• International journal of advanced smart convergence
• /
• v.11 no.3
• /
• pp.28-35
• /
• 2022

Interference always exists between wireless communication systems used in the same frequency band or adjacent frequency bands. In order to deploy a new wireless communication system such as a 5G system, a new frequency band must be allocated to the system. For this purpose, after analyzing interference between the existing system and the new system, a method of setting a frequency guard band or a minimum separation distance has been used as a passive method to limit the interference effect. This paper presents a wideband RF IRM(Interference Reduction Module) that can actively reduce the influence of interference between wireless communication systems. The wideband RF IRM can reduce the interference effects of 5G signals on satellite signals. The principle and structure of the wideband RF IRM are presented. The wideband RF IRM can suppress approximately 20dB of interference signal in 100MHz bandwidth when only interference signal exists. It also shows that when a 5G interference signal of -45dBm/100MHz and a satellite signal of -55dBm/40MHz exist simultaneously at a center frequency of 3.83GHz, about 15dB of 5G interference signal can be reduced in the frequency range covered by the satellite signal. The experimental results demonstrate that the wideband RF IRM can actively reduce the 5G interference signal on the satellite signal and can be used for the purpose of reducing the interference effect in a similar environment.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.11 no.2
• /
• pp.1-6
• /
• 2011

In this paper, an 1.5Gbit/s wireless data transmission system using the carrier frequency of 300 GHz band was implemented. The RF front-end was composed of schottky diode sub-harmonic mixer, frequency tripler, and horn antennas for transmitter and receiver, respectively. The LO frequencies of sub-harmonic mixer are 150GHz for transmit chain and 156GHz for receive chain. The ASK(Amplitude Shift Keying) modulation was used in the transmitter and the envelope detection method was used in the heterodyne receiver. The conversion loss of sub-harmonic mixer and implementation system loss were measured to be 9.8dB and 1.2dB, respectively. The 1.5Gbit/s video signal with HD-SDI format was transmitted over wireless distance of 40cm without optical lens(4.2m with optical lens) and displayed on HDTV at the transmitted average output power of $20{\mu}W$.

• Journal of Broadcast Engineering
• /
• v.22 no.4
• /
• pp.448-461
• /
• 2017

This paper proposes a vehicle counting and speed estimation method for traffic situation analysis in road CCTV videos. The proposed method removes a distortion in the images using Inverse perspective Mapping, and obtains specific region for vehicle counting and speed estimation using lane detection algorithm. Then, we can obtain vehicle counting and speed estimation results from using optical flow at specific region. The proposed method achieves stable accuracy of 88.94% from several CCTV images by regional groups and it totally applied at 106,993 frames, about 3 hours video.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.18 no.4 s.119
• /
• pp.358-363
• /
• 2007

The multi-band and wide-band antenna for a portable broadcasting terminal is proposed. The proposed antenna consists of two radiators with a parallel structure. The antenna has an enough wide impedance bandwidth for the DVB-H(Digital Video Broadcasting-Handheld) service band since two radiators have adjacent resonance frequencies and operates in the DAB(Digital Audio Broadcasting) service band using the third harmonic of the radiator 1. The fabricated antenna has VSWR characteristics of less than 2:1 in the frequency band $470{\sim}740\;MHz$ for DVB-H and $1,450{\sim}1,480\;MHz$ for DAB. The measured peak gain of the antenna is $1.97{\sim}4.10\;dBi$ in the DVB-H band and $1.98{\sim}2.04\;dBi$ in the DAB band.

• Journal of Broadcast Engineering
• /
• v.18 no.6
• /
• pp.808-815
• /
• 2013

In this paper, we propose a novel fast and low-complexity Motion Estimation (ME) algorithm for Ultra High Definition (UHD) High Efficiency Video Coding (HEVC). Motion estimation occupies 77~81% of the amount of computation in HEVC. After all, the main key of video codec implementation is to find a fast and low-complexity motion estimation algorithm and architecture. We analyze the previous motion estimation algorithms and propose three optimal algorithm to reduce the computation proportion for HEVC. The proposed algorithm uses only 0.36% of the amount of operations compared to full search algorithm while maintaining compression performance with slight loss of 1.1%.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.20 no.5
• /
• pp.63-70
• /
• 2020

In this paper, the transmit-receive module for military seekers has been designed and fabricated in 35 GHz. To increase the performance of substrates and high integration of circuits in millimeter-wave band, a 4-layer LCP(Liquid Crystal Polymer) substrate was developed. This substrate was implemented with three FCCL substrates and two adhesive layers, and a process using the difference in melting point between the substrates was used for lamination. Using a strip line and a microstrip line was confirmed by the transmission loss along the length of the substrate, and the performance of LCP substrates was validated with a power divider in 35 GHz. After confirming the performance of individual blocks such as power amplifier and low noise amplifier, a single channel Ka-band transmission/reception module was developed using a 4-layer liquid crystal polymer substrate. The transmit power of this module has above 1.1W in pulse duty 10% and has an output power of 1.1W and it has receive noise figure less than 8.5 dB and receive gain more than 17.6 dB.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.22 no.4
• /
• pp.67-72
• /
• 2022

