• Journal of the Korean Institute of Telematics and Electronics T
• /
• v.36T no.4
• /
• pp.88-93
• /
• 1999

In this paper, a new Mac-wave detection system by strain gage is constructed for study on a Mac-wave which is major factor of diagnosis in oriental medicine. Inherent resistance of a strain gage is linearly changed with strain of the sensor, thus the Mac-wave of wrist can be detected by using of the strain gage. A precision bridge circuit and high sensitive amplifier is designed for detecting the change of resistance of the strain gage in this experiments. A very small change of Mac-wave is acquired in the circuit. And the digital signal of the detected Mac-wave are acquired on a PC by multichannel A/D converter and displayed graphically by programming. The characteristics of the Mac-wave of sampled 6 persons in the time and the frequency domain are analysed, therefore the usefulness of the system constructed in this experiments are proved.

• Journal of KIISE:Information Networking
• /
• v.35 no.5
• /
• pp.437-452
• /
• 2008

IEEE 802.16j MR networks introduce RSs (Relay Stations) within the IEEE 802.16 system in order to enhance the data throughput and extend the coverage. However, the current standardization defines that the BS (Base Station) controls MS's (Mobile Station's) handover, not only it induces the large signaling overhead but also handover latency could increase. In this paper, we propose a handover protocol in the MR networks where the high capability RSs that can process the MS's control functions are deployed. First, we classify the handover scenarios for the MR networks with the high capability RSs. Then, we define the MAC handover procedure, corresponding MAC management messages and the transmission routes for the proposed messages so that an 802.16e MS can perform seamless handover without noticing it is attached to an MR network. The simulation results show that the proposed handover protocol not only reduces the MAC management message overhead transferred through the wireless links compared to IEEE 802.16j/D1, which is the current standard for MR networks, but also performs the rapider and more secure MS handover than IEEE 802.16e and IEEE 802.16j/D1.

• Journal of Korea Multimedia Society
• /
• v.14 no.3
• /
• pp.423-432
• /
• 2011

In a warehouse, because there exist frequent changes of stock status and the quality of some contents are influenced by the environment such as temperature, fast and accurate management of the warehouse's environment is very important for Warehouse Management Systems (WMS). However, due to the absence of a unified standard for the communication protocol between RFID nodes, the connection between RFID nodes can be broken in case of movement of a RFID reader to a region with a different protocol. Moreover, centralized MAC schemes for RFID communications in previous studies have severe problems. For an example, if a cluster header disappears from the cluster due to the cluster header's movement or bad channel conditions, the RFID member nodes of the cluster waste lots of time and energy to re-elect a new cluster header. Therefore, in this paper, we propose a WiMedia Distributed MAC (D-MAC) scheme for RFID communications and its cooperative relay transmission scheme for WMS applications Simulation results show performance improvement at the RFID node by using the proposed cooperative relay transmission scheme.

• Proceedings of the IEEK Conference
• /
• 2003.11c
• /
• pp.168-171
• /
• 2003

IEEE 802.16 Wireless MAN standard specifies the air interface of fixed point-to-multipoint broadband wireless access systems providing multiple services. Among the service classes supported by the wireless MAN, the best effort service class is ranked on the lowest position in priority and is assisted by a MAC scheme based on reservation ALOHL Such MAC scheme must include a number of components, while many of them are not specified in the standard. In this paper, we thus reveal main components of a MAC scheme supporting the best effort service and present candidate schemes implementing such components. Combining schemes for implementing components, we then construct distinctive MAC schemes supporting best effort service. In designing a MAC scheme, the delay performance induced by the scheme should be considered since scarce resource may be available for the best effort service after the preemptive resource occupation by other service classes. In this paper, we focus on the delay fairness among the subscriber stations using the best effort service. For evaluating a MAC scheme in delay fairness, we present two definitions of delay fairness and provide a criterion for optimal MAC scheme according to each definition of delay fairness. Using a simulation method we investigate the mean delay performance exhibited by each MAC scheme arid find an optimal scheme in delay fairness. From numerical examples, we observe that SR/ED/PG＋P scheme has strong delay fairness compared with MR/ED/PG＋P and SR/ED/PG＋D schemes according to a definition of delay fairness. However, other schemes are rather shown to have better delay fairness when the other definition is adopted.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.18 no.3
• /
• pp.526-534
• /
• 2014

In this paper, for the WiMedia Distributed Medium Access Control (D-MAC) protocol based on UWB. performance degradation due to the Distributed Reservation Protocol (DRP) conflict problem caused by devices' mobility is analyzed. And a DRP relay protocol and a DRP conflict resolution (CR) are proposed to overcome the performance degradation at DRP conflicts. In order to give the loser device at DRP conflicts a chance to maintain resources, the proposed DRP relay protocol executed at each device helps the loser device reserve an indirect link maintaining the required resources via a relay node. Simulation results considering the mobile environment have indicated that the DRP relay combined with the CR prevent the throughput decrease even though mobility of devices increases.

