• Journal of the Korean Society for Railway
• /
• v.6 no.1
• /
• pp.15-20
• /
• 2003

The computer simulation techniques were adopted to evaluate the effects of seating positions of passenger under various accident scenarios. The baseline of computer simulation model was tuned by the sled impact tests which conducted under the upright and standard seating positions. This study shows the effect of relative velocity between occupant and struck vehicle while occupant is impacted to a front seat's seatback. Although, base on the current accident scenarios, The KHST is performed well enough to protect average adult male occupants. However, Results from the tests indicate small size occupant or higher impact speed may cause sever neck and femur injuries.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.34 no.4
• /
• pp.1269-1278
• /
• 2014

The urban highway, which is a motorway constructed to solve traffic issues, has the characteristic of extremely high damage to life during traffic accidents because the speed of vehicles is higher than typical roadways. In particular, because traffic accidents involving serious injuries hold a very important place among overall traffic accidents, analysis on factors affecting the occurrence of traffic accidents involving serious injuries must be considered with priority when establishing a reduction measure. Therefore, the study built a model that was capable of distinguishing the degree of the factors as part of microscopic analysis for investigating the complex effect of many elements concerning the occurrence of traffic accidents involving serious injuries in urban highways. The results are as follows. First, discriminant model showed a comparatively high level in overall accuracy rates, and, considering the correlation ratio, the models were determined to be valid, as all characteristics of the factors were clearly distinguished. Second, the problems of traffic accidents involving serious injuries on urban highways according to each factor, were clearly drawn out through the discriminant model. Third, the improvement measure for the problems drawn out from the discriminant models were clearly proposed.

• Journal of Digital Convergence
• /
• v.16 no.9
• /
• pp.173-178
• /
• 2018

The vehicle collision speed in mid and high range can be checked by EDM(Event Driven memory) data recorded when the air bag works. But it's difficult to estimate the low speed of vehicle collision. And estimating the speed is important because the injury level can be changed by the impact speed. The study proposed an estimating algorithm by analysing the images recorded in car blackbox instrument. Low speed rear collision accidents simulated with wire winding motor for various vehicle types. The study estimated the impact speed with the ratio of the distance change between two vehicles and the length change of the number plate of front vehicle. The closer the vehicles are, the larger the plate length is. You can estimate the impact speed with the ratio. The impact speed is calculated with the initial distance for a specific length of number plate in the algorithm. The results can be applied to the linear rear collision because the angle of impact was not considered in this study.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.15 no.4
• /
• pp.239-247
• /
• 2015

Recently, various research studies on frontal collision and rear-ender which occur more frequently compared to others are underway as the public interest on them is growing. This study analyzes scientifically the relationship between effective impact speed and injury incidence for vehicle crash accident reconstruction and presents a relevant model formula. Because real vehicle experiments have certain limitations such as possible injuries, this study efforts to collect and analyze as many materials as possible to substitute real vehicle experiments, including data from various collision tests and human experiments. As a result, this study present a threshold in which head-on collisions and rear impacts do not cause injuries under 7 km/h of effective impact speed, and suggests a model formula showing that injury extent is linearly proportional to effective impact speed through collision speed and amount of plastic deformation. In conclusion, a model formula for estimating effective impact speed and injury incidence newly proposed in this study is expected to be used as a minimum standard of judgment in disputes on the injury extent of passenger in head-on collisions and rear impacts. Furthermore its availability in terms of technological analysis in legal arguments is expected to be very high if this study will be enhanced by referring to scientific analyses of various real accidents so as to apply it in various types of collision accidents.

• Proceedings of the KSR Conference
• /
• 2008.06a
• /
• pp.820-825
• /
• 2008

In the article 16 of the domestic rolling stock crashworthiness regulations, the collision acceleration level during collision accidents should remain under the maximum 7.5g and the average 5g. By the way, the accelerations obtained in crash simulations and tests contain many kinds of high frequency components due to numerical oscillations or noisy signals. So, this paper aims to develop reliable post-processing methods to filter high frequency oscillations and extract the rigid body motions of passenger rail cars. For this study we used the 1-dimensional dynamic model of KHST (Korean high-speed train), and evaluated acceleration data at the driver's area in the first power car and the passenger area in the following trailer.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.12 no.2 s.25
• /
• pp.139-144
• /
• 2006

