• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.9 no.2
• /
• pp.168-172
• /
• 1999

The 9 $\mu\textrm{m}$ GaN films on sapphire substrate were grown by Hydride vapor phase epitaxy. Dislocation density of these GaN films was measured by TEM. GaN film with crack free and mirror surface was directly grown on sapphire substrate. The dislocation density of this GaN film was $2{\times}10^9/cm^2$. The surface of GaN film on patterned GaN layer also presented a smooth mirror. But a part of GaN surface included holes because of incomplete coalescence. The dislocation density of GaN film above the mask region was lower than that in the window region. Especially, the dislocation density in the region between mask center and window region was close to dislocation free. The average dislocation density of ELO GaN was $8{\times}10^7/cm^2$.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.24 no.10
• /
• pp.1306-1311
• /
• 2020

In this study, we proposed an anti-reflective nano-structure to improve the photoresponsivity of AlGaN UV photodiode that can be used as a receiver in a solar blind UV optical communication system. The anti-reflective nano-structure was fabricated by forming Ni nano-clusters on SiO2 film followed by etching the underneath SiO2 film. A sample with the anti-reflective nano-structure exhibited lower surface reflection along with less dependency on the wavelength in comparison with a sample without the nano-structure. Finally, a UV photodiode was fabricated by applying an anti-reflective structure produced by heat-treating a 2 nm-thick Ni layer. The photodiode fabricated with the proposed nano-structure exhibited noticeable improvement in the photoresponsivity at the wavelength range from 240 nm to 270 nm in comparison with the same photodiode with a SiO2 film without the nano-structure.

• Current Optics and Photonics
• /
• v.5 no.2
• /
• pp.129-133
• /
• 2021

This study observed the performance of an InAs/GaSb type-II superlattice photodiode with a p-i-n structure for mid-wavelength infrared detection. The 10 ML InAs/10 ML GaSb type-II superlattice photodiode was grown using molecular beam epitaxy. The cutoff wavelength of the manufactured photodiode with Si3N4 passivation on the mesa sidewall was determined to be approximately 5.4 and 5.5 ㎛ at 30 K and 77 K, respectively. At a bias of -50 mV, the dark-current density for the Si3N4-passivated diode was measured to be 7.9 × 10-5 and 1.1 × 10-4 A/㎠ at 77 K and 100 K, respectively. The differential resistance-area product RdA at a bias of -0.15 V was 1481 and 1056 Ω ㎠ at 77 K and 100 K, respectively. The measured detectivity from a blackbody source at 800 K was calculated to be 1.1 × 1010 cm Hz1/2/W at zero bias and 77 K.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.2 no.2
• /
• pp.93-101
• /
• 2002

We have proposed and fabricated two lateral type field emission diodes, poly-Si emitter by utilizing the local oxidation of silicon (LOCOS) and GaN emitter using metal organic chemical vapor deposition (MOCVD) process. The fabricated poly-Si diode exhibited excellent electrical characteristics such as a very low turn-on voltage of 2 V and a high emission current of $300{\;}\bu\textrm{A}/tip$ at the anode-to-cathode voltage of 25 V. These superior field emission characteristics was speculated as a result of strong surface modification inducing a quasi-negative electron affinity and the increase of emitting sites due to local sharp protrusions by an appropriate activation treatment. In respect, two kinds of procedures were proposed for the fabrication of the lateral type GaN emitter: a selective etching method with electron cyclotron resonance-reactive ion etching (ECR-RIE) or a simple selective growth by utilizing $Si_3N_4$ film as a masking layer. The fabricated device using the ECR-RIE exhibited electrical characteristics such as a turn-on voltage of 35 V for $7\bu\textrm{m}$ gap and an emission current of~580 nA/l0tips at anode-to-cathode voltage of 100 V. These new field emission characteristics of GaN tips are believed to be due to a low electron affinity as well as the shorter inter-electrode distance. Compared to lateral type GaN field emission diode using ECR-RIE, re-grown GaN emitters shows sharper shape tips and shorter inter-electrode distance.

