• 대한기계학회논문집B
• /
• 제21권4호
• /
• pp.503-508
• /
• 1997

The change of the structure of homogeneous turbulence subject to irrotational strains has been studied in an anti-Morel type diffuser (center matched cubic contour) using the hot wire anemometry. It was observed that the profiles of mean velocities and turbulence velocities along the center line were stable at the entrance region but rapidly changed near the matching point. The wall induced turbulence at the entrance region grows fast and was diffused toward the center at downstream. It was also observed that the axial turbulence grows faster than the radial one in the middle region of the diffusing flow and that the diffusing process has the vortex compression mechanism due to the conservation of angular momentum. These phenomena are frequently observed at the initial flow region of the free jet.

• 대한기계학회논문집B
• /
• 제28권12호
• /
• pp.1600-1607
• /
• 2004

Performance of a regenerative pump is evaluated based on the calculated through flows using the CFX-TASCflow code. Flow calculations are performed in one vane to vane space of the impeller and side channel. The flow is very complex three dimensional with a strong radial vortex due to centrifugal force and an axial vortex due to re-circulating flow between the impeller and the side channel. Momentum exchange on the plane between the impeller and the side channel are evaluated to estimate design parameters and viscous losses in the pump. The present study contributes to showing the capability of flow simulation of complex flow in the regenerative pump by comparing the calculated performance with the measured value.

• 한국초전도ㆍ저온공학회논문지
• /
• 제1권1호
• /
• pp.42-47
• /
• 1999

Enthalpy transport in a pulse tube was investigated by two-dimensional analysis of mass. momentum an energy equations of the gas as well as energy conservation of the tube wall. The mean temperature of the gas and the tube wall was obtained directly by assuming that the outer surface of a pules tibe wall is adiabatic. Axial profile of mean temperature is small. but it deviates significantly from linear profile when the dimensionless frequency is large. Effect of operating frequency. tube wall thickness, velocity ratio and velocity phase angle between both ends of a pulse tube on net enthalpy flow were shown.

• International Journal of Air-Conditioning and Refrigeration
• /
• 제9권2호
• /
• pp.77-84
• /
• 2001

Experimental and computational studies were carried out to investigate the turbulent heat transfer enhancement of the cooling system in nuclear reactor by large scale vortex generation. The large scale vortex motion was generated by rearranging the inclination angels of mixing vanes to the coordinate direction. Axial development of mean and turbulent velocities in the subchannels were measured by the 2-color LDV system. Eddy diffusivity concept based on $\kappa{-}\varepsilon$ model was employed to calculate the turbulent heat and momentum transfers in the subchannel. The turbulences generated by split mixing vanes has small length scales so that they maintain only about $10D_H$ after the spacer grid. On the other hand, the turbulences generated by the large scale vortex motions continue longer and remain up to $25D_H$ after the spacer grid.

• 대한조선학회지
• /
• 제23권1호
• /
• pp.13-22
• /
• 1986

Axisymmetric turbulent thick boundary layers on a rotating body of revolution are calculated numerically in the paper. Richardson number is introduced to the mixing length to take account of swirl effects on Reynolds stresses. Interactions of the boundary layer and the external potential flow are included by adding the displacement thickness of boundary layers on the original body. Pressure distributions on the body surface are estimated by integrating normal momentum equation across the boundary layer. A model is designed and tested in the wind tunnel. Mean velocities are measured. Through the present study, swirl effects on the thick axisymmetric boundary layer development are considerable in comparison with those of non-totating cases. Rotational motion generally increase boundary layer thickness, axial skin friction coefficients, and form drags. Circumferential flow can be reversed to induce negative skin friction when the section area is reduced.

• 대한기계학회논문집B
• /
• 제24권7호
• /
• pp.945-956
• /
• 2000

The axisymmetric bodies considered in this study have hemispherical and ellipsoidal noses. The near-field pressure fluctuations over each nose model at $Re_D=2.43{\times}10^5$ were investigated in the laminar separation region and developing turbulent boundary layers using a 1/8' pin-holed microphone sensor. The wall pressure fluctuations were also measured in an axisymmetric boundary layer on a cylinder parallel to mean flow at a momentum thickness Reynolds number of 850 and a boundary layer thickness to cylinder radius ratio of 1.88.