Recently, ships' average navigation speed become faster than before because of the increasing of high-speeds vessel including container ships and passenger-ferries. So, it is considered that the speed limit in the navigation channel in Korea isn't proper for vessel management in these days. Also, there is rare paper studies about the speed limit quantitatively and numerically, especially the speed limit is discussing continuously, as abrogation of Incheon Port's speed limit and alleviation of Gwang-yang Port's speed limit according to the requests by the navigating mariners. Consequently this paper deals with the effectiveness of speed limits using the Environmental Stress Model, after replay of the navigation traffic flow in the straight waterway using marine traffic flow simulation technique.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.4 no.1 s.6
• /
• pp.43-56
• /
• 2005

This research has examined a time series analysis(TSA) of an every hour traffic information such as occupancy, a traffic flow, and a speed, a statistical model of a surveyed data on the traffic fundamental diagram and an expand aspect of a traffic jam by many Parts of the traffic flow. Based on the detected data from traffic accidents on the Cheonan-Nonsan high way and events when the road volume decreases dramatically like traffic accidents it can be estimated from the change of occupancy right after accidents. When it comes to a traffic jam like events the changing gap of the occupancy and the mean speed is gentle, in addition to a quickness and an accuracy of a detection by the time series analyse of simple traffic index is weak. When it is a stable flow a relationship between the occupancy and a flow is a linear, which explain a very high reliability. In contrast, a platoon form presented by a wide deviation about an ideal speed of drivers is difficult to express by a statical model in a relationship between the speed and occupancy, In this case the speed drops shifty at 6$\~$8$\%$ occupancy. In case of an unstable flow, it is difficult to adopt a statistical model because the formation-clearance Process of a traffic jam is analyzed in each parts. Taken the formation-clearance process of a traffic jam by 2 parts division into consideration the flow having an accident is transferred to a stopped flow and the occupancy increases dramatically. When the flow recovers from a sloped flow to a free flow the occupancy which has increased dramatically decrease gradually and then traffic flow increases according as the result analyzed traffic flow by the multi regime as time series. When it is on the traffic jam the traffic flow transfers from an impeded free flow to a congested flow and then a jammed flow which is complicated more than on the accidents and the gap of traffic volume in each traffic conditions about a same occupancy is generated huge. This research presents a need of a multi-regime division when analyzing a traffic flow and for the future it needs a fixed quantity division and model about each traffic regimes.

• Proceedings of KOSOMES biannual meeting
• /
• 2006.05a
• /
• pp.53-58
• /
• 2006

Recently, vessel's average speed in the sea becomes fast because of the increasing of high-speeds vessel like a container ship and ferry. So, it is considered that speed control in the korean narrow waterway isn't the proper vessel traffic management, now. And, there is a rare paper studied about speed control quantitatively and numerically, especially speed control is discussing continuously, as abrogation of Incheon Port's speed control and alleviation of Kwangyang Port's speed control a according to navigating mariner's request. After this paper replayed the navigation traffic flow in the straight waterway using marine traffic flow simulation, the Environmental Stress Model is introduced to evaluate difficulty of each vessel's traffic.

• Journal of Advanced Navigation Technology
• /
• v.12 no.6
• /
• pp.627-633
• /
• 2008

In the case of traffic accidents, the broadcasting methods used in the mobile ad hoc network (MANET) cannot applied to transmit reliable message since moving high-speed in vehicular ad hoc networks (VANET) environments. In this paper, in order to guarantee transmitting reliable messages, we propose a collision avoidance method based-on directional antenna in VANET. In order to reduce interference from omni-broadcasting and to avoid hidden node problem from moving high-speed, we employed a forward-handed and backward directional antenna. The authors simulated the proposed method based on directional antenna and showed that the proposed method has been improved in respect to network utilization compared to existing VANET protocols.

• Proceedings of the Korean Society for Technology of Plasticity Conference
• /
• 2007.10a
• /
• pp.360-363
• /
• 2007

This paper deals with the dynamic tensile characteristics of the steel sheets for structural members of a train. Train accidents occurs rarely but lead to many casualties and economical loss. Therefore the safety of the train becomes important during the train crash. The dynamic tensile characteristics of the steel sheets are indispensable to analyze the structural crashworthiness. Current research reports the stress-strain curves, fracture elongation and strain rate sensitivities evaluated at the various strain rates especially for SUS304L-ST and SUS304L-LT steel sheets. The results include the difference in the dynamic tensile characteristics of both rolling and transverse directions. Dynamic tensile tests were performed at the strain rates ranging from 0.003/sec to 200/sec using High Speed Material Testing Machine. The materials tested in this research shows interesting behavior at the low strain rates. The strain hardening exponent decreases remarkably while the yield strength increases.