• Carbon letters
• /
• v.12 no.2
• /
• pp.70-80
• /
• 2011

Two pitches with different average molecular structures were electrospun and compared in terms of the properties of their fibers after oxidative stabilization, carbonization, and activation. The precursor with a higher molecular weight and greater content of aliphatic groups (Pitch A) resulted in better solubility and spinnability compared to that with a lower molecular weight and lower aliphatic group content (Pitch B). The electrical conductivity of the carbon fiber web from Pitch A of 67 S/cm was higher than that from Pitch B of 52 S/cm. The carbon fiber web based on Pitch A was activated more readily with lower activation energy, resulting in a higher specific surface area compared to the carbon fiber based on Pitch B (Pitch A, 2053 $m^2/g$; Pitch B, 1374 $m^2/g$).

• Carbon letters
• /
• v.9 no.2
• /
• pp.108-114
• /
• 2008

We have demonstrated the feasibility of using electrospinning method to fabricate long and continuous composite nanofiber sheets of polyacrylonitrile (PAN) incorporated with zinc oxide (ZnO). Such PAN/ZnO composite nanofiber sheets represent an important step toward utilizing carbon nanofibers (CNFs) as materials to achieve remarkably enhanced physico-chemical properties. In an attempt to derive these advantages, we have used a variety of techniques such as field emission scanning electron microscopy (FE-SEM), transmission electron microscopy (TEM) and high resolution X-ray diffraction (HR-XRD) to obtain quantitative data on the materials. The CNFs produced are in the diameter range of 100 to 350 nm after carbonization at $1000^{\circ}C$. Electrical conductivity of the random CNFs was increased by increasing the concentration of ZnO. A dramatic improvement in porosity and specific surface area of the CNFs was a clear evidence of the novelty of the method used. This study indicated that the optimal ZnO concentration of 3 wt% is enough to produce CNFs having enhanced electrical and physico-chemical properties.

• Journal of Power System Engineering
• /
• v.7 no.2
• /
• pp.11-16
• /
• 2003

Because of the advancement of digital computers and software technologies, simulation methods have been used to reduce time and costs. A lot of simulation methods have been developed for the improvement of charging efficiency on the intake and exhaust system of engines. In this study, as a basic step for the development of the gas flow simulation program for the intake and exhaust system, the gas flow in a pipe-orifice system was calculated with three algorithms(Method of Characteristics, MacCormack Method for conservation, and MacCoramck Method for nonconservation). The calculated results using three numerical algorithms were compared with measured result to verify the calculation accuracy.

• Journal of Internet Computing and Services
• /
• v.9 no.5
• /
• pp.153-163
• /
• 2008

Almost literature has so far proposed the modifications to IEEE 802.11 DCF MAC protocol to improve system throughput and average delay. Jitter(variance in packet delays) is, however, considered as an important QoS parameter for real-time streaming service which is popularized increasingly. Unfortunately, legacy access protocol for WLAN can't support the jitter. This paper proposes two schemes modifying the DCF MAC protocol to reduce the average value of jitter for multimedia frames arrived at received nodes. The one scheme, referred to as DCW-DCF(Decreasing Contention Window-DCF), reduces CW(Contention Window) size by half whenever a transmitted frame collided against other frames and back-off happens. Also, it increase initial CW size according as the link utilization and the collision probability increase. The other scheme, referred to as D-DIFS(Differential-DIFS), assigns different values to DIFS. That is, the DIFS interval is deceased as the number of back-off for a frame increases. In this paper, the two schemes are evaluated through simulation using ns2 and simulation results show that the proposed schemes are effective for improving the jitter property of standard WLAN.

• Journal of Communications and Networks
• /
• v.12 no.2
• /
• pp.174-180
• /
• 2010

Automatic Repeat reQuest (ARQ) is a very effective technique against transmission error at the medium access control (MAC) layer. An erroneous MAC protocol data unit can be typically retransmitted within a given limit. In order to improve the IP-level performance, which directly affects the user-perceived quality-of-service (QoS), we propose a new truncated ARQ strategy, called MAC service data unit-based ARQ (S-ARQ), where the finite number of opportunities for retransmissions are shared by multiple fragments out of an IP datagram. We describe how SARQ can be implemented in a practical system, and then propose another variant of S-ARQ employing a functionality called early detection of failure. Basically, we evaluate the performance of SARQ in two different manners. First, assuming i.i.d. error process, we analyze both the probability of the delivery failure and the average delay of IP datagram. Then, we assess the performance of S-ARQ via simulation over a 2-state Markov channel.