• Journal of Information Display
• /
• 제2권3호
• /
• pp.54-59
• /
• 2001

The role of $NH_3$ for vertical alignment of CNTs was investigated. The direct cause of the alignment was a dense distribution of catalytic metal particles, but which was kept catalytically active during the growth process by $NH_3$. This allows a dense nucleation of the CNTs, and consequently, assists vertical alignment through entanglement and mechanical leaning among the tubes. The CNTs grow in a base growth mode. Several evidences were presented including a direct cross-sectional TEM observation. Since Ni is consumed both by silicide reaction and by capture in the growing tube, the growth stops when Ni is completely depleted. This occurs faster for smaller particles, and thus a longer growth results in thin bottom with poor adhesion.

• 펄프종이기술
• /
• 제47권4호
• /
• pp.54-59
• /
• 2015

In this study, effects of kneading concentration on characteristics of hardwood bleached kraft pulp (HwBKP) fibers were elucidated. A laboratory two-shaft kneader was utilized for kneading. Kneading concentration was varied in the range of 15-30% (w/w) and the number of kneading treatment was adjusted between 0 and 6 passes. It was found that kneading concentration influenced fiber characteristics. At 15% of pulp concentration, fiber length slightly increased with increasing the number of kneading passes, while other morphological properties such as fiber width and curl decreased: fiber straightening occurred. In addition, the increase in WRV and the decrease in CSF were the largest at 15% kneading concentration, meanings that fibrillation mainly occurred. In contrast, at higher kneading concentration exceeding 20%, fiber deformation like curl was mainly occurred. Also, at kneading concentration of 20% and 30%, fiber length decreased with the number of kneading passes while other morphological properties such as fiber width, and WRV increased. Severe fiber entanglement was found at 30% kneading, which shall be removed during papermaking.

• Carbon letters
• /
• 제22권
• /
• pp.36-41
• /
• 2017

Biodegradable epoxy (B-epoxy) was prepared from diglycidyl ether of bisphenol A and epoxidized linseed oil. The mechanical properties of B-epoxy composites reinforced with multi-walled carbon nanotubes (MWCNTs/B-epoxy) were examined by employing dynamic mechanical analysis, critical stress intensity factor ($K_{IC}$) tests, and impact strength tests. The electromagnetic interference shielding effectiveness (EMI-SE) of the composites was evaluated using reflection and absorption methods. Mechanical properties of MWCNTs/B-epoxy were enhanced with an increase in the MWCNT content, whereas they deteriorated when the MWCNT content was >5 parts per hundred resin (phr). This can likely be attributed to the entanglement of MWCNTs with each other in the B-epoxy due to the presence of an excess amount of MWCNTs. The highest EMI-SE obtained was ~16 dB for the MWCNTs/B-epoxy composites with a MWCNT content of 13 phr at 1.4 GHz. The composites (13 phr) exhibited the minimum EMI-SE (90%) when used as shielding materials at 1.4 GHz. The EMI-SE of the MWCNTs/B-epoxy also increased with an increase in the MWCNT content, which is a key factor affecting the EMI-SE.

• 공업화학
• /
• 제9권3호
• /
• pp.445-450
• /
• 1998

에폭시수지와 caster oil(CO)형 폴리우레탄(PU)은 상호침투고분자(IPNs)를 형성하였다. 사슬연장제인 polypropylene ether glycol(PPG)와 가교제인 CO를 사용하여 두 종류의 폴리우레탄을 제조했다. CO를 이용한 COPU/epoxy의 동시중합 상호침투고분자(SINs)는 PPG를 이용한 PPGPU/epoxy SINs보다 상용성이 좋았다. PPGPU/epoxy SINs의 전조성에서 가교구조의 얽힘정도가 감소함에 따라 굴곡강도가 감소하였다. COPU/epoxy SINs은 PPGPU/epoxy SINs에 비해 기계적 물성과 파괴인성이 우수하였다. 실험 결과, 모든 SINs의 파괴단면에서 폴리우레탄의 공동화에 의한 응력백화 현상보다는 전단변형과 크랙의 편향이 관찰되었다.

• Neonatal Medicine
• /
• 제16권1호
• /
• pp.85-88
• /
• 2009

저자들은 우측 다리와 겨드랑이의 협착고리, 우측 발의 만곡족, 척추 측만증, 좌측 엄지 손가락의 다지증, 우측 엄지 손가락 결여증과 더불어, 두피에 피부 무형성증이 동반된 양막대증후근 1례를 경험하였기에 문헌 괓ㄹ과 함께 보고하는 바이다.

• 수산해양기술연구
• /
• 제45권1호
• /
• pp.14-21
• /
• 2009

This experimental study was carried out to obtain the base data for saving the man power in the fishing operation of largehead hairtail hand line by using the continuous type hand line system with a rotary device which could make a main line move automatically. In order to solve the twists and entangling on the main line happened during operating test, the resistance board was suspended at the end of the main line at sea. As the result, there were no problems of tangling and so on due to up and down moving of a main line. According to the control of a fixed angle of guide roller, it was possible to prevent the main line to be separated from a side roller and a guide roller. In addition, PVC tube between a guide roller and a side roller enabled a main line to be moved smoothly without any entanglement.

