• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.20 no.3
• /
• pp.240-247
• /
• 2009

In this paper, we proposed the method of the interference evaluation between the microwave oven noise and the wireless LAN(Local Area Network) by using the GTEM cell. We used microwave oven noise in time to assess the interference unintentional noise effects on wireless LAN and realized by combining an AM(Amplitude Modulation) modulator and a FM(frequency Modulation) modulator. Also the GTEM cell can be used to guarantee the reliability by the evaluations of the frequency and time responses. As measurement results for the APD(Amplitude Probability Distribution) of the interfering noise we analyzed the effect of microwave oven noise to the throughput of wireless LAN.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.33 no.4
• /
• pp.291-296
• /
• 2020

The high power of a shingled photovoltaic module can be attributed to its low cell-to-module loss. The production of high power modules in limited area requires high efficiency solar cells. Shingled photovoltaic modules can be made by divided solar cells, which can be produced by the laser scribing process. After dividing the 21% PERC cell using laser scribing, the efficiency decreased by approximately 0.35%. However, there was no change in the efficiency of the solar cell having relatively lower efficiency, because the laser scribing process induce higher heat damages in solar cells with high efficiency. To prove this phenomena, the J₀ (leakage current density) of each cell was analyzed. It was found that the J₀ of 21% PERC increased about 17 times between full and divided solar cell. However, the J₀ of 20.2% PERC increased only about 2.5 times between full and divided solar cell.

• Journal of Korean Neurosurgical Society
• /
• v.30 no.sup1
• /
• pp.124-127
• /
• 2001

Langerhans' cell histiocytosis is a rare disease showing proliferation of histiocytes in multiple organ system. Bone lesions are the most common radiolologic manifestation of Langerhans' cell hysticytosis. Extraskeletal sites of Langerhans' cell hystiocytosis involvement include the skin, lymph nodes, thymus, lungs, central nervous system, liver, pancrease, spleen, and bowel. The authors have experienced a case of Langerhans' cell histiocytosis which involved the skull. A 3-year-old female presented with soft tissue mass on right periorbital area. Plain skull X-ray showed punched out bone lesion. Computed tomography showed non-enhancing osteolytic lesion on right frontal skull. Histologic findings of an excised mass revealed pathologic features of Langerhans' cell histiocytosis.

• Journal of Microbiology and Biotechnology
• /
• v.31 no.3
• /
• pp.349-357
• /
• 2021

Monoclonal antibodies are widely used as diagnostic reagents and for therapeutic purposes, and their demand is increasing extensively. To produce these proteins in sufficient quantities for commercial use, it is necessary to raise the output by scaling up the production processes. This review describes recent trends in high-density cell culture systems established for monoclonal antibody production that are excellent methods to scale up from the lab-scale cell culture. Among the reactors, hollow fiber bioreactors contribute to a major part of high-density cell culture as they can provide a tremendous amount of surface area in a small volume for cell growth. As an alternative to hollow fiber reactors, a novel disposable bioreactor has been developed, which consists of a polymer-based supermacroporous material, cryogel, as a matrix for cell growth. Packed bed systems and disposable wave bioreactors have also been introduced for high cell density culture. These developments in high-density cell culture systems have led to the monoclonal antibody production in an economically favourable manner and made monoclonal antibodies one of the dominant therapeutic and diagnostic proteins in biopharmaceutical industry.

• Journal of Environmental Impact Assessment
• /
• v.21 no.5
• /
• pp.649-664
• /
• 2012

