• Journal of Advanced Navigation Technology
• /
• v.26 no.5
• /
• pp.350-357
• /
• 2022

With the recent prediction of 'Cycle 25', the importance of space weather research increases. Accordingly, the World Radiocommunication Conference (WRC)-23 has adopted Agenda Item 9.1a) and carried out sharing researches between active/passive space weather observation systems and existing services. Therefore, in this paper, in order to increase the precision of space weather environment data and secure the frequency spectrum for observation systems, the direct interference effect from the weather radar in Gosan, Jeju on the space weather observation receiver in Hallim, Jeju, and the indirect interference on the observation receiver by diffraction and scattering from the radar target have been analyzed. As a result, it can be known that the radar direction, the propagation direction diffracted and scattered from the target, and the Rradar Cross Section (RCS) of the radar target, the reception area of the space weather observation antenna, and the antenna off-boresight are important parameters for the interference effect analysis.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.14 no.2
• /
• pp.148-156
• /
• 2003

This paper describes the RF performance issues of UE for W-CDMA system based on 3 GPP specifications. The parameters of transmitter and receiver are derived from the viewpoint of RF performance. In order for UE to achieve high performance, the transceiver performance requirements such as ACLR, EVM, Peak Code Domain Error, spectrum emission mask, frequency error stability and TX power control dynamic range for transmitter and reference sensitivity level, blocking characteristics, noise figure, ACS, AGC dynamic range for receiver are considered. On the basis of the required parameters, the UE RF transceiver is implemented and then the evaluation of RF performance is accomplished through practical test scenarios.

• Journal of Advanced Navigation Technology
• /
• v.4 no.2
• /
• pp.152-161
• /
• 2000

Recently, it is considered to combine the GPS receiver with the GLONASS for the improvement of performance and accuracy. This combined system reduces errors by SA for GPS, and has merits to select receivable satellite. In this paper, aperture-coupled patch antenna and small sized ceramic dielectric patch antenna are designed and implemented for GPS/GLONASS combined receiver, which show a wideband characteristics with circular polarization. The manufactured antennas have the bandwidth more than 240 MHz, VSWR less than 1.5:1, and the axial ratio less than 3dB, and satisfy required characteristics of the GPS/GLONASS antenna.

• Journal of Advanced Navigation Technology
• /
• v.20 no.5
• /
• pp.394-400
• /
• 2016

It is well known that the encrypted ranging signal, such as GPS P(Y) code, is immune to spoofing attack. However, in order for users to use the signal, there needs permission from the operator. And also there are many restrictions for use because of security issues. In this paper, a ground reference station equipped with high-gain directional antenna and a user receiver were simulated. In the reference station, the encrypted code can be demodulated from the high-gain signal. And then the code can be used to detect spoofing attack in the user receiver. This paper proposes the spoofing detection method using the encrypted signal and deals with simulation results.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.8 no.5
• /
• pp.970-976
• /
• 2004

In this paper, we analyze channel estimation algorithms in a RAKE receiver with MRC. There are 3 popular channel estimation algorithms, which are WMSA(Weighted Multi-Slot Averaging) algorithm, EGE(Equal Gain Estimation) algorithm, SSE(Symbol-to-Symbol Estimation) algorithm. We analyze asynchronous IMT-2000(3GPP) which employ 3 different channel estimation algorithms by HP-ADS(Advanced Design System) simulation tool. We used lakes fading channel model for the analysis. from simulation results, we could observe that the performance of WMSA algorithm is better than others in low Doppler effect(3Km/h). However, in the case of high Doppler effect(120km1h), the EGE algorithm is more efficient. In this case the simple estimator with EGE algorithm seems to be more useful.

• Journal of Advanced Navigation Technology
• /
• v.16 no.4
• /
• pp.593-601
• /
• 2012

This paper develops and analyzes a new multiple-hypothesis Receiver Autonomous Integrity Monitoring (RAIM) algorithm as a candidate for future standard architecture. The proposed algorithm can handle simultaneous multiple failures as well as a single failure. It uses measurement residuals and satellite observation matrices of several consecutive epochs for Failure Detection and Exclusion (FDE). The proposed algorithm redueces the Minimum Detectable Bias (MDB) via the Relative RAIM (RRAIM) scheme. Simulation results show that the proposed algorithm can detect and filter out multiple failures in tens of meters.

• Journal of Advanced Navigation Technology
• /
• v.13 no.1
• /
• pp.97-103
• /
• 2009

In this paper, the structure and detailed specifications of the HDR-WPAN physical layer have been analyzed and the block module of transmitter and receiver have been also designed, and analyzed the performance as well. In the process of transmitter design, it concentrated on all possibility of modulation of QPSK, DQPSK and 16/32/64QAM-TCM, which could be available for mode selection due to the transmission rate. In addition to the receiver module, DQPSK and TCM decoding algorithm is mainly concerned. After designing the transceiver MODEM using VHDL, we have programmed on the platform board and verified the functions of the MODEM. Some experimental results showed that it can be considered a possibility of data communication without error over SNR 22dB.

• International journal of advanced smart convergence
• /
• v.5 no.3
• /
• pp.16-26
• /
• 2016

This proposed project is about a bicycle anti theft devised system which helps people protect the bicycle from theft and helps to track the stolen bicycle's location using a smart phone. Safety bike uses two main devices to keep the bicycle secured, the vibration sensor and GPS sensor. The purpose of this project is to put all these small devices into one well connected system which will help the bicycle owner have more control over the security of his own bicycle. The whole system can be divided into two main parts. The first part is about the hardware development whereby all electronics components are connected via the circuit design using wire wrapping technique. This hardware part includes, a vibrations sensor, a GPS receiver, a toggle switch, LED light, Bluetooth and a buzzer. Wireless Bluetooth signals are used as the means of communication between the smartphone and the microcontroller. The second part is the software part which is being to program and control the whole system. The program is written using MikroBasic, a full-featured Basic compiler for microcontroller based systems. In conclusion, this system is designed to enable user to have control in securing his/her bicycle also being able to find and locate it at any time using GPS receiver and mobile android application.

• Journal of Advanced Navigation Technology
• /
• v.3 no.1
• /
• pp.52-59
• /
• 1999

Digital microwave wideband receiver including linear amplifier, analog-to-digital converter(ADC) and digital signal processor is able to analyze its performance using sensitivity and dynamic range of system. Determination of gain, third-order intermodulation products and ADC characteristics and design criteria for the linear amplifier chain is essential problem for sensitive and dynamic range. Also, if there are two signals with frequencies very close, digital signal processor must be able to separate the two signals. In this paper, we measured dynamic range as gain was changed and determined gain value for the proper sensitivity and dynamic range and high resolution spectrum estimation was used to separate two close signals.

• Journal of Advanced Navigation Technology
• /
• v.2 no.1
• /
• pp.22-33
• /
• 1998

In the coherent-on-receiver radar system using the magnetron source, frequency synthesizer is employed as a STALO(Stable Local Oscillator) to keep the intermediate frequency stable. In this paper, X-band(8.4GHz~9.7GHz) single loop frequency synthesizer is designed and implemented by an indirect frequency synthesis technique. Phase comparison is performed by a digital PLL(Phase-Locked Loop) chip and the loop filter is designed for the low phase noise. The effects of loop component characteristics on the output phase noise are analyzed for single loop structures, and the calculated results are compared with the measured data.