• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.19 no.11
• /
• pp.604-613
• /
• 2018

In recent years, numerous train derailment accidents caused by deterioration and high speed technology of railways have increased. Guardrails or barriers of railway bridges are installed to restrain and prevent the derailment of the train body level. On the other hand, it can result in a high casualties and secondary damage. Therefore, a Derailment Containment Provision (DCP) within the track at the wheel/bogie level was developed. DCP is designed for rapid installation because it reduces the impact load on the barrier and inertia force on the steep curve to minimize turnover, fall, and trespass on the other side track of the bridge. In this paper, DCP was analyzed using LS-Dyna with a parameter study as the impact loading location and interface contact condition. The contact conditions were analyzed using the Tiebreak contact simulating breakage of material properties and Perfect bond contact assuming fully attached. As a result, the Tiebreak contact behaved similarly with the actual behavior. In addition, the maximum displacement and flexural failure was generated on the interface and DCP center, respectively. The impact analysis was carried out in advance to confirm the DCP design due to the difficulties of performing the actual impact test, and it could change the DCP anchor design as the analysis results.

• Journal of Korean Society of Environmental Engineers
• /
• v.37 no.12
• /
• pp.705-711
• /
• 2015

Degradation of 2,6-Dichlorophenol (DCP) using liquid ferrate(VI) synthesized by wet oxidation method has been studied. Several parameters such as pH (acid, base and neutral), DCP initial concentration, ferrate dosage, and temperature have been examined to determine the optimal experimental conditions. The ferrate(VI) has useful properties such as strong oxidizing power and selectivity and generates a non-toxic end product, Fe(III). Ferrate ion reduced rapidly to Fe(III) and oxygen in acidic and neutral conditions. The experimental results showed the higher DCP degradation efficiency in the neutral condition than in the acidic and basic conditions. The oxidation of DCP strongly depended on the dosage of ferrate added to the reactor and DCP initial concentration. With increasing of ferrate dosage the degradation efficiency of DCP increased, while the degradation efficiency of DCP decreased with increasing of DCP initial concentration. The effect of temperature has been tested at 4 different levels (10, 25, 35, and $50^{\circ}C$). The optimal temperature was obtained in $25^{\circ}C$ and degradation efficiency decreased as the temperature increased in the range from $25^{\circ}C$ to $50^{\circ}C$. The DCP degradation pathways were studied and proposed based on the intermediate products identified by GC/MS analysis.

• Journal of Power System Engineering
• /
• v.20 no.1
• /
• pp.42-49
• /
• 2016

This study showed that on-site ferrate(VI) solution was synthesized by wet oxidation method and applied aqueous 2,4-dichlorophenol(DCP) solution to evaluate the degradation efficiency. On-site ferrate(VI) solution was synthesized by putting $FeCl_3{\cdot}6H_2O$ in the strong alkali solution with NaClO and NaOH and applied DCP solution directly. DCP solution was extracted by the liquid-liquid method and analyzed by GC-ECD. The factors such as pH, DCP initial concentration, injected ferrate(VI) dosage, temperature were investigated. The optimum pH and temperature conditions of DCP degradation were obtained in neutral condition and $35^{\circ}C$. And the experimental results showed that DCP removal efficiency also increased with the decrease of DCP initial condition and the injected ferrate(VI) dosage.

• Proceedings of the KIEE Conference
• /
• 2000.07c
• /
• pp.2077-2080
• /
• 2000

We studied about electrical, chemical and mechanical characteristics of XLPE by dicumyl peroxide(DCP) and trimethylolpropane triacrylate(TMPTA) content ratio. DCP content was changed from 1.0 to 2.5phr increasing 0.5phr. TMPTA content was changed 0.5 to 1.5phr increasing 0.5phr. Thermal analysis (DSC) was carried out in order to observe tendency of 79 according to DCP and TMPTA content. In experimental results, content DCP 2.0phr and TMPTA 1.0phr has highest breakdown strength. Content DCP 2.0phr and TMPTA 0.5phr has lowest dielectric constant. Tendency of Tg did not affected by DCP and TMPTA content. Breakdown strength and Specific inductive capacity was measured.

• Elastomers and Composites
• /
• v.55 no.1
• /
• pp.6-12
• /
• 2020

Poly(ethylene-co-vinyl acetate) compounds and vulcanizates containing dicumyl peroxide (DCP) (HD) were prepared, and the curing agent and reaction products were analyzed using gas chromatography/mass spectrometry (GC/MS). Samples containing trially cyanurate (TAC) and DCP (HDT) were also prepared and analyzed. Some raw DCP were decomposed in the injector region of GC to produce acetophenone. DCP was detected in the HD compound but was not observed in the HD vulcanizate, and instead acetophenone and 2-phenyl-2-propanol were detected. Both DCP and TAC were observed in the HDT compound but not in the HDT vulcanizate, where acetophenone and 2-phenyl-2-propanol were detected. Thus, some of the DCP decomposed during the compounding process. The formation mechanism for acetophenone and 2-phenyl-2-propanol during the crosslinking reaction was identified, and differences in the crosslinking reactions of HD and HDT compounds were discussed.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2000.07a
• /
• pp.715-718
• /
• 2000

We studied about electrical, chemical and mechanical characteristics of XLPE by dicumyl peroxide(DCP) and trimethylolpropane triacrylate(TMPTA) content ratio. DCP content was changed from 1.0 to 2.Sphr increasing 0.5phr. TMPTA content was changed 0.5 to 1.5phr increasing 0.5phr. Thermal analysis (DSC) was carried out in order to observe tendency of Tg according to DCP and TMPTA content. Tensile strength was measured in order to observe mechanical strength. In experimental results, content DCP 2.0phr and TMPTA 1.0phr has highest breakdown strength. Content DCP 2.0phr and TMPTA 0.5phr has lowest dielectric constant. Tendency of Tg did not affected by DCP and TMPTA content. Breakdown strength and Specific inductive capacity was measured.

