access to more development technologies. Nevertheless, the green roofs system has begun to apply since 1980's, the green roofs technology was restricted to develop without verification of technologies such as a load or water leakage. There is a limit as urethane waterproofing to almost domestic waterproofing materials and methods of construction for general green roofs. The introduction of materials and methods of construction which are appropriated to property of green roofs could be a decisive factor in a long-range durability and economical maintenance cost, moreover, it support to variety construction system and organization. This present paper describes a necessity of waterproofing and root barrier system is one of the sub-organization based on green roofs construction. which have enormously large impact on the durability.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.15 no.2
• /
• pp.127-133
• /
• 2010

In the paper, reactorless high efficiency boost DC/DC converter for EV is proposed. In proposed converter, improves efficiency because decrease power loss when the switches are turned on/off using zero current switching (ZCS) at all switch of primary full bridge. By replacing reactance ingredients of L-C resonance circuit for ZCS with leakage inductance ingredients of high frequency transformer, it reduces system size and expense because of not add special reactor. For validity verification of proposed converter, in the paper implements simulation using PSIM and perform experiment by making 5KW DC/DC converter. In experimental results, efficiency of proposed converter conformed superiority.

• Nuclear Engineering and Technology
• /
• v.53 no.8
• /
• pp.2547-2555
• /
• 2021

The frequency of reactor coolant leakage is expected to increase over the lifetime of a nuclear power plant owing to degradation mechanisms, such as flow-acceleration corrosion and stress corrosion cracking. When loss of coolant accidents (LOCAs) occur, several parameters change rapidly depending on the size and location of the cracks. In this study, leak flow during LOCAs is predicted using a deep fuzzy neural network (DFNN) model. The DFNN model is based on fuzzy neural network (FNN) modules and has a structure where the FNN modules are sequentially connected. Because the DFNN model is based on the FNN modules, the performance factors are the number of FNN modules and the parameters of the FNN module. These parameters are determined by a least-squares method combined with a genetic algorithm; the number of FNN modules is determined automatically by cross checking a fitness function using the verification dataset output to prevent an overfitting problem. To acquire the data of LOCAs, an optimized power reactor-1000 was simulated using a modular accident analysis program code. The predicted results of the DFNN model are found to be superior to those predicted in previous works. The leak flow prediction results obtained in this study will be useful to check the core integrity in nuclear power plant during LOCAs. This information is also expected to reduce the workload of the operators.