• Journal of IKEEE
• /
• v.28 no.1
• /
• pp.104-109
• /
• 2024

In this research, we explored the influence of post-annealing atmospheres on the electrical properties of Ga₂O₃/SiC heterojunction diodes. We fabricated Ga₂O₃/SiC heterojunction diodes by RF sputtering and after the fabrication the post-annealing in various gas atmospheres was performed. We measured the changes in deep-level defects using Deep Level Transient Spectroscopy (DLTS) and we conducted an electrical characteristic of J-V measurement and Hall measurement to analyzed the effects of annealing atmosphere on Ga₂O₃/SiC heterojunction diode. In the N₂ annealed devices, the highest on-state current was measured as 3.06 × 10^-2 A/cm^2, and an increase in carrier concentration of 3.8 × 10¹⁴ cm^-3 was observed. This confirms that the variations in deep level defects due to the post-annealing atmosphere can influence the electrical properties.

• Journal of Sensor Science and Technology
• /
• v.25 no.5
• /
• pp.320-325
• /
• 2016

In this paper, we propose an AlGaN/GaN-based extended-gate metal-insulator-semiconductor high electron mobility transistor (MISHEMT)-type biosensor for detecting streptavidin-biotin complexes. We measure the drain current of the fabricated sensor, which varies depending on the antibody-antigen reaction of streptavidin with biotin molecules. To confirm the immobilization of biotin polyethylene glycol (PEG) thiol, we analyze the Au surface of a GaN sample using X-ray photoelectron spectroscopy (XPS). The proposed biosensor shows higher sensitivity than Si-based extended-gate metal oxide semiconductor field effect transistor (MOSFET)-type biosensor. In addition, the proposed AlGaN/GaN-based extended-gate MISHEMT-type biosensor exhibits better long-term stability, compared to the conventional AlGaN/GaN-based MISHEMT-type biosensor.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.21 no.3
• /
• pp.110-113
• /
• 2011

In this paper, we propose a new method for the fabrication of GaN microstructures formed only on the vertex of GaN pyramid by using of metal catalysts. GaN pyramidal structures were selectively grown on 3 ${\mu}m$ $SiO_2$ dot patterns followed by thin film deposition of Au and Cr only on the vertex area of the GaN pyramids with precisely controlled photolithography. After the metal deposition, the samples were loaded in the MOVPE reactor for the growth of GaN microstructures for 10 minutes. Temperature for the growth of the GaN microstructures was changed from $650^{\circ}C$ to $750^{\circ}C$. Rod type GaN microstructures were grown in the direction of vertical to the six {1-101} facets and the shape of the GaN microstructures was changed depend on the type of metal.

• Proceedings of the Materials Research Society of Korea Conference
• /
• 2000.11a
• /
• pp.99-99
• /
• 2000

• Proceedings of the Materials Research Society of Korea Conference
• /
• 2006.05a
• /
• pp.15.2-15.2
• /
• 2006

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.13 no.2
• /
• pp.79-82
• /
• 2003

GaN nanoparticles were synthesized by the pulsed laser deposition (PLD) process on $SiO_2$substrate after irradiating the surface of the GaN sintered pellet by the ArF (193 nm) excimer laser. At this moment Ar gas pressure of 100 Pa, 50 Pa, 10 Pa and 1 Pa were applied during the ablation process and laser power of 100 mJ and 200 mJ were also applied. The synthesized fan nanoparticles were characterized by XRD, SEM, TEM, XPS and optical absorption spectra. The synthesized GaN nanoparticles had the crystallite sizes of 20~30 nm, and besides, GaN nanoparticles synthesized under low Ar gas pressure compared to the others corresponded with stoichiometry, and the optical band edge of the GaN nanoparticles was blueshifted.