• Magazine of the Korea Concrete Institute
• /
• v.9 no.4
• /
• pp.167-176
• /
• 1997

The current study is a part of series of research about the evaluation method of the unbonded tendon stress in prestressed concrete member at flexural failure. As the first part. previous design equations were examined in oder to find whether any modifications may be needed. A total of 167 experimental results tested for more than 40 years were gathered to build D/B and then previous proposed and codified equations were evaluated with the experimental relsults. The ACI Code equation and Naaman, Harajli, and Chakrabarti's equations were chosen for the purpose of examination. Then, the followings were obtained from the analytical examination. It is desirable to compute the tendon stress with the member analysis method instead of the sectional analysis method which has been used in the current ACI Code. The tendon stress may also be influenced significantly by the amount of ordinary bonded reinforcements and the loading types. And the current ACI Code overestimated the effect of span/depth ratio. As results, it was concluded that the revision of the ACi Code equation should be considered positively. Then, a new design has to be proposed with the reasonable and comprehensive investigation about influential factors on the tendon stress variation.

• Journal of the Korean Applied Science and Technology
• /
• v.32 no.4
• /
• pp.649-660
• /
• 2015

Data obtained from the Calpuff inverse modeling estimate the emission amount of pollutants, and enable to establish the aim for reduction through the comparison of various cases. This study pursued to accumulate the fundamental data by the Calpuff inverse modeling for five areas in the vicinity of Donghae harbor, which focused on reduction of atmospheric fine dust. As a result of evaluation of the allowed emission amount for local sites, site-D required the most reduction, $4.95{\mu}g/m^2{\cdot}S$, based on the atmospheric guideline, $50{\mu}g/m^3$. The theoretical mitigation could decrease the average concentration of PM10 to $42.6{\mu}g/m^3$ for the study field (Donghae waste water treatment plant). Modeling only for site-A emission showed the potential concentration around the residential area of Donghae harbor, $40{\sim}50{\mu}g/m^3$. However, it will rise over $50{\mu}g/m^3$ with the addition of background level. Therefore no more emission would be allowed. Site-B including commercial area and unpaved field required the reduction of $0.11{\mu}g/m^2{\cdot}S$ due to vehicles and fugitive dust. Site-C and E did not emit additional pollutants.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.21 no.10
• /
• pp.433-439
• /
• 2020

This study, which was designed to improve and increase the utilization of female elk, examined the possibility of collecting their embryos during the non-reproductive period using ultrasound-guided Ovum Pick-Up (OPU) technology. Once follicles in the ovaries of an elk were observed, the embryos were retrieved through the absorption of the follicles using an OPU ultrasound probe. Fifty-seven embryos were retrieved from 85 follicles, giving a retrieval rate of 67.1%. Morphological evaluation of the recovered embryos revealed 14.0% embryos to be in grade A, 19.2% in grade B, 15.7% in grade C, and 50.8% in grade D. The developmental efficiency of the retrieved embryos was also investigated using in vitro maturation, in vitro fertilization, and in vitro culture. After cultivating 28 embryos through in vitro fertilization, 19 embryos were found to be fertilized; the fertilization rate was 67.9%. Four embryos developed to the blastocyst stage, indicating a 14.3% development rate. This study confirmed that the production of fertilized embryos from a seasonal breeder, such as elk, is possible via the ultrasound-guided OPU method. If the efficiency of in vitro fertilization and in vitro culture can be improved through further research, it will help improve the efficiency of elk embryo production through the transplantation of their fertilized embryos.

• Journal of IKEEE
• /
• v.24 no.1
• /
• pp.347-353
• /
• 2020

In this paper, the durability of an electromagnetic metamaterial absorber is verified in a temperature varying condition mimicking a maritime environment for the purpose of applying it to reduce the radar cross section of an integrated mast of the next-generation destroyer. To validate the durability, the reflectance of the electromagnetic metamaterial absorber was measured after storing it in a chamber that can control the temperature according to Procedure I of Method 501.7 included in MIL-STD-810H. Before and after the environmental test, both of the measured reflectances were retained less than -10 dB over the X band, that can guarantee the stealth functionality.

• Korean Journal of Environment and Ecology
• /
• v.12 no.1
• /
• pp.78-90
• /
• 1998

An objective of this study was to provide database for the planting disign of buffer green space. Types, planting structure, and effect of vuffer green space were investigated in five housing complexes of newtown of metropolitan area, Korea. Buffer green space in the study sites were constructed as mounding, slope, and plate. The number of species was found 20 tree and sub-tree species(10 evergreen and 20 deciduous species ) and 13 shrub species. These species were planted in one-storyed planting structure and there was no difference with ornamental species in the urban parks. Effect of sound proof by the buffer green space was recognized but sound level in four types among the seven types was observed above standard sound level for housing complex(65dB). Effect of sound proof was especially most effective in the mounding type. It was found that planting density and index of plant crown volume were mot satisfied to the function of buffer green space because of lower density and crown volume than natural vegetation per unit. Based on these results, this study suggested that buffer green space is desirable to be developed in the mounding type over two meters height with multi-layer planting model. In addition, there is needed to consider vegetation structure of natural forest around the developing site.

