• The Korean Journal of Rheology
• /
• v.4 no.2
• /
• pp.107-115
• /
• 1992

전방향족 에스테르계 열방성 액정중합체(LCP) 벡트라(Vectra)와 폴리카보네이트 (PC)를 무게비 30/70으로 구성한 고분자 블렌드를 확장되는 다이를 통하여 압출한후 압출쉬 트의 탄성 및 점탄성 특성을 만능시험기(UTM)와 동적기계적 스펙트로터(RDS)를 이용하여 측정하였다. 블렌드의 기계적 특성은 기지재인 PC의 ductility에도 불구하고 순수 LCP보다 도 더 brittle하였다. 그러나 탄성률이나 인장강도 모두 PC보다 훨씬 높게 나타나 보강효과 가 확인되었다. 이러한 보강효과는 복합계 내부에서 스스로 형성된 직경 2~10$\mu$m 정도의 거대 섬유소 그리고 거대 섬유소는 다시 직경 0.05$\mu$m 정도의 미세섬유로서 구성된 형태학 적 특성으로 설명될수 있었다. 한편 블렌드의 점탄성 거동은 마치 entanglement coupling이 높은 계의 특성과 비슷하였으며 시편의 위치에 따른 특성변화는 관찰되지 않았고 순수산 LCP의 점탄성 특성과 아주 유사하였다.

• International Journal of Highway Engineering
• /
• v.8 no.2 s.28
• /
• pp.87-93
• /
• 2006

To evaluate the deformational characteristics of subgrade soils, four subgrade samples in Korea were tested using the RC and TS tests with various dry unit weight and water content. Both the maximum modulus and normalized modulus reduction curves of subgrade soils were affected by the dry unit weight. The normalized modulus was decreased about 20% with increasing of relative compaction of 5%. It was founded that the variations of modulus of subgrade soils in Korea were over 40% with water content variation of $\pm$2%, and those effects can be estimated by exponential model. However, the normalized modulus reduction curves were almost identical and independent of water content. It was also founded that confining pressure, loading frequency, dry unit weight, and water content have an affect on modulus of subgrade soils independently. Therefore, it can be considered that those effects are independent variables.

• Journal of the Korean Geotechnical Society
• /
• v.20 no.6
• /
• pp.51-59
• /
• 2004

The evaluation of shear modulus is very important in various fields of civil engineering. In this paper, the site characterization method using HWAW method is applied to determine shear wave velocity profile of two test sites in order to verify the field applicability of HWAW method. Shear wave velocity profiles by HWAW method are compared with shear wave velocity profiles by SASW test and PS-Suspension Logging test. Through field applications, it is shown that HWAW method can minimize the effect of noise and lateral non-homogeneity of the site and determine detailed local shear wave velocity profile of site.

• Elastomers and Composites
• /
• v.33 no.4
• /
• pp.290-296
• /
• 1998

Recycling of waste tire has been limited and very simple, few applications have been observed. This study introduces a new elastic and permeable pavement made of scrap tire. Experimental results showed that key factors affecting the compressive strength were the size of scrap tire, size of aggregate, amounts and property of binder. Also, the water permeability depended on the size of aggregate and scrap tire. The compressive strength and water permeability of the samples were 1.4 and 116 times higher than those of the conventional porous cement concrete, respectively.

• Journal of the Korean Geotechnical Society
• /
• v.39 no.7
• /
• pp.49-56
• /
• 2023

Gravel is commonly employed to enhance the bearing capacity of foundations and provide stable support for structures. However, effectively assessing the ground characteristics in the presence of gravel poses significant challenges. This study aims to compare the resolution of ground containing gravel using electrical resistivity, elastic wave surveys, and ground penetration radar (GPR). Nondestructive methods are applied at construction sites where soil improvement is carried out using gravel. The experiments focus on shallow depths, and the obtained results cover depths up to 2 m. Both the electrical resistivity and elastic wave techniques exhibit similar behavior in their findings, indicating comparable outcomes. However, GPR has limitations in observing the characteristics of ground with gravel. Dynamic cone-penetration tests were conducted to validate these findings. The electrical resistivity and elastic wave profiles exhibited similar behaviors in localized areas, further supporting their compatibility and reliability.

• Journal of the Korean Society of Hazard Mitigation
• /
• v.4 no.2 s.13
• /
• pp.19-27
• /
• 2004

The interest in the dynamic properties of soils has increased strongly because of earthquake, heavy traffic, and foundations undergo high amplitude of vibrations. Most of soils in Korean peninsula are composed of granite soils, especially the decomposed mudstone soils are widely spread in Pohang areas, Kyong-buk province. Therefore, it is very important to investigate the dynamic properties of these types of soils. The most important soil parameters under dynamic loadings are shear modulus and material dampings. Furthermore, few definitive data exist that can evaluate the behavior of unsaturated decomposed mudstone soils under dynamic loading conditions. The investigations described in this paper is designed to identify the shear modulus and damping ratio due to a surface tension for the unsaturated decomposed mudstone soils under low and high strain amplitude. For this purpose, the resonant column test and the cyclic triaxial test were performed. Test results and data have shown that the optimum saturated degree of decomposed mudstone soils under low and strain amplitude is $32{\sim}37%$ which is higher than that of decomposed granite due to the amount of fine particles as well as the type and proportion of chief rock-forming minerals.

