• Journal of The Korean Society of Grassland and Forage Science
• /
• v.5 no.1
• /
• pp.33-36
• /
• 1985

This experiment was carried out to investigate the effect of crown density of trees on the growth and yield of cool-season grasses in forest. The species used in this study was orchard-grass (Dactylis glomerata L.) and 4 levels of tree crown density(O=full sunlight, 25, 50 and 75%) were treated. The experiment was performed at the experimental filed of the Livestock Experiment Station in Suweon, during 1979 to 1950. The results obtained are summarized as follows: 1. Maximum leaf area was obtained at 25% crown density of trees, followed by 0, 50 and 75%, regardless of cutting times. 2. Plant height tended to increase as the crown density of trees increased. However, there was no difference between 0% and 25% crown density of trees. 3. There was a negative correlation between plant height and leaf area of orchardgrass grown under pine trees. 4. The more dry matter yield of orchardgrass was obtained at 25% crown density of trees (p<0.05), follwed by 0, 50 and 75%, respectively. However, there was no significant difference between 0% and 50% crown density of trees. Therefore it is suggested that the critical level of crown density of trees is 50% to culture of cool-season grasses in forest.

• Journal of Korean Society of Forest Science
• /
• v.99 no.1
• /
• pp.52-56
• /
• 2010

Crown fuel characteristics such as crown bulk density, crown base height, and fuel moisture content of Japanese red pine were analyzed. Ten trees in Mt. Palgong at Daegu, were destructively sampled and their crown fuels were weighed separately for each fuel category. Fuel content of live and dead crown component were 53%, and 15.3%, respectively. Foliar moisture content was 56%. Needles and twigs with diameter less than 1cm diameter accounted for 16.2%, 55% of total and crown fuel load. Average crown bulk density of Japanese red pine was 0.24 kg/$m^3$, effective crown fuel bulk density was 0.1325 kg/$m^3$.

• Journal of The Korean Society of Agricultural Engineers
• /
• v.56 no.6
• /
• pp.149-158
• /
• 2014

The effects of spot cooling on growing ever-bearing strawberry in hydroponic cultivation during summer by spot cooling system was estimated in plastic greenhouse located in Pyeongchang. The temperature of cooling water was controlled by heat pump and maintained at the range of $15{\sim}20^{\circ}C$. Cooling pipes were installed in root zone and very close to crown. Spot cooling effect was estimated by applying system in three cases which were cooling root zone, crown plus root zone, and crown only. White low density polyethylene pipe in nominal diameter of 16 mm was installed on crown spot, and Stainless steel flexible pipe in nominal diameter of 15A was installed in root zone. Crown and root zone cooling water circulation was continuously performed at flowrates of 300 ~ 600 L/hr all day long. Strawberry yields by test beds were surveyed from Aug. 1 to Sep. 30. The accumulated yield growth rate compared with a control bed of crown cooling bed was 25 % and that of crown plus root zone cooling bed was 25 % and that of root zone cooling bed was 20 %. The temperatures of root spot in root zone cooling was maintained at $18{\sim}23.0^{\circ}C$ and that of crown spot in crown cooling was maintained at $19{\sim}24^{\circ}C$. Also, the temperatures of root spot in crown plus root zone cooling bed was maintained at $17.0{\sim}22.0^{\circ}C$ and that of crown spot was maintained at $19{\sim}25^{\circ}C$.

• Journal of Korean Society of Forest Science
• /
• v.99 no.3
• /
• pp.391-396
• /
• 2010

To analyze the characteristics of canopy fuel in Pinus densiflora stand, which is essential to assess the crown fire hazard, allometric equations for estimation of crown fuel biomass were developed by subjectively categorized crown fuel component and crown bulk density was analyzed by available fuel component categories. Ten trees were destructively sampled at Pinus densiflora stand in Mt. Palgong in Daegu and their crown fuels were weighed separately for each fuel category by size classes and by living and dead. Regression equations that estimate crown fuel load by diameter at breast height(D) or additional total height(H) were derived. The adjusted coefficient of determination values were the highest (${R^2}_{adj}$=0.835-0.996) and standard error of estimate were the lowest (SEE=0.074-0.638) in the allometric equation lnWt=${\alpha}+{\beta}lnD+{\gamma}lnH$ in average. However, in needles and small branches categories, the differences in ${R^2}_{adj}$ and SEE between equations were not significant. Crown bulk density (CBD), which was calculated by crown fuel load divided by crown volume, was 0.067 kg/$m^3$ in average when only needles were considered as available crown fuel and 0.097 kg/$m^3$ when needles and branches (0-0.5 cm diameter) were considered. The increments of CBD of needles and small branches were little even when diameter at breast height increased.

• Journal of Korean Society for Geospatial Information Science
• /
• v.20 no.1
• /
• pp.83-91
• /
• 2012

Crown density, which is defined as the proportion of the forest floor concealed by tree crown, is important and useful information in various fields. Previous methods of measuring crown density have estimated crown density by interpreting aerial photographs or through a ground survey. These are time-consuming, labor-intensive, expensive and inconsistent approaches, as they involve a great deal of subjectivity and rely on the experience of the interpreter. In this study, the crown density of a forest in Korea was estimated using KOMPSAT-2 high-resolution satellite images. Using the image segmentation technique and stand information of the digital forest map, the forest area was divided into zones. The crown density for each segment was determined using the discriminant analysis method and the forest ratio method. The results showed that the accuracy of the discriminant analysis method was about 60%, while the accuracy of the forest ratio method was about 85%. The probability of extraction of candidate to update was verified by comparing the result with the digital forest map.

