• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.25 no.9B
• /
• pp.1511-1517
• /
• 2000

A new slot-coupled back-to-back microstrip array antenna is proposed for using in the IMT-2000 base station or repeater antenna. This antenna is composed of symmetrical SSAIP(Strip Slot, Air Inverted Patch) It has bidirectional radiation pattern in horizontal plane and 22.5$^{\circ}$main beam squint in vertical plane. The analysis is based on the cavity model and the design is achieved using Ensemble. Experimental results for the radiation pattern and the return loss have shown that the direction of the main beam is about 21$^{\circ}$and the impedance bandwidth is approximately 22.9% Thus the proposed antenna is able to operate over both uplink and downlink frequencies in IMT-2000.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.3 no.4
• /
• pp.76-82
• /
• 2010

For the purpose of controlling the beam tilt angle of the base station sector array antenna, phase shifter is used. Phase angles of this antenna depending on the tilt angles are designed, and the patterns on the vertical and horizontal planes are simulated and analyzed for the evaluation of base station antenna. This analysis is used in the optimal design of base station antenna because of maximum cell coverage and incremented traffic capacity, decreased interference.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.22 no.8
• /
• pp.1747-1754
• /
• 1997

The helical array antenna is designed for domestic DBS(Directcast Satellite) reception. The antenna diameter is determined 30cm with 168 element s to cover from Moojoo (beam center) to Seoul. The helical antenna with 2-turns and 4.deg. pitch angle is chosen as array elements for good axial ratio and antenna height. In array antenna design, row distance is 0.787.lambda., array distance is 0.824.lambda. in the same row. The feed is constructed using the radial waveguide to decrease the height of antenna. The measured values of the designed antenna are not only satisfied with the design goals but also similar to theoritical values except the axial ratio.

• Proceedings of the Korea Electromagnetic Engineering Society Conference
• /
• 2005.11a
• /
• pp.297-302
• /
• 2005

Right hand circularly polarized Ka band microstrip patch array antenna was designed, manufacture and measurement were carried out. In order to lower axial ratio performance sequential rotation array technique was used. With mono-pulse feed There are sum and delta channel. Waveguide to microstrip transition was used. The 512 array antenna was performed which axial ratio is about 1.ldB in the half power beam width and also 1.ldB at the normal direction. Directivity gain of designed antenna is 32dB.

• ETRI Journal
• /
• v.27 no.6
• /
• pp.677-684
• /
• 2005

A phased array antenna was fabricated using four-element ferroelectric phase shifters with a coplanar waveguide (CPW) transmission line structure based on a $Ba_{0.6}Sr_{0.4}TiO_3(BST)/MgO$ structure. Epitaxial BST films were deposited on MgO (001) substrates by pulsed laser deposition. To attain the large differential phase shift and small losses for a ferroelectric CPW phase shifter, an impedance-matching-part adding technique between the effective transmission line and connecting cable was used. The return loss and insertion loss for this techniqueadapted BST CPW device were improved with respect to those for a normal BST CPW device. For an X-band phased array antenna system consisting of ferroelectric BST CPW phase shifters, power divider, dc block, patch antenna, and programmed dc power, the steering beam could be tilted by $15^{\circ}$ in either direction.

• Proceedings of the IEEK Conference
• /
• 2006.06a
• /
• pp.215-216
• /
• 2006

In this paper, the antenna the with linear active phased array of $1{\times}16$ operated in DBS band was designed. The antenna was composed of sixteen radiating elements, sixteen active channels and five Wilkinson power combiners with 4-channel inputs, a digital control board and a stabilizing DC bias board. The radiating element of the array has the structure of a microstrip stack patch with a left-hand circular polarization. And, each active channel consists of a low noise ampilifier, a 3-bit digital phase shifter and a variable analog attenuator. The breadboard of linear active phased array antenna was also fabricated to test the electrical performances. The radiation patterns of the antenna were measured after correcting initial phases of each active channel in aechoic chamber. And also, the beam scanning chracteristcs of $10^{\circ}$, $20^{\circ}$, $30^{\circ}$ were measured.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.21 no.12
• /
• pp.3205-3214
• /
• 1996

