DOI QR코드

DOI QR Code

Crown Fuel Characteristics and Fuel Load Estimation of Pinus densiflora S. et Z. in Bonghwa, Gyeongbuk

경북 봉화 지역 소나무림에 대한 수관연료 특성과 연료량 추정

  • Jang, Mina (Department of Forest Resources, Kongju National University) ;
  • Lee, Byungdoo (Korea Forest Research Institute) ;
  • Seo, Yeonok (Department of Forest Resources, Kongju National University) ;
  • Kim, Sungyong (Department of Forest Resources, Kongju National University) ;
  • Lee, Young Jin (Department of Forest Resources, Kongju National University)
  • Received : 2011.04.19
  • Accepted : 2011.05.20
  • Published : 2011.09.30

Abstract

The objectives of this study were to analyze the crown vertical structure, crown bulk density, and to develop regression models for predicting crown fuel load using the data from 10 destructively sampled Pinus densiflora trees in Bonghwa, Gyeongbuk. The fuel loads were observed higher in the middle portion of the vertical distribution of crown followed by the lower portion and upper portion of Pinus densiflora, respectively. Approximately 25% crown fuel load was found in the needle while 33% was observed in the branches with <1 cm diameter with a total of 58% available fuel loads. The average crown bulk density was $0.45kg/m^3$, and $0.27kg/m^3$ of this was available in the needles and branches with <1 cm diameters. The resulting models in linear equations were able to account for 84% and 88% of the observed variation, while the allometric equations with diameter at breast height as the single predictor showed better results to account for 90% and 95% of the observed variation in the available crown fuel loads and total crown fuel loads, respectively. The suggested equations in this study could provide quantitative fuel load attributes for crown fire behavior models and fire management of red pine stands in Bonghwa areas.

본 연구의 목적은 경북 봉화 지역에 분포하는 소나무림을 대상으로 수관의 수직적 구조, 수관연료밀도, 수관특성을 분석하고, 수관연료량 추정을 위한 회귀모형을 개발하는 것이다. 소나무림에 대한 수관의 수직적 구조에서 연료량 비율은 수관의 중간부분이 가장 높은 것으로 나타났으며, 수관연료량에서 잎과 가지가 차지하는 비율은 잎 25%, 직경 1 cm이하 가지 33%로 수관화 확산 시 이용 가능한 수관연료량은 총 58%를 차지하는 것으로 나타났다. 봉화 지역 소나무림에 대한 평균 수관연료밀도는 $0.45kg/m^3$으로 매우 높게 나타났고, 잎과 1 cm이하의 이용 가능한 연료밀도는 $0.27kg/m^3$으로 나타났다. 선형회귀식과 비선형회귀식을 이용하여 이용 가능한 수관연료량과 전체 수관연료량을 추정한 결과, 선형회귀식의 경우 결정계수($R^2$)가 각각 84%, 88%로 나타난 반면에, 비선형회귀식의 경우 결정계수가 각각 90%, 95%로 더 높게 나타났다. 본 연구에서 제시된 상대생장식은 봉화 지역 소나무림의 산불관리와 수관화모델에 대한 정량적인 연료량 정보를 제공해 줄 수 있다.

Keywords

References

  1. 구교상, 이병두, 원명수, 이명보. 2010. 대구 팔공산 지역 소나무 수관층 연료 특성. 한국임학회지 99(1): 52-56.
  2. 박인협, 김준선. 1989. 한국산 4개 지역별 소나무천연림의 물질 현존량 추정식에 관한 연구. 한국임학회지 78(3): 323-330.
  3. 박인협, 이석면. 1990. 한국산 4개 지역별 소나무 천연림의 물질생산에 관한 연구. 한국임학회지 79(2): 196-204.
  4. 박정식, 윤선영. 2009. 현대 통계학. 다산출판사 pp. 353.
  5. 신만용, 정동준, 이태희. 1999. 우리나라 주요 수종별 수관형 형태식 개발의 관한 연구. 한국산림측정학회지 2(1): 3-11.
  6. 산림청. 2011. 산림청홈페이지. http://www.forest.go.kr/
  7. 산림청. 2010. 임업통계연보. 제40권 pp. 186-193.
  8. 이경학, 손영모, 노대균, 권순덕. 2002. 우리나라 주요 6수종의 수간중량 추정식. 한국임학회지 91(2): 206-212.
  9. 이병두, 원명수, 김선영, 윤석희, 이명보. 2010. 소나무 수관 부위별 연료량 추정식 개발 및 수관연료밀도 분석. 한국임학회지 99(3): 391-396.
  10. Bilgili, E. and Kucuk, O. 2009. Estimating above-ground fuel biomass in young Calabrian pine (Pinus brutia Ten.). Energy & Fuels. 23: 1797-1800.
  11. Call, P.T. and Albini, F.A. 1997. Aerial and surface fuel consumption in crown fires. International Journal of Wild-land Fire 4(3): 143-155.
  12. Cruz, M.G., Alexander, M.E. and Wakimoto, R.H. 2003. Assessing canopy fuel stratum characteristic in crown fire prone fuel types of western North America. International Journal of Wildland Fire 12: 39-50. https://doi.org/10.1071/WF02024
  13. Gray, K.L. and Reinhardt, E.D. 2003. Analysis of algorithms for predicting canopy fuel. In Proceedings of the Second International Wildland Fire Ecology and Fire Management Congress and Fifth Symposium on Fire and Forest Meteorology, Orlando, FL, American Meteorological Society, Boston, MA, November 16-20. Paper pp. 58.
  14. Hough, W.A. 1973. Fuel and weather influence wildfires in sand pine forests. USDA Forest Service Southeast Research Paper SE-RP-106. pp. 6.
  15. Kucuk, O., Saglam, B. and Bilgili, E. 2007. Canopy fuel characteristics and fuel load in young black pine trees. Biotechnology and Biotechnological Equipment 21(2): 235-240.
  16. Mitsopoulos, I.D. and Dimitrakopoulos, A.P. 2007. Allometric equations for crown fuel biomass of Aleppo pine (Pinus halepensis MIll.) in Greece. International Journal of Wildland Fire 16: 642-647. https://doi.org/10.1071/WF06038
  17. Peter, Z.F., Joseph, E.C., Allison, E.C., Margaret M.M. and W. Wallace Covington. 2004. Ecological Modelling. 175: 231-248. https://doi.org/10.1016/j.ecolmodel.2003.10.023
  18. Reinhardt, E.D., Scott, J.H., Gray, K. and Keane, R.E. 2006. Estimating canopy fuel characteristics in five conifer stands in the western United States using tree and stand measurements. Canadian Journal of Forest Research 36: 2803-2814. https://doi.org/10.1139/x06-157
  19. Sando, R.W. and Wick, C.H. 1972. A method of evaluating crown fuels in forest stands. USDA Forest Service Research paper NC-84.
  20. Shinozaki, K., Yoda, K., Hozumi, K. and Kira, T. 1964. A quantitative analysis of plant form-the pipe model theory. I. Basic analysis. Japanese Journal of Ecology 14: 97-105.
  21. Todd, L.E. and Moskal, L.M. 2010. Fusion of LiDAR and imagery for estimating forest canopy fuels. Remote Sensing of Environment 114: 725-737. https://doi.org/10.1016/j.rse.2009.11.002