• Journal of the Korean Geophysical Society
• /
• v.8 no.2
• /
• pp.97-103
• /
• 2005

It is necessary, in the light of the importance of long-term slope stability problem, to develop a simple method or tool which can figure out the possible failure zone resulted from weathering effect and other factors. The FBG sensor system is used to estimate the correlations between the temperature and the slope in Yunhwajae, and to find a failure zone in slopes effectively. This research is to seek for the correlation between the soil temperature distribution and the strain distribution in a active zone by analyzing the data from the in-situ measurement so that the possible failure zone should be well defined based on the correlation. The zone of high temperature fluctuation can be regarded as one of the possible sliding zone due to the weathering effect while the constant temperature depth of the ground, if exists, would not be relatively affected by the weathering process.

• Korean Journal of Agricultural Science
• /
• v.35 no.1
• /
• pp.33-40
• /
• 2008

The structural characteristics that influence on the fungicidal activities of N-phenylbenzenesulfonamide (1~24) and N-phenyltheinylsulfonamide (25~30) derivatives against Dampping-off (Pythium ultimum) were discussed quantitatively using the models of molecular holographic quantitative structure-activity relationships (HQSAR). From the based on these findings, the statistical results of the optimized HQSAR F-3 model showed better predictablity ($r^2_{cv.}$ or $q^2=0.581$) and correlation coefficient ($r^2_{ncv.}=0.963$). And, from the analytical results of the atomic contribution maps on the fungicidal activities, the most active compound is $R_1=2-fluoro-4-chloro$ substituent (4) and the most inactive one is $R_1=4-methoxy$ substituent (20). It was found that the 2-fluoro-4-chlorophenyl group as a $R_1$-group was an important structure and a characteristic factor not only for herbicidal activity but also for fungicidal activity.

• Journal of the Korean Chemical Society
• /
• v.35 no.3
• /
• pp.253-257
• /
• 1991

The optically active glycerol acetonides are often used as important chiral intermediates for many syntheses. In connection with the development of inhibitors of phospholipases, we have compared the synthetic routes to (S)-and (R)-glycerol acetonide from D-mannitol and D-isoascorbic acid, and L-serine and L-ascorbic acid, respectively. In our hands, the conversions of L-serine to (R)-glycerol acetonide and of D-mannitol to (S)-glycerol acetonide were found to be most effective.

• Clinical and Experimental Pediatrics
• /
• v.45 no.10
• /
• pp.1292-1298
• /
• 2002

Melkersson-Rosenthal syndrome(MRS) is a rare disorder, having a symptom triad of recurrent facial palsy, orofacial swelling and fissured tongue(lingua plicata). This disorder is usually recurrent or progressive, and monosymptomatic or oligosymptomatic forms have been reported to be more common than classic forms. Generally, MRS occurs in young adults at the end of the second decade of life and incidence of the disease in childhood is known to be very low. Although the clinical manifestation of MRS in children is similar to that in adults, early diagnosis and management is essential to avoid long-lasting functional disorders and psychological problems. We experienced MRS in a 13 year old boy with a history of recurrent facial palsy. We report this case with review of related literature.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.11 no.1
• /
• pp.131-131
• /
• 2003

왕겨 활용의 일환으로 파쇄과정을 거쳐 돈분과 혼합하여 퇴비화에 미치는 영향 및 물질의 특성 변화를 조사하였다. 왕겨 입자는 1mm 이하, 1~2mm, 2mm 이상 등 3가지로 분리하여 돈분과 부피비(4 : 3)로 혼합한 후 정체식 퇴비화 시설에 적하하여 $250m^3/hr.$의 송풍기로 10min./day씩 강제송풍을 시켰다. 처리구는 톱밥구(Control), 왕겨구(RH), 1~2mm 왕겨구(MRH), 1mm이하 왕겨구(SRH) 등 4개였으며, 수분함량은 혼합물질의 특성에 따라 차이를 보였다. 온도변화는 퇴비화 시작 3일째부터 온도 상승이 시작되었으며, RH구에서 가장 빨리 $60^{\circ}C$로 상승하였다. 그 후 가장 먼저 온도가 하강하였으며 40일째 온도가 대기온도와 같았다. pH는 모든 처리구에서 10일 이내에서 감소하였지만 그 후 지속적으로 증가하는 경향을 보였다. 유기물은 퇴비화 초기와 후기에 큰 차이를 보이지 않았지만 RH구의 감소율이 다른 처리구에 비해 높았다. 공극률이 높은처리구일수록 암모니아 휘산이 적어 T-N함량이 높았고 C/N율은 20~40사이로 적당하였다. 퇴비화 과정 중 온도 변화는 용적밀도의 차이에 의한 것이며, 화학성분의 함량 차이는 두 물질사이의 혼합량 차이에 의한 것이었다.

