• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2013년도 제44회 동계 정기학술대회 초록집
• /
• pp.310-310
• /
• 2013

본 연구에서는 Titanium (Ti) source/drain 전극 접합이 차세대 비정질 InGaZnO (IGZO) 기반 박막형 트랜지스터에 미치는 영향을 화학적, 구조적, 전기적 특성 분석을 통하여 관찰하고 Ti/IGZO 접합 특성을 설명할 수 있는 메커니즘을 제시하였다. IGZO 기반 박막형 트랜지스터 소자의 구동 특성은 transmission line method (TLM) 패턴 공정을 이용하여 정량적으로 분석되었다. 비정질 IGZO 기반의 박막형 트랜지스터에서 Ti source/drain 전극 접합에 의한 구동 특성 변화 및 영향을 확인하기 위하여 금속/산화물 계면 반응성이 낮은 silver (Ag) source/drain 전극이 reference로 비교되었으며, 그 결과 Ti source/drain 전극 접합이 적용된 비정질 IGZO 트랜지스터의 경우 Ti 금속과 IGZO 산화물 계면에 형성되는 열역학적으로 안정한 $TiO_x$ 층의 형성에 의해 VT ($-{\Delta}0.52V$) shift 및 saturation mobility ($8.48cm^2$/Vs) 상승됨을 확인하였다. 뿐만 아니라 TLM 패턴을 이용한 IGZO 트랜지스터의 전기적 변수 도출 및 수치적 해석으로부터 $TiO_x$ 계면층 형성이 Ti 금속과 비정질 InGaZnO 계면에서의 effective contact resistivity를 효과적으로 낮출 수 있음을 확인하였다. Ti source/drain 전극 접합에 의해 발생되는 $TiO_x$ 계면층의 화학적, 구조적 특성과 $TiO_x$ 계면층 생성에 의한 소자 특성 변화를 연관시켜 해석함으로써, IGZO 기반 박막형 트랜지스터에서의 Ti source/drain 전극 접합이 비정질 IGZO 기반 박막형 트랜지스터에 미치는 영향을 설명하였다.

• 한국전기전자재료학회논문지
• /
• 제24권6호
• /
• pp.473-479
• /
• 2011

In this paper, we have compared amorphous InGaZnO (a-IGZO) thin-film transistor (TFT) with the nano-crystalline embedded-IGZO ($N_c$-embedded-IGZO) TFT fabricated by solid-phase crystallization (SPC) technique. The field effect mobility (${\mu}_{FE}$) of $N_c$-embedded-IGZO TFT was 2.37 $cm^2/Vs$ and the subthreshold slope (S-factor) was 0.83 V/decade, which showed lower performance than those of a-IGZO TFT (${\mu}_{FE}$ of a-IGZO was 9.67 $cm^2/Vs$ and S-factor was 0.19 V/decade). This results originated from generation of oxygen vacancies in oxide semiconductor and interface between gate insulator and semiconductor due to high temperature annealing process. However, the threshold voltage shift (${\Delta}V_{TH}$) of $N_c$-embedded-IGZO TFT was 0.5 V, which showed 1 V less shift than that of a-IGZO TFT under constant current stress during $10^5$ s. This was because there were additionally less increase of interface trap charges in Nc-embedded-IGZO TFT than a-IGZO TFT.

• 대한금속재료학회지
• /
• 제47권1호
• /
• pp.38-43
• /
• 2009

To investigate the effect of RF power on the structural, optical and electrical properties of amorphous InGaZnO (a-IGZO), its thin films and TFTs were prepared by RF magnetron sputtering method with different RF power conditions of 40, 80 and 120 W at room temperature. In this study, as RF power during the deposition process increases, the RMS roughness of a-IGZO films increased from 0.26 nm to 1.09 nm, while the optical band-gap decreased from 3.28 eV to 3.04 eV. In the case of the electrical characteristics of a-IGZO TFTs, the saturation mobility increased from $7.3cm^2/Vs$ to $17.0cm^2/Vs$, but the threshold voltage decreased from 5.9 V to 3.9 V with increasing RF power. It is regarded that the increment of RF power increases the carrier concentration of the a-IGZO semiconductor layer due to the higher generation of oxygen vacancies.

• 한국전기전자재료학회논문지
• /
• 제29권2호
• /
• pp.69-74
• /
• 2016

In this study, we proposed an a-IGZO (amorphous In-Ga-Zn-O) TFT (thin-film transistor) with off-planed source/drain structure. Furthermore, two different electrode materials (ITO and Ti) were applied to the source and drain contacts for performance improvement of a-IGZO TFTs. When the ITO with a large work-function and the Ti with a small work-function are applied to drain electrode and source contact, respectively, the electrical performances of a-IGZO TFTs were improved; an increased driving current, a decreased leakage current, a high on-off current ratio, and a reduced subthreshold swing. As a result of gate bias stress test at various temperatures, the off-planed S/D a-IGZO TFTs showed a degradation mechanism due to electron trapping and both devices with ITO-drain or Ti-drain electrode revealed an equivalent instability.

• 한국정보디스플레이학회:학술대회논문집
• /
• 한국정보디스플레이학회 2009년도 9th International Meeting on Information Display
• /
• pp.524-526
• /
• 2009

The effects of In and Ga contents on characteristics of InGaZnO (IGZO) films grown by a sol-gel method and their thin film transistors (TFTs) have been investigated. Excess In incorporation into IGZO enhances the field effect mobilities of the TFTs due to the increase in conducting path ways, and decreases the grain size and the surface roughness of the films because more $InO_2^-$ ions induce cubic stacking faults with IGZO. Ga incorporation into results in decrease in carrier concentration of films and off-current of TFTs since Ga ion forms stronger chemical bonds with oxygen than Zn and In ions, acting as a carrier killer.