• Journal of Food Hygiene and Safety
• /
• v.21 no.3
• /
• pp.153-158
• /
• 2006

The contamination levels of 3-MCPD(3-Monochloropropane-1,2-diol) and 1,3-DCP(1,3-Dichloro-2-Propanol) in soy sauce, sauces was monitored. 105 samples were collected from June 2005 to August 2005 in Gyeonggi-do. 3-MCPD and 1,3-DCP were analyzed by GCMSD. As results, the detection range of 3-MCPD concentration was between 0.02 mg/kg and 0.27 mg/kg in soy sauce. However any samples were not detected with 1,3-DCP. The contaminated rates of 3-MCPD in soy sauce was 17.1%. Soy sauce is the representative vegetable protein hydrolyzed food. The reliable analytical method f3r the toxic 3-MCPD and 1,3-DCP in Soy sauce has been studied. The derivatization studies of 3-MCPD and 1,3-DCP were performed mainly as Silylation with BSA(N,O-Bis(trimethylsilyl)-acetamide). The retention times of derivative, BSA-MCPD, BSA-DCP were 11.30 and 10.12 minutes.

• International Journal of Highway Engineering
• /
• v.6 no.3 s.21
• /
• pp.17-26
• /
• 2004

The in-situ California Bearing Ratio (CBR) test has been widely used for evaluating the subgrade condition in asphalt concrete pavements. However, because the in-situ CBR test is expensive and takes plenty of time for operation, it is very difficult to figure out the in-situ characteristics of subgrade strength in detail. For faster and economical operation, the Dynamic Cone Penetrometer (DCP) has been often utilized for estimating the subgrade strength in the field. The relationship between the CBR value and DCP index obtained from the DCP testing has been studied using the laboratory and in-situ testing by other foreign researchers. The objective of this study is to determine the relationship between in-situ CBR value and DCP index of the subgrade materials used in Korea. The DCP index for evaluating the strength of subgrade materials produced in Korea is presented in this paper. Research results propose the regression equation to explain the relationship between the CBR and DCP tests. The in-situ CBR values of subgrade materials range from 20 to 45% indicating the good and sound subgrade condition.

• Journal of Life Science
• /
• v.16 no.7 s.80
• /
• pp.1164-1168
• /
• 2006

This study was carried out to investigate the possible for utilization of garbage in pig feed by investigating the functional characteristics of pork from pigs fed dried citrus byproduct. The samples consisted of the pork loin from pigs not fed with dried citrus pulp (DCP-0) and fed with 6% and 10% dried citrus pulp during growing and fattening period (DCP-1) there is no respective comparison here The pH, VBN content, TBARS value, bacterial counts, surface color, water holding capacity, loss degree and rheological properties of the samples were determined by physicochemical properties, and the sensory scores were evaluated. The pH, VBN content, surface color, water holding capacity and loss degree were not different between the samples, but the TBARS value and bacterial counts of DCP-1 were significantly lower than those of the DCP-0 (p<0.05). The cohesiveness, gumminess, chewiness, shear forte value, taste, flavor, tenderness, juiciness and palatability were not different between the samples, but the hardness of DCP-0 was higher than that of the DCP-1 and the springiness of DCP-1 was higher than that of the DCP-0 (p<0.05).

• Journal of Environmental Science International
• /
• v.16 no.2
• /
• pp.219-225
• /
• 2007

Endocrine disrupting compounds (EDC's) are chemicals that either mimic endogenous hormones interfering with pharmacokinetics or act by other mechanisms. Some endocrine disrupters were reported to be chemical substances that cause apoptosis in cells. A number of reports have indicated that 1,3-DCP, one of the EDC's may act as an endocrine disrupter and also has possible carcinogenic effects. 1,3-DCP, present in commercial protein hydrolysates used for human nutrition, are genotoxic and 1,3-dichloro-2-propanol induced tumors in rats. In the present study, it was investigated whether 1,3-DCP induces ROS generation and apotosis in A549 adenocarcinoma cells. Here we show that 1,3-DCP inhibits the growth of lung cancer cell lines and generates reactive oxygen species (ROS), a major cause of DNA damage and genetic instability, It was investigated that 1,3-DCP increases G1 phase cells after 12 hours, thereafter abruptly draws A549 cells to G0 state after 24 hours by flow cytometric analysis. 1,3-DCP induces p53 and $p21^{Cip1/WAF1}$ activation time- and dose-dependently by 24 hours, while the level $p21^{Cip1/WAF1}$ was decreased after 48 hours. These results suggest that 1,3-DCP, an EDC's generates ROS and regulates genes involved with cell cycle and apoptosis.