• Journal of IKEEE
• /
• v.16 no.4
• /
• pp.343-348
• /
• 2012

A 11b 100KS/s Algorithmic ADC for Digital PFC controller is proposed. The proposed Algorithmic ADC structure for 11bit resolution is based on a cyclic architecture to reduce chip area and power consumption. The prototype Algorithmic ADC implemented with a 0.18um 1Poly-3Metal CMOS process shows a SNDR 66.7dB and ENOB 10.78bits. And the current consumption is about 780uA at 100KS/s and 5V. The occupied active die area is $0.27mm^2$.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.15 no.4
• /
• pp.502-506
• /
• 2012

In order to find the structural characteristics of the thin films of group II-VI semiconductor compounds compared with those of powder materials, films were made of 4 powders of ZnS, CdS, CdSe, and CdTe(Aldrich), each with 99.99 % purity. For the ZnS/CdS multi-layers, the ZnS layer was coated over the CdS layer on an $AlO_x$ membrane, which served as a protective layer within a vacuum at the average speed of 1 ${\AA}$/sec. After studying the structures of the group II-VI semiconductor thin films by using X-ray spectroscopy, we found that the ZnS, ZnS/CdS, CdS, and CdSe films were hexagonal and exhibited some degree of preferred orientation. Also, the particles of the thin films of II-VI semiconductor compounds proved to be more homogeneous in size compared to those of the powder materials. These results were further verified through scanning electron microscopy(SEM), EDX analysis, and powder and thin film X-ray diffraction.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.13 no.4
• /
• pp.659-664
• /
• 2010

The ZnS/CdS thin films were made using 99.99% ZnS and CdS(Aldrich) powders in $7{\times}10^{-6}torr$. The ZnS layer was coated over the CdS layer on an AlOx membrane within a vacuum, at the average speed of $1{\AA}/sec$. After studying the ZnS/CdS and CdS thin films(both with the dimensions of 2.52nm), using fluorescence spectroscopy and comparing the respective results together, we found that although both of the resulting spectra peaked at 390nm, the ZnS/CdS thin films showed a narrower peak, and a higher intensity of photoluminescence than the CdS thin films. The particles of ZnS/CdS thin films also proved to be more homogeneous in size. In addition, the ZnS layer acted as a protective layer. Also, after studying the spectra of ZnS/CdS thin films taken 30 days after their preparation, we found no signs of aging. These results were verified through the scanning electron microscopy(SEM), EDX analysis, thin film X-ray diffraction, and luminescence spectroscopy.

• Proceedings of the KIEE Conference
• /
• 2007.07a
• /
• pp.1311-1312
• /
• 2007

본 논문에서는 YBCO coated conductor(CC) 의 접합연구와 접합된 선재의 응용을 위한 특성연구를 수행하였다. 최근에 지속적으로 연구 개발되어 본격적으로 응용이 시작되는 CC는 기본적으로 높은 인덱스 값과 자기장에 대한 임계전류의 균일성 등 다른 고온초전도에 비해 좋은 특성을 갖고 있으며 따라서 미래의 초전도 기기에 광범위하게 사용될 것으로 예상된다. CC와 같은 초전도 선재가 초전도 기기에 적용되는 경우 대부분 초전도 선재와 초전도 사이의 접합, 초전도 선재와 상전도체 사이의 접합 등의 접합들이 존재하게 된다. 접합을 위해서는 접합 땜납이 들어가게 되고 이 부분에서 저항이 발생하게 되어 손실이 발생하게 된다. 이러한 손실은 저항이 '0'이어서 손실이 적다는 초전도기기의 장점을 떨어뜨리는 요인이 될 수 있다. 따라서 CC의 접합 특성을 연구 하는 것은 초전도 기기의 성능향상에 도움을 줄 수도 있는 요인이 될 수 있다. 이 논문에서는 구리 안정화층, YBCO 층, 완충층과 기판층으로 이루어진 YBCO CC 선재를 이용하여 두 가지의 접합 방법을 이용하여 접합특성을 연구하였다.

• Journal of the Korean Geophysical Society
• /
• v.7 no.4
• /
• pp.269-276
• /
• 2004

Optical fiber sensors have shown a potential to serve real time health monitoring of the structures. They can be easily embedded or attached to the structures and are not affected by the electro-magnetic field. Furthermore, they have the flexibility of the sensor size and very highly sensitive. In this study, we conducted several laboratory and field tests using a novel optical sensor based on Brillouin scattering. One of the advantages of this technique is that the bare fiber itself acts as sensing element without any special fiber processing or preparation. Test results have shown that BOTDR can be a great solution for sensor systems of Civil Engineering Smart Structures.