• Journal of the Korean Geotechnical Society
• /
• v.20 no.6
• /
• pp.137-150
• /
• 2004

Aging effect of sands showed insignificant result in comparison with that of clay, so that it has not been studied so far. But, as penetration resistance increase has been observed with the lapse of time after deposition and disturbance, aging effect of sands has been actively investigated by field tests, and recently many researchers are performing not oかy field tests but also laboratory tests on sands, so aging effects of sands have been also examined by laboratory tests. In this study, to observe the aging effect of undrained static shear behavior for Nak-Dong River sand, undrained static triaxial tests were performed with changing relative density$(D_r)$, consolidation stress ratio$(K_c)$, and consolidation time. These tests showed that modulus within elastic section increased as consolidation time increased, and in addition, phase transformation point strength$(S_{PT})$ and critical stress ratio point strength $(S_{CSR})$ also increased. But pore water pressure ratio$(u/{p_c}')$ decreased as consolidation time increased, so with this various result, aging effect of static shear for sands can be observed as well.

• Tunnel and Underground Space
• /
• v.21 no.3
• /
• pp.205-215
• /
• 2011

In this study, we analyzed physical properties of granites and their correlation with rock mass classification methods. The granite samples were obtained from field survey, in-situ borehole tests and laboratory tests for a design phase of various roads, railways and other civil engineering works in Korea. Among the measured physical properties, the results of unit weight, compressive strength, tensile strength, seismic velocity, cohesion, friction angle, elastic modulus and deformation modulus were introduced. We also correlated these properties with the compressive strength. The results of different rock classification method of RQD, RMR, and Q-system against the granites in Korea were compared with each other, and the correlation equations were proposed in a more simplified form. We also derived RMR values using the compressive strength as well as the RQD values of in-situ drilled cores, and estimated the deformation modulus of in-situ rock mass in terms of the RMR values.

• Tunnel and Underground Space
• /
• v.22 no.4
• /
• pp.284-295
• /
• 2012

Abrasiveness of rock plays an important role on the wear of rock cutting tools. In this study, Cerchar abrasiveness tests were carried out to assess the abrasiveness of 19 different Korean rocks. Cerchar abrasiveness test is widely used to assess the abrasiveness of rock because of its simplicity and inexpensive cost. This study examines the relationship between Cerchar Abrasiveness Index (CAI) and mechanical properties (uniaxial compressive strength, Brazilian tensile strength, Young's modulus, Poisson's ratio, porosity, shore hardness of rock), and the effect of quartz content, equivalent quartz content, which was obtained from XRD analysis. As a result of test, CAI was more influenced by petrographical properties than by the bonding strength of the matrix material of rock. CAI prediction model which consisted of UCS and EQC was proposed. CAI decreased linearly with the hardness of the steel pin. Numerical analysis was performed using Autodyn-3D for simulating the Cerchar abrasiveness test. In the simulations, most of pin wear occurred during the initial scratching distance, and CAI increased with the increase of normal loading.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2015.08a
• /
• pp.161.1-161.1
• /
• 2015

복합소재는 두가지 이상의 서로 다른 물질을 조합하여, 단일 물질이 가질 수 없는 뛰어난 특성을 가진 소재로 그 중 전기 전도성 복합소재는 일반적으로 폴리머와 전도성 필러의 혼합을 통해 만들어 전자파 차폐, 대전 방지 등의 목적으로 사용되고 있다. 종류에 따라 기존 금속 소재에 비해 가볍거나 탄성율이 높은 등의 장점이 있으나 필러나 레진에 따라 재활용에 어려움이 있으며 전도성 필러로 주로 쓰이는 카본블랙 등이 석유/천연가스 등의 한정적 자원으로부터 만들어짐에 따라 환경적인 이슈가 최근 부각되고 있다. 목재는 가장 널리 쓰이는 소재 중 하나로 재생 가능하며 친환경적인 특성으로 인해 더욱 다양한 분야로의 활용이 모색되고 있다. 본 연구에서는 목재 소재의 탄화를 통해 만들어진 탄화목분의 전도성 필러로의 적용가능성을 시험하고자 CBT 레진과 탄화목분 필러의 복합소재를 제작하였다. 탄화 목분 복합소재의 전도성은 20 wt% 필러 함량 기준 카본블랙 복합소재 전도도에 20%에 이르렀으며, 전도도의 향상을 위해 필러의 플라즈마 처리 시 복합소재의 전도도가 급격히 향상되어, 카본 블랙 복합소재 전도도의 3배에 이르렀다. 플라즈마 처리가 탄화목분 복합소재의 전도도향상에 미치는 영향을 분석하기 위해 micro-CT, TGA 분석을 수행하였으며, 플라즈마 처리 시 탄화 목분 필러가 일부 미분화 되어 복합소재의 전도도를 향상하는 것으로 나타났다. 이와 같이 탄화 목분의 전도성 복합소재 적용과, 탄화목분의 플라즈마 처리를 통해 친환경적일 뿐만아니라 전도도도 우수한 복합소재를 구현하였으며, 실험적으로 전도도 향상 메커니즘을 확인하였다.