• Journal of the Korea Society of Computer and Information
• /
• v.19 no.6
• /
• pp.93-100
• /
• 2014

The objective of this study is to propose the measurement system implementation method for the evaluation and measurement of the indoor-impulsive over 170 dB noise source. For the purpose of measuring impulse noise, design and implementation constructed followed subsystems of the testing center, microphone, ear simulator, head and torso simulator and so on. Measurement systems for the accuracy and reliability of impulse noise are implemented when measuring 3 ways of measurements method by the simultaneous measurement system design. For the accuracy and reliability of three mutually indoor-impulse noise measurements were compared, three kinds of measuring methods in accordance with the peak sound pressure level and octave band. Comparing the results of data, the indoor-impulse noise by analyzing a frequency characteristic was validated in difference for the statistical significance. Result are determined by the influence of the reflected wave. Therefore, the flexible size of the interior test site while interior impulse noise measurement system was constructed. Throughout this system can be affected by parameters that are the impulse noise source and the corresponding frequency-characteristic analysis to determine the spectrum of the reflected wave. And, in the near future, indoor impulse noise measurement systems for acquisition and analysis are utilized in useful data.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.17 no.9
• /
• pp.401-406
• /
• 2016

When measuring live cable faults and their location based on reflectometry, a coupler is placed between the cable and the test system. This coupler prevents damage to the test circuits by indirectly measuring the live voltage of the cable using reflectometry. It also provides a coupling path that allows the transmission and receive signal to pass into the cable. In this study, we design and construct a contact coupler to locate faults in both dead and live cables using reflectometry. The proposed coupler is of the inductive coupling type and is constructed after the calculation of the signal transmission loss by simulation. The performance of the developed coupler is tested by measuring the transmission loss and frequency flatness. The results showed that the transmission signal loss is less than -1.98dB in the frequency bandwidth above 1 Mhz. The reflectometry system was designed based on sequence time domain reflectometry (STDR) and spread spectrum time domain reflectometry (SSTDR) in order to apply it to the detection of faults and their location in live cables and tests on live cables were performed. The test results showed that the proposed coupler can be used in a reflectometry system for live cable fault detection.

• KIPS Transactions on Software and Data Engineering
• /
• v.11 no.3
• /
• pp.133-140
• /
• 2022

We investigate the performance of deep learning-based Korean language models on a task of predicting the score range of Korean essays written by foreign students. We construct a data set containing a total of 304 essays, which include essays discussing the criteria for choosing a job ('job'), conditions of a happy life ('happ'), relationship between money and happiness ('econ'), and definition of success ('succ'). These essays were labeled according to four letter grades (A, B, C, and D), and a total of eleven essay score range prediction experiments were conducted (i.e., five for predicting the score range of 'job' essays, five for predicting the score range of 'happiness' essays, and one for predicting the score range of mixed topic essays). Three deep learning-based Korean language models, KoBERT, KcBERT, and KR-BERT, were fine-tuned using various training data. Moreover, two traditional probabilistic machine learning classifiers, naive Bayes and logistic regression, were also evaluated. Experiment results show that deep learning-based Korean language models performed better than the two traditional classifiers, with KR-BERT performing the best with 55.83% overall average prediction accuracy. A close second was KcBERT (55.77%) followed by KoBERT (54.91%). The performances of naive Bayes and logistic regression classifiers were 52.52% and 50.28% respectively. Due to the scarcity of training data and the imbalance in class distribution, the overall prediction performance was not high for all classifiers. Moreover, the classifiers' vocabulary did not explicitly capture the error features that were helpful in correctly grading the Korean essay. By overcoming these two limitations, we expect the score range prediction performance to improve.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.30 no.2B
• /
• pp.211-217
• /
• 2010

This paper presents numerical investigations of the physical habitat changes induced by the hydropeaking in the downstream river of dam. For the two-dimensional ecohydraulic simulations, River2D model is used. Pirami (Zacco platypus) is selected as the target fish for investigating the impact of the hydropeaking. For validation of the model, the water surface elevations are simulated with two different water discharges. The computed results are compared with field data in the literature, and the result shows that the model successfully simulates the water flows. The weight usable area (WUA) of Pirami with the life cycle and the composite suitability index with different water discharges are computed and discussed. The results show that habitat for Pirami appears to be best in the bend region downstream of the dam. The discharge of the maximum WUA for adult Pirami is computed to be about 9 $m^3/s$. Also, the WUA computed in a condition of hydropeaking during seven days are presented. The averaged discharge of the hydropeaking appears to be about 20% larger than the drought flow, but the WUA by the hydropeaking is computed to be 60-100% smaller. This result shows that the hydropeaking reduces quantity of habitat available to fish.

• Korean Journal of Mineralogy and Petrology
• /
• v.36 no.4
• /
• pp.259-271
• /
• 2023

Since the short-wave infrared spectrum has a significant range of variation depending on the production environment, countries with advanced resource exploration are collecting the spectrum and building a database. Representative organizations include the USGS and CSIRO, and they are currently carrying out a project in China that can synthesize and use a large number of existing data. The USGS library provides a total of 2,457 spectra targeting not only minerals but also various materials that respond to infrared radiation. Among these, there are 1,276 mineral spectra, which are about half of the total. The spectrum title includes information, such as analysis devices (NIC4, BECK, ASDNG, etc.), purity codes (a, b, c, d, u), and measurement methods (AREF, RREF, RTGC, TRAN). Analyzed raw data are provided in ASCII and GIF format. The CSIRO library has a total of 502 spectra, of which the majority, 493, correspond to mineral spectra. The USGS library is a free, publically available resource, while the CSIRO library is bundled with TSG8 or must be purchased separately. Among these, when comparing the eight spectra whose spectral shapes can be analyzed with the spectra of domestic illite, the positions of the absorption peaks are significantly different from those of domestic illite, except for one Japanese illite. Additional research will be needed to determine the causes of such differences, and the domestically relevant databases should be established as well.