• Proceedings of the Korean Nuclear Society Conference
• /
• 2004.10a
• /
• pp.683-684
• /
• 2004

The RF system for PEFP 20MeV proton linear accelerator is described. The RF system for 3MeV RFQ was already installed and operated to drive the RFQ. The klystron was tested up to 600kW itself and operated up to 350kW routinely. The HPRF dummy load was stabilized with the change of the coolant. Preparation of 20MeV DTL HPRF test has been completed. LCP and PLC system for klystron power supply was already prepared. Voltage fluctuation was measured during klystron test. Voltage control feedback loop seems to be re-adjusted.

• Proceedings of the KIEE Conference
• /
• 2011.07a
• /
• pp.492-494
• /
• 2011

전력설비 증가와 더불어 GIS 사용이 확대되고 있는 상황에서 GIS 내부고장 발생시 복구 지연으로 인한 사례가 지속 발생하고 있다. 이를 예방하기 위해 170kV GIS 고장구간 판정시스템용 압력센서를 개발하고 검증을 위해 실사용 GIS 2대를 이용하여 내아크 시험을 수행한 결과이다. 시험을 통해 고장시 GIS 탱크 내부의 압력, 온도, 압력파를 측정하였고 SF6 Gas 배관과 연결된 현장조작함(LCP)내 가스주입구에 설치한 압력센서의 동작유무을 검증하였다. 시험결과 유동해석(CFD) 등 시뮬레이션 예측보다 압력 및 온도 상승이 높게 측정되었고 제품에 대한 신뢰성과 확대적용 가능성을 확인할 수 있었다.

• Proceedings of the KIEE Conference
• /
• 2007.11c
• /
• pp.179-182
• /
• 2007

The Design and Optimization of a low-profile antenna for the Satellite Digital Audio Radio System(SDARS) using a Non-Dominated Sorting Genetic Algorithm(NSGA) is presented. a fairly omni-directional elevation gain pattern over 60 degrees < q <60 degrees are obtained. The average value of the LCP gain pattern is approximately 2 dBic. The heights of the antennas are less than 0.251. The cross polarized signal level is approximately 12 dBic less than the co-polarized signal level.

• Communications of the Korean Mathematical Society
• /
• v.32 no.3
• /
• pp.765-778
• /
• 2017

Finding an initial feasible solution on the central path is the main difficulty of feasible interior-point methods. Although, some algorithms have been suggested to remedy this difficulty, many practical implementations often do not use perfectly centered starting points. Therefore, it is worth to analyze the case that the starting point is not exactly on the central path. In this paper, we propose a weighted-path following interior-point algorithm for solving the Cartesian $P_{\ast}({\kappa})$-linear complementarity problems (LCPs) over symmetric cones. The convergence analysis of the algorithm is shown and it is proved that the algorithm terminates after at most $O\((1+4{\kappa}){\sqrt{r}}{\log}{\frac{x^0{\diamond}s^0}{\varepsilon}}\)$ iterations.

• Journal of Information Display
• /
• v.9 no.4
• /
• pp.11-14
• /
• 2008

A highly efficient organic light-emitting diode (OLED) with an in-cell polarizer made of an imprinted liquid crystalline polymer (LCP) layer doped with dichroic dye molecules is presented. The in-cell polarizer was found to be capable of effectively polarizing the emission light of the OLED and of significantly improving the luminance through the periodic microstructures fabricated using an imprinting method. This type of OLED with an imprinted in-cell polarizer is useful for efficient light source applications in liquid crystal displays (LCDs).

• Proceedings of the KIEE Conference
• /
• 2006.07a
• /
• pp.456-457
• /
• 2006

We have carried out the construction of the 154kV intelligent substation with KEPRI. The Intelligent substation is built in Gochang testing facility of KEPCO and consists of electronic instruments for GIS(gas insulated switchgear), digital control panel, remote monitoring and diagnosis system, and digital relay system. Rogowski coil type CT(RCT) and capacitive voltage divider(CVD) are introduced compared with the instrument transformer of conventional type. Digital control Panel(DCP) replaces the LCP(local control panel) which is drived for mechanical operation. For the monitoring of the condition of GIS and TR, various sensors are used. In this Paper, we mention the synopsis and report the progress state of project.

• Proceedings of the Korean Society for Technology of Plasticity Conference
• /
• 2004.05a
• /
• pp.241-244
• /
• 2004

Microlens patterned micro-mold fabrication method for Light Guiding Plate(LGP), kernel part of LCD-BLU(Back Light Unit), was presented. Instead of erosion dot pattern for LCP optical design, microlens pattern, fabricated by LIGA-reflow process, was applied. Optical pattern design method was also developed not only for negative pattern LGP, but also positive pattern LGP. In order to achieve flow balance during the micro-injection molding process and dimensional accuracy, two LGP pattern was made in one micro-mold.

• The Korean Journal of Rheology
• /
• v.9 no.3
• /
• pp.111-117
• /
• 1997

대표적인 신장유동의 하나인 방사공정을 통해 액정고분자를 포함한 블렌드 섬유의 신장유동의 특성과 형구학적 성질간의 관계를 고찰하였다. 신장유동에 의해 분산상인 액정 고분자는 미세섬유구조를 바뀌었고 압출온도가 높을수록 더욱 발달된 미세섬유구조를 가졌 다. 이러한 분산상의 미세구조 변화에 대한 설명은 블렌드의 신장유동특성을 나타내는 신장 점도비로서 가능하였다. 즉, 압출온도가 높을수록 방사사선에서 신장변형률속도가 z지고 신 장점도비가 작아지므로 분산상의 신장변형이 더 많이 되었다고 판단된다. 방사이전의블렌드 내의 분산상은 압출온도를달리하여도 모두 구형으로 존재함을 발견하였고 이사실로부터 분 산상의 미세섬유구조는 방사사선에서의 신장변형에 의해 주로 이루어졌음을 확인하였다.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2003.07a
• /
• pp.482-483
• /
• 2003

We have synthesized a new material of polyoxetane based liquid crystalline polymer/liquid crystal (LCP/LC) for flexible memory or dynamic mode device and characterized the electro-optics behavior of this system. The microscopic dynamic behavior of main chain, side chain, and the low molecular weight LC were characterized by X-ray scattering and time resolved FTIR..

• Bulletin of the Korean Chemical Society
• /
• v.23 no.9
• /
• pp.1201-1210
• /
• 2002

A new series of hyperbranched aromatic polyesters containing azoxybenzene mesogens and polymethylene spacers were prepared by polymerizing AB2 type monomers that have the isophthaloyl dicarboxylic acid terminal at one end and the p-oxyp henol terminal at the other end. The monomers contain a built-in azoxybenzene mesogen that is linked to the terminal groups through polymethylene spacers. The polyesters prepared were characterized by solution viscosity, differential scanning calorimetry, X-ray diffractometry and polarizing microscopy. All of the polyesters were found to be thermotropic (nematic). Their glass-transition temperatures and mesophase temperature ranges were very sensitive to the length of the two spacers existing in the repeating unit. The degree of branching of one of the polyesters was determined by the NMR spectroscopy and found to be 0.56.