The grid cell analysis is used to select good sites as habitats at the region. The northern area of Yeongjong Island, Incheon has been disturbing by habitat loss due to human activities such as residential development, deforestation. In order to determine significant places as bird habitats and to select conservation areas at this island, the study area was divided into 70 grid cells($500{\times}500m$ each grid) and then each grid was ranked by spatial analysis using the species diversity index. Fieldwork was carried out in Spring and Autumn of 2010. To examine grid cells which were ranked high in both seasons in common, we used the average ranking value, combined data from two seasons. This area consists of mainly agricultural areas and forests(more than 68%) among eight habitat types: the agricultural land, forest, coast, lake, meadow, stream, city and other things. A total of 110 species was recorded: 4,183 birds of 102 species in Spring and 3,326 birds of 58 species in Autumn. In other words, the number of individuals and species was higher in Spring than in Autumn. Species diversity index presented the highest value at M8 grid cell in Spring(3.380) and at A4 gird cell in Autumn(2.736). In 18 of 22 grid cells where the average ranking value was higher than 3, the forest was distributed and in 4 grid cells, the coast and wetland were widely distributed, in which theses were located apart from human-associated disturbances such as construction works for a leisure complex. Our results present a new estimate method not only to minimize loss of bird habitats but also to conserve important habitats when the large-scale development takes place at particular region.

• Journal of Electrochemical Science and Technology
• /
• v.7 no.1
• /
• pp.41-51
• /
• 2016

In the stratosphere, the air is stable and a photovoltaic (PV) system can produce more solar energy compared to in the atmosphere. If unmanned aerial vehicles (UAVs) fly in the stratosphere, the flight stability and efficiency of the mission are improved. On the other hand, the weakened lift force of the UAV due to the rarefied atmosphere can require more power for lift according to the weight and/or wing area of the UAV. To solve this problem, it is necessary to minimize the weight of the aircraft and improve the performance of the power system. A regenerative fuel cell (RFC) consisting of a fuel cell (FC) and water electrolysis (WE) combined PV power system has been investigated as a good alterative because of its higher specific energy. The WE system produces hydrogen and oxygen, providing extra energy beyond the energy generated by the PV system in the daytime, and then saves the gases in tanks. The FC system supplies the required power to the UAV at night, so the additional fuel supply to the UAV is not needed anymore. The specific energy of RFC systems is higher than that of Li-ion battery systems, so they have less weight than batteries that supply the same energy to the UAV. In this paper, for a stratospheric long-endurance hybrid UAV based on an RFC system, three major design factors (UAV weight, wing area and performance of WE) affecting the ability of long-term flight were determined and a simulation-based feasibility study was performed. The effects of the three design factors were analyzed as the flight time increased, and acceptable values of the factors for long endurance were found. As a result, the long-endurance of the target UAV was possible when the values were under 350 kg, above 150 m² and under 80 kWh/kg H₂.

• Transactions of the Korean hydrogen and new energy society
• /
• v.16 no.2
• /
• pp.170-179
• /
• 2005

Electrolyte loss is considered as one of the major obstacles limiting the life time of molten carbonate fuel cells (MCFCs). Unit cells with an effective area of 100 $cm^2$ were prepared and were operated to determine the optimum matrix thickness which contains the maximum amount of electrolyte without serious preformance loss caused by high resistance. Matrices with different thickness, 1.45, 1.8, and 2.3 mm, were used in unit cells and those cells were operared about 5000, 10000, and 4000 hrs. The unit cell used 1.8 mm thick matrix showed 0.85 V (at 150 mA/$cm^2$) as the intial performance and this cell voltage is not lower than the cell voltage obtained in the cell with 1 mm thick matrix. This cell was operated for 10000 hrs. The cell used 1.45 mm thick matrices showed 16.6 % in the electrolyte loss after 5000 hr operation. In the case of the cell with 2.3 mm thick matrix, the initial cell voltage was below 0.80 V (at 150 mA/$cm^2$). For thermal cycle test, the gas crossover amount of unit cell used 1.8 mm thick matrix was much less than that of the cell with 1.0 mm thick matrix.