• Journal of the Korean Wood Science and Technology
• /
• 제16권2호
• /
• pp.42-49
• /
• 1988

Anatomical characteristics on abnormal type of bisected compression woods and light colored wood intervened between these dark colored compression woods on under part and their respective opposite woods on upper parts of cross section in Pinus densiflora S. et Z. stem were compared through optical microscopic investigation. and the obtained results were summarized as follows: 1. Tracheid length increased linearly as the number of rings from the pith increases in all investigated parts, but increasing tendency in tracheid length was similar within bisected two compression woods and their opposite woods. 2. Tracheids were the shortest in bisected two compression woods and tracheid length in intervened wood between these two compression woods was longer than in compression woods but shorter than in the opposite woods. 3. Bisected two compression woods and intervened wood between these two compression woods revealed similar features in tracheid transition from springwood to summerwood, intercellular space, tracheid entanglement, and cross sectional view of tracheid. but spiral check was observed only in these two compression woods, therefore the intervened wood between these two compression woods disclosed anatomical characteristics similar to, not typical of, compression woods.

• 한국환경보건학회:학술대회논문집
• /
• 한국환경보건학회 2002년도 춘계 국제 학술대회
• /
• pp.69-73
• /
• 2002

There have been few reports on the survey of pathological findings of cetaceans stranded on the coast of Japan. This is partly because of lack of the procedures and/or network of systemic sampling of fresh tissues for the pathological study of stranded marine mammals. In contrast, there are a numbers of reports on the cause of illness and death in wild, free-living cetaceans examined in other countries; the commonest cause of death was parasitic and bacterial pneumonia except for entanglement in fishing gear. Anthracosis, lung and hilar lymph nodes polluted by suspended particulate matter in the air, has been recently found in some cetaceans stranded on the coast of Japan. In addition to the data from the chemical analysis of tissues, scientific data obtained from pathological study of stranded marine mammals would be also one of the useful base for the assessment of global environment. Usefulness of metallothionein in the hepatopancreas of crabs as a biomarker of marine pollution monitoring was also discussed in this study.

• 천문학회보
• /
• 제42권2호
• /
• pp.55.5-56
• /
• 2017

Galaxy dynamics probes weak gravity at accelerations below the de Sitter scale of acceleration adS = cH, where c is the velocity of light and H is the Hubble parameter. Low and high redshift galaxies hereby offer a novel probe of weak gravity in an evolving cosmology, satisfying H(z) = H0(1 + A(6z + 12z^2 +12z^3+ 6z^4+ (6/5)z^5)/(1 + z) with baryonic matter content A sans tension to H0 in surveys of the Local Universe. Galaxy rotation curves show anomalous galaxy dynamics in weak gravity aN < adS across a transition radius r beyond about 5 kpc for galaxy mass of 1e11 solar mass. where aN is the Newtonian acceleration based on baryonic matter content. We identify this behavior with a holographic origin of inertia from entanglement entropy, that introduces a C0 onset across aN=adS with asymptotic behavior described by a Milgrom parameter satisfying a0=omega/(2pi), where omega=sqrt(1-q)H is a fundamental eigenfrequency of the cosmological horizon. Extending an earlier confrontation with data covering 0.003 < aN/adS < 1 at redshift z about zero in Lellie et al. (2016), the modest anomalous behavior in the Genzel et al. sample at redshifts 0.854 < z <2.282 is found to be mostly due to clustering 0.36 < aN/adS < 1 close to the C0 onset to weak gravity and an increase of up to 65% in a0.

• 기술경영경제학회:학술대회논문집
• /
• 기술경영경제학회 1998년도 제13회 하계학술발표회 논문집
• /
• pp.208-215
• /
• 1998

Since the advent of conceptual prototype and seminal application, the notion of national systems of innovation(NSI) has drawn an increasing recognition. Although the morphological entanglement is still ubiquitous and the theoretical underpinning is fragile, NSI seems to be the last step toward an increasingly complex and encompassing concept of innovation research. Inevitably, NSI necessitates the comparative analysis in that it normatively attempts to draw best practices. Unfortunately, national profiles are too complex and diverse to derive a unified, concrete representation of the system, posing the problem of defining and modelling NSI for international comparison. This paper aims at providing an inductive taxonomy of NSI based on R&D structure of OECD member economies. Based on the similarity among national profiles, clustering method was applied to identify seven clusters such as (1) enterprise-government funding and enterprise-education performing group, (2) enterprise-government funding and balanced performing group, (3) balanced funding and enterprise-education performing group, (4) balanced funding and performing group, (5) enterprise-dominating group, (6) government-education dominating group and (7) government-education funding and education performing group. This paper by nature is descriptive and exploratory. R&D structure represents a static snapshot of innovative performance since it accounts for only the input side of NSI and thus may not offer convincing explanations of the holistic innovation system. A more detailed and extensive analysis on the economic/technological performance across clusters will shed light on the promising avenue to future research.