• Journal of Korean Society of Forest Science
• /
• v.100 no.3
• /
• pp.402-407
• /
• 2011

The objectives of this study were to analyze the crown vertical structure, crown bulk density, and to develop regression models for predicting crown fuel load using the data from 10 destructively sampled Pinus densiflora trees in Bonghwa, Gyeongbuk. The fuel loads were observed higher in the middle portion of the vertical distribution of crown followed by the lower portion and upper portion of Pinus densiflora, respectively. Approximately 25% crown fuel load was found in the needle while 33% was observed in the branches with <1 cm diameter with a total of 58% available fuel loads. The average crown bulk density was $0.45kg/m^3$, and $0.27kg/m^3$ of this was available in the needles and branches with <1 cm diameters. The resulting models in linear equations were able to account for 84% and 88% of the observed variation, while the allometric equations with diameter at breast height as the single predictor showed better results to account for 90% and 95% of the observed variation in the available crown fuel loads and total crown fuel loads, respectively. The suggested equations in this study could provide quantitative fuel load attributes for crown fire behavior models and fire management of red pine stands in Bonghwa areas.

• Korean Journal of Environment and Ecology
• /
• v.35 no.4
• /
• pp.398-407
• /
• 2021

This study intended to identify causes of poor tree vigor in the Hanbando coastal forest by investigating its geographical environment, climate condition, soil physicochemical characteristics, and growth condition of Pinus thunbergii. It divided the forest into an area with poor tree vigor or dead standing trees and a control area with good tree vigor and examined them separately. The survey showed that stand density was significantly higher in the area with poor tree vigor. In contrast, the crown width in the area with good tree vigor was wider. The number of dead standing trees and the stand density showed a negative correlation. The stand density and diameter at breast height (DBH), tree height, crown height, and crown width also showed a negative correlation. The result indicated that, as the tree's stand density increases, the crowns of individual trees overlapped and the lower branches died. Then crown height and crown width decreased, and the number of leaves and photosynthesis was reduced, leading to lower tree height and weaker growth of breast diameter. As a result, tree vigor weakened, and combined with environmental pressures from the lack of moisture and nutrients in coastal soil and salty wind, P. thunbergii in coastal areas is expected to die massively. Although the causes of dead standing trees and poor tree vigor of P. thunbergii in the Hanbando coastal forest are complicated, poor management of adequate tree density in response to the growth of P. thunbergii is the primary cause. The secondary cause is external environmental pressures, including unfavorable soil conditions and salty and strong wind that obstruct the growth of P. thunbergii.

• Journal of the Korean GEO-environmental Society
• /
• v.17 no.6
• /
• pp.13-21
• /
• 2016

Since the landslide hazard areas prediction was analyzed by slope-angle and soil properties, regional characteristics is not taken. Therefore, in order to make more rational prediction, it is necessary to consider the characteristics of the region. Tree roots have been known to increase soil cohesion in landslide hazard areas and to vary the degrees depending on the tree type. In addition, a reasonable prediction of landslide hazard areas can be made by considering crown density based on crown distribution patterns of the area of interest. In this study, using the roots cohesion considering the crown density of the trees, which is in the landslides risk areas around Mt. Gwehwa in Sejong City, the landslides risk areas were predicted and compared with predicted results obtained by not considering root cohesion.

• Journal of Korean Society of Forest Science
• /
• v.101 no.2
• /
• pp.244-250
• /
• 2012

The objective of this study was to analyze the above-ground biomass and crown fuel characteristics of Pinus densiflora stands in Yangyang, Gangwon province. A total of thirteen representative trees were destructively sampled in Yangyang region. The results showed that the stem density ($g{\cdot}cm^{-3}$) was 0.347~0.409, whereas the above-ground biomass expansion factors ranged from 1.251~1.419. In terms of crown fuel biomass, the above-ground biomass was $161.6Mg{\cdot}ha^{-1}$ while the stem biomass, branch biomass and needle biomass were $126.4Mg{\cdot}ha^{-1}$, $29.3Mg{\cdot}ha^{-1}$ and $5.9Mg{\cdot}ha^{-1}$, respectively. Needles and twigs with less than 1 cm diameter accounted 45.2% of the total crown fuel load. The available crown bulk density, which was calculated by dividing the crown fuel load to the crown volume, was $0.178kg{\cdot}m^{-3}$. The results of this study on the biomass and carbon stocks estimation of the Pinus densiflora together with the crown fire hazard assessment based on crown fuel loads are very significant information for the forest managers.

• Analytical Science and Technology
• /
• v.10 no.1
• /
• pp.60-65
• /
• 1997

Solvent extraction of alkali metal and alkaline earth metal cations by mono-crown ether(benzo-15-crown-5) and bis-(crown ether)s(ethylenediamine bis(4'-formyl benzo-15-crown-5)) containing benzo-15-crown-5 moieties were investigated with water-chloroform system at $25^{\circ}C$. The order of the extraction equilibrium constants($K_e$) and the complexation constants($K_c$) for the alkali metal and alkaline earth metal cations with mono-crown ether and bis-(crown ether)s were Ca(II)>Na(I)>Sr(II)>K(I)>Mg(II)>Rb(I) and Sr(II)>Ca(II)>K(I)>Rb(I)>Mg(II)>Na(I) respectively. These results were explained in terms of the size effect of metal cation and electron density effect. Also, the bis-(crown ether)s was found to extract metal cations more effectively than the corresponding mono-crown ether.