• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.67 no.1
• /
• pp.142-147
• /
• 2018

Private electrical facilities are judged whether it is suitable for the insulation aging condition of their incoming underground cables using DC leakage current test method. In the case where the service point of utility is the secondary side of cut out switch installed in the electric pole, there is a problem that it is difficult to separate the lightning arresters(LA) because of their high position of the pole. Therefore, the field test voltage is applied at value lower than DC 30 kV, which are stated in the inspection guideline. However, this test could reduced the insulation performance of the LA by accelerating the electrical stress of the metal oxide varistor element in the pre-breakdown region. In this study, we analyzed the relationship between the DC test voltage and the leakage current using the non-destructive DC high voltage equipment with leakage current measurement function. The results show that the leakage current increases sharply above the specified test voltage. As a consequence, it could be contributed to improve insulation aging inspection method by selecting the possible test area on the VI characteristic curve of the pre-breakdown area of the LA.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2003.07a
• /
• pp.981-983
• /
• 2003

Using the conventional standard CMOS logic process, the high voltage MOSFET to drive top emission OLEDs was fabricated for the silicon-based organic electroluminescent display. The drift region of the conventional high voltage MOSFET was implemented by the n-well of the logic process. The measurement result shows a good saturation characteristic up to 50 V without breakdown phenomena.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.18 no.3
• /
• pp.217-224
• /
• 2013

This paper presents a diagnostic method for a sparse matrix converter that detects faults in any single switch or a pair of switches. The sparse matrix converter is functionally equivalent to the standard matrix converter but has a reduced number of switches. The proposed diagnostic method is based in the measurement of input and output currents. The currents have respective characteristic according to the location of faulty switches. This method not only detects the switches of open-circuit fault but identifies the location of the faulty switching devices without complicated calculations. The simulation and experimental results verify that, based on the proposed method, the fault of sparse matrix converter can be easily and fast detected.

• 한국태양에너지학회:학술대회논문집
• /
• 2008.04a
• /
• pp.92-97
• /
• 2008

To survive in outdoor environments, photovoltaic modules rely on packaging materials to provide requisite durability. We analyzed the properties of encapsulant materials that are important for photovoltaic module packaging. The properties of Ethylene Vinyl Acetate(EVA) sheet in photovoltaic encapsulant materials have to meet conditions that are high optical transmittance, good adhesion and high cross-linking rate. The objective of this paper is to understand the property evaluation methods of EVA sheet. Through this research, we could confirm that properties of EVA sheet have an effect on durability and operating efficiency of photovoltaic module.

• Proceedings of the KIEE Conference
• /
• 1990.07a
• /
• pp.247-249
• /
• 1990

Nondestructive eddy current testing has been used for measuring the electromagnetic properties of metals. It is well known that the conventional eddy current sensors are not effective to measure multi-layer properties. In this paper, the mutual inductance type sensor is studied and transformed fractions of metals are measured. Characteristic factors in eddy current testing are considered and their influences on the testing results are investigated.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.13 no.1
• /
• pp.1-5
• /
• 2000

Optical and electrical properties of GaSe:Er\ulcorner single crystals grown by the Bridgenman technique have been investigated by using optical absorption and h\Hall-effect measurement system. The Hall coefficients were mea-sured by using a high impedance electrometer in the temperature range from 360K to 150K. The temperature dependence of hole concentration show the characteristic of a partially compensated p-type semiconductor. Carrier density(N\ulcorner) of GaSe doped with Erbium was measured about 3.25$\times$10\ulcorner [cm\ulcorner] at temperature 300K, which was higher than undoped specimen. Photon energy gap (E\ulcorner) of GaSe:Er\ulcorner specimen was measured about 1.79eV.

• Journal of Electrical Engineering and information Science
• /
• v.2 no.4
• /
• pp.59-65
• /
• 1997

In this paper, a general fuzzy syntactic method for recognition of flaw patterns and for the measurement of flaw characteristic parameters for a non-destructive inspections signal, called eddy-current, is presented. Solutions are given to the subtasks of primitive pattern selection, signal to symbol transformation, pattern grammar formulation, and event-synchronous flaw pattern extraction based on the grammars. Fuzzy attribute grammars are used as the model for the pattern grammar because of their descriptive power in the face of uncertain constraints caused by nose or distortion in the signal waveform, due to their ability to handle syntactic as well as semantic information. This approach has been implemented and the performance of eh resultant system has been evaluated using a library of law patterns obtained from steam generator tubes in nuclear power plants by an eddy current-based non-destructive inspection method.

• Transactions of the Korean hydrogen and new energy society
• /
• v.16 no.4
• /
• pp.386-390
• /
• 2005

Al film(135.5 nm thick) with Pd film(39.6 nm thick) on the top of it was made by thermal evaporation method. Electrical resistance change due to hydrogen absorption and desorption was measured by four point measurement method. The sample was activated by hydrogen absorption and desorption cycling at room temp. Hydrogen was introduced into the film by increasing hydrogen gas pressure step by step up to 640 torr at room temp. The resistance change ratio was decreased to 12 % with increasing hydrogen pressure in contrast to normal metal behavior. This strange tendency was not understood yet. Further study is needed to find out the mechanism of hydrogen absorption in Al in Al/Pd film.

• The Transactions of the Korean Institute of Electrical Engineers B
• /
• v.51 no.10
• /
• pp.595-600
• /
• 2002

This paper presents the analyzed results of dynamic characteristics including steady state characteristics of the boost input type ZVS converter using the active clamp circuit by the state space averaging method. From the results, it can be seen that the converter has the 5th order transfer functions and the stable closed loop characteristic is obtained by using the compensated error amplifier with 2-pole and 1-zero. The validity of all analyzed results are verified by measurement.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.10 no.5
• /
• pp.962-966
• /
• 2009

In this paper, N-way resistance power divider is described for wideband frequency characteristic. For this, we derived in design equation of a N-way resistance power divider using 3-way resistance power divider. We designed 8-way resistance power divider that can divide same power by 7 output and measurement result of fabricated resistance power divider is observed to prove the validity of derived design equation. Fabricated resistance power divider shown equal power division ratio and reflection loss displayed excellent characteristic by about -25dB in broadband from DC to 3GHz.