• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2000년도 추계종합학술대회 논문집(2)
• /
• pp.13-16
• /
• 2000

A quantum-wire field effect transistor(QW-FET) using asymmetric double InGaAs channel and Si-delta doped barrier has been fabricated. It exhibited good modulation and saturation characteristic in the range of ${\mu}\textrm{A}$ current level. For estimated channel width of 150nm QW-FET, maximum transconductance was about 400 mS/mm which is higher than a conventional heterostructure FET(HFET) with the same epi-structure.

• 전자공학회논문지A
• /
• 제29A권4호
• /
• pp.33-37
• /
• 1992

AlGaAs/GaAs quantum well delta-doped channel FET's have been successfully fabricated using by low-pressure metalorganic chemical vapor deposition(LP-MOCVD). The FET's with a gate dimension of 1.8$\mu$m $\times$ 100$\mu$m have a maximum transconductance of 190 mS/mm and a maximum current density of 425 mA/nm. The devices show extremely broad transconductances with a large voltage swing of 2.4V. The S-parameter measurements have indicated that the current gain and power gain cutoff frequencies of the device were 7 and 15 GHz, respectively. These values are among the best performance reported for GaAs based heterojunction FET's with a similar device geometry.

• 전력전자학회논문지
• /
• 제19권3호
• /
• pp.283-289
• /
• 2014

This paper carries out a series of analysis of power system using Gallium Nitride (GaN) FET which has wide band gap (WBG) characteristics comparing to conventional Si MOSFET-used power system. At first, for comparison of each semiconductor device, the switching-transient parameter is quantitatively extracted from released information of GaN FET. And GaN FET model which reflect this dynamic property is configured. By using this model, the performance of GaN FET is analyzed comparing to Si MOSFET. Also, in order to enable a representative assessment on the power system level, Si MOSFET and GaN FET are applied to the most common structure of power system, full-bridge, and each power systems are compared based on various criteria, such as performance, efficiency and power density. The entire process is verified with the aid of mathematical analysis and simulation.

• 반도체디스플레이기술학회지
• /
• 제19권4호
• /
• pp.99-104
• /
• 2020

In this paper, efficiency and loss characteristics of GaN FET were reported by applying it into the QR flyback converter. In particular, for the comparison of efficiency characteristics, QR flyback converter experimental circuits with Si FET and with GaN FET were separately produced in 12W class. As a result of the experiment, the experimental circuit of the QR flyback converter using GaN FET reached a high efficiency of 90% or more when the load power was 2W or more, and the maximum efficiency was observed to be about 92%, and the maximum loss power was about 1.1W. Meanwhile, the efficiency of the experimental circuit with Si FET increased as the input voltage increased, and the maximum efficiency was observed to be about 82% when the load power was 9W or higher, and the maximum loss power was about 2.8W. From the results, it is estimated that that in the case of the experimental circuit applying the GaN FET switch, the power conversion efficiency was improved as the switching loss and conduction loss due to on-resistance were reduced, and the internal loss due to the synchronous rectifier was minimized. Consequently, it is concluded that the GaN FET is suitable for under 20W class power supply unit as a high efficiency power switch.

• 전자공학회논문지A
• /
• 제30A권8호
• /
• pp.57-62
• /
• 1993

In this paper, both feasible power gain and power added efficiency at the operating center frequency of 12 GHz are stressed to design a power FET with double-heterjunction structure. The variable parameters or the design are the unit gate width, the gate length, the doping density of AlGaAs, the AlGaAs thickness, the spacer thickness, the Al mole fraction, and the GaAs well thickness. The results of simulation for the FET with 1.mu.m gate length show that the power gain and the power added efficiency are 10.2 dB and 36.3% at 12GHz, respectively. An extrapolation of the relation between current gain and unilateral gain yields a 17 GHz cutoff frequency and 43GHz maximum frequency of oscillation. The calculation of the current versus voltage characteristics show that the output power of the device is about 0.62W.

• 전력전자학회논문지
• /
• 제20권1호
• /
• pp.65-71
• /
• 2015

This paper presents the efficiency analysis of a critical current mode interleaved PFC rectifier, in which each of three different semiconductor switches is employed as the active switch. The Si FET, SiC FET, and GaN FET are consecutively used with the prototype PFC rectifier, and the efficiency of the PFC rectifier with each different semiconductor switch is analyzed. An equivalent circuit model of the PFC rectifier, which incorporates all the internal losses of the PFC rectifier, is developed. The rms values of the current waveforms main circuit components are calculated. By adapting the rms current waveforms to the equivalent model, all the losses are broken down and individually analyzed to assess the conduction loss, switching loss, and magnetic loss in the PFC rectifier. This study revealed that the GaN FET offers the highest overall efficiency with the least loss among the three switching devices. The GaN FET yields 96% efficiency at 90 V input and 97.6% efficiency at 240 V, under full load condition. This paper also confirmed that the efficiency of the three switching devices largely depends on the turn-on resistance and parasitic capacitance of the respective switching devices.

• 한국광학회:학술대회논문집
• /
• 한국광학회 1989년도 제4회 파동 및 레이저 학술발표회 4th Conference on Waves and lasers 논문집 - 한국광학회
• /
• pp.176-179
• /
• 1989

The optimization of the monolithic pin-FET receiver is discussed, with emphasis on the sensitivity and bandwidth. The amplifier circuit, bias resistance, total input capacitance, and transconductance of FET for the 2 Gbps transmission are calculated.

• 한국광학회:학술대회논문집
• /
• 한국광학회 2005년도 하계학술발표회
• /
• pp.50-51
• /
• 2005

• 대한전자공학회논문지
• /
• 제21권1호
• /
• pp.51-56
• /
• 1984

마이크로파 분배증폭기에서 게이트선로에서 감쇠정수를 줄여서 대역폭을 넓히기 위하여 FET 칩에 직렬 케페시터를 삽입할 때 대역폭이 증가되는 관계를 유도하고 이때 분배증폭기의 설계방법을 제시한다. 실제 예로서 300μ 게이트 FET로써 4개 소자를 썼을 때 2-12GHz의 대역폭을 직렬 케페시터를 삽입하여서 2-200Hz까지의 균일한 전력이득을 얻었다.

• 한국광학회:학술대회논문집
• /
• 한국광학회 1990년도 제5회 파동 및 레이저 학술발표회 5th Conference on Waves and lasers 논문집 - 한국광학회
• /
• pp.136-140
• /
• 1990

A hybrid wideband amplifier having bandwidth from 5MHz to 2000MHz with a gain of 10db$\pm$3dB is designed and implemented by using a lossy matched network and GaAs FET. The implemented amplifier circuit operates as a capacitor-resistor(C-R) coupled amplifier circuit in the low frequency range (below 800 MHz) in which {{{{ LEFT $\mid$ S_{21 } RIGHT $\mid$ }} for the GaAs FET is constant. It also operates as a lossless impedance matching circuit in the microwave frequency range in which S21 for the GaAs FET has a slope of approximately -6dB/octave. Using this configuration technique, Two stage GaAs FET amplifier implemented is measured to 10dB gain within a 3dB fluctuation over the frequency band from 5 to 2000MHz.