In this paper, the microstrip phased array antennas with coupling-slots for the base station of mobile communication is proposed and anlyzed with accurate analysis method which is based on both reciprocity principle and full-wave analysis. The basis functions used for the numerical analysis are determined depending upon the accuracy, convergence properties of the solution, and the computation time. The patch uses 3 EB mode and the slot uses IPWS mode. The designed phased array antenna has 8 slot-coupled microstrip patch array elements and the beam scanning capability is obtained by using the 4-bit PIN-diode phase shifters as switching devices which are consisted of the loaded line phase shifters for 30.deg. and 60.deg. and the reflection type phase shifters for 90.deg. and 180.deg. repectively. The 4-bits phase shifters which aremade by connecting each phase shifter have about 2.deg.-3.deg. phase errors and their insertion loss are about 3dB for each phase state. The fabricated 8-element phased array antenna with 4-bits phase shifters provides 12.deg.-14.deg. beamwidths depending on the scanning angle and is capable of scanning its beam to .+-.45.deg. with 9.deg. intervals, and the gain 12dBi. The overall results show that the slot-coupled phased array antenna has great advantages of wideband, high gain and reduced spurious radiation. Also, the antenna can be made small and thin. Furthermore, the scanning property of this antenna allows for its application in several areas, such as mobile communication system and PCS.

• Journal of IKEEE
• /
• v.24 no.2
• /
• pp.372-377
• /
• 2020

This paper is based on the triangular inset patch antenna as the basic structure, and the array structure is the twin tree form to improve the antenna's main lobe gain and reduce the side lobe gain. A twin tree structure was implemented by placing two identical trees of 2-4-6 arrays of triangular inset patches side by side. The parametric analysis confirmed that the gap between tree structures arranged side by side is most effective for impedance matching. The fabricated antenna has a gain of 16.74 dBi at 24.15 GHz, and the beam width of the main lobe is 22° in the E-plane and 6° in the H-plane. The antenna size was 125 mm × 50 mm, and a Taconic TLC substrate with a dielectric constant of 3.2 was used. Although the main lobe gain is improved over the twin tree structure, The directivity in the beam pattern due to the mutual interference of the two tree array structure can be improved.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.11 no.4
• /
• pp.514-522
• /
• 2000

In this thesis, a two-dimensional active phased array antenna without phase shifter is studied for two-dimensional beam scanning. A designed two-dimensional oscillator-type active array antenna, radiation elements and the oscillator circuits were combined with via-hole and coupled by slot on the opposite ground plane. The operating characteristics are analyzed and experimentally demonstrated , The two-dimensional $4\times4$ elements were designed for the proper coupling strengths and coupling phases by adjusting the width, length and offset position of slot-lines. The fabricated active phased array antenna shows the beam shift characteristics capable of scanning from $-17^{\circ}$ to $18^{\circ}$ with respect to broadside in one dimension, from $-5^{\circ}$ to $10^{\circ}$ in two dimension. The experimental results show that it is possible to use the oscillator-type active phased array antenna as a two-dimensional planar array antenna.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.20 no.2
• /
• pp.167-173
• /
• 2009

This paper proposes an electronically beam steering array antenna, consisting of single fed active element and 4 parasitic elements, operating in 5.8 GHz ISM band. Beam steering can be achieved by controlling the reactance of the variable reactance control circuit connected to the load of the parasitic elements without using the high cost phase shifters. The proposed antenna realizes ${\pm}30^{\circ}$ beam scanning of E-plane and H-plane with the below -10 dB return loss in ISM band. The gain of the $6.18{\sim}7.53\;dBi$ in E-plane and $7.022{\sim}7.779\;dBi$ in H-plane is shown in the scanning range.