• Asian Pacific Journal of Cancer Prevention
• /
• v.13 no.2
• /
• pp.647-651
• /
• 2012

Aim: An epidemiological study was conducted based on an esophageal cancer patient's cohort to investigate the association of folate intake and MTHFR C677T polymorphism with the prognosis of esophageal cancer in a Chinese population. Methods: 167 patients aged 37-75 years who had histological confirmed diagnosis of esophageal squamous cell cancer were collected from Jan. 2006 to Jan. 2008. MTHFR genotypes at the C677T site were analyzed by PCR-based RFLP methods, and the folate intake was computed by multiplying the food intake (in grams) and the folate content (per gram) of food in our questionnaire. Results: We found associations between the prognosis of esophageal cancer and smoking status, T and N stages. Individuals carrying the MTHFR 677CT and TT genotypes showed a shorter survival time than with the CC genotype, with adjusted HRs (95% CI) of 1.20 (0.56-2.15) and 2.29 (1.30-4.28), respectively. Similarly, those carrying MTHFR 677T allele had a 1.86-fold risk of death. A higher folate concentration showed a significant decreased risk of death, with an HR (95% CI) of 0.45 (0.18-0.87). Individuals with high folate intake and the MTHFR 677CC genotype showed a significant decreased risk of esophageal cancer (0.43, 0.25-0.89).Conclusion: Our findings supports the hypothesis that high folate intake and active MTHFR C677T polymorphism may exert protective roles in the prognosis of esophageal cancer in the Chinese population.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.14 no.2
• /
• pp.108-116
• /
• 1985

This study was designed to investigate the nutritional anemic state and hematological findings of children, aged 11 and 12 years, living in Haenam Koon (living at home) and in Mokpo City (living in an orphan asylum) located in Chonnam. The mean red blood cell number of male was higher than female in both groups of living in the rural area and in the city orphan asylum (p<0.01), but the white blood cell count was not significantly different. The levels of average hemoglobin, hematocrit and mean corpuscular hemoglobin concentration of the children in both groups were similar, and 19.8% of children living at home in the rural area and 32.1% of children living in the city orphan asylum were anemic. The mean levels of serum total protein, albumin and A/G ratio in children of both group were not statistically different, and 18.4% of children living at home in the rural area and 13.2% of children living in the city orphan asylum were insufficient in the serum total protein value. The average serum cholesterol level of children living at home in the rural area was higher than that of children living in the city orphan asylum(p<0.01), and that of female living at home was higher than that of male (p<0.05). The mean levels of serum iron, total iron binding capacity and transferrin saturation of children living at home in the rural area were significantly higher than those of children living in the city orphan asylum (p<0.01).

• Proceedings of the Korean Vacuum Society Conference
• /
• 2011.08a
• /
• pp.148-148
• /
• 2011

Recently, there have been many research activities to develop the large-area plasma source, which is able to generate the high-density plasma with relatively good uniformity, for the plasma processing in the thin-film solar cell and display panel industries. The large-area CCP sources have been applied to the PECVD process as well as the etching. Especially, the PECVD processes for the depositions of various films such as a-Si:H, ${\mu}c$-Si:H, Si3N4, and SiO2 take a significant portion of processes. In order to achieve higher deposition rate (DR), good uniformity in large-area reactor, and good film quality (low defect density, high film strength, etc.), the application of VHF (>40 MHz) CCP is indispensible. However, the electromagnetic wave effect in the VHF CCP becomes an issue to resolve for the achievement of good uniformity of plasma and film. Here, we propose a new electrode as part of a method to resolve the standing wave effect in the large-area VHF CCP. The electrode is split up a series of strip-type electrodes and the strip-type electrodes and the ground ones are arranged by turns. The standing wave effect in the longitudinal direction of the strip-type electrode is reduced by using the multi-feeding method of VHF power and the uniformity in the transverse direction of the electrodes is achieved by controlling the gas flow and the gap length between the powered electrodes and the substrate. Also, we provide the process results for the growths of the a-Si:H and the ${\mu}c$-Si:H films. The high DR (2.4 nm/s for a-Si:H film and 1.5 nm/s for the ${\mu}c$-Si:H film), the controllable crystallinity (~70%) for the ${\mu}c$-Si:H film, and the relatively good uniformity (1% for a-Si:H film and 7% for the ${\mu}c$-Si:H film) can be obtained at the high frequency of 40 MHz in the large-area discharge (280 mm${\times}$540 mm). Finally, we will discuss the issues in expanding the multi-electrode to the 8G class large-area plasma processing (2.2 m${\times}$2.4 m) and in improving the process efficiency.