• Bulletin of the Korean Chemical Society
• /
• 제18권9호
• /
• pp.976-981
• /
• 1997

The magnetic susceptibilities of molybdenum ions with 4d1 electronic configuration in the octahedral crystal field were calculated on the basis of ligand field theory. The experimental magnetic susceptibilities for molybdenum ions, which are stabilized at the octahedral site in the perovskite lattice of Ba2ScMoⅤO6 and Sr2YMoⅤO6, were compared with the theoretical ones. We have tried to fit their temperature dependence of magnetic susceptibility with ligand field parameters, spin-orbit coupling constant ζSO, and orbital reduction parameter κ according to intermediate field coupling and strong field theory. Strong field coupling theory could not explain experimental curves without unrealistically large axial ligand field, since it ignores the mixing up between different state via spin-orbit interaction and ligand field. On the other hand, the intermediate field coupling theory could successfully reproduce experimental data in octahedral and trigonal ligand field. The fitting result demonstrates not only the fact that spin-orbit interaction is primarily responsible for the variation of magnetic behavior but also the fact that effective orbital overlap, enhanced by cubic crystal structure, reduces significantly orbital angular momentum as indicated by κ parameter.

• 해양환경안전학회지
• /
• 제17권1호
• /
• pp.75-82
• /
• 2011

해양에너지는 아직 개발되지 않은 가장 유망한 재생 및 청정에너지 자원 중 하나이다. 특히 우리나라는 세계적으로 보기 드문 조류발전의 적지이며, 이를 이용하기 위해서는 각 해역에 적합한 조류에너지 변환 장치의 개발이 매우 필요하다. 따라서 본 연구에서는 조류발전 방식 중 수평축 로터 블레이드의 최적형상 설계 및 성능평가를 목적으로 날개 끝 손실 모델을 포함하는 날개요소 운동량이론을 적용한 조류터빈 설계기법을 제안하고, 100 kW급 로터 블레이드를 설계하였다. 또한 블레이드 국부위치에서 주속비에 따른 Prandtl의 날개 끝 손실 변화를 비교하였으며, 정격 날개 끝 속도비에서 NACA63812를 사용하여 설계된 로터 블레이드의 동력계수는 0.49로 우수한 성능을 나타내었다.

• 한국자기학회지
• /
• 제17권1호
• /
• pp.30-33
• /
• 2007

[ $FeIn_2S_4$ ]를 제조하여 뫼스바우어 분광기, X-선 회절기, SQUID 자화율 측정기를 이용하여 결정학적 및 자기적 특성을 연구하였다. 결정구조는 역스피넬 구조로 In 이온은 각각 사면체 자리(A site)와 팔면체 자리(B site)에 동시에 존재하는데 비하여, Fe 이온은 팔면체 자리에만 존재하였다. Curie-Weiss 역자화율에 따른 유효자기모멘트는 $5.09{\mu}_B$였으며, 닐온도($N\'{e}el$ temperature)는 13 K였다. 이와 같이 낮은 닐온도는 팔면체 자리의 $Fe^{2+}(B)-S^2-Fe^{2+}(B)$의 초미세 상호작용이 약하기 때문인 것으로 설명되어진다. 전기사중극자 상호작용의 온도 의존성은 z-축에 따른 결정장 이론으로 설명되어진다.

• Wind and Structures
• /
• 제15권1호
• /
• pp.17-26
• /
• 2012

Modeling swirling wakes is of considerable interest to wind farm designers. The present work is an attempt to develop a computational tool to understand free, far-wake development behind a single rotating wind turbine. Besides the standard momentum and continuity equations from the boundary layer theory in two dimensions, an additional equation for the conservation of angular momentum is introduced to study axisymmetric swirl effects on wake growth. Turbulence is simulated with two options: the standard ${\kappa}-{\varepsilon}$ model and the Reynolds Stress transport model. A finite volume method is used to discretize the governing equations for mean flow and turbulence quantities. A marching algorithm of expanding grids is employed to enclose the growing far-wake and to solve the equations implicitly at every axial step. Axisymmetric far-wakes with/without swirl are studied at different Reynolds numbers and swirl numbers. Wake characteristics such as wake width, half radius, velocity profiles and pressure profiles are computed. Compared with the results obtained under similar flow conditions using the computational software, FLUENT, this far-wake model shows simplicity with acceptable accuracy, covering large wake regions in far-wake study.