• 한국분말재료학회지
• /
• 제26권5호
• /
• pp.375-382
• /
• 2019

Homogeneous multicomponent indium gallium zinc oxide (IGZO) ceramics for transparent electrode targets are prepared from the oxides and nitrates as the source materials, and their properties are characterized. The selected compositions were $In_2O_3:Ga_2O_3:ZnO$ = 1:1:2, 1:1:6, and 1:1:12 in mole ratio based on oxide. As revealed by X-ray diffraction analysis, calcination of the selected oxide or nitrides at $1200^{\circ}C$ results in the formation of $InGaZnO_4$, $InGaZn_3O_6$, and $InGaZn_5O_8$ phases. The 1:1:2, 1:1:6, and 1:1:12 oxide samples pressed in the form of discs exhibit relative densities of 96.9, 93.2, and 84.1%, respectively, after sintering at $1450^{\circ}C$ for 12 h. The $InGaZn_3O_6$ ceramics prepared from the oxide or nitrate batches comprise large grains and exhibit homogeneous elemental distribution. Under optimized conditions, IGZO multicomponent ceramics with controlled phases, high densities, and homogeneous microstructures (grain and elemental distribution) are obtained.

• 한국표면공학회지
• /
• 제48권6호
• /
• pp.322-328
• /
• 2015

We investigated the diffusion behaviors, electrical properties, microstructures, and composition of In-Ga-Zn-O (IGZO) oxide thin films deposited by radio frequency reactive magnetron sputtering with increasing annealing temperatures. The samples were deposited at room temperature and then annealed at 300, 400, 500, 600 and $700^{\circ}C$ in air ambient for 2 h. According to the results of time-of-flight secondary ion mass spectrometry and X-ray photoelectron spectroscopy, no diffusion of In, Ga, and Zn components were observed at 300, 400, 500, $600^{\circ}C$, but there was a diffusion at $700^{\circ}C$. However, for the sample annealed at $700^{\circ}C$, considerable diffusion occurred. Especially, the concentration of In and Ga components were similar at the IGZO thin film but were decreased near the interface between the IGZO and glass substrate, while the concentration of Zn was decreased at the IGZO thin film and some Zn were partially diffused into the glass substrate. The high-resolution transmission electron microscopy results showed that a phase change at the interface between IGZO film and glass substrate began to occur at $500^{\circ}C$ and an unidentified crystalline phase was observed at the interface between IGZO film and glass substrate due to a rapid change in composition of In, Ga and Zn at $700^{\circ}C$. The best values of electron mobility of $15.5cm^2/V{\cdot}s$ and resistivity of $0.21{\Omega}cm$ were obtained from the sample annealed at $600^{\circ}C$.

• 한국표면공학회:학술대회논문집
• /
• 한국표면공학회 2013년도 춘계학술대회 논문집
• /
• pp.162-163
• /
• 2013

Single-crystal InGaZnO (IGZO) thin films were spontaneously formed as periodic layered structure along the c-axis by thermal treatment at high temperature. when the IGZO superlattice were synthesized by sol-gel method, the effects of preferred growth orientations and the flatness of ZnO buffer layer were investigated. $InGaO_3(ZnO)_2$ superlattice were favorably formed on ZnO buffer layer with single preferred orientation. Futhermore, it showed relatively high Seebeck coefficient and power factor.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2012년도 제42회 동계 정기 학술대회 초록집
• /
• pp.346-346
• /
• 2012

We investigated electrical and optical properties and chemical states of amorphous In-Ga-Zn-O (a-IGZO) thin films deposited at different substrate temperatures (from room temperature to $300^{\circ}C$). a-IGZO thin films were fabricated by radio frequency magnetron sputtering using $In_2O_3$ : $Ga_2O_3$ : ZnO = 1 : 1 : 1 target, and their electrical and optical properties and chemical states were investigated by Hall-measurement, UV-visible spectroscopy and x-ray photoelectron spectroscopy (XPS), respectively. The data showed that as substrate temperature increased, carrier concentration increased, but mobility, conductivity, transmittance in the shorter wavelength region (>350 nm), and the Tauc-plot-estimated optical bandgap decreased. XPS data indicated that the intensity of In 3d peak compared to Ga 3d peak increased but the intensity of Zn 3d peak compared to Ga 3d decreased, and that, from the deconvoluted O 1s peak, defects or oxygen vacancies and non-quaternary contents increased as the temperature increased. The relative intensity changes of the In, Zn, and O 1s sub-component are suggested to explain the changes in electrical and optical properties.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2010년도 하계학술대회 논문집
• /
• pp.4-4
• /
• 2010

Single-crystalline IGZO (Indium-Gallium-Zinc oxide) was fabricated on c-sapphire substrate. Single crystal ZnO was used as a buffer layer, and post-annealing was treated in $900^{\circ}C$ for crystallization of IGZO. Crystallized IGZO formed superlattice structure spontaneously induced to c-axis direction by ZnO butTer layer, the composition of IGZO was varied by amount of ZnO. Crystallinity and composition of IGZO was analyzed by X-ray Diffraction and Transmission Electron Microscopy.