This study presents the design of power amplifier (PA) in 60 nm GaN/Si HEMT technology. A customized transistor model enables the designing circuits operating at W-band. The all matching network of the PA was composed of equivalent transformer circuit to reduce matching loss. And then, equivalent transformer is several advantages without any additional inductive devices so that a wideband power characteristic can be achieved. The designed die area is 3900 ㎛ × 2300 ㎛. The designed results at center frequency achieved the small signal gain of 15.9 dB, the saturated output power (Psat) of 29.9 dBm, and the power added efficiency (PAE) of 24.2% at the supply voltage of 12 V.

• Journal of Bio-Environment Control
• /
• v.33 no.1
• /
• pp.55-62
• /
• 2024

This study aimed to compare the nutrient uptake rate, growth and yield of strawberry grown under the aquaponic and hydroponic systems in a plant factory. For aquaculture, 12 of fish (Cyprinus carpio cv. Koi) were raised in an aquaponics tank (W 0.7 m × L 1.5 m × H 0.45 m, 472.5 L) filled with 367.5L of water at a density of 5.44 kg·m^-3. The 30 seedlings of strawberry were planted in ports filled with perlite substrate and then were placed on the bed (W 0.7 m × L 1.5 m × H 0.22 m) at the top of the aquaponics system, and the 30 seedlings were planted in net-pots and then placed on the holes of acrylic plates (140 cm × 60 cm, Ø80 mm) on the bed (W 0.7 m × L 1.5 m × H 0.22 m) at the deep flow technique (DFT)- hydroponics. The pH and EC of the aquaponic solution was ranged from 4.3 to 6.9 and 0.32 to 1.14 dS·m^-1, respectively, while those of hydroponics were ranged from 5.1 to 7.5 and 1.0-1.8 dS·m^-1, respectively. The NO₃-N and NH₄-N concentration of the aquaponic solution were higher about 3.6 and 2.2 me·L^-1 than those of the standard hydroponic solution for strawberry cultivation. The P, Ca, Mg, and S ions in the aquaponic solution were also higher about 0.76, 3.1, 0.8, and 0.9 me·L^-1 than those of standard hydroponic solution, respectively, while the K and Fe were lower about 0.8 me·L^-1 and 0.5 mg·L^-1, respectively. The mineral contents of the strawberry leaves grown on aquaponics did not differ from that of hydroponics, and K content in the leaves were in an appropriate range. Uptake rates of T-N and P between the 58 and 98 days after transplant (DAT) were 1.5 and 1.9-fold higher in the aquaponics than those of hydroponics, respectively with no significant difference in the uptake rate of K. The crown diameter, plant height, and leaf length and width in the 98 DAT were significantly higher in aquaponics. The number of fruits per plant was significantly higher in aquaponics than those in hydroponics, and the fresh and dry weights of fruit and length and width of fruit were significantly higher in hydroponics. The results suggest that plants in aquaponics continuously utilize fertilizer components of solid particles from fish and feed wastes.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.12 no.2
• /
• pp.167-174
• /
• 2012

The circuits including with Optical transceiver and clock data recovery, in this paper, SERDES (SERializer-DESerializer) are implemented to construct a GE-PON burst-mode transceiver supporting IEEE 802.3ah and a jig for measuring the burst-mode characteristics, that is to say, PON upstream optical transmission environment are manufactured to evaluate the performance of transceiver. we verified that the limiting amplifier compensated the gap of max. 26dB optical power by experiments. The startup acquisition lock time is 670ns in case of using VSC7123 and 2300ns in case of S2060 and the data acquisition lock time were measured to be 400ns and 600ns, respectively, in the upstream channel transmission in this work. While on the other, VSC7123 is satisfied with IEEE802.3ah recommendations.

• Journal of Advanced Navigation Technology
• /
• v.18 no.5
• /
• pp.421-428
• /
• 2014

GPS satellite positions can be obtained from the navigation message transmitted from the GPS satellite. In this paper, the accuracy of broadcast orbit and clock are analyzed by comparing with the NGA precise ephemeris. For analyzing global and local orbit errors in 2004 to 2013, GPS satellite visibilities are calculated in Korea. Local RMS of 3D orbit error and SISRE are 4 cm and 3 cm less than global RMS of 3D orbit errors and SISRE. Orbit and clock errors are calculated for each GPS satellite Block for 10 years. SISRE of Block IIA satellites are 2.8 times greater than Block IIF satellites. The correlation between orbit errors and shadow condition is analyzed. The orbit errors in shadow is 2.1% higher than that in sunlight. Correlation analysis between the orbit errors and solar/geomagnetic index shows that orbit errors has a high correlation with from 2004 to 2008. However, the correlation became low since 2009.